TiO2@palygorskite composite for the efficient remediation of oil spills via a dispersion-photodegradation synergy

• A novel and multi-functional clay-based oil spill remediation system was constructed. • TiO₂@PAL functions as a particulate dispersant to break oil slick into tiny droplets. • Effective dispersion leads to the direct contact of TiO₂ with oil pollutes directly. • TiO₂ loaded on PAL exhibits efficient photodegradation for oil pollutants. • TiO₂@PAL shows a typical dispersion-photocatalysis synergistic remediation. Removing spilled oil from the water surface is critically important given that oil spill accidents are a common occurrence. In this study, TiO₂@Palygorskite composite prepared by a simple coprecipitation method was used for oil spill remediation via a dispersion-photodegradation synergy. Diesel could be efficiently dispersed into small oil droplets by TiO₂@Palygorskite. These dispersed droplets had an average diameter of 20–30 mm and exhibited good time stability. The tight adsorption of TiO₂@Palygorskite on the surface of the droplets was observed in fluorescence and SEM images. As a particulate dispersant, the direct contact of TiO₂@Palygorskite with oil pollutants effectively enhanced the photodegradation efficiency of TiO₂ for oil. During the photodegradation process, •O₂⁻and •OH were detected by ESR and radical trapping experiments. The photodegradation efficiency of diesel by TiO₂@Palygorskite was enhanced by about 5 times compared with pure TiO₂ under simulated sunlight irradiation. The establishment of this new dispersion-photodegradation synergistic remediation system provides a new direction for the development of marine oil spill remediation.     

Property-performance relationship of core-shell structured black TiO2 photocatalyst for environmental remediation

● Properties and performance relationship of CSBT photocatalyst were investigated. ● Properties of CSBT were controlled by simply manipulating glycerol content. ● Performance was linked to semiconducting and physicochemical properties. ● CSBT (W:G ratio 9:1) had better performance with lower energy consumption. ● Phenols were reduced by 48.30% at a cost of $2.4127 per unit volume of effluent. Understanding the relationship between the properties and performance of black titanium dioxide with core-shell structure (CSBT) for environmental remediation is crucial for improving its prospects in practical applications. In this study, CSBT was synthesized using a glycerol-assisted sol-gel approach. The effect of different water-to-glycerol ratios (W:G = 1:0, 9:1, 2:1, and 1:1) on the semiconducting and physicochemical properties of CSBT was investigated. The effectiveness of CSBT in removing phenolic compounds (PHCs) from real agro-industrial wastewater was studied. The CSBT synthesized with a W:G ratio of 9:1 has optimized properties for enhanced removal of PHCs. It has a distinct core-shell structure and an appropriate amount of Ti³⁺ cations (11.18%), which play a crucial role in enhancing the performance of CSBT. When exposed to visible light, the CSBT performed better: 48.30% of PHCs were removed after 180 min, compared to only 21.95% for TiO₂ without core-shell structure. The CSBT consumed only 45.5235 kWh/m³ of electrical energy per order of magnitude and cost $2.4127 per unit volume of treated agro-industrial wastewater. Under the conditions tested, the CSBT demonstrated exceptional stability and reusability. The CSBT showed promising results in the treatment of phenols-containing agro-industrial wastewater.     

C/N比和曝气量影响MBR同步硝化反硝化的研究

通过连续运行MBR研究了C/N比和曝气量对同步硝化反硝化的影响,结果表明,在环境温度13～23℃,MLSS为6.0～6.8 g/L,进水NH⁺₄-N浓度50 mg/L,曝气量0.5 m³/h,HRT为6 h实验条件下,总氮去除率随着进水C/N比的增加而增加,在C/N比为6∶1～8∶1时,TN去除率达到79%～89%,低的C/N比抑制反硝化,过高的C/N比增加了碳源补加的成本。改变反应曝气量,当C/N比为6∶1,曝气量为0.4 m³/h时,TN的去除率达到了最大值85%。曝气量过高或过低,TN去除率均下降。并对在不同曝气量下MBR 内的DO 值分布进行了初步研究。     

饮用水生物处理中微生物量和活性的测定方法

微生物量和微生物活性是饮用水生物处理工艺设计与运行的重要参数。总结论述了适用于表示饮用水生物处理过程生物膜中微生物数量和活性的几种主要指标的测定方法。     

采用Fe2+/NaClO处理乐果废水的研究

研究了利用NaClO在酸性条件下生成的HClO代替Fenton试剂中的氧化剂H2O2,在Fe^2＋的作用下对乐果模拟废水进行处理。结果表明此方法处理乐果废水的效果比较明显。使用Fe^2＋／NaClO氧化处理乐果模拟废水,在pH值等于2,NaClO与FeSO4·7H2O的投加量分别为10mL/L,2．5g／L,振荡时间为30min,乐果初始质量浓度小于53mg／L时,乐果的处理率大于88．90％。     

