大直径TA2卷焊坯制备工艺

此文介绍尺寸为φ1547×L900×δ30的大直径TA2卷焊坯的制备工艺。主要包括卷焊坯设计、展开下料的计算、卷圆工艺、焊接工艺等,可供同类材质圆筒件卷圆时参考。     

高径比对猪场废水脱氮与沼气脱硫耦联反应器的影响

采用填料鼓泡塔反应器研究其高径比对猪场废水脱氮与沼气脱硫耦联过程的影响,比较了3种不同高径比(8∶1、3∶1、2∶1)反应器的废水脱氮与沼气脱硫效能.在温度30～32℃、空塔停留时间6.70 min、水力停留时间3.35 d、沼气中H2 S浓度1 414～1 838 mg.m-3、进水NO x--N浓度114～243 mg.L-1的条件下,高径比2∶1反应器的运行较稳定,且处理效果较好,硫化氢去除率平均值为96.7%,NO x--N去除率平均值达到88.7%;而高径比8∶1和3∶1反应器的运行不太稳定,硫化氢去除率的平均值分别为68.0%、80.4%,NO x--N的去除率平均值分别为89.7%、90.2%.主要是因为高径比2∶1反应器的实际气速(3.12×10-2 m.s-1)比高径比3∶1、8∶1反应器的实际气速(分别为3.62×10-2 m.s-1和6.64×10-2 m.s-1)更慢,其气液传质系数(1.79×10-5 s-1)比高径比3∶1、8∶1反应器的气液传质系数(分别为1.64×10-5 s-1和1.55×10-5 s-1)更大,传质效果更好.处理效能试验结果以及反应器流体力学特征参数均表明,高径比2∶1反应器为最适合的反应器.     

Effect of catalyzed diesel particulate filter and its catalyst loading on emission characteristics of a non-road diesel engine

In this study, the effects of a diesel oxidation catalyst (DOC) coupled with a catalyzed diesel particulate filter (CDPF) with different catalyst loadings on the power, fuel consumption, gaseous and particulate emissions from a non-road diesel engine were investigated. Results showed that the after-treatment had a negligible effect on the power and fuel consumption. The reduction effect of the DOC on the CO and hydrocarbon (HC) increased with the engine load. Further reductions occurred coupling with the CDPF. Increasing the catalyst loading resulted in a more significant reduction in the HC emissions than CO emissions. The DOC could increase the NO₂ proportion to 37.9%, and more NO₂ was produced when coupled with the CDPF below 250°C; above 250°C, more NO₂ was consumed. The after-treatment could reduce more than 99% of the particle number (PN) and 98% of the particle mass (PM). Further reductions in the PN and PM occurred with a higher CDPF catalyst loading. The DOC had a better reduction effect on the nucleation particles than the accumulation ones, but the trend reversed with the CDPF. The DOC shifted the particle size distribution (PSD) to larger particles with an accumulation particle proportion increasing from 13% to 20%, and the geometric mean diameter (GMD) increased from 18.2 to 26.0 nm. The trend reversed with the CDPF and the accumulation particle proportion declined to less than 10%. A lower catalyst loading on the CDPF led to a higher proportion of nucleation particles and a smaller GMD.     

活性滤料滤池气提系统影响因素研究

为了研究气量、水深和提砂管规格对活性滤料滤池提砂系统性能的影响,本实验以石英砂作为活性滤料滤池的提升介质,在恒定水头状态下,测量了不同管径下被提升的水和砂的体积和质量随压缩空气流量的变化.结果表明:随着气量的增大,提升系统的提砂量和提砂效率均呈先增大后减小的趋势;提砂管管径是最大提砂量的限制因素,但提升的砂水体积比与管径无关;相同气量条件下,单位空气提砂量与水深呈线性关系.因此,在活性滤料滤池提砂系统的设计应用过程中应选择合适的提砂管径,尽量增加浸水率,并注意控制气量以提升系统能效.     

辽宁省大型底栖无脊椎动物耐污值及水质评价

根据采自辽宁省河流、水库、湖泊及河口湿地水体的209个大型底栖无脊椎动物样本,以及文献记载数据,依据其系统发育、亲缘关系和相同栖息地环境等进行推算,确定了辽宁省大型底栖无脊椎动物耐污值332个。利用上述耐污值并结合BI指数法对辽河、浑河、太子河流域内20个采样点所获得的大型底栖无脊椎动物监测数据进行分析与评价,结果显示各河流上游段水质良好,中下游河段水质较差。     

