Influence of Na2S on the degradation kinetics of CCl4 in the presence of very pure iron

This paper presents the results of kinetic studies to investigate the effect of FeS film formation on the degradation rate of CCl(4) by 99.99% pure metallic iron. The film was formed by submersing metallic iron grains in an oxygen free HCO(3)(-)/CO(3)(2-) electrolyte solution. When the grains had reached a quasi steady-state value of the corrosion potential, Na(2)S((aq)) was injected. Upon injection, a microm thick poorly crystalline FeS film formed immediately on the iron surface. Over time, the iron became strongly corroded and both the FeS film and the metallic iron grains began to crack leading to exposure of bare metallic iron to the solution. The effect of the surface film on the degradation rate of CCl(4) was investigated following four periods of aging, 1, 10, 30, and 60 days. Relative to the controls, the 1-day sulfide-aged iron showed a substantial decrease in rate of degradation of CCl(4.) However, over time, the rate of degradation increased and surpassed the degradation rate obtained in the controls. It has been proposed that CCl(4) is reduced to HCCl(3) by metallic iron by electron transfer. The FeS film is substantially less conducting than the bulk iron metal or non-stoichiometric magnetite and from the results of this study, greatly decreases the rate of CCl(4) degradation relative to iron that has not been exposed to Na(2)S. However, continued aging of the FeS film results in breakdown and stress-induced cracking of the film, followed by dissolution and cracking of the iron itself. The cracking of the bulk iron is believed to be a consequence of hydrogen embrittlement, which is promoted by sulfide. The increase in CCl(4) degradation rate, as the FeS films age, suggests that the process of hydrogen cracking increases the surface area available for charge transfer.     

A comparison of the low frequency electrical signatures of iron oxide versus calcite precipitation in granular zero valent iron columns

Geophysical methods have been proposed as technologies for non-invasively monitoring geochemical alteration in permeable reactive barriers (PRBs). We conducted column experiments to investigate the effect of mineralogy on the electrical signatures resulting from iron corrosion and mineral precipitation in Fe0 columns using (a) Na2SO4, and (b) NaHCO3 plus CaCl2 mixture, solutions. At the influent interface where the reactions were most severe, a contrasting time-lapse electrical response was observed between the two columns. Solid phase analysis confirmed the formation of corrosion halos and increased mineralogical complexity in the corroded sections of the columns compared to the minimal/non-corroded sections. We attribute the contrasting time-lapse signatures to the differences in the electrical properties of the mineral phases formed within the two columns. While newly precipitated/transformed polarizable and semi-conductive iron oxides (mostly magnetite and green rust) increase the polarization and conductivity of the sulfate column, the decrease of both parameters in the bicarbonate column is attributed to the precipitation of non-polarizable and non-conductive calcite. Our results show that precipitate mineralogy is an important factor influencing the electrical properties of the corroded iron cores and must be considered if electrical geophysical methods are to be developed to monitor PRB barrier corrosion processes in situ.     

Reinventing the bicycle: how calculative practices shape urban environmental governance

The concept of sustainability transitions has become increasingly prominent in academic and policy discourses during recent decades, but the importance of the link between knowledge-producing epistemic practices and urban governance has been underappreciated in this discourse. Based on a case study of cycling in Copenhagen between 1900 and 2015, and drawing upon a governmentality-inspired analytical framework, this research demonstrates that transformative governance may be initiated by epistemic practices that render urban systems visible in other ways. Urban cycling has been reconstructed over time in Copenhagen as a traffic safety ‘problem’, a component of the experiential and liveable city, and a health-producing (and hence economically valuable) regional transport mode. The research findings emphasise that epistemic practices can provide a powerful stimulus for creating changes in urban governance. The results also provide support for initiatives to broaden the terms of academic debate on sustainability transitions.     

