尿中氚水和总氚的对比分析测定研究

用蒸馏液闪法测量尿中氚水浓度 ,用氧化蒸馏液闪法测量尿中总氚 (氚水和有机氚 )浓度。同时测量了 1999年核设施退役时接触氚人员的高于本底水平的尿中氚水和总氚浓度 72个样品。比较氚水和有机氚浓度 ,得到有机氚浓度占氚水浓度的平均值为 (5 4± 3 7) % ,其值与理论值和动物实验值基本相符     

MANGANESE CYCLE IN IMPOUNDMENT WATER

Manganese entering impounded water will undergo a cyclic transformation. Oxidation precipitates manganese from top waters. At the bottom of the lake, biological activity will render manganese soluble by both intracellular as well as extracellular activity. The study was made to demonstrate that biological reduction and transformation, organometallic complexation, together with the presence of carbon dioxide and the lowering of pH all have some effect on the solubility of manganese. Dissolved manganese may be brought back to top waters during the lake overturn and therefore deteriorates the water quality.     

Investigation the effect of adding graphene oxide into diesel/higher alcohols blends on a diesel engine performance

ABSTRACT

This article aims to study the influence of the addition of graphene oxide nanoparticles (GO) to diesel/higher alcohols blends on the combustion, emission, and exergy parameters of a CI engine under various engine loads. The higher alcohols mainly n-butanol, n-heptanol, and n-octanol are blended with diesel at a volume fraction of 50%. Then, the 25 and 50 mg/L concentrations of GO are dispersed into diesel/higher alcohols blends using an ultrasonicator. The GO structures are examined using TEM, TGA, XRD and FTIR. The findings show that there is a reduction in p_max. and HRR when adding higher alcohols with diesel fuel. Regarding engine emission, there is a significant improvement in emissions formation with adding higher alcohols. The addition of GO into diesel/higher alcohols blends improves the brake thermal efficiency by 15%. Moreover, the p_max. and HRR are both enhanced by 4%. The CO, UHC and smoke formation are reduced considerably by 40%, 50 and 20%, respectively, while NO_x level is increased by 30% with adding GO. Finally, adding high percentages of n-butanol, n-heptanol, and n-octanol with diesel fuel with the presence of GO has the potential to achieve ultra-low CO, UHC, and smoke formation meanwhile keeping high thermal efficiency level.     

Ethoxylated Soybean Polyols for Polyurethanes

Soybean polyols prepared by ring opening reactions of epoxidized soybean oil with hydrogen active compounds (water, alcohols, organic or inorganic acids, thiols, hydrogen etc.) have a low reactivity in the reaction with isocyanates because the hydroxyl groups are secondary. This paper presents a simple and convenient method to increase the reactivity of soybean polyols with secondary hydroxyl groups by ethoxylation reactions with the preservation of triglyceride ester bonds. The method uses mild reaction conditions: low alkoxylation temperature of 35–45 °C, low pressure of 0.1–0.2 MPa (15–30 p.s.i.) and a superacid as catalyst (HBF₄). The new soybean polyols have a higher reactivity toward isocyanates in polyurethane formation due to the high percentage of primary hydroxyl groups. The primary hydroxyl content was determined by the second order kinetics of polyol reaction with phenyl isocyanate.     

Technetium: A toxic waste product of the nuclear fuel cycle: Effects on soybean growth and development

Technetium-99 (⁹⁹Tc) is formed in significant amounts (6.2% fission yield) during fission in both nuclear reactors and nuclear bombs. The effects of technetium on soybeans (Glycine max) were studied in relation to (a) cytochemical events in the apical meristems of germinating seedlings; (b) growth responses to 0, 0.04, 0.2, 1.0, 5.0, and 20.0 ppm Tc; (c) growth responses to varying levels of Tc after a prior 5-day germination on Tc-free media, and (d) response to Tc in the presence of added manganese.By 20 days, reductions in growth were evident at all levels of Tc except 0.04 ppm (Experiment 2). Root growth was most severely affected, and seedling abnormality at 20 ppm was fivefold greater than that of the controls. The effect of 20 ppm Tc was evident at 10 days when the accumulated absorption dose was approximately 25 rads. The first evidence of damage at this dose was a delay in the initiation of the first trifoliate leaf. The shoot meristem size was 1.2-fold smaller than that of the control; however, there was no cytological evidence of radiation-induced damage. Observation of mitotic figures did not reveal any chromosome aberrations, micronuclei, or chromosome bridges. The lowest level of Tc showing toxicity was 0.2 ppm which resulted in a 31% reduction in growth at 20 days. The accumulated dose was 0.5 rad (0.025 rad/day) and thus it seems unlikely that the rapid inhibition of growth and development is due to radiological toxicity. It is quite probable that the growth effects are due to chemical toxicity possibly due to nutrient competition and/or substitution in uptake or metabolism. However, extremely low doses of radiation have been shown to delay the onset of DNA synthesis (possibly by membrane effects) inTradescantia and until the actual mechanism of Tc inhibition is determined a radiation effect cannot be totally ruled out.This research was partially supported by ERDA Contract EY-76-S-02-4139     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl)，探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备，对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析，分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀，同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏，导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中，在合金的亚表面发生内氧化、内硫化以及内氯化反应，横截面上出现明显的腐蚀层，其主要由氧化物以及硫化物组成。随着热腐蚀的进行，DD6表面物质发生了剥蚀，沉积盐量的增加导致剥蚀现象越加严重，合金内部致密的组织结构也被破坏，横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下，周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关，相同涂盐方式下，涂盐量越大，DD6热腐蚀更加严重。涂盐量一定时，周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法，且DD6在上述热腐蚀条件下均发生剥蚀破坏。     

