3种染料化合物在UV-TiO2/H2O2和UV-TiO2体系中的光催化降解研究

采用自制的TiO2膜和平板式固定床型光催化氧化反应装置,对甲基橙、茜素红和罗丹明B 3种含有不同生色基团的染料化合物进行了TiO2光催化氧化降解研究,通过对照测定降解过程中吸光度、电导率、pH的变化,分析了在加入和不加入H2O22种情况下降解过程的异同,比较了3种染料化合物脱色的难易程度,揭示了降解产物中无机离子的变化规律及某些可能的产物类型.     

Winsor I微乳液+臭氧氧化联合处理油基岩屑的研究

采用“含有配制油基钻井液用主乳和油相的Winsor I微乳液+臭氧氧化”联合工艺对油基岩屑进行处理,Winsor I微乳液处理油基岩屑后的所得基础油和部分主乳进入平衡油相,可以用来配制油基钻井液,臭氧氧化对岩屑进行深度处理,进一步降低岩屑表面含油量。论文以处理后岩屑含油量为指标,系统优化了微乳液组成、微乳液清洗油基岩屑工艺和臭氧氧化工艺。实验结果建议微乳液组成为“脂肪醇聚氧乙烯醚硫酸钠+配制油基钻井液用主乳(2:1)”混合乳化剂浓度为6wt%,正戊醇浓度5 wt%,柴油浓度36 wt%,其他为盐水。推荐微乳液清洗条件为固液比1:5,室温下搅拌清洗60 min。此条件下岩屑含油量可以降低至1.41 wt%,微乳液重复使用4次后,岩屑含油量仍可以保持在2.0 wt%以下。臭氧氧化深度处理时,建议工艺条件为臭氧氧化时间40 min,清水pH=7,固液比1:5,臭氧流量5 mg/min,处理后岩屑含油量可降低至0.36wt%。     

Fenton氧化与生化组合技术处理油田采油废水的研究

采用Fenton氧化与生化组合技术处理生物难降解的采油废水的研究结果表明 ,Fenton氧化技术不但对采油废水中有机质有较好的去除率 ,而且大大地改善了废水的可生化性 ,在H2 O2 的投加浓度和Fe2 + 与H2 O2 的摩尔比分别为10mmol/L和 0 .1的条件下 ,经过 30min氧化后可使废水BOD值由原来的 5mg/L上升至 4 0mg/L ;同时随着氧化时间的延长 ,废水中残余的有机物分子量逐渐降低。 30min氧化后的废水经过生物处理 ,其出水COD值为 10 2mg/L ,可以满足国家综合污水外排标准 ,经济分析结果表明 ,该技术处理采油废水的运行成本为 1 4 7元 /t。这一技术在解决石油行业采油废水的外排达标方面具有很好的应用前景。     

H2O2处理酸性大红GR染料废水的研究

通过对废水pH值、H2O2用量、催化剂用量、反应时间、反应温度等工艺条件的考察,确定了H2O2催化氧化处理酸性大红染料废水的最佳工艺条件pH 4、H2O2用量6 mL/L、催化剂用量3 g/L、反应时间100 min、反应温度70℃.在该条件下,COD和色度的去除率分别为76.7%和99.4%;通过反应前后的紫外-可见光光谱分析表明,H2O2催化氧化处理酸性大红GR染料废水有比较好的效果,为该工艺处理酸性大红GR染料废水提供了科学依据.     

微电解—芬顿氧化工艺预处理高浓度松香改性酚醛树脂生产废水

为了降低松香改性酚醛树脂生产废水的COD并改善其可生化性,采用微电解—芬顿氧化工艺对该废水进行预处理。研究了pH、微电解反应时间、曝气、双氧水投加量等对微电解和芬顿氧化处理效果的影响,考察了COD去除率和BOD₅/COD值的变化趋势。实验结果表明：曝气条件下,调节废水pH为4、进行2次微电解、微电解反应时间各2.0 h时,废水的COD去除率为38%,BOD₅/COD值提高为0.18;再投加7.5%（w）的双氧水,废水的COD去除率为65.3%,BOD₅/COD值为0.37。采用微电解—芬顿氧化的预处理工艺,不仅有效去除了废水的COD,而且显著改善了废水的可生化性。     

单级SBR生物膜中全程自养脱氮的研究

研究了具有全程自养脱氮作用的生物膜中无机碳源浓度、pH值、溶解氧(DO)对全程自养脱氮的影响.结果表明,当NaHCO3浓度从1.75g/L上升到2.50g/L时,反应体系中的pH值从7.6～8.0上升到8.8左右,氨氮转化率和总无机氮去除率分别急剧下降到53%和48.8%.在进水氨氮负荷为60g/(m³·d)时,最佳DO应控制在0.5～0.7mg/L,此时氨氮转化率达到90%以上.     

我国长江中下游平原典型稻田含碳温室气体通量变化特性

近年来关于碳排放研究的内容越来越受到重视,我国提出了在2030年实现碳达峰的战略目标,因此对我国温室气体排放监测的研究显得非常重要.基于涡度相关法对我国长江中下游区域典型稻田生长季的CO2和CH4通量进行监测分析,结果发现整个观测阶段稻田CO2通量呈"U"型曲线,整体表现为汇,分蘖期开始出现负值,抽穗期降到最低,通量平...     

