Nitrous oxide emission from an agricultural field: Comparison between measurements by flux chamber and micrometerological techniques

The soil in a drained fjord area, reclaimed for arable farming, produced N₂O mainly at 75–105 cm depth, just above the ground water level. Surface emissions of N₂O were measured from discrete small areas by closed and open-flow chamber methods, using gas chromatographic analysis and over larger areas by integrative methods: flux gradient (analysis by FTIR), conditional sampling (analysis by TDLAS), and eddy covariance (analysis by TDLAS). The mean emission of N₂O as determined by chamber procedures during a 9-day campaign was 162–202 μg N₂ONm⁻²h⁻¹ from a wheat stubble and 328–467 μg N₂ONm⁻² h⁻¹ from a carrot field. The integrative approaches gave N₂O emissions of 149–495 μg N₂ONm⁻² h⁻¹, i.e. a range similar to those determined with the chamber methods. Wind direction affected the comparison of chamber and integrative methods because of patchiness of the N₂O emission over the area. When a uniform area with a single type of vegetation had a dominant effect on the N₂O gradient at the sampling mast, the temporal variation in N₂O emission determined by the flux gradient/FTIR method and chamber methods was very similar, with differences of only 18% or less in mean N₂O emission, well below the variation encountered with the chamber methods themselves. A detailed comparison of FTIR gradient and chamber data taking into account the precise emission footprint showed good agreement. It is concluded that there was no bias between the different approaches used to measure the N₂O emission and that the precision of the measurements was determined by the spatial variability of the N₂O emission at the site and the variability inherent in the individual techniques. These results confirm that measurements of N₂O emissions from different ecosystems obtained by the different methods can be meaningfully compared.     

(M)VOC and composting facilities. Part 1: (M)VOC emissions from municipal biowaste and plant refuse

GOAL, SCOPE AND BACKGROUND: Malodorous volatiles derived from the decomposition of biowaste within the process of composting might pose a risk to human health. Different techniques of process engineering have been developed to minimise the burden of malodorous compounds in air possibly affecting compost workers and residents in the vicinity. METHODS: In the present study, three different composting facilities were examined for the emission of volatiles to estimate the impact of process engineering on the dispersal of odorous compounds and to discuss its relevance for human health. RESULTS AND DISCUSSION: Concentrations of single compounds belonging to alcohols, ketones, furanes, sulfur-containing compounds and especially terpenes ranged from 10(2) up to nearly 10(6) ng/m3 depending on the sampling sites and the process engineering. The ratio of MVOC and total VOC measured changed throughout the process of biodegradation. A certain combination of volatile compounds coincided with the occurrence of typical compost odour. CONCLUSION: The type of process engineering seemed to have a major impact on the emission of volatiles, as amounts of (microbial) volatiles emitted were characteristic for the different techniques used. Thus, the MVOC emission basically depends on the degree of biodegradation. It is likely that the concentrations workers are exposed to can have an impact on human health. RECOMMENDATIONS AND OUTLOOK: It is obvious that less sophisticated types of process engineering give rise to greater amounts of bioaerosols and volatiles and, therefore, technical devices have to be improved and controlled regularly to minimise adverse health effects on workers.     

Studies on sampling methods for PCDDs and PCDFs in stack emission

Polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) in stack emission exist both as vapor and sorbed onto the surface of particles. The partition between the two phases is of a dynamic nature and changes rapidly with temperature. When monitoring stack emissions, a sampling method must be used that efficiently collects both phases as well as any condensation aerosol formed in the sampling train. In this study, the two sampling methods used in Sweden, the cooled probe polyurethane foam plug (PUFP) sampling train and the sampling train recommended by the Swedish Environmental Protection Board has been tested for particle collection ability. The results show that an aerosol filter has to be introduced after the condensor in order to collect particle bound PCDDs and PCDFs efficiently.     

Optimal spatial sampling schemes for environmental surveys

A practical problem in spatial statistics is that of constructing spatial sampling designs for environmental monitoring network. This paper presents a fractal-based criterion for the construction of coverage designs to optimize the location of sampling points. The algorithm does not depend on the covariance structure of the process and provides desirable results for situations in which a poor prior knowledge is available. The statistical characteristics of the method are explored by a simulation study while a design exercise concerning the Pescara area monitoring network is used to demonstrate potential designs under realistic assumptions.     

Asymptotics in adaptive cluster sampling

In this article we consider asymptotic properties of the Horvitz-Thompson and Hansen-Hurwitz types of estimators under the adaptive cluster sampling variants obtained by selecting the initial sample by simple random sampling without replacement and by unequal probability sampling with replacement. We develop an asymptotic framework, which basically assumes that the number of units in the initial sample, as well as the number of units and networks in the population tend to infinity, but that the network sizes are bounded. Using this framework we prove that under each of the two variants of adaptive sampling above mentioned, both the Horvitz-Thompson and Hansen-Hurwitz types of estimators are design-consistent and asymptotically normally distributed. In addition we show that the ordinary estimators of their variances are also design-consistent estimators.     

