SBR法处理低C/N污水的工程应用——以某基地污水处理站改造工程为例

低C/N污水的生化处理过程中,由于碳源不足,不能满足硝化和反硝化的要求,造成出水NH3-N超标。采用SBR工艺对某基地污水处理站厌氧处理后的低C/N污水进行改造,处理后出水COD去除率达到97%以上,NH3-N去除率达到93%以上。     

微波消解-火焰原子吸收分光光度法测定固体废物中的钡

采用微波消解法对固体废物浸出液样品进行前处理,采用乙炔-空气火焰原子吸收法测定钡的含量,检出限为2．04mg／L,加标回收率为94．5％,精密度为4．85％-6．81％。     

An efficient technology to treat heavy metal--lead--contaminated soil by microwave radiation

Microwave (MW) technology can be used to vitrify contaminated soil wastes and immobilize heavy metal ions in soils. More than 93% of the Pb(II)-contaminated soil was vitrified to a glass/ceramic formation after 30 min of MW radiation. In a 6-year study, the Pb(II) concentration of the vitrified soil in the leaching test was less than 1.0 mg/l, which is substantially below the USEPA regulatory limit of 5.0 mg/l.     

The role of analogues in radioecology

If no data are available for a specific radionuclide its analogue could be used in radioecological models. They might be used not only in the frame of screening modelling. Relevant processes and features have to be known, such as time scales of these processes, physical, chemical and biological properties of the environment and relevant media. An analogue could only be proven to be valid by comparing its behaviour in the conditions of interest, while confidence in the validity of an analogue will increase as the quality of the justification increases, there will always be some residual uncertainty. Several main types of analogy can be used when measured or recommended values are not available: the same parameter obtained for another isotope of the same element; the same parameter obtained for another element; a different parameter obtained for the same element. There are several cases, when analogues might be applied as indicators of the determining processes in the radioecological studies.     

Application of lime and calcium hypochlorite in the dephenolisation and discolouration of olive mill wastewater

The application of hypochlorite for the removal of soluble COD, phenolic and polyphenolic like compounds, and other organic compounds responsible for the olive mill wastewater (OOWW) colour has been experimentally studied. After the OOWW filtration on a sand column, the effluent was subjected to a fast liming under optimal conditions. Lime application reduced polyphenols, COD and SS contents to half of their initial values but an important blackening of the treated OOWW was observed, especially when adding high concentrations of lime (10% (W/V) and 15% (W/V)).A second stage of treatment was applied using calcium hypochlorite. In this stage, removal of the studied compounds reached as much as 95% at higher concentrations, and particularly the colouring of OOWW which is generally difficult to eliminate was greatly reduced. The OOWW hypochloration acted through coagulation–flocculation and a rapid oxidation of the organic matter proceeded from the first 5 min. The kinetic study of the degradation of the waste polluting compounds from liming showed that Ca(ClO)₂ reacts similarly in the elimination of organic compounds, polyphenols, SS and colouration. The analysis of the organochloride compounds generated by the reaction between hypochlorite and the organic compounds showed that DDD, DDT and the heptachlor contents exceeded the values recommended by the International and European drinking water standards.     

Process design optimization and risk analysis

Hazard identification and risk assessment are key aspects in process plant design. They are often applied in the final stages of the process at whatever the cost, unless financial constraints are imposed. However, a much better solution would be to introduce risk analysis earlier by including it in earlier stages of the design process, such as when the cost of a plant and the cost of any accidents that may occur are estimated. In this paper, an optimization methodology is proposed, in which both cost and risk (with a deterministic approach) are taken into account, to improve on the current situation. If a decision variable is chosen, an objective function will be established that makes it possible to analyze variations in overall costs, including the cost of the investment and the cost of accidents. This leads to an optimum situation in which costs are kept to a minimum. Of course, this optimization is subject to constraints, the greatest of which is the fact that risk must not exceed tolerated threshold levels. The procedure is explained and two examples, one involving a toxic release and the other a BLEVE/fireball, are used to illustrate it.     

