基于多孔环形喷嘴的可燃爆粉尘分散特征的密度效应研究*

为了研究不同密度的可燃爆粉尘在内置多孔环形喷嘴的20 L爆炸特性测试装置中的分散特征,基于负载粒子流方法、耦合DPM动量平衡方程和时间平均 Navier Stokes控制方程组,实现3种不同密度的煤粉、铝粉和锆粉在20 L爆炸测试装置中粉尘分散全过程的数值模拟。研究结果表明:多孔环形喷嘴的分散较为均匀,但是约束管道末端存在局部粉尘残留区,致使爆炸仓内真实粉尘浓度远低于形式浓度;爆炸仓中心位置的最大湍动能随着粉尘密度的增加而减小,只有显著地变化粉尘密度才能展示区分度较高的浓度峰值和抵达浓度峰值的时间。     

Comprehensive temperature monitoring in an in-vessel forced-aeration static-bed composting process

Comprehensive temperature monitoring was done in an in-vessel forced-aeration static-bed composting process using sewage sludge. The three layers that divided the compost pile horizontally showed different temperature distributions. The temperature of the top layer appeared not to be influenced by the ambient temperature. The temperature of the center area of the top layer was taken to be the representative temperature for evaluating composting start-up performance. The temperature of the bottom layer was strongly influenced by the ambient temperature, and the temperature of the center area of the bottom layer was taken to be the representative temperature for pathogen control as it was the minimum temperature in the reactor. Composting start-up performance was influenced by several factors when the ambient temperature was either below or above 20°C. When the ambient temperature was below 20°C, the time taken to reach 65°C (T ₆₅) was influenced by the temperature of inflowing air, but when the temperature was higher than 20°C, it was influenced by the ratio of sewage sludge to seed compost (F/S). T ₆₅ was least when F/S was 1–2. Received: January 9, 2001 / Accepted: October 10, 2001     

Improvement of the antifouling characteristics in a bioreactor of polypropylene microporous membrane by the adsorption of Tween 20

Surface modification by physical adsorption of Tween 20 was accomplished on polypropylene microporous membranes (PPMMs). Attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR) and scanning electron microscope (SEM) were used to characterize the chemical and morphological changes on the membrane surfaces. Water contact angles and relative pure water fluxes were measured. The data showed that the hydrophilic performance for the modified membranes increased with the increase in the adsorption amount of Tween 20 onto the surface or into the pores of polypropylene microporous membranes. To test the antifouling property of the membranes by the adsorption of Tween 20 in a membrane bioreactor (MBR), filtration for active sludge was performed using synthetic wastewater. With the help of the data of water fluxes and the FE-SEM photos of the modified PPMMs before or after operating in a MBR for about 12 d, the PPMMs with monolayer adsorption of Tween 20 showed higher remained flux and stronger antifouling ability than unmodified membrane and other modification membranes studied.     

Competition of Hydrogen and Manganese Ions for Adsorption Sites in Sitka Spruce Litter

The competition of hydrogen and manganese ions for adsorption sites in Sitka spruce litter was investigated in a factorial design, simulated acid rain experiment, which involved leaching of litter with simulated throughfall solutions at three pH levels (5.3, 4.3 and 3.3) and three manganese concentrations (0 to 0.2 mg1^-1). the throughfall solution at the lowest pH was the most efficient in removing exchangeable manganese from litter. the manganese concentration in the leachates was approximately proportional to the hydrogen ion concentration in the simulated throughfall solution. Under field conditions, throughfall manganese concentration also naturally tends to increase as a consequence of enhanced foliar leaching of manganese in response to increasing precipitation acidity. the manganese concentration in the simulated throughfall also affected manganese concentration in the leachates, however, and contributed to a buildup of exchangeable manganese in litter, thus counteracting to some extent possible adverse effects of excess leaching due to increased throughfall acidity.     

