生物反应器填埋场渗滤液及其处理对策

根据垃圾的降解和稳定机理分析了生物反应器填埋场渗滤液的动态变化规律，并对其处理对策进行了探讨。生物反应器填埋场前期产生的渗滤液可全部回灌，后期再根据实际情况排放处理部分过量的渗滤液。在对渗滤液水量和水质全面直观认识后，再对生物反应器填埋场渗滤液处理工艺进行针对性的选择和设计，并宜采用物化法处理方式。     

预处理对城市固体有机垃圾厌氧发酵的影响

对近年来城市固体有机垃圾厌氧消化的各种预处理技术和发展趋势进行了综合分析和评述.研究认为,通过预处理能够改善城市固体有机物的物化性质,提高微生物对难降解有机物的降解,优化垃圾的厌氧消化过程.     

Environmental effects and risk control of antibiotic resistance genes in the organic solid waste aerobic composting system: A review

• ARGs were detected in livestock manure, sludge, food waste and fermentation dregs. • The succession of microbial community is an important factor affecting ARGs. • Horizontal transfer mechanism of ARGs during composting should be further studied. Antibiotic resistance genes (ARGs) have been diffusely detected in several kinds of organic solid waste, such as livestock manure, sludge, antibiotic fermentation residues, and food waste, thus attracting great attention. Aerobic composting, which is an effective, harmless treatment method for organic solid waste to promote recycling, has been identified to also aid in ARG reduction. However, the effect of composting in removing ARGs from organic solid waste has recently become controversial. Thus, this article summarizes and reviews the research on ARGs in relation to composting in the past 5 years. ARGs in organic solid waste could spread in different environmental media, including soil and the atmosphere, which could widen environmental risks. However, the conventional composting technology had limited effect on ARGs removal from organic solid waste. Improved composting processes, such as hyperthermophilic temperature composting, could effectively remove ARGs, and the HGT of ARGs and the microbial communities are identified as vital influencing factors. Currently, during the composting process, ARGs were mainly affected by three response pathways, (I) “Microenvironment-ARGs”; (II) “Microenvironment-microorganisms-ARGs”; (III) “Microorganisms-horizontal gene transfer-ARGs”, respectively. Response pathway II had been studied the most which was believed that microbial community was an important factor affecting ARGs. In response pathway III, mainly believed that MGEs played an important role and paid less attention to eARGs. Further research on the role and impact of eARGs in ARGs may be considered in the future. It aims to provide support for further research on environmental risk control of ARGs in organic solid waste.     

厌氧-好氧生物反应器填埋工艺特性研究

基于生物反应器填埋技术,研究1种填埋场地循环操作的厌氧-好氧生物反应器填埋工艺,设计了该工艺模拟装置并研究了其运行工艺特性.厌氧阶段主要通过渗滤液回灌控制反应器工艺条件,主要试验结果为,pH值,R1在 6周后可上升至6.7～7.8,R2在17周内一直低于6.8;渗滤液COD浓度,R1在13周时下降至10?617 mg/L,R2在5周后上升至60?000 mg/L后长期趋于稳定;填埋气累计产量,R1在8周达到44%,R2几乎不产气.衡量稳定化可以分别采用渗滤液pH、COD浓度及BOD₅/COD的减少率、填埋气的累计产率等指标来判断,并据此转换为好氧填埋运行.好氧阶段主要是通过强制通风来减少恶臭和水分,主要试验结果为,通风19d氨气浓度降为1.16 mg/m³,通风23d后恶臭浓度降为19;通风14d后含水率降为26%.完成此阶段的工艺指标值可依据矿化垃圾开采的最终用途确定.对主要试验数据进行了数值模拟.厌氧-好氧填埋过程的微生物演替经RISA分析,有4个优势菌群,一些兼性菌群在厌氧-好氧阶段起着重要的承前启后作用.     

曝气生物滤池处理城市污水的试验研究

采用两级曝气生物滤池处理含工业废水的城市污水。结果表明:在水温26.7~29.5℃,气/水比6∶1,进水CODcr浓度为260~600mg/L,NH3 浓度为52~90mg/L、SS浓度为60~90mg/L、滤速为2.2m/h条件下,系统取得了良好的处理效果,其CODcr、NH3、SS的平均去除效率分别达到80.2%、97.8%、95.4%、出水CODcr、NH3、SS浓度满足污水综合排放要求。     

搅拌-序批式活性污泥反应器(WSBR)中好氧颗粒污泥的特性研究

为研究搅拌-序批式活性污泥反应器(WSBR)中好氧颗粒污泥的特性,利用WSBR反应器与传统SBR反应器对好氧活性污泥颗粒化的过程进行了比较.结果表明,在添加同量的聚炳烯酰胺(PAM)条件下,具有合理二次流场的WSBR反应器在4d就可见好氧颗粒污泥,而SBR反应器则在第10d才出现好氧颗粒污泥,且WSBR反应器中好氧颗粒...     

