不同强度岩石中开挖圆形巷道的局部化过程模拟

利用FLAC模拟了不同粘聚力条件下圆形巷道的局部化过程。为了模拟巷道开挖,利用编写的F ISH函数删除巷道内部的单元。岩石服从莫尔库仑剪破坏与拉破坏复合的破坏准则,破坏之后呈现应变软化-理想塑性行为。文中模拟分为3步:首先,将静水压力施加在模型上,直到达到静力平衡状态;然后,利用编写的F ISH函数开挖巷道;最后,计算重新开始,直到达到静力平衡状态或者塑性流动状态。模拟结果表明,随着粘聚力的降低,巷道围岩的破坏模式首先由孔壁附近零星单元的破坏向4个对称的小V形坑式剪切破坏转变,然后由包含若干小V形坑的大V形坑式剪切破坏向巷道全断面的破坏转变。前三者破坏发生后,巷道围岩仍然能保持稳定。与最大塑性拉伸应变相比,最大剪切应变增量、最大塑性剪切应变要高得多;最大剪切应变增量、最大塑性剪切应变相差不大;随着粘聚力的增加,三者均越来越小。     

弹性滑移支座力学性能的试验研究

介绍了弹性滑移支座的原理、构造和特点;通过对其在不同工况下的性能试验,研究了竖向荷载、位移幅值以及加载频率对弹性滑移支座力学性能的影响,并给出了试验值与理论计算值之间的对比。研究结果表明:弹性滑移支座具有良好的工作性能,滞回曲线饱满,耗能能力强;竖向荷载和加载频率对弹性滑移支座的力学性能有一定的影响,而位移幅值对其影响较小;弹性滑移支座的恢复力模型,可以用考虑速度的指数摩擦力模型来描述,并且模拟得较为准确。     

基于《电力设施抗震设计规范》的地震动随机模型参数研究

依据《电力设施抗震设计规范》(GB50260-96)中的设计反应谱,对随机地震动功率谱参数的取值进行了具体研究。首先,采用时间包络函数考虑地震的非平稳特性,给出了地震动持时的取值;然后,根据加速度峰值等效原则,迭代计算得到地面的加速度功率谱密度曲线;最后,选定Clough-Penzien修正过滤白噪声模型作为拟合函数,通过非线性拟合技术拟合了与《规范》中的地震烈度、场地类别相对应的谱参数。研究结果表明,Clough-Penzien修正过滤白噪声模型能较好地拟合其曲线形状。本文给出了相对于规范中的地面加速度功率谱参数值,可供这种模型作为地震地面运动输入时选用。     

恐惧诉求对职业驾驶员安全驾驶态度和行为意向的影响

研究以EPPM模型作为理论框架,探讨恐惧诉求对危险驾驶行为(超速和不系安全带)态度和行为意向的作用。54名职业驾驶员在观看交通安全恐惧诉求录像后,完成安全驾驶行为问卷。回归分析表明恐惧诉求的交通事故录像能够改变驾驶员对超速及不系安全带驾驶的态度和行为意向,但作用不完全一致。恐惧情绪唤起通过恐惧情感所引发的威胁评估过程中介对不超速行为意向的影响。最后,对研究的局限和未来的研究进行讨论。     

Effect of Sweating on Insulation of Footwear

The study aimed to find out the influence of sweating on footwear insulation with a thermal foot model. Simultaneously, the influence of applied weight (35 kg), sock, and steel toe cap were studied. Water to 3 sweat glands was supplied with a pump at the rate of 10 g/hr in total. Four models of boots with steel toe caps were tested. The same models were manufactured also without steel toe. Sweating reduced footwear insulation 19–25% (30–37% in toes). During static conditions, only a minimal amount of sweat evaporated from boots. Weight affected sole insulation: Reduction depended on compressibility of sole material. The influence of steel toe varied with insulation. The method of thermal foot model appears to be a practical tool for footwear evaluation.     

Determination of Heat Loss from the Feet and Insulation of the Footwear

This study compared the methods of determining footwear insulation on human participants and a thermal foot model. Another purpose was to find the minimal number of measurement points on the human foot that is needed for insulation calculation. A bare foot was tested at 3 ambient temperatures on 6 participants. Three types of footwear were tested on 2 participants. The mean insulation for a bare foot obtained on the participant and model were similar. The insulation of warm footwear measured by the 2 methods was also similar. For thin footwear the insulation values from the participants were higher than those from the thermal model. The differences could be related to undefined physiological factors. Two points on the foot can be enough to measure the insulation of footwear on human participants (r = .98). However, due to the big individual differences of humans, and good repeatability and simplicity of thermal foot method, the latter should be preferred for testing.     

A Comparison of Two Methods of Determining Thermal Properties of Footwear

The present European Standard for footwear testing (Standard No. EN 344:1992; European Committee for Standardization [CEN], 1992) classifies footwear thermally by a temperature drop inside the footwear during 30 min at defined conditions. Today, other methods for footwear thermal testing are also available. The aim of this study was to compare EN 344:1992 with a thermal foot method. Six boots were tested according to both methods. Additional tests with modified standard tests were also carried out. The methods ranked the footwear in a similar way. However, the test according to standard EN 344:1992 is a pass-or-fail test, whereas data that is gained from the thermal foot method gives more information and allows further use in research and product development. A change of the present standard method is suggested.     

扬沸火灾发生时间预测模型的建立与应用分析

原油储罐扬沸火灾由池火灾发展而成,是一种危害性极大的事故.准确预测扬沸事故发生的时间,是扬沸机理研究中的难题之一.现有扬沸时间计算的通用模型由于没有考虑油品的粘性作用,计算结果误差较大.把扬沸火灾简化为无内热源的非稳态传热问题,在此基础上进行传热分析,进而推导出扬沸事故时间计算模型.设定了6组不同尺寸和不同充装水平的原油储罐池火灾,利用推导模型计算出了相应的扬沸事故发生时间.将计算结果与通用模型计算结果以及实验结果进行对比:该模型的准确性由于通用模型,计算结果与实验值误差较小,较为合理.研究结果对于扬沸火灾事故下消防人员的灭火救援的安全保障具有重要意义.     

基于累积Logistic回归模型对化工园区人群认知风险的研究

随着化工园区重大危险源集中监管的深化,政府和企业在安全生产活动中扮演着比以往更重要的角色.如何降低园区内人群对危险源的敏感性,以便在有谣言时不会伴随更大的混乱;什么样的因素对园区内人群认知风险具有显著相关性,以便政府和企业在安全生产活动中更好地发挥职能.针对上述问题,通过对江西省某化工园区进行问卷调查,所得的数据采用累积logistic模型进行分析,得出对风险认知具有显著性差异的因素.有助于政府及企业管理人员对园区内人群认知风险的了解,建议化工园区以及政府需要进一步宣传安全知识,配套安全设备等,最终降低谣言对生产活动的影响、冲击,稳定社会秩序.