五氟苄基羟胺衍生与GC/MS联用分析大气中的单羰基化合物和多羰基化合物

利用涂布五氟苄基羟胺（PFBHA）的Tenax-TA作为固体吸附剂,采取主动采样的方式采集大气中羰基化合物,再经溶剂洗脱和氮吹浓缩后用气相色谱/质谱（GC/MS）分析,成功检测到14种单羰基化合物和2种二羰基化合物（乙二醛与甲基乙二醛）.研究表明：在吸附剂的装载量为50mg的前提下,当衍生剂的涂布量为260nmol,采集流速为50mL·min^-1时,采集效果最佳.羰基化合物的检测限、平行样的相对标准偏差和样品的加标回收率范围分别为0.54～3.83ng·m^-3、1.0%～14.2%、89.2%～113.8%.该方法在实际大气样品中合适的采样时间为0.5～8.0h.利用此法对上海市宝山区大气中羰基化合物进行了检测,成功检测到16种羰基化合物,且具有明显的日变化趋势.     

三峡库区城市给水厂多环芳烃分布变化评价

多环芳烃PAHs(Polycyclic Aromatic Hydrocarbons)是广泛存在的典型持久性有机污染物,了解三峡库区城市供水中PAHs的分布和变化具有重要的理论和现实意义.本文选用EPA推荐的3510c液-液萃取前处理方法和GC/MS 8270c测定方法,对三峡库区6个城市自来水厂(重庆主城3个,库区3个)原水与出厂水的多环芳烃物质的种类和含量进行了测定,并对主城某水厂两套常规处理工艺各工段PAHs的分布和水平进行了分析评价.结果表明,6个水厂的原水和出厂水中检出了萘、菲、蒽、芘、荧蒽、二氢苊共6种PAHs,其中萘、蒽、荧蒽检出率较高,枯水期含量水平在1～40 ng/L.PAHs经2种常规的水处理工艺后,浓度有所降低.但滤后水经加氯消毒等工序后,PAHs浓度有所增加.     

Formation of multiple trimethylsilyl derivatives in the derivatization of 17α-ethinylestradiol with BSTFA or MSTFA followed by gas chromatography-mass spectrometry determination

N,O-bis（trimethylsily）trifluoroacetamide （BSTFA） and N-methyl-N（trimethylsily） trifluoroacetamide （MSTFA） are common derivatization reagents used in the GC-MS analysis of estrogen steroids such as estrone （El） and 17α-ethinylestradiol （EE2）. In this study, three trimethylsilyl （TMS） steroid derivatives, mono- and di-trimethylsilyl EE2 and mono-trimethylsilyl El, were observed during the derivatization of EE2 with BSTFA or MSTFA and/or GC separation. Factors influencing the production of multiple TMS derivatives and their relative abundance were examined. It was found that both methanol and bisphenol A competed with estrogenic esteroids when reacting with silylation reagents, and thus affected the formation of TMS derivatives and their relative abundance in the derivatization products. Methanol was found to be more reactive than bisphenol A with the BSTFA reagent. None of the three solvents tested in this study could prevent the generation of multiple TMS derivatives during the derivatization of EE2 with BSTFA, followed by GC analysis. A similar result was observed using MSTFA as the derivative reagent followed by GC analysis. Thus, the suitability of BSTFA or MSTFA as the derivatization reagent for the determination of E1 and EE2 by GC-MS, under the conditions reported here, is questionable. This problem can be solved by adding trimethylsilylimidaz （TMSI） in the BSTFA reagent as recommended, and the performance of the method has been proved in this study.     

Determination of Acaricide Residues in Saudi Arabian Honey and Beeswax Using Solid Phase Extraction and Gas Chromatography

Determination of acaricide residues of flumethrin, tau-fluvalinate, coumaphos, and amitraz in honey and beeswax was carried out using a rapid extraction method utilizing C-18 SPE cartridges and an analytical method utilizing GC with ECD, NPD, and MSD detectors for the four acaricides. Recovery percentages from the extraction method ranged from 90–102%, while the minimum detection levels ranged from 0.01–0.05 mg/kg for the acaricides. Nine of the 21 analyzed samples were found to be contaminated with the acaricides tau-fluvalinate and coumaphos. Neither flumethrin nor amitraz was detected in any of the honey or wax samples. Coumaphos was found only in honey samples in which two samples exceeded the tolerance levels set by EPA and EC regulations. It has not been detected in beeswax. Five honey samples and eight beeswax samples were found to be contaminated with tau-fluvalinate. One of the wax samples was contaminated with a relatively high residue of tau-fluvalinate and contained above 10 mg/kg.     

