生化-调碱后垃圾渗滤液的Fenton深度处理效果

针对上海老港垃圾填埋场经过厌氧-曝气塘处理后的渗滤液难进一步处理的问题,对其采用厌氧滤池-好氧接触法、氧化钙2种方式预处理,在此预处理基础上,考察了Fenton法深度处理的效果,探讨了H2O2/Fe2+投加比、初始pH、H2O2投加量、反应时间和Fenton试剂投加方式对渗滤液COD去除效果的影响。研究发现:经过生物预处理后,渗滤液的COD和TP分别降低了24%和25%;氧化钙调碱可以进一步使COD和TP去除率分别达到42%和96%;后续Fenton深度氧化的最佳条件为:初始pH为2,H2O2投加量为2.4 g/L,H2O2/Fe2+摩尔比为5∶1,Fenton试剂一次投加,反应时间为2 h。在此条件下,渗滤液的COD从1 340 mg/L降到198 mg/L,总COD去除率达到85%。     

垃圾填埋场底土层污染状况调查

通过钻探取样对一个垃圾场底部支的污染状况进行了现场调查。结果表明,垃圾场下方浅层土壤已受到一定程度的污染,Ｐｂ、Ｃｄ、Ｈｇ、Ｃｒ等重元素污染较轻,ＮＨ３Ｎ、ＴＯＣ值较高。由于该场地下方粘土层的渗透系数很小,污染物的迁移距离在３０ｃｍ～４０ｃｍ左右,能较有效地防止垃圾中污染物的快速下渗适移。     

垃圾焚烧发电厂渗滤液MBR-NF截留液中腐植酸的超滤分离回收

垃圾焚烧发电厂渗滤液MBR-NF膜截留液因含有高浓度的难降解有机物和无机盐而难以处理。考虑其所含有机物大部分为腐植酸,可加于资源利用。本研究采用超滤对MBR—NF膜截留液中的腐植酸进行分离回收。实验结果表明,超滤能有效分离截留液中有机物和无机盐离子,分离因子与体积浓缩倍数（CF）呈良好的线性关系;回收样品的腐植酸含量达到36g／L以上,重金属含量低于相关标准限值,表明采用超滤分离回收垃圾焚烧发电厂渗滤液MBR-NF截留液中的腐植酸是可行的。     

城市生活垃圾填埋场渗滤液生化处理过程中重金属离子问题

我国对城市生活填埋场渗滤液处理技术的研究主要集中在COD与NH4^＋-N的去除上。对渗滤液中重金属离子的专项研究几乎未见报道。本文首先总结了国内外城市生活垃圾渗滤液中重金属的种类及浓度，在渗滤液中的存在状态。渗滤液中重金属与其他成分（有机物、氨氮）的相互作用关系，辨证分析了重金属在渗滤液生化处理过程中的有益作用和毒性，归纳了重金属在渗滤液生化处理过程中的变化规律。同时总结分析了重金属的去除技术。     

垃圾渗滤液膜滤浓缩液的电化学氧化处理研究

垃圾渗滤液的膜滤浓缩液盐度高,腐殖质含量大,制约着其进一步的处理处置。借助于电化学在高盐度废水中的氧化能力,对膜滤浓缩液的电解条件和电解机制进行研究,发现在电压10V、pH=6、极板间距2cm的最佳电解条件下,COD、TN、TP质量浓度可分别从4 160、280.2、8.1mg/L下降到1 279、84.6、1.9mg/L,去除率分别为69.3%、69.8%、76.5%。此时膜滤浓缩液中的大分子物质被降解为小分子物质,而类胡敏酸物质分解为低腐殖化、低缩合度有机物,出水BOD5/COD从0.054升高到0.106,提高了96.3%,为后续处理奠定了基础。     

UASB启动及不同浓度垃圾渗滤液的处理效果

在UASB反应器中接种好氧污泥培养厌氧颗粒污泥进行启动,研究不同浓度老龄(13年)垃圾渗滤液对处理效果的影响情况。通过保持进水COD浓度不变、逐步缩短HRT从而提高容积负荷到20 g COD/(L.d)的方法,可以培育出直径为1～3 mm颗粒污泥,最终产气量稳定在60～70 L/d,甲烷含量在50%～70%之间,COD去除率保持在90%左右,污泥层最底部MLSS为50 g/L。逐步提高进水中渗滤液的含量考察其对处理效果的影响,当进水为100%渗滤液时日产气量为500 mL/d、COD去除率仅为10%,表明渗滤液中多为难降解性有机物质。     