含氰污泥处理的研究

就逆流洗涤和洗涤投药两种工艺进行试验研究,结果表明采用逆流洗涤的方法,能降低污泥中的氰化物,浓度可达标,但是存在不少缺点。而采用洗涤投药工艺,不但可以使污泥达标,更重要的是技术上可行,经济上也比较合理。     

Characterization and control of odorous gases at a landfill site: a case study in Hangzhou, China

Municipal solid waste (MSW) landfills are one of the major sources of offensive odors potentially creating annoyance in adjacent communities. At the end of May 2007, an odor pollution incident occurred at the Tianziling landfill site, Hangzhou, China, where the residents lodged complaints about the intense odor from the landfill, which drew a significant attention from the government. In this study, ambient air monitoring was conducted at the Tianziling landfill site. The main odor composition of the gas samples collected on June 1st 2007 and the reduction of various odorous gases from the samples collected on June 1st 2009 due to the applied odor control techniques were determined using gas chromatography-mass spectrometry (GC-MS). In addition, variations of primary odorous gaseous (NH₃ and H₂S) concentrations at different locations in the landfill site from July 2007 to June 2009 were also investigated by using classical spectrophotometric methods. Results showed that a total of 68 volatile compounds were identified among which H₂S (56.58-579.84 μg/m³) and NH₃ (520-4460 μg/m³) were the notable odor components contributing to 4.47-10.92% and 83.91-93.94% of total concentrations, respectively. Similar spatial and temporal shifts of H₂S and NH₃ concentrations were observed and were significantly affected by environmental factors including temperature, air pressure and wind direction. Odor pollution was worse when high temperature, high humidity, low air pressure, and southeast, northeast or east wind appeared. Moreover, the environmental sampling points of the dumping area and the leachate treatment plant were found to be the main odor sources at the Tianziling landfill site. The odor control technologies used in this project had a good mitigating effect on the primary odorous compounds. This study provides long-term valuable information concerning the characteristics and control of odors at landfill sites in a long run.     

Use of thermal analysis techniques (TG-DSC) for the characterization of diverse organic municipal waste streams to predict biological stability prior to land application

The use of organic municipal wastes as soil amendments is an increasing practice that can divert significant amounts of waste from landfill, and provides a potential source of nutrients and organic matter to ameliorate degraded soils. Due to the high heterogeneity of organic municipal waste streams, it is difficult to rapidly and cost-effectively establish their suitability as soil amendments using a single method. Thermal analysis has been proposed as an evolving technique to assess the stability and composition of the organic matter present in these wastes. In this study, three different organic municipal waste streams (i.e., a municipal waste compost (MC), a composted sewage sludge (CS) and a thermally dried sewage sludge (TS)) were characterized using conventional and thermal methods. The conventional methods used to test organic matter stability included laboratory incubation with measurement of respired C, and spectroscopic methods to characterize chemical composition. Carbon mineralization was measured during a 90-day incubation, and samples before and after incubation were analyzed by chemical (elemental analysis) and spectroscopic (infrared and nuclear magnetic resonance) methods. Results were compared with those obtained by thermogravimetry (TG) and differential scanning calorimetry (DSC) techniques. Total amounts of CO₂ respired indicated that the organic matter in the TS was the least stable, while that in the CS was the most stable. This was confirmed by changes detected with the spectroscopic methods in the composition of the organic wastes due to C mineralization. Differences were especially pronounced for TS, which showed a remarkable loss of aliphatic and proteinaceous compounds during the incubation process. TG, and especially DSC analysis, clearly reflected these differences between the three organic wastes before and after the incubation. Furthermore, the calculated energy density, which represents the energy available per unit of organic matter, showed a strong correlation with cumulative respiration. Results obtained support the hypothesis of a potential link between the thermal and biological stability of the studied organic materials, and consequently the ability of thermal analysis to characterize the maturity of municipal organic wastes and composts.     

Recovery of solid fuel from municipal solid waste by hydrothermal treatment using subcritical water

Hydrothermal treatments using subcritical water (HTSW) such as that at 234 °C and 3 MPa (LT condition) and 295 °C and 8 MPa (HT condition) were investigated to recover solid fuel from municipal solid waste (MSW). Printing paper, dog food (DF), wooden chopsticks, and mixed plastic film and sheets of polyethylene, polypropylene, and polystyrene were prepared as model MSW components, in which polyvinylchloride (PVC) powder and sodium chloride were used to simulate Cl sources.While more than 75% of carbon in paper, DF, and wood was recovered as char under both LT and HT conditions, plastics did not degrade under either LT or HT conditions. The heating value (HV) of obtained char was 13,886-27,544 kJ/kg and was comparable to that of brown coal and lignite. Higher formation of fixed carbon and greater oxygen dissociation during HTSW were thought to improve the HV of char.Cl atoms added as PVC powder and sodium chloride to raw material remained in char after HTSW. However, most Cl originating from PVC was found to converse into soluble Cl compounds during HTSW under the HT condition and could be removed by washing.From these results, the merit of HTSW as a method of recovering solid fuel from MSW is considered to produce char with minimal carbon loss without a drying process prior to HTSW. In addition, Cl originating from PVC decomposes into soluble Cl compound under the HT condition. The combination of HTSW under the HT condition and char washing might improve the quality of char as alternative fuel.