废渣──Al(OH)_3凝胶再利用研究

研究了对处理铝材加工含Al3＋的酸性废液过程中产生的二次污染物Al（OH）3凝胶废渣的应用。含水分约90％、80％左右的Al（OH）3凝胶200g分别与14～16mL、22～24mL95％的工业浓硫酸酸反应，可制得浓度为20％～23％的Al（SO4）3溶液，经稀释可用作造纸原料。     

苏州河市郊段底泥中COD_(Cr)和NH_3-N的空间分布特征

对苏州河截流区外河段(城郊段)东大盈河口—北新泾,按河道形态,支流与城镇分布等因素,沿程采集24个底泥柱样,测定其不同部位不同深度底泥中COD_(Cr)和NH_3-N含量,分析COD_(Cr)和NH_3-N在沿程和垂向上的分布特征及其成因。结果表明,底泥中污染沿程分布呈不规则波状起伏,东大盈河、蕴藻浜、盐铁塘、封浜、华漕港、新槎浦等支流口,浮泥层中COD_(Cr)含量达2万mg/kg,超过背景值2—3倍,支流口下游200m范围内均较高;黄渡小支流口、华漕港支流口浮泥层中NH_3-H含量达250mg/kg,超过背景值3倍。在垂向分布上,底泥柱样都出现峰值分布,在某些弯道及支流口出现递减分布。底泥耗氧污染程度主要与支流及其排污量有关,其次是弯道凸岸处污染物易于沉积富集。这为苏州河市郊段环境综合治理、底泥疏浚和处置提供了科学依据。     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.     

碱激发胶凝材料及其固化Pb^2＋的试验研究

对碱激胶凝材料（碱-偏高岭土、碱-矿渣和碱-粉煤灰）与水-水泥体系固化Ph^2＋进行了试验研究,其中水-水泥体系为对比样。结果表明：对于相同稠度的碱激发胶凝材料,即使Pb^2＋含量达到2．4％,除了碱-粉煤灰的抗压强度略低外,其他都达到30MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子（Ph^2＋）浸出浓度,其规律性与其NH4交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性。     

碱激发胶凝材料及其固化Pb~(2+)的试验研究

对碱激胶凝材料(碱-偏高岭土、碱-矿渣和碱-粉煤灰)与水-水泥体系固化Pb2+进行了试验研究,其中水-水泥体系为对比样.结果表明:对于相同稠度的碱激发胶凝材料,即使Pb2+含量达到2.4%,除了碱-粉煤灰的抗压强度略低外,其他都达到30 MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子(Pb2+)浸出浓度,其规律性与其NH4+交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性.     

Effect of variations in the redox potential of Gleysol on barium mobility and absorption in rice plants

Two assays were designed to obtain information about the influence of redox potential variations on barium mobility and bioavailability in soil. One assay was undertaken in leaching columns, and the other was conducted in pots cultivated with rice (Oryza sativa) using soil samples collected from the surface of Gleysol in both assays. Three doses of barium (100,300 mg kg⁻¹ and 3000 mg kg⁻¹-soil dry weight) and two redox potential values (oxidizing and reducing) were evaluated. During the incubation period, the redox potential (Eh) was monitored in columns and pots until values of −250 mV were reached. After the incubation period, geochemical partitioning was conducted on the barium using the European Communities Bureau of Reference (BCR) method. Rainfall of 200 mm d⁻¹ was simulated in the columns and in the planting of rice seedlings in the pots. The results of the geochemical partitioning demonstrated that the condition of reduction favors increased barium concentrations in the more labile chemical forms and decreased levels in the chemical forms related to oxides. The highest barium concentrations in leached extracts (3.36 mg L⁻¹) were observed at the highest dose and condition of reduction at approximately five times above the drinking water standard. The high concentrations of barium in the soil did not affect plant dry matter production. The highest levels and accumulation of barium in roots, leaves, and grains of rice were found at the highest dose and condition of reduction. These results demonstrate that reduction leads to solubilization of barium sulfate, thereby favoring greater mobility and bioavailability of this element.     

含锰废渣的氧化-活化再生回用工艺

为实现紫苏醛生产过程中二氧化锰（氧化剂）的循环利用,采用一种新型的氧化-活化工艺再生得到活性二氧化锰,即以紫苏醇合成紫苏醛过程中产生的含锰废渣为原料,首先采用氯酸钠氧化含锰废渣得到初级二氧化锰,然后使用高锰酸钾对初级二氧化锰进一步活化得到活性二氧化锰。实验表明,制取初级二氧化锰的最佳工艺条件为：反应时间为4h,反应温度为90～95℃,硫酸摩尔浓度为1.5 mol/L,氯酸钠加量为理论量的130%。制取活性二氧化锰的合适条件为：反应温度在60℃时,反应时间为1.5 h;反应温度在50℃时,反应时间为2.5 h。采用氧化-活化法再生的活性二氧化锰氧化紫苏醇,紫苏醛的产率可达52.8%,与使用电解二氧化锰氧化得到的紫苏醛的产率53.1%相当,而使用初级二氧化锰,紫苏醛的产率仅为14.9%。