Moment and maximum likelihood estimators for Weibull distributions under length- and area-biased sampling

Many of the most popular sampling schemes used in forestry are probability proportional to size methods. These methods are also referred to as size-biased because sampling is actually from a weighted form of the underlying population distribution. Length- and area-biased sampling are special cases of size-biased sampling where the probability weighting comes from a lineal or areal function of the random variable of interest, respectively. Often, interest is in estimating a parametric probability density of the data. In forestry, the Weibull function has been used extensively for such purposes. Estimating equations for method of moments and maximum likelihood for two- and three-parameter Weibull distributions are presented. Fitting is illustrated with an example from an area-biased angle-gauge sample of standing trees in a woodlot. Finally, some specific points concerning the form of the size-biased densities are reported.     

Adaptive two-stage one-per-stratum sampling

We briefly describe adaptive cluster sampling designs in which the initial sample is taken according to a Markov chain one-per-stratum design (Breidt, 1995) and one or more secondary samples are taken within strata if units in the initial sample satisfy a given condition C. An empirical study of the behavior of the estimation procedure is conducted for three small artificial populations for which adaptive sampling is appropriate. The specific sampling strategy used in the empirical study was a single random-start systematic sample with predefined systematic samples within strata when the initially sampled unit in that stratum satisfies C. The bias of the Horvitz-Thompson estimator for this design is usually very small when adaptive sampling is conducted in a population for which it is suited. In addition, we compare the behavior of several alternative estimators of the standard error of the Horvitz-Thompson estimator of the population total. The best estimator of the standard error is population-dependent but it is not unreasonable to use the Horvitz-Thompson estimator of the variance. Unfortunately, the distribution of the estimator is highly skewed hence the usual approach of constructing confidence intervals assuming normality cannot be used here.     

Aqua regia extractable trace elements in surface soils of venezuela

Surface soils (0–15 cm) were sampled at 10–20 km intervals along two transects in Venezuela. One (1162 km, 70 samples) ran west to east parallel with the Caribbean coastline, the other (920 km, 92 samples) ran south to north from the frontier with Brazil to the Caribbean shore. Sampling took place in both a wet and a dry season. Trace metals were extracted from dried, sieved (<2 mm) soil with boiling aqua regia followed by analysis by ICP or flame AAS. Metal values did not differ significantly between the two seasons and dates were averaged. Geometric mean values for the west–east transect were: Cr=41.5, Cu 17.9, Cs 3.6, Li=13.9, Mn=294, Ni=21.3, Pb=17.4, Sr=39.4, V=60.4 and Zn = 83.7g g^–1, respectively. Similarly, for the south–north transect Cr=21.3, Cu=4.3, Cs=1.1, Li=2.0, Mn=55.7, Ni=4.4, Pb=6.1, Sr=13.3, V=28.2 and Zn=16.7g g^–1, respectively. A classification of samples by lithology showed surface soil composition to be related to rock composition. Metal values were low in the soils in the south of the country, in the Guyana highlands (Gran Sabana). Low Zn contents were prevalent. Lead contents were affected by roadside fallout from vehicles using leaded petrol except that high Pb contents of soils in the Gran Sabana were of more complex origin.     

大连地区生态植被所排放VOC的估算研究

根据实测的太阳总辐射在全波段的辐射照度Q（Wm^-2）估算出光合有效辐射照度UPAR（μmolm^-2S^-1）,利用各类植物的排放因子,估算出大连地区生态植被所排放的VOC,结果表明,生态植被所排放VOC的日变化规律即与植物本身有关又与气温和太阳辐射有关,区域内年排放VOC的总量为256.5t。     

Prenatal diagnosis of hemoglobinopathies in twin pregnancies by double simultaneous fetoscopy

A new technique for sampling fetal blood in twin pregnancies using two fetoscopes simultaneously is described. Two fetoscopes were inserted, one after the other, into both amniotic cavities and fetal blood samples were obtained from either the chorionic plate vessels or the umbilical cord insertion area. The observation of the bright tip of the second fetoscope behind the septum using the first fetoscope assured the successful entry of the two fetoscopes into the two different amniotic sacs. This technique was performed on 15 out of 17 patients. In all patients the fetuses were at risk of β-thalassemia major. Sampling was successful in all cases. Double simultaneous fetoscopy seems to be a safe and accurate technique without technical problems or complications. The simultaneous use of two fetoscopes opens new possibilities in intrauterine fetal surgery and research.