碱减量-印染混合废水的预处理研究

针对碱度大、COD高、组成复杂的碱减量-印染混合废水,采用高碱度下直接混凝再酸析相结合的方法进行预处理,取得理想效果.试验结果表明,在高碱度条件下先加入镁盐及少量高分子絮凝剂,可去除大部分可溶性及不溶性污染物;再通过降低pH的酸析法,能有效去除废水中的色度、浊度,大大降低COD.在MgSO4用量为800～1 500 mg/L,阴离子聚丙烯酰胺用量为2 mg/L,酸析pH小于3.0时,色度去除率达97%,COD去除率达92%,浊度去除率近100%.     

细菌脱氢酶活性生物测试法用于水质毒性检测的改进

从培养基配方、菌种来源、激活时间、菌液用量以及检测方式等几个方面对脱氢酶快速毒性检测法进行了改进,确定了整个体系的操作方法。并用HgCl2和NaN3验证了改进后方法的可行性。结果表明,以天然地表水作为菌种来源,转接培养1次后,混合细菌的脱氢酶活性的稳定性便可达到实验要求。样品液与菌液按照6∶1的比例混合效果较好。混合体系在37℃恒温培养箱中激活50min以上细菌可完全活化,最终检测可用普通分光光度计进行。改进后的方法解决了原方法菌液失活过快,实验稳定性较差的问题,同时克服了检测仪器难以购买的问题,使这一方法得以在普通实验室实现。     

SOME SIMPLE MODELS FOR CONTINUOUS VARIATE TIME SERIES1

ABSTRACT: A survey is given of recently developed models for continuous variate non–Gaussian time series. The emphasis is on marginally specific models with given correlation structure. Exponential, Gamma, Weibull, Laplace, Beta and Mixed Exponential models are considered for the marginal distributions of the stationary time series. Most of the models are random coefficient, additive linear models. Some discussion of the meaning of autoregression and linearity is given, as well as suggestions for higher–order linear residual analysis for non–Gaussian models.     

混合微电解-生物铁-气浮法处理印染废水

印染行业的废水具有高浓度、高色度和含有大量难降解有机物的特点,属于难降解、重污染工业废水,如采用传统处理工艺,很难达到国家一级排放标准.实践证明,采用混合微电解 生物铁 气浮法处理此类生产废水,CODCr去除率达97%,色度去除率达98%.同时,该工艺具有占地面积小,脱色效果好,处理效率高等特点,能广泛应用于纺织印染废水处理的实际工程中.     

微生物絮凝剂产生菌的筛选及产絮凝剂的周期研究

用常规的分离、纯化方法 ,从活性污泥中共分离出 32株菌株。将单菌株分别培养于“JM- 1”、“DF-1”、“PT- 1”液体培养基中 ,摇床培养一定时间后 ,以高岭土悬浊液筛选具有絮凝活性的菌种 ,由此获得 8株微生物絮凝剂产生菌 ,其中有 1株絮凝活性较高 ,初步鉴定为酵母菌 ,代号为“Dfjm- 1”,产生的絮凝剂命名为“Dtjm-1”。本文研究了“Dfjm- 1”在不同培养时间的生长情况、培养液中 p H值变化情况及絮凝活性变化情况 ,得出絮凝活性与菌生长量呈正相关关系 ,絮凝剂“Dtjm - 1”在菌生长稳定后期达到稳定活性的最高值     

微生物絮凝剂的研究现状和成果

通过分析目前国内外微生物絮凝的研究现状 ,归纳了微生物絮凝剂的一般研究方法 ,综述了微生物絮凝剂的研究成果 ,并提出了微生物絮凝剂研究中亟待解决的问题和建议     

微生物絮凝剂净化废水实验研究

文章主要研究从实验室得到的三种微生物絮凝剂A91、A92、A2净化各种废水的效果及净化条件.在实验过程中应用单因素测定与正交实验方法相结合,确定了微生物絮凝剂的最佳投加量、最佳絮凝pH值、最佳助凝剂及助凝剂的最佳量.净化的废水有高岭土悬浊液,土壤悬浊液,涂料废水碳素墨水地表废水及生活污水(主要研究了前三种废水).从实验结果来看,实验研究证实了所研制出的微生物絮凝剂主要是对高岭土悬浊液、土壤悬浊液和涂料废水有很好的净化效果,最高絮凝率达98.0%.且絮凝的pH值一般都在7.0～8.0 范围,絮凝剂的投加量为1.0 ml～2.0 ml(水样为100 ml),在絮凝剂作用上,Ca2 比Fe2 、Mg2 、Al3 等其他离子效果好,而且CaO的效果明显优于CaCl2.微生物絮凝剂应用于废水处理有很好的前景.     

