中小型燃煤锅炉烟气的除尘脱硫

总结了多年来在中小型燃煤锅炉烟气除尘脱硫方面的经验，较详细地介绍了常见除尘脱硫的特点，缺陷及其原因。根据多年的经验，采用由于干式旋风除尘器和除尘脱硫嚣 串联而成的干湿两级除尘脱硫系统，可获得较大成功。但在标准要求的特殊区域，目前的设备均不能达到要求，市场迫切高效湿式除法脱硫器的出现。     

Buses retrofitting with diesel particle filters: Real-world fuel economy and roadworthiness test considerations

Retrofitting older vehicles with diesel particulate filter(DPF) is a cost-effective measure to quickly and efficiently reduce particulate matter emissions. This study experimentally analyzes real-world performance of buses retrofitted with CRT DPFs. 18 in-use Euro III technology urban and intercity buses were investigated for a period of 12 months. The influence of the DPF and of the vehicle natural aging on buses fuel economy are analyzed and discussed. While the effect of natural deterioration is about 1.2%–1.3%, DPF contribution to fuel economy penalty is found to be 0.6% to 1.8%, depending on the bus type. DPF filtration efficiency is analyzed throughout the study and found to be in average 96% in the size range of 23–560 nm. Four different load and non-load engine operating modes are investigated on their appropriateness for roadworthiness tests. High idle is found to be the most suitable regime for PN diagnostics considering particle number filtration efficiency.     

Determination of the effective density and fractal dimension of PM emissions from an aircraft auxiliary power unit

Gas turbine particulate matter (PM) emissions contribute to air quality degradation and are dangerous to both human health and the environment. Currently, PM mass concentrations determined from gravimetric measurements are the default parameter for gas turbine emissions compliance with PM regulations. The measurement of particle size however, is of significant interest due to its specific effects on health and climate science. The mass concentration can be determined from the number-size distribution measurement but requires the experimental evaluation of effective density of a number of particles to establish the power-law relationship. In this study, the effective density of PM emissions from an aircraft Auxiliary Power Unit (APU) with petroleum diesel, conventional aviation fuel (Jet A-1) and a multicomponent surrogate fuel (Banner NP 1014) as combusting fuels have been compared. An experimental configuration consisting of a Differential Mobility Analyzer, a Centrifugal Particle Mass Analyzer and a Condensation Particle Counter (DMA-CPMA-CPC) was deployed for this purpose. Overall, a decrease in the effective density (220–1900 km? 3) with an increase in the particle size was observed and found to depend on the engine operating condition and the type of fuel undergoing combustion. There was a change in the trend of the effective densities between the PM emissions generated from the fuels burnt and the engine operating conditions with increasing particle size.     

The presence of zinc in Swedish waste fuels

Zinc (Zn) is a chemical element that has gained more attention lately owing to its possibility to form corrosive deposits in large boilers, such as Waste-to-Energy plants. Zn enters the boilers in many different forms and particularly in waste, the amount of Zn is hard to determine due to both the heterogeneity of waste in general but also due to the fact that little is yet published specifically about the Zn levels in waste. This study aimed to determine the Zn in Swedish waste fuels by taking regular samples from seven different and geographically separate waste combustion plants over a 12-month period. The analysis shows that there is a relation between the municipal solid waste (MSW) content and the Zn-content; high MSW-content gives lower Zn-content. This means that waste combustion plants with a higher share of industrial and commercial waste and/or building and demolition waste would have a higher share of Zn in the fuel. The study also shows that in Sweden, the geographic location of the plant does not have any effect on the Zn-content. Furthermore, it is concluded that different seasons appear not to affect the Zn concentrations significantly. In some plants there was a clear correlation between the Zn-content and the content of other trace metals.     

辐射热流作用下树叶样品的燃烧特征研究

研究植物叶样在外部热辐射和值班火源作用下的燃烧现象特征并探索其成因和物理及化学本质。采用锥形量热仪开展实验,热辐射强度分别设定为35kW m-2、55kW m-2、70kW m-2和85kW m-2。实验样品为针阔叶树种共13种,其含水率在45%至79%间变化。实验表明,样品表现出不同的着火模式,有的为明火,有的则为阴燃,取决于树种和设定的辐射强度。样品出现有焰燃烧现象的最低热释放速率峰值(PHRR)在22.3kW m-2至35.6kW m-2之间,反映了形成气相火焰所需最低挥发分质量流率。气相产物CO2产生速率的峰值与PHRR呈高度线性性,表明了不同样品间气相燃烧或固相表面氧化(阴燃燃烧)反应的相似性。进一步分析表明,出现的独特热释放速率尖锐峰形是样品分层特性以及树叶的物理属性和热物性共同作用的结果。具有热薄特性的样品表层,在实验初期是接受外部辐射热的主体,其热解的产物是形成气相火焰的物质来源;在其转变为焦炭层后,对辐射热流向内层的渗透具有阻挡作用。建立起来的认识对于评估分层样品的燃烧性有一定的指导意义。     

Fire hazard after prescribed burning in a gorse shrubland: implications for fuel management

