低中放废物处置场核素经地下水迁移对环境影响预测

研究了我国某民用低中放固体废物处置场核素迁移的途径，对核素在地下水中的迁移进行了详细分析与计算，假定正常释放或一次降水量达到６００ｍｍ，处置场底浸泡一个月，存在６ｍ的包气带时，对该处置场处置的７种核素进行预测，结果表明，包气带是延迟核素迁移的主要屏障，在５００年内，可以使＾６０Ｃｏ＾１３７Ｃｓ＾９０Ｓｒ、＾６３Ｎｉ等核素延迟，其中＾２３９Ｐｕ降低６个月数量级，但不能延迟＾３Ｈ和＾１４Ｃ的迁移，穿过     

利用智利地震震源分布确定智利地区主震断层面

从历史地震来看,智利及其周边地区的历史强震主要集中在Nazca板块和南美洲板块之间的俯冲带上,该区也是7级以上大震频发的地区,所以对于该地区的断层结构和震源机制的研究就显得十分有必要.大地震发生后,大量余震在断层面上发生.因此余震震源位置的空间分布可以较为精确地勾画出断层面的位置.假定地震的发震断层可以用一个平面来模拟...     

Optimisation algorithms for spatially constrained forest planning

We compared genetic algorithms, simulated annealing and hill climbing algorithms on spatially constrained, integrated forest planning problems. There has been growing interest in algorithms that mimic natural processes, such as genetic algorithms and simulated annealing. These algorithms use random moves to generate new solutions, and employ a probabilistic acceptance/rejection criterion that allows inferior moves within the search space. Algorithms for a genetic algorithm, simulated annealing, and random hill climbing are formulated and tested on a same-sample forest-planning problem where the adjacency rule is strictly enforced. Each method was randomly started 20 times and allowed to run for 10,000 iterations. All three algorithms identified good solutions (within 3% of the highest found), however, simulated annealing consistently produced superior solutions. Simulated annealing and random hill climbing were approximately 10 times faster than the genetic algorithm because only one solution needs to be modified at each iteration. Performance of simulated annealing was essentially independent of the starting point, giving it an important advantage over random hill climbing. The genetic algorithm was not well suited to the strict adjacency problem because considerable computation time was necessary to repair the damage caused during crossover.     

Photolysis of a mixture of anthracene and benzo[a]pyrene at ultra-trace levels in natural water with disinfection purposes

The photodegradation of anthracene(AN) and benzo[a]pyrene(BaP),two priority polycyclic aromatic hydrocarbons(PAHs),was examined at ultra-trace levels in surface water to elucidate their behaviour under several irradiance values and types of radiation.The emitting flux and the spectrum of the lamps were found to develop a crucial role in AN and BaP degradation since removal efficiencies of the target contaminants higher than 99%were found after 15 min of irradiation under an ultraviolet C(UVC) irradiance of 0.63 mW/cm~2,corresponding to a fluence of 560.25 mJ/cm~2.On the other hand,although ultraviolet A(UVA) lamps exhibited a higher irradiance compared to that of UVC lamps,they were not efficient for degrading the target PAHs.The removal kinetic studies corroborated these findings,being the AN elimination rate in surface water higher than that in deionized water at optimal operating conditions.Disinfection potential was also measured.A rapid microbial load inactivation,in terms of total coliforms naturally contained in the water matrix studied,was evidenced within 15 min of treatment for the fluence referred.However,after 24 hr in the dark,a regrowth was observed.Additionally,photolysis products more toxic than the parent compounds were found,which were not removed even by extending the treatment time.In this regard,it can be concluded that the individual action of UVC light for removing AN and BaP with disinfection purposes is not an efficient treatment;therefore,the use of radiation in combination with other kinds of treatments is required.     

钢线拉丝及表面处理生产线成套装备

主要论述了一种钢线拉丝及表面处理生产线成套装备的设计。该生产线的生产方式是多根钢线在牵引动力系统的作用下依次穿过各种处理设备,完成各道工序,实现钢线完成表面处理的目的。这个生产过程中,钢线可以完成放线、脱脂、退火、镀镍、造膜、烘干及收线一体化的工序。采用立体式布置,空间利用更为合理。     

Hydroforming of locally heat treated tubes

In tube hydroforming, the process chain can be very long as it may involve several pre-forming operations (e.g. bending, crushing, end forming, etc.) which are usually followed by an intermediate annealing stage. Conventional annealing is performed in batches and it is often perceived as a long, relatively expensive and non-environmentally friendly operation. For this reason, in this paper local intermediate heat treatment is proposed as a promising alternative solution, in order to reduce the throughput process time. The study has been carried out on a real tubular motorcycle part, by performing both experiments and numerical simulations, in order to verify whether local annealing can be an effective substitute of conventional global annealing. Several alternative ways of locally heat treating an Al6060 tube right before hydroforming have been investigated. The results demonstrate that a feasible solution can be found, with local heat treatment of relatively small portions of the tube.     