Determination of flame-retardant hexabromocyclododecane diastereomers in textiles

To establish a concise and rapid procedure to analyze hexabromocyclododecane (HBCD) diastereomers in flame-retarded textiles, three different methods of extraction—Soxhlet, ultrasonic, and soaking extractions with toluene and dichloromethane (DCM)—were compared. During Soxhlet extraction using toluene, the percent contribution of α-HBCD to total HBCDs increased slightly and that of γ-HBCD decreased, indicating that γ-HBCD was isomerized to some extent at the boiling point of toluene (110.6 °C). For ultrasonic extraction, the temperature of the water bath can easily increase over time during the procedure, which might lead to undesirable effects. Therefore, we considered soaking extraction with DCM to be the most facile procedure to analyze HBCD diastereomers in textiles. Using the method established in this study, commercially available textiles in Japan (n = 10) were analyzed to understand the actual composition of HBCD contents and its diastereomer profiles. With the exception of one textile sample, HBCDs were detected in all the samples analyzed, with concentrations ranging from 22 000 to 43 000 mg kg⁻¹ (i.e. 2.2–4.3%). We found a higher proportion of the α-diastereomer in most textile products compared with that of commercial HBCD mixtures, indicating that γ-HBCD isomerized to α-diastereomer by heating processes to incorporate the commercial formulation into treated materials or that the α-diastereomer preferentially absorbed onto textile materials during the manufacturing of flame-retarded consumer products.     

Persistence of C-labeled atrazine and its residues in a field lysimeter soil after 22 years

Twenty-two years after the last application of ring-¹⁴C-labeled atrazine at customary rate (1.7 kg ha⁻¹) on an agriculturally used outdoor lysimeter, atrazine is still detectable by means of accelerated solvent extraction and LC-MS/MS analysis. Extractions of the 0-10 cm soil layer yielded 60% of the residual ¹⁴C-activity. The extracts contained atrazine (1.0 μg kg⁻¹) and 2-hydroxy-atrazine (42.5 μg kg⁻¹). Extractions of the material of the lowest layer 55-60 cm consisting of fine gravel yielded 93% of residual ¹⁴C-activity, of which 3.4 μg kg⁻¹ was detected as atrazine and 17.7 μg kg⁻¹ was 2-hydroxy-atrazine. The detection of atrazine in the lowest layer was of almost four times higher mass than in the upper soil layer. These findings highlight the fact that atrazine is unexpectedly persistent in soil. The overall persistence of atrazine in the environment might represent a potential risk for successive groundwater contamination by leaching even after 22 years of environmental exposure.     

吹扫捕集-GC/MS-SIM法测定海水中挥发性有机污染物

采用吹扫捕集 -GC/MS -SIM法测定水中挥发性有机物 ,具有定量准确、操作简便等特点 ,检测限可达ng/L级 ,适合环境水中低浓度挥发性有机物的测定。测定实际海水样品 ,其浓度范围在 0 4ng/L～ 1 0 0 0ng/L之间。     

气相色谱/质谱法测定水中五氯酚

用GC/MS法测定环境水体和废水中的五氯酚 ,选择乙酸酐作衍生化试剂 ,二氯甲烷为萃取剂 ,比较了不同的衍生pH条件 ,以m/z为 2 6 6的定量特征离子定量 ,获得了较高的灵敏度和选择性     

地表水中氨基甲酸酯农药及代谢物的快速、灵敏分析方法研究

利用固相萃取-超高效液相色谱/串联质谱,建立水样中痕量氨基甲酸酯农药及代谢物的分析方法.该方法在5min之内完成15种目标物的分析;加标回收率为80.4%～120.7%,相对标准偏差为0.7%～12.0%;检测限为0.005～0.2ng/L;在0.002～0.2μg/ml浓度范围内具有很好的线性.该方法具有快速、灵敏的特点.     

吹扫捕集-气相色谱质谱法测定地表水中12种氯苯类有机物

采用吹扫捕集-气相色谱质谱联用法测定地表水中的12种氯苯类有机污染物,特别是一些半挥发性的多氯苯化合物如五氯苯、六氯苯等。在室温下分析时,当进样体积为25.0 mL,吹扫时间为11 min,解析时间为3 min,采用全扫描方式定量分析时,方法检出限为0.02~1.50μg/L。不同浓度水平的加标回收率为86.0%~113%,相对标准偏差为1.3%~17.5%;实际样品加标回收率为84.4%~119%,相对标准偏差为2.2%~18.9%。该法具有简便高效、灵敏度高、有机溶剂用量少等优点,适用于饮用水和地表水中氯苯类化合物的测定,并为突发性环境污染事件氯苯类有机物的快速响应提供了一种快速有效的检测方法。