一种新型的清洁能源——燃料电池

燃料电池高效率、无污染、建设周期短、易维护以及低成本的特点被受人们关注。本文介绍了各种类型燃料电池(碱性燃料电池、熔融碳酸盐燃料电池、固体氧化物燃料电池、磷酸燃料电池及质子交换膜燃料电池)的技术进展及其发展现状,对燃料电池的应用前景进行了探讨。     

Optimization of the electrocoagulation process for the removal of copper, lead and cadmium in natural waters and simulated wastewater

Chemical, electrochemical and flow variables were optimized to examine the effectiveness of the electrocoagulation process for the removal of copper, lead and cadmium. The electrochemical process, which uses electrodes of commercial laminate steel, was applied to simulated wastewater containing 12 mg dm(-3) of copper, 4 mg dm(-3) of lead and 4 mg dm(-3) of cadmium. The optimum conditions for the process were identified as pH=7, flow rate=6.3 cm(3) min(-1) and a current density between 31 and 54 A m(-2). When the electrode geometric area and time of electrolysis reached critical values, the copper removal reached a maximum value of 80%. A linear relationship was identified between the current density and the mass of generated sludge. In addition, a linear relationship was found between specific energy consumption and current density. The results of this investigation provide important data for the development of an industrial-scale electrolytic reactor.     

Comparative sensitivity of 20 bioassays for soil quality

Increasing evidence suggests that the use of a single bioassay will never provide a full picture of the quality of the environment. Only a test battery, composed of bioassays of different animal and plant species from different trophic levels will reduce uncertainty, allowing an accurate assessment of the quality of the environment. In the present study, a test battery composed of 20 bioassays of varying biological endpoints has been compared Apart from lethality and reproductive failure in earthworms, springtails, nematoda, algae and vascular plants, these endpoints also included bioavailibility of metals (bacteria), heat-shock induction (nematodes, algae), DNA damage (bacteria, earthworm, vascular plants), β-galactosidase (Daphnia) and esterase activity (algae) and a range of immunological parameters (earthworm). Four chemicals (cadmium, phenol, pentachlorophenol and triflurahn) — each representing a different toxic mode of action — were applied in a dilution series (from 1 mg/kg up to 1000 mg/kg) onto OECD standard soil. The tests have been performed both on these artificially contaminated soil samples and on aqueous extracts subsequently obtained from these soils. The results show that the immunological parameters and the loss of weight in the earthworms were among the most sensitive solid phase assays. Esterase inhibition and heat-shock induction in algae were shown to be extremely sensitive when applied to soil extracts. As previously shown at the species level, no single biological endpoint was shown to be the most sensitive for all four modes of toxic action.     

Numerical and experimental investigation of state of health of Li-ion battery

ABSTRACT

Estimation of State of Health (SoH) of Lithium-ion (Li-ion) battery is essential to predict the lifespan of batteries of an electric vehicle (EV). The efficient prediction of battery health indicates to the effective and safe operation of EV. However, delivering an effective and accurate method for the estimation of SoH in the real condition is truly a challenging task. The present study proposed a holistic procedure of combining both experimental and numerical investigations to conduct the fundamental study on coupled mechanical-electrochemical behavior of Li-ion battery. The proposed investigation highlighted the effect of stress on the capacity of the battery, considering capacity fade as an equivalent parameter to its health for real-time estimation of SoH. Finally, a simple model of Artificial Neural Network (ANN) is provided, which shows the linear dependency of stress with the SoH. The results obtained from the ANN model are validated with a Linear Regression (LR) model for a better understanding of the inspection. The predicted value of mean Square Error (MSE) and R square error in the ANN training model are found to be 0.000309 and 0.849687, respectively. Whereas for the test model, these predicted values are found to be 0.000438 and 0.819347, respectively.     

燃煤电厂烟气中铅的测定方法初探

采用过滤法与吸收法联用的采样方法,测定燃煤电厂烟气中Pb,并通过试验考察4种不同的吸收液和4种不同采样流量对测定的影响。结果表明:0.1 mol/L HNO_3、体积分数为5%的HNO_3+10%的H_2O_2和体积分数为1.6%的HNO_3+2.5%的HCl 3种吸收液均对Pb起到良好的捕集作用,且测定结果相近。采样流量控制在20 L/min吸收效果最好。     

锂离子电池火灾风险管控研究现状分析

为了研究锂离子电池火灾风险管控,本文对锂离子电池火灾的特点及诱因进行了分析,通过查阅国内外相关文献,对锂离子电池模型仿真技术、火灾防治材料以及各阶段安全评价的研究状况进行归纳总结。研究发现,对锂离子电池火灾进行评价时,评价对象较为单一,无法系统地对锂离子电池火灾进行风险管控,故提出将生物免疫机理引入对锂离子电池火灾的风险管控中,为实现锂离子电池的全生命周期安全管理提供了新思路。     