长江中下游中酸性侵入岩中的黑云母及其地质意义

本区中酸性侵入岩中的黑云母属镁铁系列。有铁叶云母、铁黑云母、铁质黑云母及镁质黑云母四种类型。Ⅰ型长江系列为镁质黑云母;江南系列为铁质黑云母。A型苏州式为铁叶云母和铁黑云母;大龙山式则为镁黑云母—金云母。黑云母的成分与其生成条件有关,在榍石—磁铁矿—石英—角闪石矿物组合中,黑云母含铁度高者(ΣFe/ΣFe+Mg>0.5)其氧逸度随温度上升而增高,形成温度低则压力高,岩体侵位深。含铁度低者(ΣFe/ΣFe十Mg<0.5)氧逸度随温度上升而降低,形成温度高则压力低,岩体侵位浅。各类云母均有自己的成矿专属性。     

物化—生化法处理染料中间体生产废水

采用物化—生化法进行染料中间体生产废水的处理试验 ,物化法包括混凝、电解、Fenton氧化工艺过程。试验结果表明 :废水经物化及水解酸化工序后 ,可生化性显著提高 ,经好氧生化处理后的水质指标符合国家有关排放标准     

Intermediate storage of carbon dioxide in geological formations: A technical perspective

Enhanced oil recovery (EOR) through CO₂ flooding has been practiced on a commercial basis for the last 35 years and continues today at several sites, currently injecting in total over 30 million tons of CO₂ annually. This practice is currently exclusively for economic gain, but can potentially contribute to the reduction of emissions of greenhouse gases provided it is implemented on a large scale. Optimal operations in distributing CO₂ to CO₂-EOR or enhanced gas recovery (EGR) projects (referred to here collectively as CO₂-EHR) on a large scale and long time span imply that intermediate storage of CO₂ in geological formations may be a key component. Intermediate storage is defined as the storage of CO₂ in geological media for a limited time span such that the CO₂ can be sufficiently reproduced for later use in CO₂-EHR. This paper investigates the technical aspects, key individual parameters and possibilities of intermediate storage of CO₂ in geological formations aiming at large scale implementation of carbon dioxide capture and storage (CCS) for deep emission reduction. The main parameters are thus the depth of injection and density, CO₂ flow and transport processes, storage mechanisms, reservoir heterogeneity, the presence of impurities, the type of the reservoirs and the duration of intermediate storage. Structural traps with no flow of formation water combined with proper injection planning such as gas-phase injection favour intermediate storage in deep saline aquifers. In depleted oil and gas fields, high permeability, homogeneous reservoirs with structural traps (e.g. anticlinal structures) are good candidates for intermediate CO₂ storage. Intuitively, depleted natural gas reservoirs can be potential candidates for intermediate storage of carbon dioxide due to similarity in storage characteristics.     

Assessment of nitrogen leaching from arable land in large river basins: Part II: regionalisation using fuzzy rule based modelling

This study deals with fuzzy rule based modelling of nitrogen (N)-leaching from arable land. Main purpose is the elaboration of a method, which allows dynamical regionalisation of results from process-based models for large regions and can be efficiently included in metamodels or decision support systems for rapid integrated assessment of water resources. The paper is the second part of a two-part paper. In the first paper the distributed ecohydrological model SWIM had been applied to calculate and analyse nitrogen dynamics in arable soils for a set of representative natural and management conditions in the Saale River basin (Ecol. Model. (in press)). Here, in the second paper the results from those simulation experiments are used to define, train and validate fuzzy rule systems for the estimation of N-leaching. Nine fuzzy rule systems, specific for nine soil classes, were created from the simulation experiments, representing the conditions for the whole Saale River basin. The fuzzy rule systems operate on monthly time steps and consist of 15 rules and seven input variables each, which are compiled from time series of precipitation, percolation and evapotranspiration as well as from information about fertilizer and crop specific nitrogen uptake. Simulated annealing as a non-linear discrete optimisation method is used for automatic rule assessment. Validation of the fuzzy rule systems, carried out by split sampling of 30-year simulation period, shows satisfactory performance on an annual basis and good performance on the long-term basis with average correlation between SWIM-simulated and fuzzy rule-estimated N-leaching values of 0.78 and 0.94, respectively.