油池火作用下钢管混凝土柱温度分布研究

在开敞空间条件下利用油池火模拟不同的火灾场景,对火源燃烧阶段和燃烧结束后钢管混凝土柱的温度变化进行研究。测量了燃料质量变化和钢管混凝土柱的温度分布等参数,分析不同火灾场景下钢管混凝土柱轴向、横截面的温度变化,并以实验工况HS3为例进行深入分析,同时分析了火源的燃烧时间、热释放速率对钢管混凝土柱温度场分布的影响。研究结果表明,钢管混凝土柱纵向温度分布与横向温度分布一样都存在明显的温度梯度,其表面钢管温度变化受火场热释放速率影响较大,而内部混凝土的温度变化则主要受火场持续时间的影响。     

基于总物流分析的我国钢铁工业生态效率分析

近年来我国钢铁产量快速增长且钢铁工业规模庞大,因此有必要对我国钢铁工业的生态效率进行研究. 采用总物流分析方法对我国钢铁系统的总物流进行分析,得到了钢铁系统的总物流分析指标;对1995—2011年我国钢铁工业的生态效率(包括资源效率、能源效率、脱钩指数等)进行了分析. 结果表明:2004年资源效率(粗钢产量与铁矿原矿消耗的比值)和资源经济效率(钢铁工业增加值与铁矿原矿消耗的比值)均达到最大值,二者分别为0.54 t/t和827.66元/t;2011年能源效率(粗钢产量与钢铁工业能耗的比值)和能源经济效率(钢铁工业增加值与钢铁工业能耗的比值)均达到最大值,分别为1.53 t/t和2 976.65元/t. 基于我国钢铁系统的总物流分析结果进行了脱钩指标分析,结果显示,D_DEU(国内开采量的脱钩指数)为0.189,大于DMI(直接物质投入量)、TMR(总物质需求)及DPO(国内排放量)的脱钩指数(分别为0.115、0.084和0.061),即国内开采量的脱钩情况在该阶段达到最佳,这与我国铁矿石产量不足、钢铁生产更多依赖于进口资源密切相关. 最后提出了提高矿产资源综合利用率和重视废钢资源回收利用等相应的对策建议.      

双齿许水蚤(Pseudodiaptomus dubia)对亚热带虾池Cu和Zn富集的研究

重金属污染是对虾养殖环境主要污染现象之一,查明重金属在环境中的迁移规律对养殖水质调控和对虾健康养殖具有重要意义。本文采用火焰原子吸收分光光度计测定在不同暴露时间下双齿许水蚤(Pseudodiaptomus dubia) 对Cu和Zn的富集量,研究了双齿许水蚤对Cu和Zn富集动力学,并探讨了温度和盐度对其富集的影响。结果表明：双齿许水蚤对Cu和Zn的富集过程均经历了快速、慢速和平衡3个阶段,实验24 h达到富集平衡;双齿许水蚤对Cu和Zn的富集动力学参数k_1(Cu)=0.077 < k_1(Zn)=0.272,BCF_(Cu)=0.344 < BCF_(Zn)=2.252,双齿许水蚤对Zn的富集速率和富集能力均大于Cu。温度对双齿许水蚤Cu和Zn富集的影响显著(p <0.05),最适温度范围为15~30 ℃;盐度对双齿许水蚤Zn富集的影响极显著(p <0.01),而对Cu富集的影响不显著(p >0.05),对Cu和Zn适宜的富集盐度范围为5~35。这些研究结果表明,双齿许水蚤对Cu和Zn均具有较强的富集能力。基于以上研究结果,在对虾养殖期间,应通过循环过滤设施去除受到重金属污染池塘中的浮游动物,从而减少幼虾对其摄食和量度体重金属的积累,降低食品安全隐患。     

Corrosion behavior of steels for CO2 injection

The process chain for Carbon Capture and Sequestration (CCS) includes tubing for injection of CO₂ into saline aquifers. The compressed CO₂ is likely to contain specific impurities; small concentrations of SO₂ and NO₂ in combination with oxygen and humidity are most harmful. In addition, CO₂ saturated brine is supposed to rise in the well when the injection process is interrupted. The material selection has to ensure that neither CO₂ nor brine or a combination of both will leak out of the inner tubing. In this comprehensive paper the investigated materials range from low-alloy steels and 13% Cr steels up to high-alloy materials. Electrochemical tests as well as long term exposure tests were performed in CO₂, in brine and combination of both; pressure was up to 100 bar, temperature up to 60 °C. Whereas the CO₂ stream itself can be handled using low alloy steels, combinations of CO₂ and brine require more resistant materials to control the strong tendency to pitting corrosion. The corrosion behavior of heat-treated steels depends on factors such as microstructure and carbon content. For different sections of the injection tube, appropriate materials should be used to guarantee safety and consider cost effectiveness.     