Photocatalytic mechanisms of indoleamine destruction by the quinalphos metabolite 2-hydroxyquinoxaline: a study on melatonin and its precursors serotonin and N-acetylserotonin

The redox-active quinalphos main metabolite, 2-hydroxyquinoxaline, is particularly effective under excitation by light. We have studied the photocatalytic destruction of melatonin and its precursors, because the cytoprotective indoleamine has been detected in high quantities in mammalian skin. In photooxidation reactions, in which melatonin, N-acetylserotonin and serotonin are destroyed by 2-hydroxyquinoxaline, the photocatalyst is virtually not consumed. Rates of melatonin and serotonin destruction are not changed by the singlet oxygen quencher 1,4-diazabicyclo-(2,2,2)-octane, indicating that this oxygen species is not involved in the primary reactions, so that the persistence of 2-hydroxyquinoxaline has to be explained by redox cycling. This should imply formation of an organic radical, presumably the quinoxaline-2-oxyl radical, from which 2-hydroxyquinoxaline is regenerated by electron abstraction from indolic radical scavengers. Electron donation by 2-hydroxyquinoxaline is demonstrated by reduction of the 2,2′-azino-bis-(3-ethylbenzthiazolinyl-6-sulfonic acid) cation radical under ultrasound excitation. The compound 2-hydroxyquinoxaline interacts with the specific superoxide anion scavenger Tiron. Formation of oligomeric products from melatonin and serotonin is strongly inhibited by sodium dithionite. Products from photocatalytic indolamine conversion are predominantly dimers and oligomers. No kynuramines were detected in the case of serotonin oxidation, and melatonin's otherwise prevailing oxidation product N ¹-acetyl-N ²-formyl-5-methoxykynuramine, another cytoprotective metabolite, is only formed in relatively small quantities. The proportion between products from melatonin is changed by 1,4-diazabicyclo-(2,2,2)-octane: singlet oxygen, also formed under the influence of excited 2-hydroxyquinoxaline, only affects secondary reactions.     

Treatment of coking wastewater by an advanced Fenton oxidation process using iron powder and hydrogen peroxide

In this study the treatment of coking wastewater was investigated by an advanced Fenton oxidation process using iron powder and hydrogen peroxide. Particular attention was paid to the effect of initial pH, dosage of H₂O₂ and to improvement in biodegradation. The results showed that higher COD and total phenol removal rates were achieved with a decrease in initial pH and an increase in H₂O₂ dosage. At an initial pH of less than 6.5 and H₂O₂ concentration of 0.3 M, COD removal reached 44-50% and approximately 95% of total phenol removal was achieved at a reaction time of 1 h. The oxygen uptake rate of the effluent measured at a reaction time of 1 h increased by approximately 65% compared to that of the raw coking wastewater. This indicated that biodegradation of the coking wastewater was significantly improved. Several organic compounds, including bifuran, quinoline, resorcinol and benzofuranol were removed completely as determined by GC-MS analysis. The advanced Fenton oxidation process is an effective pretreatment method for the removal of organic pollutants from coking wastewater. This process increases biodegradation, and may be combined with a classical biological process to achieve effluent of high quality.     

Formation of PCDD/Fs from oxidation of 2-monochlorophenol over an Fe2O3/silica surface

The role of iron in surface-mediated formation of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) from 2-chlorophenol (2-MCP) was investigated over the temperature range of 200-550 °C under oxidative conditions. In order to compare and contrast with previous work on copper and ferric oxide-mediated pyrolysis of 2-MCP, identical reaction conditions were maintained (50 ppm 2-MCP, model fly-ash particles containing 5% Fe₂O₃ on silica). Observed products included dibenzo-p-dioxin (DD), 1-monochlorodibenzo-p-dioxin (1-MCDD), dibenzofuran (DF), 4,6-dichlorodibenzofuran (4,6-DCDF), 2,4- and 2,6-dichlorophenol, 2,4,6-trichlorophenol, quinone, catechol, chloro-o-quinone, chlorocatechol and polychlorinated benzenes. Yields of DD and 1-MCDD were 2 and 5 times higher than under pyolysis conditions, respectively. Although 4,6-DCDF was the major PCDD/F product formed with a yield that was 2.5× greater than under pyrolysis, the yield of non-chlorinated DF, which was the dominant PCDD/F product under pyrolysis, decreased by a factor of 3. Furthermore, the ∼2× higher yield of PCDDs under oxidative conditions resulted in a PCDD to PCDF ratio of 0.75 compared to a relatively low ratio of 0.39 previously observed under pyrolytic conditions.     