低压环境下不同三元圆柱锂电池热失控危险特性对比研究

为研究21700和18650新旧2型多用途锂离子电池在航空运输低压环境下的热失控特性差异,采用动压变温实验舱搭建实验平台开展实验。将实验环境压力设定为飞机巡航时的环境压力30 kPa,对比常压101 kPa,使用外部热源加热的方式触发锂电池热失控,利用热传播引发相邻电池热失控,分别从热失控温度变化特性、热释放速率和热解气体组分浓度变化进行分析。研究结果表明:能量密度更高的21700电池热失控峰值温度更高,高温危险性要高于18650电池,但触发热失控所需的热量更多,电池间热传播时间会延长;低压环境有利于降低锂电池热失控燃爆峰值温度,减小燃爆热释放速率,但会产生更多CxHy和CO等具有燃爆性的热解气体,可能会在有限空间内与氧气混合引起二次燃爆。     

The effect of EDDS and citrate on the uptake of lead in hydroponically grown Matthiola flavida

Root and shoot lead concentrations and the impact of chelating agents on these were investigated in two populations of the novel metallophyte Matthiola flavida. Plants were exposed in hydroponics to Pb(NO₃)₂, supplied alone, or in combination with citric acid, or EDDS. When supplied at concentrations expected to bind about 95% of the Pb in a solution containing 1-μM Pb (1000 μM citrate or 3.1 μM EDDS, respectively), the root and shoot Pb concentrations were dramatically lowered, in comparison with a 1-μM free ionic Pb control exposure. A 1-mM EDDS + 1-μM Pb treatment decreased the plants’ Pb concentrations further, even to undetectable levels in one population. At 100 μM Pb in a 1-mM EDDS-amended solution the Pb concentration increased strongly in shoots, but barely in roots, in comparison with the 1-μM Pb + 1-mM EDDS treatment, without causing toxicity symptoms. Further increments of the Pb concentration in the 1-mM EDDS-amended solution, i.e. to 800 and 990 μM, caused Pb hyperaccumulation, both in roots and in shoots, associated with a complete arrest of root growth and foliar necrosis. M. flavida seemed to be devoid of constitutive mechanisms for uptake of Pb-citrate or Pb-EDDS complexes. Hyperaccumulation of Pb-EDDS occurred only at high exposure levels. Pb-EDDS was toxic, but is much less so than free Pb. Free EDDS did not seem to be toxic at the concentrations tested.     

Kelp as a Bioindicator: Does it Matter Which Part of 5 M Long Plant is Used for Metal Analysis?

Kelp may be useful as a bioindicator because they are primary producers that are eaten by higher trophic level organisms, including people and livestock. Often when kelp or other algae species are used as bioindicators, the whole organism is homogenized. However, some kelp can be over 25 m long from their holdfast to the tip of the blade, making it important to understand how contaminant levels vary throughout the plant. We compared the levels of arsenic, cadmium, chromium, lead, manganese, mercury and selenium in five different parts of the kelp Alaria nana to examine the variability of metal distribution. To be useful as a bioindicator, it is critical to know whether levels are constant throughout the kelp, or which part is the highest accumulator. Kelp were collected on Adak Island in the Aleutian Chain of Alaska from the Adak Harbor and Clam Cove, which opens onto the Bering Sea. In addition to determining if the levels differ in different parts of the kelp, we wanted to determine whether there were locational or size-related differences. Regression models indicated that between 14% and 43% of the variation in the levels of arsenic, cadmium, chromium, manganese, mercury, and selenium was explained by total length, part of the plant, and location (but not for lead). The main contributors to variability were length (for arsenic and selenium), location (mercury), and part of the plant (for arsenic, cadmium, chromium and manganese). The higher levels of selenium occurred at Clam Cove, while mercury was higher at the harbor. Where there was a significant difference among parts, the holdfast had the highest levels, although the differences were not great. These data indicate that consistency should be applied in selecting the part of kelp (and the length) to be used as a bioindicator. While any part of Alaria could be collected for some metals, for arsenic, cadmium, chromium, and manganese a conversion should be made among parts. In the Aleutians the holdfast can be perennial while the blade, whipped to pieces by winter wave action, is regrown each year. Thus the holdfast may be used for longer-term exposure for arsenic, cadmium, chromium and manganese, while the blade can be used for short-term exposure for all metals. Cadmium, lead and selenium were at levels that suggest that predators, including people, may be at risk from consuming Alaria. More attention should be devoted to heavy metal levels in kelp and other algae from Adak, particularly where they may play a role in a subsistence diets.     

废铅酸蓄电池铅膏性质分析

为给废旧铅蓄电池铅膏的湿法回收工艺提供理论依据,对湖北金洋冶金股份有限公司破碎分选后的废铅膏进行了XRF、XRD、物理分析及化学分析等,确定了废铅膏的主要成分、理化性质等特性。结果表明,废铅膏粒径细小,碾钵磨细后能过120目的筛下物超过77.4%,这对湿法转化是有利的。废铅膏主要组成为64.5%PbSO4、29.5%PbO2、4.5%PbO、0.8%Pb及其他微量杂质元素,杂质主要包括Fe、Sb和Si等。因此,铅膏湿法处理时应该采取合适的净化工艺。