Cosolvent effects on sorption isotherm linearity

Sorption-desorption hysteresis, slow desorption kinetics, and other nonideal phenomena have been attributed to the differing sorptive characteristics of the natural organic polymers associated with soils and sediments. In this study, aqueous and mixed solvent systems were used to investigate the effects of a cosolvent, methanol, on sorption isotherm linearity with natural organic matter (NOM), and to evaluate whether these results support, or weaken, the rubbery/glassy polymer conceptualization of NOM. All of the sorption isotherms displayed some nonlinear character. Our data indicates that all of the phenanthrene and atrazine isotherms were nonlinear up to the highest equilibrium solution concentration to solute solubility in water or cosolvent ratios (Ce/Sw,c) used, approximately 0.018 and 0.070, respectively. Isotherm linearity was also observed to increase with volumetric methanol content (fc). This observation is consistent with the NOM rubbery/glassy polymer conceptualization: the presence of methanol in NOM increased isotherm linearity as do solvents in synthetic polymers, and suggests that methanol is interacting with the NOM, enhancing its homogeneity as a sorptive phase so that sorption is less bimodal as fc increases. When the equilibrium solution concentration was normalized for solute solubility in water or methanol-water solutions, greater relative sorption magnitude was observed for the methanol-water treatments. This observation, in conjunction with the faster sorption kinetics observed in the methanol-water sediment column systems, indicates that the increase in relative sorption magnitude with fc may be attributed to the faster sorption kinetics in the methanol-water systems, and hence, greater relative sorptive uptake for the rubbery polymer fraction of NOM at similar time scales.     

On the behaviour of the residence time at the bottom of the mixed layer

To understand why the findings of Deleersnijder et al. [(2006), Environ Fluid Mech 6: 25–42]—the residence time in the mixed layer in not necessarily zero at the pycnocline—are consistent with those of Delhez and Deleersnijder [(2006), Ocean Dyn 56:139–150]—the residence time in a control domain vanishes at the open boundaries of this control domain—, it is necessary to consider a control domain that includes part of the pycnocline, in which the eddy diffusivity is assumed to be zero. Then, depending on the behaviour of the eddy diffusivity near the bottom of the mixed layer, the residence time may be seen to exhibit a discontinuity at the interface between the mixed layer and the pycnocline. If such a discontinuity exists, the residence time is non-zero in the former and zero in the latter. This is illustrated by analytical solutions obtained under the assumption that the eddy diffusivity is constant in the mixed layer.     

IMPASEA: A methodological framework to monitor and assess the socioeconomic effects of marine protected areas. An English Channel case study

Marine protected areas (MPAs) are increasingly regarded as socio-ecological systems. In addition to their reported ecological effects, MPAs may have important social, economic and cultural effects on local communities and marine and coastal stakeholders. Those effects should be considered within an ecosystem approach to MPA planning, designation and management. Here we present a new framework to monitor and assess the socioeconomic effects of MPAs saliently and soundly: the Integrated MPA Socio-Economic Assessment (IMPASEA). The IMPASEA considers and analyses those factors deemed most important for marine and coastal stakeholders in a spatially referenced, sound and cost-effective manner. The development of the IMPASEA followed a mixed-methods research design in 3 phases: literature review, stakeholder survey and geo-statistical analysis using a Multiple-Paired-Before-After-Control-Impact design (MPBACI). The framework was tested on a set of 6 multiple-use MPAs on the French side of the English Channel. Of the eight socioeconomic variables analysed at the scale of ‘commune’ in the geo-statistical phase, only one variable (‘number of hotel rooms’) might have been affected by the designation of MPAs. Factors such as MPA designation category and management status are likely to have contributed to the non-significant differences shown at the scale of commune for the selected MPAs. In contrast, most of the six variables related to fishing showed differences between ports inside and outside MPAs, although these results need further ground truthing to discriminate attribution of effects. The characteristics of the IMPASEA make it a sound monitoring and assessment framework that could be applied in different contexts and to different types of sustainability assessments involving protected areas or other spatially-defined entities under certain conditions: existence of consistent time series of fine-scale socioeconomic data and avoidance of overlap of designation categories over single spaces.