天然黄铁矿的除磷性能

除磷是控制水体富营养化的重要手段。为了考察黄铁矿的除磷特征,采用序批实验,分别研究了反应时间、初始磷浓度和干扰离子（NH4＋、NO3- 和SO24-）对黄铁矿除磷的影响。动力学表明,黄铁矿的除磷过程符合伪二级动力学模型。pH=6．5时,磷的平衡去除量为6．82mg／kg。Langmuir方程能较好描述黄铁矿除磷的吸附等温过程,其磷的饱和吸附量为11．01mg／kg。NH4＋、NO3-和SO24- 对黄铁矿除磷基本没有影响。磷的去除主要是通过铁磷沉淀和铁氧化物及氢氧化物的吸附,去除的磷主要以可被生物利用的Fe、Al-P形态存在。黄铁矿的这些除磷性能和机制对选取黄铁矿作为人工湿地填料实现同步脱氮除磷具有重要指导作用。     

小型好氧堆肥设备处理有机垃圾

针对我国生活垃圾的特点,提出了厨余等有机生活垃圾单独收集,在产生源头进行好氧堆肥处理。研制了好氧堆肥设备,由加热装置、通风装置、冷凝水收集和回灌装置,以及与该生物堆肥设备配套的生物过滤除臭装置、自控系统和数据采集软件几部分构成。自控系统由氧气、温度、湿度三路传感器以及2个控制器构成,并与加热装置、通风装置连接,能满足物料加热、供氧和散热的要求。本研究通过为期30 d的试运行实验表明,物料快速升温并稳定保持在高温阶段(50～60℃),物料中的氧气浓度保持在14%～16%范围内。在堆肥实验结束时,物料的含水率降至36.4%,有机质含量降至49%,另外,通过好氧速率指标也可判定物料达到腐熟。     

不同流量分配比对多级A/O工艺去除有机物及脱氮的影响

采用三级A/O工艺分段进水工艺处理低碳源生活污水,考察了进水流量分配比对系统去除有机物、硝化反硝化能力以及去除TN的影响。通过对水质指标沿程监测结果表明,不同流量分配比(4∶3∶3,5∶3∶2,6∶3∶1)对系统去除有机物及硝化效率影响不大,出水COD、氨氮分别均在30 mg/L、1 mg/L以下。但反硝化效果受流量分配比的影响较大,在流量比为5∶3∶2时,有效利用原水中碳源进行反硝化,反硝化效果最好。在流量比为5∶3∶2的情况下,TN出水为5.7 mg/L去除率为82.9%,优于流量分配比为6∶3∶1和4∶3∶3时的脱氮效果。总体而言,分段进水工艺在对碳源的有效利用及能耗节省方面优于单点进水。     

UASB处理畜禽废水的氨化率研究

因畜禽废水除了含有大量的有机物，还含有一定量的氨基酸，因此，研究利用UASB处理畜禽废水，在不同环境条件和工况条件下对氨化率的影响，结果表明：氨化菌适应的pH值范围较宽，在6．5—8．0范围均可以较好的生存，其中以7．0为最佳；温度与氨化率基本成正相关关系，从经济等多种角度考虑，中温阶段38％为最适宜；氨化率随进水浓度的增加而增加；进水有机负荷越大，氨化率越小。     

微生物絮凝剂有效真菌的筛选

通过真菌培养基（马铃薯培养基），对旱田土壤和活性污泥中的微生物进行筛选分离，得到3株絮凝率超过67％的菌株，其中絮凝率超过75％的高絮凝活性菌株1株——MZ52。将MZ52在产絮凝剂的培养基中进行发酵培养后，对1000mg／L高岭土悬浮液絮凝，得出MZ52菌产絮凝剂最佳培养条件，分别为摇床转速160r／min，培养时间90h，初始pH值为8．0，培养温度为40℃。     