厌氧陈腐垃圾模拟柱对渗滤液COD和NH_3-N的处理特性

通过实地钻取阿苏卫填埋场陈腐垃圾,真实模拟填埋场压实工艺,制作2种不同压实密度的陈腐垃圾模拟柱,对比研究其对渗滤液COD、NH3-N处理效果。结果表明,当模拟柱压实密度为1.09 t/m3时,渗滤液垂直运动明显;回灌此模拟柱水力负荷分别为18.6、28、37.2和46.5 L/t时,COD去除效果稳定,平均去除率达82.4%,最高去除率可达90.1%;出水NH3-N浓度均值为549.3 mg/L,且介于415～700 mg/L间变化。自循环回灌COD去除率最高仅为11.5%,NH3-N去除率最高仅为11.8%,两者去除效果不明显。因此,北方平原型填埋场进一步完善填埋工艺,使填埋场垂直方向渗透系数分布均匀,充分利用陈腐垃圾堆体的自降解能力,才是处理渗滤液污染的关键。     

Natural attenuation of xenobiotic organic compounds in a landfill leachate plume (Vejen,Denmark)

Demonstration of natural attenuation of xenobiotic organic compounds (XOCs) in landfill leachate plumes is a difficult task and still an emerging discipline within groundwater remediation. One of the early studies was made at the Vejen Landfill in Denmark in the late 1980s, which suggested that natural attenuation of XOCs took place under strongly anaerobic conditions within the first 150 m of the leachate plume. This paper reports on a revisit to the same plume 10 years later. Within the strongly anaerobic part of the plume, 49 groundwater samples were characterized with respect to redox-sensitive species and XOCs. The analytical procedures have been developed further and more compounds and lower detection limits were observed this time. In addition, the samples were screened for degradation intermediates and for toxicity. The plume showed fairly stationary features over the 10-year period except that the XOC level as well as the level of chloride and nonvolatile organic carbon (NVOC) in the plume had decreased somewhat. Most of the compounds studied were subject to degradation in addition to dilution. Exceptions were benzene, the herbicide Mecoprop (MCPP), and NVOC. In the early study, NVOC seemed to degrade in the first part of the plume, but this was no longer the case. Benzyl succinic acid (BSA) was for the first time identified in a leachate plume as a direct indicator, and as the only intermediate of toluene degradation. Toxicity measurements on solid phase-extracted (SPE) samples revealed that toxic compounds not analytically identified were still present in the plume, suggesting that toxicity measurements could be helpful in assessing natural attenuation in leachate plumes.     

Effect of loading rate on shear strength parameters of mechanically and biologically treated waste

● Mechanical behavior of MBT waste affected by loading rate was investigated. ● Shear strength ratio of MBT waste increases with an increase in loading rate. ● Cohesion is inversely related to loading rate. ● Internal friction angles are positively related to loading rate. ● MBT waste from China shows smaller range of φ. Mechanical biological treatment (MBT) technology has attracted increasing attention because it can reduce the volume of waste produced. To deal with the current trend of increasing waste, MBT practices are being adopted to address waste generated in developing urban societies. In this study, a total of 20 specimens of consolidated undrained triaxial tests were conducted on waste obtained from the Hangzhou Tianziling landfill, China, to evaluate the effect of loading rate on the shear strength parameters of MBT waste. The MBT waste samples exhibited an evident strain-hardening behavior, and no peak was observed even when the axial strain exceeded 25%. Further, the shear strength increased with an increase in the loading rate; the effect of loading rate on shear strength under a low confining pressure was greater than that under a high confining pressure. Furthermore, the shear strength parameters of MBT waste were related to the loading rate. The relationship between the cohesion, internal friction angle, and logarithm of the loading rate could be fitted to a linear relationship, which was established in this study. Finally, the ranges of shear strength parameters cohesion c and effective cohesion c ´ were determined as 1.0–8.2 kPa and 2.1–14.9 kPa, respectively; the ranges of the internal friction angle φ and effective internal friction angle φ ´ were determined as 16.2°–29° and 19.8°–43.9°, respectively. These results could be used as a valuable reference for conducting stability analyses of MBT landfills.     

垃圾渗滤液厌氧处理过程颗粒污泥生长特性

以上流式厌氧反应器为例,研究了渗滤液厌氧处理过程中颗粒污泥的生长特性。结果表明,反应器运行阶段,颗粒污泥粒径由0.96 mm增长至1.06 mm,MLVSS/MLSS大于0.76,污泥能够保持较高的活性。高污泥负荷有利于0.90 mm颗粒污泥生长,0.60~0.90 mm污泥颗粒生长过程中结构不稳定,易发生解体。厌氧颗粒污泥生长过程中,粒径较大的颗粒污泥的孔隙结构较为疏松,它对污泥的活性产生影响。随着孔隙率增大,污泥沉降速度由0.88 cm/s升至0.97cm/s。颗粒污泥表层与内部微生物分布不同,表层微生物以球菌为主,各微生物种群间紧密联系,颗粒污泥内部以短杆菌为主。