Numerical simulation of propane detonation in medium and large scale geometries

A modelling strategy has been developed for consequence analysis of medium and large scale gaseous detonation. The model is based on the solution of Euler equations with one-step chemistry. The Van Leer flux limited method which is a total variation diminishing scheme is used for shock capturing. Preliminary calculations were firstly conducted for small domains with fine grids which resolve the wave, relatively coarse grids which have less than 10 grids across the wave and coarse grids in which the minimum grid size is larger than the wave thickness to ensure that the reaction scheme has been properly tuned to capture the correct detonation pressure, temperature and velocity in the resolutions used in the different cases. The model was firstly tested against a medium scale detonation test in a shock tube with U-bends. Reasonably good agreement is achieved on detonation pressure and mean shock wave velocities at different measuring segments of the tube. Following the validation, the detonation of a hypothetical planar propane-air cloud is simulated. The predictions uncovered some interesting features of such large scale detonation phenomena which are of significance in the safety context, especially for accidental investigations. The findings from the present analysis are in line with the forensic evidence on damages in some historic accidents and challenges previous analysis of a major accident in which forensic evidence suggested localised detonation but was considered as the consequence of fire storms by the investigation team.     

环境影响综合评价灰色层次模型研究

针对水电工程环境影响综合评价问题，应用拓展的灰关联理论和最小二乘准则，建立了环境影响综合评价的灰色层次模型。以东江水电工程环境影响综合评价为实例说明了该模型的合理性、可信性。结果表明：此基工程使环境总体向理想的１８．１％     

菌根真菌侵染对植物生物量累积的影响

为了从生态系统尺度探讨菌根资源与植物生物量累积的关系,调查了鼎湖山不同成熟度的三个森林群落主要优势树种的菌根侵染情况.综合分析各森林群落优势树种的个体数、生物量和菌根侵染率发现：1）菌根侵染率与径向生长速率相关,植物生长迅速的阶段菌根侵染率更高.中径级（胸径15-30 cm）的马尾松（Pinus massoniana）和锥（Castanopsis chinensis）的侵染率比小径级（胸径1-15 cm）个体的侵染率高,而大径级个体（胸径30 cm 以上）的侵染率略低于中径级个体的侵染率.木荷（Schima superba）则表现出侵染率随着胸径增大而增高的趋势.2）树种在群落内的侵染率越高,其对群落生物量的贡献率越大.如马尾松在马尾松林和混交林的侵染率分别为（77.30±18.02）%和（40.50±14.42）%,其对马尾松林群落生物量的贡献率达到87.43%,是对混交林生物量贡献率（17.51%）的5 倍.混交林和阔叶林的共有优势树种锥的侵染率和生物量贡献率也有存在相同规律.3）根系碳储量占群落总碳储量比例较高的群落其优势树种平均侵染率相对较高.马尾松林、混交林和季风常绿阔叶林中,根系碳储量占群落总碳储量的比例分别为55%、54%、42%,群落优势树种平均侵染率分别为（66.73±10.55）%、（46.97±27.28）%、（54.22±25.45）%,马尾松林的根系碳储量和平均侵染率均高于混交林和季风常绿阔叶林.以上结果表明,菌根真菌侵染对于植物个体生长速率以及群落水平的生物量累积具有-定的促进作用.     

水中乙醛、丙烯醛和丙烯腈3种测定方法的对比

对比研究了大体积直接进样填充柱气相色谱法、顶空-气相色谱法和吹扫捕集-气相色谱法等3种测定水中乙醛、丙烯醛和丙烯腈的方法.结果表明,大体积直接进样法设备简单,但手动进样耗力费时,且灵敏度低,精密度差,直接水样分析易影响色谱柱和检测器的使用寿命;顶空法稳定性好,线性范围宽,相关性和精密度好,适合较高浓度水样的分析;吹扫捕集法操作简便,峰形好,检出限低,回收率高,适合低浓度水样的分析.顶空法和吹扫捕集法自动化程度高,均适用于大批量样品分析.     

畜禽养殖场空气中可培养抗生素耐药菌污染特点研究

畜禽养殖场被认为是空气环境中耐药基因和致病菌的重要来源.本研究对北京地区22个畜禽养殖场逸散细菌、四环素和红霉素耐药菌气溶胶的浓度进行检测,对其粒径分布和动力学粒径进行分析.结果表明,所调查的3种生物气溶胶(细菌、四环素耐药菌和红霉素耐药菌),在猪舍内浓度最高,牛舍内最低.蛋鸡舍内两种抗生素耐药菌气溶胶的浓度均低于肉鸡.本研究在蛋鸡和肉鸡舍外空气中检测到了四环素和红霉素耐药菌,所占丰度分别为8.81%、15.89%和23.19%、36.53%.不同养殖场舍内外细菌、四环素耐药菌和红霉素耐药菌气溶胶浓度的粒径分布特点存在差异.动力学粒径研究结果显示,4种动物舍内的四环素和红霉素耐药菌气溶胶主要沉降在人体的咽喉和支气管.本研究结果将为评价养殖场生物气溶胶对周边空气环境污染及人类健康造成的危害提供基础数据.