Fe3O4@SA/Ce微球的表征及对染料的吸附特性

以天然高分子化合物海藻酸钠(sodium alginate,SA)为骨架,结合磁性Fe₃O₄和稀土铈离子Ce(Ⅲ)通过溶液反应制备出一种新型的磁性海藻酸铈复合微球(Fe₃O₄@SA;Ce).采用X射线衍射(XRD)、孔结构比表面积分析(BET)、扫描电子显微镜(SEM)、红外光谱(FT-IR)及振动样品强磁计(VSM)对Fe₃O₄@SA;Ce的结构进行了表征,并以直接桃红12B(direct red 12B,DR 12B)和直接橙S(direct orange S,DO S)两种染料为吸附对象,探讨了Fe₃O₄@SA;Ce的吸附剂性能、吸附动力学和热力学.结果表明,Fe₃O₄@SA;Ce对室温下自然pH染料溶液中DR 12B和DO S均表现出良好的吸附效果,吸附量分别可达464 mg·g^-1和730 mg·g^-1.在不同温度下(298、313、328 K),Fe₃O₄@SA;Ce对DR 12B和DO S的吸附过程均可用拟二级吸附动力学方程准确描述.通过等温吸附研究,发现Fe₃O₄@SA;Ce对两种染料的等温吸附较好地符合Freundlich模型.各种表征结果表明,SA与Ce(Ⅲ)和Fe₃O₄交联反应后生成的Fe₃O₄@SA;Ce凝胶球表面有大量深浅不一的褶皱沟纹,形貌发生了显著变化.作为一种绿色环保、制备方法简单、可高效吸附的磁性高分子复合吸附剂,Fe₃O₄@SA;Ce对高浓度染料具有很好的吸附效果,期望能够在染料废水处理中得到广泛应用.     

The performance of nitrate-reducing Fe(II) oxidation processes under variable initial Fe/N ratios: The fate of nitrogen and iron species

•Bacterially-mediated coupled N and Fe processes examined in incubation experiments. •NO₃⁻ reduction was considerably inhibited as initial Fe/N ratio increased. •The maximum production of N₂ occurred at an initial Fe/N molar ratio of 6. •Fe minerals produced at Fe/N ratios of 1–2 were mainly easily reducible oxides. The Fe/N ratio is an important control on nitrate-reducing Fe(II) oxidation processes that occur both in the aquatic environment and in wastewater treatment systems. The response of nitrate reduction, Fe oxidation, and mineral production to different initial Fe/N molar ratios in the presence of Paracoccus denitrificans was investigated in 132 h incubation experiments. A decrease in the nitrate reduction rate at 12 h occurred as the Fe/N ratio increased. Accumulated nitrite concentration at Fe/N ratios of 2–10 peaked at 12–84 h, and then decreased continuously to less than 0.1 mmol/L at the end of incubation. N₂O emission was promoted by high Fe/N ratios. Maximum production of N₂ occurred at a Fe/N ratio of 6, in parallel with the highest mole proportion of N₂ resulting from the reduction of nitrate (81.2%). XRD analysis and sequential extraction demonstrated that the main Fe minerals obtained from Fe(II) oxidation were easily reducible oxides such as ferrihydrite (at Fe/N ratios of 1–2), and easily reducible oxides and reducible oxides (at Fe/N ratios of 3–10). The results suggest that Fe/N ratio potentially plays a critical role in regulating N₂, N₂O emissions and Fe mineral formation in nitrate-reducing Fe(II) oxidation processes.     

Remediation of 2,4-dichlorophenol-contaminated groundwater using nano-sized CaO2 in a two-dimensional scale tank

• Nano CaO₂ is evaluated as a remediation agent for 2,4-DCP contaminated groundwater. • 2,4-DCP degradation mechanism by different Fe²⁺ concentration was proposed. • 2,4-DCP was not degraded in the system for solution pH>10. • The 2,4-DCP degradation area is inconsistent with the nano CaO₂ distribution area. This study evaluates the applicability of nano-sized calcium peroxide (CaO₂) as a source of H₂O₂ to remediate 2,4-dichlorophenol (2,4-DCP) contaminated groundwater via the advanced oxidation process (AOP). First, the effect and mechanism of 2,4-DCP degradation by CaO₂ at different Fe concentrations were studied (Fenton reaction). We found that at high Fe concentrations, 2,4-DCP almost completely degrades via primarily the oxidation of •OH within 5 h. At low Fe concentrations, the degradation rate of 2,4-DCP decreased rapidly. The main mechanism was the combined action of •OH and O₂^•−. Without Fe, the 2,4-DCP degradation reached 13.6% in 213 h, primarily via the heterogeneous reaction on the surface of CaO₂. Besides, 2,4-DCP degradation was significantly affected by solution pH. When the solution pH was>10, the degradation was almost completely inhibited. Thus, we adopted a two-dimensional water tank experiment to study the remediation efficiency CaO₂ on the water sample. We noticed that the degradation took place mainly in regions of pH<10 (i.e., CaO₂ distribution area), both upstream and downstream of the tank. After 28 days of treatment, the average 2,4-DCP degradation level was ≈36.5%. Given the inadequacy of the results, we recommend that groundwater remediation using nano CaO₂: (1) a buffer solution should be added to retard the rapid increase in pH, and (2) the nano CaO₂ should be injected copiously in batches to reduce CaO₂ deposition.