脉冲电晕低温等离子体提高一氧化氮氧化效率的实验研究

提高一氧化氮（NO）的氧化效率对于提高生物法处理该类废气的净化效率具有重要意义。实验研究了低温等离子体在脉冲电晕条件下氧化废气中NO的过程,考察了不同峰值电压、氧气含量、气体停留时间和添加有机物等因素对提高NO氧化效率的影响。结果表明：低温等离子法可有效地提高NO的氧化效率,主要产物为NO₂;室温条件下,当进气NO浓度590 mg/m³、脉冲频率50 Hz时,增大峰值电压、气体停留时间和进气中的氧气含量可提高NO的氧化效率;在最适峰值电压15 kV,气体停留时间5 s时,NO氧化效率为20%;在进气NO中添加甲苯、乙醇后,NO氧化效率可增加至30%以上,甲苯的效果要好于乙醇。     

Impact of Bioaugmentation with a Consortium of Bacteria on the Remediation of Wastewater-Containing Hydrocarbons (5 pp)

Goals, Scope and Background It has been observed that hydrocarbon treated wastewaters still contain high COD and a number of intermediates. This suggests that the required catabolic gene pool for further degradation might be absent in the system or, that its titer value is not significant enough. By providing the desired catabolic potential, the overall efficiency of the treatment system can be improved. This study aims to demonstrate this concept by bioaugmentation of a lab-scale reactor treating refinery wastewater with a consortium having the capacity to complement the alkB genotype to the available microbial population. Methods Two reactors were set up using activated biomass collected from a refinery treatment plant and operated at a continuous mode for a period of 8 weeks. The feed to both reactors was kept constant. Crude oil was spiked regularly. One reactor was bioaugmented with a consortium previously described for crude oil spill remediation. The efficiency of the bioaugmented reactor was demonstrated by reduced COD. The changes in the microbial population over a period of time were analyzed by RAPD. Catabolic activity of the biomass in both reactors was monitored by PCR. The presence of the catabolic loci was confirmed by Southern Hybridization. Results and Discussion 52.2% removal of COD was observed in the bioaugmented reactor while only 15.1% reduction of COD was observed in the reactor without bioaugmentation. The change in microbial population can be seen from the 4th week, which also corresponds to improved catabolic activity. The presence of the bedA locus was seen in all samples, which indicates the presence of aromatic degraders, but the appearance of the alkB locus, from the 6th week onwards, which was observed only in the samples from the bioaugmented reactor. The results suggest that the gene pool of the bioaugmented reactor has catabolic loci that can degrade accumulated intermediates, thus improving the efficiency of the system. Conclusions In this study, improvement of efficiency of bioremediation was demonstrated by addition of catabolic loci that are responsible for degradation. Bioaugmentation was carried out in biomass that was collected from an ETP (effluent treatment plant) treating hydrocarbon containing wastewater to study the strategies for improvement of the treatment system. Biostimulation, only marginally improved the efficiency, when compared to bioaugmentation. The improved efficiency was demonstrated by COD removal. The presence of the alkB locus suggests the importance of a catabolic gene pool that acts on accumulated intermediates. It is well documented that straight chain aliphatics and intermediates of aromatic compounds after ring cleavage, accumulate in refinery wastewater systems, thereby hindering further degradation of the wastewater. Supplementation of a catabolic gene pool that treats the lower pathway compounds and alkanes will improve the overall efficiency. In this study, results suggest that the alkB locus can also be used to monitor the degradative mode of the activated biomass. Recommendations and Perspective . Pollution from petroleum and petroleum products around the globe are known to have grave consequences on the environment. Bioremediation, using activated sludge, is one option for the treatment of such wastes. Effluent treatment plants are usually unable to completely degrade the wastewater being treated in the biological unit (the aerator chambers). The efficiency of degradation can be improved by biostimulation and bioaugmentation. This study demonstrates the improved efficiency of a treatment system for wastewater containing hydrocarbons by bioaugmentation of a consortium that supports degradation. Further experiments on a pilot scale are recommended to assess the use of bioaugmentation on a large scale. The use of molecular tools, like DNA probes for alkB, to monitor the system also needs to be explored.     

