Novel Co-Mg-Al-Ti-O catalyst derived from hydrotalcite-like compound for NO storage/decomposition

Catalysts of Co_1.5Mg_1.5/Al_0.9Ti_0.1O and Co_1.5Mg_1.5/AlO were successfully prepared by calcinations of corresponding hydrotalcite-like compounds at 800℃ for 4 hr. The derived oxides were of spinel phase and a small quantity of Ti substitution did not change the crystal purity. Their catalytic performance for the NO storage/decomposition was investigated. Ti incorporation enhanced the NO decomposition activity while has an opposite effect on the storage capacity of catalyst. In situ FT-IR spectra of the catalysts showed that the final adsorption species on the catalysts was coordinated nitrates/nitrites. In addition, NO storage/decomposition mechanism has been discussed on the basis of these observations.     

中国泥炭地有机碳储量与储存特征分析

根据全国泥炭资源调查的结果, 运用有机质含量、干容重、泥炭储量、泥炭地面积等数据估算中国泥炭地有机碳储量,并探讨其碳储存特征.结果表明,我国泥炭地有机碳总储量约15.03亿t.在各省和各气候区分布不均匀,四川省(6.45亿t)和云南省(2.91亿t)泥炭地有机碳储量最丰富,占总储量的62.29%.各气候区中高原湿润区泥炭地有机碳储量最大(7.14亿t),特别是若尔盖高原泥炭地有机碳储量(6.30亿t)占总储量的41.92%.我国泥炭地有机碳密度一般在80~140kg/m3, 最大值为270~360kg/m3,最小值小于80kg/m3,其分布以燕山、太行山至横断山为界,西北部低,东南部高.泥炭地单位面积有机碳储量均值为143.97kg/m2,滇南高原最高,达到637.06kg/m2.区域平均泥炭地有机碳积累强度为208.23 t/km2,若尔盖高原最高达3972.71t/km2.     

不同制备温度的水稻生物炭电子交换能力研究

为探究不同热解温度下生物炭的电子交换能力,通过限氧升温炭化法,利用水稻秸秆在不同热解温度条件下制备生物炭,与氧气、铁氰化钾氧化剂和柠檬酸钛还原剂进行氧化还原反应,对生物炭的得电子能力（EAC）和失电子能力（EDC）进行定量分析.结果显示,热解温度对生物炭的电子交换能力有较大影响,随热解温度升高至500℃时,生物炭的EAC和EDC达到最大,分别为3.86,1.72mmol/g高于500℃后,随着温度的增加,EAC和EDC逐渐减小,这是由于生物炭的醌类和酚类官能团的结构改变以及持久性自由基强度变化的联合作用.此外,柠檬酸钛和连二硫酸钠两种氧化还原电位不同的还原剂进一步证实了还原剂电位对生物炭EAC的影响.且生物炭具有氧化还原的可逆性,可逆的EAC与EDC之和近似等于生物炭的电子储存能力.     

城郊排水沟渠溶质传输的暂态存储影响及参数灵敏性

选择Na Cl为示踪剂,于2013年9~10月在合肥城郊的关镇河支渠开展5次瞬时投加示踪实验.从暂态存储、侧向补给和对流-扩散等作用机制层面,设置4种模拟情景,解析暂态存储作用对于排水沟渠溶质传输规律的影响,并对OTIS模型参数进行灵敏性分析.结果表明,暂态存储对于主流区Cl-模拟浓度穿透曲线(BTCs)峰值大小影响很大,相对偏差高达24.23%~117.26%,显著高于对峰值出现时间的影响,且暂态存储影响显著超过了侧向补给作用;由相关性分析,主流区Cl-模拟浓度BTCs峰值大小和出现时间的相对偏差与As/A具有极显著相关性;4个主要参数的灵敏度排序为AAsαD.     

Catastrophic Reproductive Failure, Terrestrial Survival, and Persistence of the Marbled Salamander

