Degassing of H/He, CFCs and SF6 by denitrification: Measurements and two-phase transport simulations

The production of N₂ gas by denitrification may lead to the appearance of a gas phase below the water table prohibiting the conservative transport of tracer gases required for groundwater dating. We used a two-phase flow and transport model (STOMP) to study the reliability of ³H/³He, CFCs and SF₆ as groundwater age tracers under agricultural land where denitrification causes degassing. We were able to reproduce the amount of degassing (R² = 69%), as well as the ³H (R² = 79%) and ³He (R² = 76%) concentrations observed in a ³H/³He data set using simple 2D models. We found that the TDG correction of the ³H/³He age overestimated the control ³He/³He age by 2.1 years, due to the accumulation of ³He in the gas phase. The total uncertainty of degassed ³H/³He ages of 6 years (± 2 σ) is due to the correction of degassed ³He using the TDG method, but also due to the travel time in the unsaturated zone and the diffusion of bomb peak ³He. CFCs appear to be subject to significant degradation in anoxic groundwater and SF₆ is highly susceptible to degassing. We conclude that ³H/³He is the most reliable method to date degassed groundwater and that two-phase flow models such as STOMP are useful tools to assist in the interpretation of degassed groundwater age tracer data.     

CuCoOx/TiO2催化氧化NO性能研究

采用浸渍法制备了CuCoOx/TiO₂催化剂,考察了焙烧温度、反应温度、氧含量、NO浓度和空间速度对催化剂催化氧化NO性能的影响,并考察了催化剂的抗硫抗水性能。XRD、TPR和BET分析表明,350℃焙烧的催化剂具有CuCo₂O₄尖晶石结构,比表面积大,对NO的氧化效果好。在空速为5 000 h^-1,NO进口浓度500 mg/m³,含氧量10%的条件下,反应温度300℃时NO转化率可达79.5%,250℃时NO转化率接近50%。该催化剂具有良好的单独抗SO₂、抗H₂O毒化性能,H₂O和SO₂同时存在时很快失活。该催化剂可用于不同时含H₂O和SO₂的含NO气体催化氧化后再吸收处理。     

几种试剂对硝酸根光催化脱色甲基橙的影响

以NO^-₃为光催化剂,在紫外灯照射下,对甲基橙溶液进行光催化脱色。结果表明,叔丁醇、甲醇和乙醇对催化脱色反应有抑制作用; KBr和Na₂SO₄对脱色反应均有促进作用;而且KBr的加入量存在最佳值; Na₂SO₄的促进作用随Na₂SO₄的量的增加逐渐增强。Na₂CO₃的存在对甲基橙的脱色反应没有影响。K₂S₃O₈和NO^-₃之间存在较强的协同作用;KIO₃和NO^-₃之间存在相加作用;KBrO₃和NO^-₃之间存在拮抗作用。     

蜂窝煤燃烧氟污染的控制

以碳酸钙为固氟添加剂,以炉渣及粉煤灰等低氟材料取代全部或部分粘土作为粘结剂来制作蜂窝煤,进行了燃煤降氟的试验研究.结果表明,添加碳酸钙能有效降低蜂窝煤燃烧时候的氟排放,当煤:粘土:CaCO3的质量比为70:17:13时,碳酸钙的固氟效果最佳,氟的排放率可降低64.1%.以炉渣为粘结剂制作蜂窝煤能够显著降低燃烧时向外界排放的氟化物量,当煤:炉渣:CaCO3为80:8:12时,蜂窝煤燃烧排氟量较小且趋于稳定.已拌有一定剂量粉煤灰粘结剂的煤中添加15%的粘土后碳酸钙的固氟效果明显改善,当煤:粘土:粉煤灰:CaCO3为70:15:9:6时固氟效果最佳,此时蜂窝煤氟逸出率仅为18.2%,氟的减排率达到77.9%,显著优于未添加粘土时碳酸钙的固氟效果,蜂窝煤添加碳酸钙固氟剂进行高效固氟时,需同时适当增加粉煤灰加入量,以稳定固氟剂的高温固氟效果.     

铈改性Al_2O_3担载Pd催化剂的CO氧化性能研究

浸渍法制备了Al2O3+CeO2为载体的Pd催化剂,对制备中各因素对催化剂效果的影响作了初步研究.考察了活性组分含量与催化荆性能的关系以及焙烧温度、水蒸气对催化剂活性的影响.结果表明,稀土Ce元素的存在使催化剂的性能得到明显改善.制备过程中焙烧步骤对催化剂的活性影响很大,催化剂制备必须高于600 ℃焙烧.     

大连市中心区O3污染特征分析

本文采用2007年大连市环境自动监测数据,分析了城市中心区O3的污染特征。结果表明：O3质量浓度的最大值出现在午后15：00—17：00,比太阳辐射强度最大值的出现时间滞后2h左右;O3质量浓度的季节性变化十分显著,春夏季较高,秋季次之,冬季最低;汽车尾气是近地面O3污染的主要原因。     

MSBR法处理焦化废水

焦化废水成分复杂,是一种较难处理的工业废水.试验采用MSBR法对其进行处理,考察了5组水力停留时问(66h,39h,28 h,20 h,17 h)下不同反应阶段(厌氧池、缺氧池、好氧池、SBR出水)对水样的处理效果.结果显示,HRT总为66h条件下.CODCr去除率为82%,效果相对最好,并且每组HRT下焦化废水中的CODCr均是在 MSBR系统前置的厌/缺氧池(A2)已得到大幅度去除.但硝化作用受到抑制,NH3-N的去除效果并不明显.     

地下饮用水中痕量NO2-的催化动力学法测定

报道了一种新的测定NO2-的高选择性和高灵敏度的催化光度分析法.基于H3PO4介质中,碘绿与溴酸钾的氧化还原反应受亚硝酸盐的催化使碘绿褪色.据此建立了测定NO2-的新方法.本方法检出限为0.29μg/L,该方法用于地下饮用水、环境标样的测定,相对标准偏差为1.05%～4.80%,加标回收率为95%～117%.     

Development of a highly sensitive extractive spectrophotometric method for the determination of nickel(II) from environmental matrices using N-ethyl-3-carbazolecarboxaldehyde-3-thiosemicarbazone

Nickel(II) reacts with N-ethyl-3-carbazolecarboxaldehyde-3-thiosemicarbazone (ECCT) and forms a yellow colored complex, which was extracted into n-butanol from sodium acetate and acetic acid buffer at pH 6.0. The absorbance value of the Ni(II)-ECCT complex was measured at different intervals of time at 400nm, to ascertain the time stability of the complex. The extraction of the complex into the solvent was instantaneous and stable for more than 72h. The system obeyed Beer's law in the concentration range of 1.2-5.6mugml(-1) of nickel(II), with an excellent linearity and a correlation coefficient of 0.999. The molar absorptivity and Sandell's sensitivity of the extracted species were found to be 1.114x10(4)Lmol(-1)cm(-1) and 5.29x10(-3)mugcm(-2) at 400nm, respectively. Hence, a detailed study of the extraction of nickel(II) with ECCT has been undertaken with a view to developing a rapid and sensitive extractive spectrophotometric method for the determination of nickel(II) when present alone or in the presence of diverse ions which are usually associated with nickel(II) in environmental matrices like soil and industrial effluents. Various standard alloy samples (CM 247 LC, IN 718, BCS 233, 266, 253 and 251) have been tested for the determination of nickel for the purpose of validation of the present method. The results of the proposed method are comparable with those from atomic absorption spectrometry and were found to be in good agreement.