Heavy metals in untreated/treated urban effluent and sludge from a biological wastewater treatment plant

Background, Aim and Scope

The presence of heavy metals in wastewater is one of the main causes of water and soil pollution. The aim of the present study was to investigate the removal of Cd, Cu, Pb, Hg, Mn, Cr and Zn in urban effluent by a biological wastewater treatment, as well as to quantify the levels of As, Be, Cd, Cr, Cu, Fe, Hg, Mn, Ni, Pb, Sn, Tl, V and Zn in dewatering sludge from the Biological Wastewater Treatment Plant to Ribeirão Preto (RP-BWTP), Brazil.

Materials and Methods

Concentrations of Cd, Cr, Cu, Mn and Pb in wastewater and those of Ni in sludge were determined by atomic absorption spectrophotometry with graphite furnace atomization. Mercury concentrations in wastewater were measured by hydride generation atomic spectrophotometry, and Zn levels were determined by atomic absorption spectrophotometry using acetylene flame. In sludge, the levels of As, Be, Cd, Cr, Cu, Fe, Hg, Mn, Pb, Sn, Tl, V and Zn were determined by inductively coupled plasma-mass spectrometry.

Results

The percentages of removal efficiency (RE) were the following: Hg 61.5%, Cd 60.0%, Zn 44.9%, Cu 44.2%, PB 39.7%, Cr 16,5% and Mn 10.4%. In turn, the mean concentrations (mg/kg) of metals in dewatering sludge followed this increasing order: Tl (<0.03), Hg (0.31), Be (0.43), As (1.14), Cd (1.34), V (59.2), Pb (132.1), Sn (166.1), Cr (195.0), Mn (208.1), Ni (239.4), Cu (391.7), Zn (864.4) and Fe (20537).

Discussion

The relationship between metal levels in untreated wastewater, as well as the removal efficiency are in agreement with previous data from various investigators, It is important to note that metal removal efficiency is not only affected by metal ion species and concentration, but also by other conditions such as operating parameters, physical, chemical, and biological factors.

Conclusions

Metal values recorded for treated wastewater and sludge were within the maximum permitted levels established by the Environmental Sanitation Company (CETESB), São Paulo, Brazil.

Recommendations

There is an urgent need for the authorities who are responsible for legislation on sludge uses in agriculture of establishing safety levels for As, Be, Hg, Sn, Tl and V.

Perspectives

According to the current metal levels, RP-BWTP sludge might be used for agriculture purposes. However, for an environmentally safe use of sewage sludge, further studies including systematic monitoring are recommended. Annual metal concentrations and predicted variations of those elements in the sludge should be monitored.

     

倒置A2/O污水处理工艺的特点及应用实例

传统A²/O工艺在保证脱氮效果的同时除磷效果往往不佳。在充分分析传统A²/O工艺的基础上，提出了将缺氧池置于厌氧池前面，厌氧池后设置好氧池的分点进水倒置A²/O工艺。某污水厂的现场试验表明，在COD去除能力与常规A²/O工艺相当的情况下，倒置A²/O工艺的脱氮除磷功能明显优于常规A²/O工艺。     

海洋柴油溢油油水快速分离的应用研究

针对海洋柴油溢油,采用破乳剂对油水快速分离进行了研究.分别对油水比、温度、破乳剂量及存在Ca2 、Mg2 的影响因素,进行了系列油水快速分离试验,并测定了破乳剂作用下乳液的界面张力.试验结果表明,柴油溢油形成的乳液稳定性较差,油水分离较容易,但分离后的水中含油量较高.加入聚醚类非离子型破乳剂FA、FB、FC和FD,可达到油水低温、快速分离的目的,且分离后的水中含油量较低.随着破乳剂浓度的增加,界面张力降低,当破乳剂浓度达到临界胶束浓度(CMC)时,界面张力最小,脱水效果最好.Ca2 、Mg2 对聚醚类非离子型破乳剂的影响很小.