Abstract:  Wide variation in reproductive success is common among amphibians that breed in seasonal ponds, but persistence of adults can buffer against these fluctuations, particularly for long-lived species. We hypothesized that the frequent episodes of catastrophic failure of the marbled salamander ( Ambystoma opacum ) enhance the importance of high terrestrial survival. At Rainbow Bay in South Carolina reproductive success was poor (<1 metamorph/breeding female) in nearly half of the 22 years that the species bred. Complete failure occurred in 6 of 22 years. To study catastrophic failure, we adapted an age-structured, individual-based model with density-dependent growth and survival of larvae. The model was based on extensive data from local field studies and experiments. With consistently good survival in the pond stages, the simulated population required survival probabilities in the upland stages (juveniles and adults) near 0.5/year to persist and near 0.8/year to achieve the increases observed. Catastrophic failure, occurring randomly with probability 0.5/year, created additional fluctuations in the population, raised the thresholds of survival required for persistence, and caused extinction under conditions that were otherwise favorable. The marbled salamander at Rainbow Bay is not at great risk of extinction because of catastrophic failure, but the risk increases dramatically if life span is decreased or frequency of failure is increased. Any reduction in terrestrial survival will have deleterious consequences by reducing the breeding populations at equilibrium, even if it does not jeopardize persistence. Our model provides assessments of risk that can be applied to poorly studied species with similar life histories, such as the endangered flatwoods salamander ( A. cingulatum ).     

聚糖菌颗粒污泥基于胞内储存物质的同步硝化反硝化

采用特殊运行方式的厌氧-好氧SBR系统(厌氧后排水),以乙酸钠为有机基质成功富集了聚糖菌颗粒污泥.聚糖菌颗粒污泥厌氧-好氧批式实验表明,聚糖菌颗粒污泥具有较强的SND能力,TOC/N分别为5.0,4.0,2.8时,SND效率分别96.4%、95.3%及96.2%,而周期总氮去除效率随着碳氮比降低而降低,分别为66.0%、61.2%及56.3%.通过对周期氨氮、亚硝酸盐氮、硝酸盐氮、TOC以及胞内糖原、PHB变化的测定分析,证明聚糖菌颗粒污泥SND过程中,污泥以厌氧阶段储存于胞内的多聚物PHB作为反硝化碳源,并且反硝化聚糖菌是系统中反硝化能力的来源.与溶解性基质相比,PHB的降解速率相对较低,因此在SND过程中,反硝化可以与硝化保持相近的速率,从而有助于获得良好的SND效果.     

I-Risk: development of an integrated technical and management risk methodology for chemical installations

This paper presents an integrated quantitative risk assessment method for hazardous installations, taking into account management as well as technical design and producing risk level measures. The key components of the I-Risk methodology are the technical model, the management model and their interface. The technical model consists of developing a master logic diagram (MLD) delineating the major immediate causes of loss of containment (LOC) and associated quantitative models for assessing their frequency. The management model consists of the tasks, which must be carried out systematically in the primary business functions (such as operations, emergency operations, maintenance and modifications). A management audit quantifies the quality of these management tasks. The management–technical interface modifies certain parameters of the technical model on the basis of the quality of the safety management system of the specific installation. The methodology is exemplified through its application to the risk assessment of an ammonia storage facility. A detailed technical model simulating the response of the system to various initiating events is developed along with a detailed management model simulating the influence of the plant-specific management and organisational practices. The overall effect is quantified through the frequency of release of ammonia as a result of a loss of containment in a storage tank and in a pipeline.     

油库泵站可燃气体智能型安全检测系统

根据目前油库泵站内存在可燃气体经常泄漏的实际情况,提出并应用计算机信息处理系统解决可燃气体泄漏监控问题。     

蒙德法在火电厂液氨储罐评价单元的应用

火电厂液氨储罐单元存在大量高纯度的液氨,一旦发生火灾、爆炸,后果极其严重。为了研究液氨储罐的火灾爆炸危险性及毒性,在对火电厂液氨储罐危险性辨识的基础上,依据液氨储罐单元的主要参数,运用蒙德法分别确定评价中需要的各种危险性系数,从而进行各项指标计算,查询危险性等级表,将各项指标进行等级划分,结论表明各项危险等级都很高。在得出结论基础上,进行安全措施补偿评价,补偿后的各种危险等级均降低,可见采取补偿措施后能够一定程度的降低火灾、爆炸、毒性的危险性,防止事故的发生。     

液化天然气储罐9％镍钢焊缝相控阵AUT工艺

9％镍钢液化天然气储罐制造安装过程中,焊缝检验通常用常规射线照相（RT）进行。本文研讨用相控阵半自动超声检测（AUT）取代射线照相的工艺制定及验证方法。要领分四步：首先带缺陷专用焊接试样的制备;然后相控阵AUT工艺的编制;其次在有已知缺陷的焊接试样上,对AUTT艺作“开放性”验证试验;最后在现场对整个数据采集系统作“封闭性”操作演示和验证评定试验。验证结果表明相控阵AUT取代RT可行可靠,能凸显AUT种种优势。