Role of nitric oxide in the genotoxic response to chronic microcystin-LR exposure in human–hamster hybrid cells

Microcystin-LR(MC-LR) is the most abundant and toxic microcystin congener and has been classified as a potential human carcinogen(Group 2B) by the International Agency for Research on Cancer. However, the mechanisms underlying the genotoxic effects of MC-LR during chronic exposure are still poorly understood. In the present study, human–hamster hybrid(AL) cells were exposed to MC-LR for varying lengths of time to investigate the role of nitrogen radicals in MC-LR-induced genotoxicity. The mutagenic potential at the CD59 locus was more than 2-fold higher(p 0.01) in ALcells exposed to a cytotoxic concentration(1 μmol/L) of MC-LR for 30 days than in untreated control cells, which was consistent with the formation of micronucleus. MC-LR caused a dose-dependent increase in nitric oxide(NO) production in treated cells. Moreover, this was blocked by concurrent treatment with the NO synthase inhibitor NG-methyl-L-arginine(L-NMMA), which suppressed MC-LRinduced mutations as well. The survival of mitochondrial DNA-depleted(ρ0) ALcells was markedly decreased by MC-LR treatment compared to that in ALcells, while the CD59 mutant fraction was unaltered. These results provided clear evidence that the genotoxicity associated with chronic MC-LR exposure in mammalian cells was mediated by NO and might be considered as a basis for the development of therapeutics that prevent carcinogenesis.     

新型纳米结构铈锰复合氧化物的磷吸附行为与机制研究

采用共沉淀法制备了一种新型铈锰复合氧化物吸附剂,对其进行了表征,并对磷吸附行为与机制进行了研究.表征结果分析表明,此氧化物由纳米级颗粒组成;铈锰复合氧化物中的铈氧化物有类似水合氧化铈的无定形结构;BET比表面积为157 m2·g-1,等电点为6.5.吸附实验结果表明,Langmuir吸附等温线模型可以更好地拟合铈锰复合氧化物对磷的吸附,最大吸附量为28.6 mg·g-1(p H=7.0);铈锰复合氧化物对磷具有较高的吸附速率,更符合准二级动力学模型;溶液p H对铈锰复合氧化物吸附磷的影响较为明显,随p H升高,吸附量降低;离子强度则影响不大;共存阴离子对吸附影响的大小顺序为Si O2-3CO2-3Cl-≥SO2-4.通过对铈锰复合氧化物吸附磷前后Zeta电位和红外谱图(FTIR)分析,可以推断磷在铈锰复合氧化物表面发生了特性吸附,磷酸根主要通过取代复合氧化物表面的金属羟基而被吸附去除.     

土壤及铁锰结核中锰氧化菌的氧化特性分析

利用从土壤铁锰结核及其附近土壤中分离筛选得到的4株锰氧化菌,研究了不同pH、Mn(Ⅱ)初始浓度下菌株的锰氧化效率及生长情况,并用SEM-EDS及TEM对菌株WHS26、GY16形成的生物氧化锰及水羟锰矿进行了表征.结果表明,pH及Mn(Ⅱ)初始浓度对菌株的锰氧化效率均有影响,4株菌在pH 7~8、Mn(Ⅱ)初始浓度为10~20 mmol·L-1时,锰氧化效率最高;GY16、WHS26形成的生物氧化锰的形貌与化学合成的水羟锰矿存在明显差异,前者呈胶膜状附着在菌株表面,后者呈结晶态.该结果可为生物氧化锰应用于重金属污染修复提供技术支撑.     

土壤颗粒对纳米TiO_2悬浮稳定性作用机制的实验研究

在不含表面活性剂和含有表面活性剂两种条件下,研究了土壤颗粒对纳米TiO2(nTiO2)悬浮稳定性的影响.结果表明,土壤颗粒降低了nTiO2在水相中的悬浮稳定性.当体系中不含表面活性剂时,nTiO2在土壤大颗粒上的沉积是导致nTiO2脱稳沉淀的主要原因.在含有表面活性剂的溶液中,土壤颗粒降低nTiO2悬浮稳定性的作用变得更加明显了.一方面,表面活性剂加速了土壤颗粒本身的沉降从而增强了nTiO2在其中的沉降,另一方面,表面活性剂在土壤上的强烈吸附促进了表面活性剂-nTiO2在土壤上的沉积.扫描电镜显示,nTiO2不仅吸附在土壤大颗粒上,还会吸附在土壤小颗粒表面.3种表面活性剂中,十六烷基三甲基溴化铵(CTAB)悬浮的nTiO2与土壤颗粒共沉淀现象最明显.除了土壤对CTAB的吸附作用之外,XDLVO/DLVO能量计算显示CTAB体系中土壤颗粒与nTiO2之间存在显著第二极小值,表明nTiO2能够在第二极小值位置与土壤颗粒结合,从而与土壤颗粒一起快速沉淀.