吨量煤体的自燃过程实验模拟研究

为更好地弄清矿井实际的煤自然发火规律,利用装煤量达5吨的大型实验台对两种烟煤分别进行了自燃模拟实验。大煤量的实验能够很好地模拟煤矿中煤低温氧化和传热传质共同作用导致的发火过程,实验得到的自然发火期与煤矿实际发火期也是一致的。实验中煤样从缓慢氧化变为快速氧化的临界温度为100～110℃。当煤温低于,临界温度时,煤样的升温受到空气流带走热量和向外界散热的影响很大,因此夹层水的保温作用就很关键。当煤温超过临界温度后,反应加快,温度急剧上升,散热的影响明显降低,反应主要受限于氧气的供应情况。     

生物倍增工艺同步脱氮除磷强化途径分析

通过对生物倍增工艺处理市政污水的沿程污染物降解规律的考察表明,工艺对有机物的去除效果显著,COD和BOD5出水分别为47.80 mg/L和19.80 mg/L;氨氮去除率可达100%。发现厌氧区提前发生反硝化并一定程度上影响系统除磷效果;通过对各主要影响因素进行分析,认为低碳源的进水条件是影响系统同步脱氮除磷效果的关键因素;提出在进水口直接添加碳源以及分点进水的碳源分配＋辅助化学除磷的方式可强化氮磷去除效果。     

Dechlorination of PCBs in the simulative transformer oil by microwave-hydrothermal reaction with zero-valent iron involved

The conventional hydrothermal reaction with iron powder, NaOH and H₂O as reactants was reported to occur at temperature above 423 K, and iron oxides (Fe₃O₄ and NaFeO₂) and hydrogen were produced. In this study, microwave heating was adopted to take the place of conventional heating to induce the hydrothermal reaction. Under microwave irradiation, NaOH and H₂O absorbed microwave energy by space charge polarization and dipolar polarization and instantly converted it into thermal energy, which initiated the hydrothermal reaction that involved with zero-valent iron. X-ray diffraction (XRD) analysis found Fe₃O₄/NaFeO₂ and confirmed the occurrence of microwave-induced hydrothermal reaction. The developed microwave-hydrothermal reaction was employed for the dechlorination of PCBs. Hexadecane containing 100 mg L⁻¹ of Aroclor1254 was used as simulative transformer oil, and the dechlorination of PCBs was evaluated by GC/ECD, GC/MS and ion chromatography. For PCBs in 10 mL simulative transformer oil, almost complete dechlorination was achieved by 750 W microwave irradiation for 10 min, with 0.3 g iron powder, 0.3 g NaOH and 0.6 mL H₂O added. The effects of important factors including microwave power and the amounts of reactants added, on the dechlorination degree were investigated, moreover, the dechlorination mechanism was suggested. Microwave irradiation combined with the common and cheap materials, iron powder, NaOH and H₂O, might provide a fast and cost-effective method for the treatment of PCBs-containing wastes.     

Biodegradable chelate enhances the phytoextraction of copper by Oenothera picensis grown in copper-contaminated acid soils

Oenothera picensis plants (Fragrant Evening Primrose) grow in the acid soils contaminated by copper smelting in the coastal region of central Chile. We evaluated the effects of the biodegradable chelate MGDA (methylglycinediacetic acid) on copper extraction by O. picensis and on leaching of copper through the soil profile, using an ex situ experiment with soil columns of varying heights. MGDA was applied in four rates: 0 (control), 2, 6 and 10 mmol plant⁻¹. MGDA application significantly increased biomass production and foliar concentration, permitting an effective increase in copper extraction, from 0.09 mg plant⁻¹ in the control, to 1.3 mg plant⁻¹ in the 6 and 10 mmol plant⁻¹ treatments. With 10 mmol plant⁻¹ rate of MGDA, the copper concentration in the leachate from the 30 cm columns was 20 times higher than in the control. For the 60 cm columns, copper concentration was 2 times higher than the control. It can be concluded that at increased soil depths, copper leaching would be minimal and that MGDA applications at the studied rates would not pose a high risk for leaching into groundwater. It can thus be stated that applications of MGDA are an effective and environmentally safe way to improve copper extraction by O. picensis in these soils.