城市交通机动车污染控制研究进展

城市交通机动车污染问题非常复杂，在许多不可控因素，城市交通是一个动态系统，污染物排放量始终处于变化之中，控制城市交通污染，必须严格控制机动车排放，该文介绍了国内外对城市机动车污染控制研究的概况，以及几种城市中污染物扩散的模型，展望了这方面研究前发展趋势，并提出了可持续发展的效能系统设计与管理的新概念。     

Chance-constrained programming (CCP)abatement of SO_2 emission for acid deposition control in Liuzhou City

A deterministic linear programming model which optimizes the abatement of each SO2 emission source, is extended into a CCP form by introducing equations of probabilistic constrained through the incorporation of uncertainty in the source-receptor-specific transfer coefficients. Based on the calculation of SO2 and sulfate average residence time for Liuzhou City, a sulfur deposition model has been developed and the distribution of transfer coefficients have been found to be approximately log-normal. Sulfur removal minimization of the model shows that the abatement of emission sources in the city is more effective, while control cost optimization provides the lowest cost programmes for source abatement at each allowable deposition limit under varied environmental risk levels. Finally a practicable programme is recommended.     

新冠疫情对我国NO2排放影响的时空分析

基于高分辨率的TROPOMI数据,分析了我国疫情爆发期的NO₂空间分布情况,同时对比了疫情同比期和环比期不同地区的变化情况.分析表明,全国范围内NO₂柱浓度的同比下降率和环比下降率分别为40.46%和50.09%,经济发达且人口稠密的城市群,排放量下降较为显著,其中江苏、河南、山东、浙江等NO₂历史排放较高的省份受疫情影响更大.湖北省疫情期的NO₂柱浓度绝对值(1.63×10¹⁵molec/cm²)在中东部省份属于最低位水平,同比和环比下降率也均在50%以上.相对来说,武汉、孝感等周边城市的影响远大于十堰、恩施等西部山区.地基国控站点的NO₂质量浓度也显示了与卫星观测较一致的空间分布和变化趋势,证明了采用“自上而下”的遥感手段,可以对不同区域的大气污染排放强度和社会经济活动水平进行快速评估.     

用MnSO4-Ce(SO4)2协同催化快速测定COD的研究

本文探讨了以MnSO4-Ce(SO4)2复合催化剂代替标准重铬酸钾法中的Ag2SO4，用密封消解法测定废水COD值的可行性，研究了复合催化剂总量、配比、消解时间、溶液酸度等因素对COD测定的影响。通过对各种废水COD值的测定表明，用MnSO4-Ce(SO4)2做催化剂，在165℃，较低酸度，密封消解15min是可行的。     

纳米复合GeO2/TiO2的制备及光催化性能研究

采用改进的Sol-gel方法,制备了一种新型的单分散椭球形微孔结构的纳米GeO2/TiO2复合光催化剂,并用TG-DTA、XRD、XPS、UV-vis、FT-IR、TEM、BET等手段进行了表征.以难生化降解的染料罗丹明B为目标降解物,采用HPLC测定不同光照时间下催化剂对染料降解的情况,考察了催化剂的光催化活性结果表明,改进的Sol-gel法制得的复合光催化剂具有明显的孔结构,而且比表面积大、粒径小、粒径分布窄、分散性好;与适量GeO2复合后能够有效提高TiO2纳米粒子的光催化活性;复合光催化剂的最佳制备条件为GeO2摩尔含量为0.1%,煅烧温度为400℃,所制得的GeO2/TiO2光催化活性比纯TiO2有显著提高.     

Methodological and Practical Considerations for Developing Multiproject Baselines for Electric Power and Cement Industry Projects in Central America

The Lawrence Berkeley National Laboratory (Berkeley Lab) and the Center for Sustainable Development in the Americas (CSDA) conducted technical studies and organized two training workshops to develop capacity in Central America for the evaluation of climate change projects. This paper describes the results of two baseline case studies conducted for these workshops, one for the power sector and one for the cement industry, that were devised to illustrate certain approaches to baseline setting. Multiproject baseline emission rates (BERs) for the main Guatemalan electricity grid were calculated from 2001 data. In recent years, the Guatemalan power sector has experienced rapid growth; thus, a sufficient number of new plants have been built to estimate viable BERs. We found that BERs for baseload plants offsetting additional baseload capacity ranged from 0.702 kgCO2/kWh (using a weighted average stringency) to 0.507 kgCO2/kWh (using a 10th percentile stringency), while the baseline for plants offsetting load-following capacity is lower at 0.567 kgCO2/kWh. For power displaced from existing load-following plants, the rate is higher, 0.735 kgCO2/kWh, as a result of the age of some plants used for meeting peak loads and the infrequency of their use. The approved consolidated methodology for the Clean Development Mechanism yields a single rate of 0.753 kgCO2/kWh. Due to the relatively small number of cement plants in the region and the regional nature of the cement market, all of Central America was chosen as the geographic boundary for setting cement industry BERs. Unfortunately, actual operations and output data were unobtainable for most of the plants in the region, and many data were estimated. Cement industry BERs ranged from 205 kgCO2 to 225 kgCO2 per metric ton of cement.     

产品生命周期环境成本核算实例研究

针对项目层次环境成本核算技术存在的2大缺陷，构建了产品生命周期环境成本核算模型。以红矾钠产品生命周期为例，通过企业的实地调查，以直接计算法、费用当量法进行拟合，得到了红矾钠产品（产量2.28万t/a)生命周期环境成本为，直接计算法：5084.48万元；费用当量法：4941.43万元。分析了环境成本核算对可持续发展决策和管理的作用和意义。     

TiO2光催化技术在有害气体净化中的应用

主要介绍了TiO2光催化技术在有害气体净化中的应用、提高TiO2光化效率的方法以及影响TiO2光催化效率的因素。     

温室效应及其生态影响综述

温室效应是目前全球性的环境问题 ,本文介绍了温室效应的机理和温室气体的来源 ,分析了温室效应的主要生态影响 ,并探讨了减缓温室效应的措施。     

扩散法测定环境空气中的二氧化硫

介绍了利用自制分子扩散式个体采样器 ,监测环境空气中的二氧化硫的方法 ,该方法改 PRA光度法为离子色谱法 ,提高了方法的灵敏度。经实验室性能评价能够满足实验室测试的要求。并经有动力的溶液吸收管法现场对比测试 ,两种测试方法结果一致