Simulation-based fault propagation analysis—Application on hydrogen production plant

Recently production of hydrogen from water through the Cu–Cl thermochemical cycle is developed as a new technology. The main advantages of this technology over existing ones are higher efficiency, lower costs, lower environmental impact and reduced greenhouse gas emissions. Considering these advantages, the usage of this technology in new industries such as nuclear and oil is increasingly developed. Due to hazards involved in hydrogen production, design and implementation of hydrogen plants require provisions for safety, reliability and risk assessment. However, very little research is done from safety point of view. This paper introduces fault semantic network (FSN) as a novel method for fault diagnosis and fault propagation analysis by using evolutionary techniques like genetic programming (GP) and neural networks (NN), to uncover process variables’ interactions. The effectiveness, feasibility and robustness of the proposed method are demonstrated on simulated data obtained from the simulation of hydrogen production process in Aspen HYSYS^®. The proposed method has successfully achieved reasonable detection and prediction of non-linear interaction patterns among process variables.     

Cu(NO3)2在亚甲蓝湿式氧化处理中的应用

用CWAO技术处理COD为2 000 mg/L的亚甲蓝水溶液.以Cu(NO3)2为催化剂,考察了催化剂投加量、反应温度、压力及进水pH值对亚甲蓝水样COD去除率、脱色率、出水pH值的影响.实验表明,亚甲蓝的氧化效率随催化剂投加量的增加,反应温度及压力的升高而升高.然而,综合考虑亚甲蓝的氧化效率、试剂费用、设备成本及能量消耗,实验确定Cu(NO3)2的投加量以Cu2 计为150 mg/L,反应温度及压力分别为200℃和2.0 MPa.在酸性进水条件下,COD去除率随进水pH值的降低而升高;而在碱性进水条件下,COD去除率随进水pH值的升高而升高.pH值按COD去除率由高到低的排列顺序是:3.87、11.23、5.50、7.25、9.47,实验确定最佳进水pH值是3.87.在以上最佳的操作条件下,反应150 min,水样COD去除率达97.4%,脱色率达99.97%,出水pH值3.63.     

轧钢污泥综合利用的技术研究

阐述了一种轧钢污泥的回收处理技术,该技术可把轧钢污泥有效地分离成氧化铁粉和混合油,实现综合利用,减少铁素资源浪费,有良好的经济效益和环境效益.     

经济转型中的中国废钢铁投资市场

废钢铁产业是我国再生资源产业的主体,其节能减排、低碳环保和不可替代的钢铁原料功效十分显著。阐述了我国废钢铁产业在经济转型中的主导地位、应用价值、投资环境及今后的发展战略。指出我国经济发展方式的转变,赋予了废钢铁产业良好的发展机遇和重大的历史使命,中国废钢产业具有良好的投资市场和巨大的发展空间。     

国内电炉钢发展现状与应用前景

通过电炉铜与转炉铜能耗对比,突显了电炉钢的节能与环保优势,同时介绍了国内外电炉钢应用现状。随着社会工业化的发展所带来的钢铁积蓄量的增加,以及电炉钢技术的不断完善和发展,加之迎合国家低碳经济政策的实施,国内电炉钢发展具有广阔前景。     

Trichoderma atroviride as a bioremediator of Cu pollution: An in vitro study

Isolated Trichoderma atroviride from Cu-polluted river sediment at the Serdang Industrial Area was studied under in vitro conditions to understand the mechanisms that allowed the fungi to thrive in the Cu-polluted freshwater ecosystem. From this study, adsorption was recognized as the main mechanism of Cu tolerance with 50–85% adsorption during the in vitro experiment. The uptake capacity of the isolate in liquid medium ranged from 0.8 to 11.2 mg g^?1 in the potato dextrose broth medium with increasing Cu concentrations from 25 to 300 mg L^?1. It was found that 2.7–5.0% of Cu was lost due to washing. The high percentage of Cu adsorption and the high uptake capacity of Cu by T. atroviride suggest that it is a potential bioremediator of Cu. However, further studies are needed to confirm its practical use as a bioremediating agent for Cu under field conditions.