Physical state and biodegradation behavior of starch-polycaprolactone systems

The biodegradation behavior of insoluble crystalline polymers depends on both chemical structure and physical state. The physical state is strongly affected by the molding conditions; moreover the presence of natural hydrophylic substances such as starch can further influence the biodegradation process. This paper examines the biotic and abiotic degradation of thick injection-molded parts, made of pure poly--caprolactone (PCL) at different molecular weights, and of PCL in the presence of starch in the case of a commercial grade of Mater-Bi, produced by Novamont. The abiotic degradation was studied at 25 and 50°C, whereas the biotic degradation was followed in conditions of SCAS (semicontinuous activated sludges) at 25 and 50°C, soil burial, and controlled composting. The physical-chemical modifications provoked at the surface and in the bulk of the samples by the different types of degradation were determined by differential scanning calorimetry, viscometric and gravimetric analysis, scanning electron microscopy, and dynamic mechanical analysis. The mechanical modifications induced by the different environments were followed by tensile tests. It was demonstrated that the presence of starch significantly increases the apparent biodegradation rate of PCL, making even thick parts of ZI01U compatible with the composting process.Paper presented at the Bio/Environmentally Degradable Polymer Society—Third National Meeting, June 6–8, 1994, Boston, Massachusetts.     

Prenatal diagnosis of trisomy for the distal two-thirds of the long arm of chromosome 14 (q21→qter)

A de novo case of ‘pure’ trisomy 14q21 → qter is described which was detected at amniocentesis following an abnormal ultrasound scan of a 25–year-old woman. This is apparently the largest distal 14q duplication reported in a case surviving beyond the first trimester. The infant apipeared to have an association of clinical abnormalities previously observed in distal 14q trisomy and proximal 14q trisomy/mosaic trisomy 14.     

Mosaicism of isochromosome 18p.

The first case of isochromosome 18p as a mosaic in a male fetus diagnosed by amniocentesis is reported. After termination of the pregnancy at 21 weeks gestation biopsies from different fetal organs as well as from the placenta were taken and set up for long term cell cultures. The distribution of the normal and abnormal cell-line in fetal organs was unequal. Unexpectedly the metaphases in the placenta and the lymphocyte culture all showed a normal karyotype. The tetrasomy 18p is associated with a uniform phenotype, even in fetal life, characterized by a small head with protuberant occiput, low-set ears with posterior rotation, epicanthic fold, sharp pinched nose, convex and poorly formed philtrum, high-arched palate, retrognathia, flexion contractures of fingers, short and broad hallux, hypoplastic penis, angulation of clavicles and mild scoliosis. The propositus showed no growth retardation.     

BT20钛合金筒形件的UOE热成形

阐述了用UOE热成形BT20钛合金筒形件的特点。通过对BT20筒形件UOE热成形的实验研究,确定了BT20钛合金筒形件UOE热成形工艺过程,得到了一系列成形工艺参数及在成形过程中控制产品质量的措施。     

Prenatal diagnosis of Pallister–Killian syndrome: Resolution of cytogenetic ambiguity by use of fluorescent in situ hybridization

We report a case of Pallister-Killian syndrome initially diagnosed prenatally as tetrasomy 21. A 33-year-old primiparous woman was noted at 24 weeks' gestation to have moderate polyhydramnios. Ultrasonography showed diminished fetal stomach filling, hydronephrosis, and prominence of the cisterna magna. Cytogenetic analysis of cultured amniocytes was initially interpreted as mosaic tetrasomy 21: 46,XX/47,XX,+i(21q). The patient was then referred to our centre for genetic counselling. At 34 weeks' gestation, a dysmorphic infant was delivered and died within 30 min. Physical features were consistent with the Pallister-Killian syndrome. Renal, gastrointestinal, and central nervous system anomalies were found at post-mortem examination. Analysis of peripheral lymphocytes revealed 5 per cent of cells with a marker chromosome, while 92 per cent of cultured fibroblasts had this same marker. Fluorescent in situ hybridization (FISH) using an alpha-satellite probe for chromosomes 13 and 21 failed to hybridize to the marker, while a chromosome 12 centromeric probe unequivocally identified it as an i(12p). Use of FISH can provide rapid, specific prenatal diagnosis of ambiguous marker chromosomes and improve prenatal counselling.     

A revisit of trisomy 20 mosaicism in prenatal diagnosis—an overview of 103 cases

One hundred and three cases with prenatal diagnosis of trisomy 20 mosaicism through amniocentesis were reviewed. Approximately 90 per cent (90/101) of the cases were associated with grossly normal phenotype. It is likely that, in the majority of cases, cells with trisomy 20 were extraembryonic in origin or largely confined to the placenta. However, in some cases, the cells with trisomy 20 were confined to certain specific fetal organs or tissues such as kidney, skin, etc. Cytogenetic follow-up studies in liveborns should include a culture from urine sediment.