Influence of environmental temperature and relative humidity on photocatalytic oxidation of toluene on activated carbon fibers coated TiO2

TiO₂ supported on active carbon fiber (TiO₂/ACF), an absorbable photocatalyst, is a new kind of material applied in air purification. In this paper, the influence of environmental temperature (T) and relative humidity (RH) on the gas-solid adsorption of toluene and the photocatalytic oxidation (PCO) efficiency of adsorbed toluene on TiO₂/ACF were studied, and then, the purification capability of TiO₂/ACF was estimated. PCO results showed that although the PCO efficiency increased under high RH and T levels, the amount of adsorption of toluene decreased. Moreover, quantitative analysis results of intermediates indicated that more environmental risk emerged when PCO of toluene was carried out at higher environmental T and RH levels because more toxic intermediates would be accumulated on the TiO₂/ACF. So, it is significant to control the environmental T and RH conditions in the application of the PCO technique. T = 25°C and RH530% is the optimal condition for purifying toluene in our experimental system. __________ Translated from Urban Environment & Urban Ecology, 2007, 20(5): 10–13 [译自: 城市环境与城市生态]     

Relation of lead adsorption on birnessites with different average oxidation states of manganese and release of Mn^2＋/H^＋/K^＋

The characteristics of Pb2+ adsorption on the surface of birnessites with different average oxidation states (AOS) of Mn, synthesized under acidic and alkali conditions, were investigated. The results indicated that the amount of adsorbed Pb2+ increased with the increase of Mn AOS in birnessites. The amount of Pb2+ adsorbed positively correlated with the amount of released Mn2+, H+, and K+ (r = 0.9962 > 0.6614, n = 14, α = 0.01). The released Mn2+, H+, and K+ were derived mostly from the corresponding catio...     

硝酸盐对矿化垃圾中兼/厌氧甲烷氧化的影响

设计全因子实验研究了NO-3-N对填埋10~12 a的矿化垃圾中兼/厌氧甲烷氧化作用的影响.结果表明,兼/厌氧条件下,NO-3-N能促进矿化垃圾中CH4的去除.初始CH4和NO-3-N对CH4去除和N2产生有明显影响,且两者具有交互作用(P<0.05).CH4去除量随着初始CH4体积分数的增加而增加,添加一定含量的NO-3-N能促进CH4去除,同时通入一定体积分数CH4可以明显促进反硝化作用,说明矿化垃圾中NO-3-N还原能与兼/厌氧甲烷氧化耦合.本实验条件下,初始CH4体积分数为30%,NO-3-N含量为110 mg·kg-1时耦合效应较好.     

2011年春季辽宁一次沙尘天气过程及其对不同粒径颗粒物和空气质量的影响

利用2011年5月11—12日辽宁沙尘天气过程的相关资料,分析了沙尘天气对不同粒径颗粒物及空气质量的影响及此次沙尘过程的天气成因.结果表明:沙尘天气发生前后可吸入颗粒物PM₁₀、PM_2.5和PM₁的浓度变化很大,沈阳、鞍山、本溪和丹东4城市PM₁₀、PM_2.5的小时浓度最大值都增大了1.5~20倍;粗粒子PM_(2.5~10)的数量浓度分别增加了30~41倍,质量浓度分别增加了27~30倍;细粒子PM_(1~2.5)的质量浓度分别增加了30~35倍,数量浓度分别增加了15~30倍;微粒子的数量浓度和质量浓度各城市表现不同,沈阳微粒子的数量浓度和质量浓度最大值增大了3倍和5倍,而鞍山PM₁的数量浓度和质量浓度分别减少了50%和10%.受蒙古气旋的影响内蒙古地区产生大风降温天气,大风将内蒙古地区的沙尘带到高空并随西风带向东移动进入辽宁,由于辽宁地区风速比较小,造成了辽宁大部分地区的浮尘天气,并对辽宁各地空气质量造成了严重影响,除丹东外辽宁其他13个城市空气质量都达到了轻微污染到重度污染的级别,铁岭、阜新、沈阳和抚顺的污染指数分别超过了300,达到了重度污染的级别.     

改性沸石(Na-Y型)对Ni2+的吸附行为

将天然沸石熔融制得新型改性沸石(Na-Y型),研究Na-Y型沸石对Ni2 的吸附行为.结果表明,对Ni2 的饱和吸附量,Na-Y型沸石为31.04mg·g-1,而天然斜发沸石和Na型沸石(NaCl改性)仅为3.60mg·g-1和7.64 mg·g-1.Na-Y型沸石对Ni2 的等温吸附行为符合Freundlich方程.对溶液中Ni2 的吸附量在初始阶段(0-5h)快速上升,而后趋于平缓.共存阳离子对Na-Y型沸石吸附Ni2 的影响为:Co2 》Ca2 》Fe3 》 K .