Prescribed burning is commonly used to prevent accumulation of biomass in fire-prone shrubland in NW Spain. However, there is a lack of knowledge about the efficacy of the technique in reducing fire hazard in these ecosystems. Fire hazard in burned shrubland areas will depend on the initial capacity of woody vegetation to recover and on the fine ground fuels existing after fire. To explore the effect that time since burning has on fire hazard, experimental tests were performed with two fuel complexes (fine ground fuels and regenerated shrubs) resulting from previous prescribed burnings conducted in a gorse shrubland (Ulex europaeus L.) one, three and five years earlier. A point-ignition source was used in burning experiments to assess ignition and initial propagation success separately for each fuel complex. The effect of wind speed was also studied for shrub fuels, and several flammability parameters were measured. Results showed that both ignition and initial propagation success of fine ground fuels mainly depended on fuel depth and were independent of time since burning, although flammability parameters indicated higher fire hazard three years after burning. In contrast, time since burning increased ignition and initial propagation success of regenerated shrub fuels, as well as the flammability parameters assessed, but wind speed had no significant effect. The combination of results of fire hazard for fine ground fuels and regenerated shrubs according to the variation in relative coverage of each fuel type after prescribed burning enabled an assessment of integrated fire hazard in treated areas. The present results suggest that prescribed burning is a very effective technique to reduce fire hazard in the study area, but that fire hazard will be significantly increased by the third year after burning. These results are valuable for fire prevention and fuel management planning in gorse shrubland areas.     

Qualitative risk assessment of a Dual Fuel (LNG-Diesel) system for heavy-duty trucks

A Dual Fuel (LNG-Diesel) system can be applied to heavy-duty diesel trucks for achieving environmental benefits in comparison to existing diesel vehicles. Because of lack of reports about risk assessment of this technology, we performed a qualitative assessment based on a framework of some literature techniques for risk identification, analysis and evaluation. After constructing a Reliability Block Diagram (RBD) to establish the context, we conducted bow-tie analysis, Fault Tree Analysis (FTA), Failure Mode and Effects Analysis (FMEA), likelihood and consequence analysis, and used a risk matrix. We applied these methods and techniques qualitatively to identify causes (e.g. collisions), critical events (e.g. releases of natural gas), related consequences (e.g. fires and explosions), and different possible pathways from a specific cause to its consequence, and to assess some negative accident scenarios related to use and parking of the vehicle. The bow-tie analysis also allowed to make explicit barriers and controls that prevent critical events and/or mitigate consequences. Therefore, we identified a set of safety measures, including design, technical, management, and emergency actions, which shall be implemented in each step of the system's life cycle.Our risk assessment showed that the risk level of the Dual Fuel (LNG-Diesel) system is similar to the risk level of a traditional diesel system. Future research will overcome current lack of data and, therefore, permit a quantitative rating of the risk of the Dual Fuel (LNG-Diesel) system.     

Development of a framework for fire risk assessment using remote sensing and geographic information system technologies

Forest fires play a critical role in landscape transformation, vegetation succession, soil degradation and air quality. Improvements in fire risk estimation are vital to reduce the negative impacts of fire, either by lessen burn severity or intensity through fuel management, or by aiding the natural vegetation recovery using post-fire treatments. This paper presents the methods to generate the input variables and the risk integration developed within the Firemap project (funded under the Spanish Ministry of Science and Technology) to map wildland fire risk for several regions of Spain. After defining the conceptual scheme for fire risk assessment, the paper describes the methods used to generate the risk parameters, and presents proposals for their integration into synthetic risk indices. The generation of the input variables was based on an extensive use of geographic information system and remote sensing technologies, since the project was intended to provide a spatial and temporal assessment of risk conditions. All variables were mapped at 1 km² spatial resolution, and were integrated into a web-mapping service system. This service was active in the summer of 2007 for semi-operational testing of end-users. The paper also presents the first validation results of the danger index, by comparing temporal trends of different danger components and fire occurrence in the different study regions.     

Alternative transportation fuel standards: Welfare effects and climate benefits

This paper develops an integrated model of the fuel and agricultural sectors to analyze the welfare and greenhouse gas emission (GHG) effects of the existing Renewable Fuel Standard (RFS), a Low Carbon Fuel Standard (LCFS) and a carbon price policy. The conceptual framework shows that these policies differ in the incentives they create for the consumption and mix of different types of biofuels and in their effects on food and fuel prices and GHG emissions. We also simulate the welfare and GHG effects of these three policies which are normalized to achieve the same level of US GHG emissions. By promoting greater production of food-crop based biofuels, the RFS is found to lead to a larger reduction in fossil fuel use but also a larger increase in food prices and a smaller reduction in global GHG emissions compared to the LCFS and carbon tax. All three policies increase US social welfare compared to a no-biofuel baseline scenario due to improved terms-of-trade, even when environmental benefits are excluded; global social welfare increases with a carbon tax but decreases with the RFS and LCFS due to the efficiency costs imposed by these policies, even after including the benefits of mitigating GHG emissions.