Extraction of raw sewage sludge containing iron phosphate for phosphorus recovery

The objective of the present study was to establish an alkali extraction technology for FePO₄-containing sewage sludge obtained from a wastewater treatment system that includes phosphorous removal by iron electrolysis. By clarifying the extraction properties of phosphorous, organic matter, and inorganic matter, conditions for alkali extraction were optimized. As a result, it was suggested that unheated phosphorous extraction would be superior for FePO₄-containing sewage sludge. And, extraction methods and sewage sludge properties were also compared, and the noteworthy result that extraction of metals can be suppressed to extremely low amounts with alkali extraction as compared with acid extraction was obtained. A new insight was also gained that, as compared with the use of incinerated ash reported in previous studies, alkali extraction was more efficient when raw sewage sludge was used.     

Accumulation and biological cycling of heavy metal in four salt marsh species, from Tagus estuary (Portugal)

Pools of Zn, Cu, Cd and Co in leaf, stem and root tissues of Sarcocornia fruticosa, Sarcocornia perennis, Halimione portulacoides and Spartina maritima were analyzed on a bimonthly basis, in a Tagus estuary salt marsh. All the major concentrations were found in the root tissues, being the concentrations in the aboveground organs neglectable for sediment budget proposes, as seen by the low root-aboveground translocation. Metal annual accumulation, root turnovers and cycling coefficients were also assessed. S. maritima showed the higher root turnovers and cycling coefficients for most of the analyzed metals, making this a phytostabilizer specie. By contrast the low root turnover, cycling coefficient and low root necromass generation makes S. perennis the most suitable specie for phytoremediation processes. Although the high amounts of metal return to the sediments, due to root senescence, salt marshes can still be considered sinks of heavy metals, cycling heavy metals mostly between sediment and root.     

Salmonella Enterica Serovar Typhimurium HilA-LacZY Fusion Gene Response to Iron Chelation or Supplementation in Rich and Minimal Media

Abstract

Virulence expression of Salmonella enterica serovar Typhimurium under iron limited condition was measured by β-galactosidase (β-gal) assay using a hilA-lacZY fusion strain and calculated as Miller units. hilA-lacZY β-galactosidase assays were performed in brain heart infusion (BHI) and minimal media (M9), after iron chelation with 2, 2-dipridyl and iron-supplementation respectively. Before performing virulence assays, concentrations of iron in the media were estimated using ferrozine. Iron content was found to be more in BHI (42.6 µg dL^?1) as compared to M9 (10.03 µg dL^?1). β-gal activity of Salmonella Typhimurium in BHI was generally less than that observed in M9. After exposure to various combinations of iron chelator in BHI, hilA-lacZY activity only increased at the highest concentration of chelator (200 µM) but decreased in M9 media for all iron concentrations when compared to controls with no iron amendment. These results indicate that iron availability may influence S. Typhimurium hilA expression.     

Determination of o-phthalic acid in snow and its photochemical degradation by capillary gas chromatography coupled with flame ionization and mass spectrometric detection

Phthalic acid and its photochemical degradation has been determined in snow and rainwater samples collected during winters (2003-2010) in the Southeast of Massachusetts using capillary gas chromatography (GC) with flame ionization and mass spectrometric detection. Water samples were dried using a rotary evaporator and derivatized with a 14% BF₃/methanol reagent before GC analysis. The developed method proved simple and accurate. Phthalic acid was found in snow samples collected in a concentration range of 7.22-76.5 nM. The photodegradation of phthalate was carried out under 300 nm UV light. The direct photodecomposition of the acid is slow (5% h⁻¹). However, the addition of dissolved Fe(III) species at 2.0 μM accelerated the light-induced degradation of phthalic acid by 3.5 times in the atmospheric water samples. Photodegradation rates of phthalic acid increases with decreasing pH value of water samples in the range of pH 2.8-4.5.