硝酸盐对反硝化除磷过程的影响分析

在厌氧/缺氧间歇反应器内考察了硝酸盐进水浓度及进水方式对反硝化除磷过程的影响。结果表明：在缺氧阶段,反硝化除磷菌(DPBs)可将硝酸盐转化为亚硝酸盐,当硝酸盐浓度较低时,DPBs以亚硝酸盐为电子受体吸磷。进水COD浓度为220 mg/L,正磷浓度为6.8 mg/L,硝酸盐初始浓度为26 mg/L时,系统达到最佳脱氮除磷效果,期间亚硝酸盐浓度积累至10.71 mg/L。采用连续流投加硝酸盐的方式更利于氮磷的高效去除。     

微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。     

Cu~(2+)、Zn~(2+)对生物脱氮系统的影响

Cu2+和Zn2+是污水处理工艺中经常遇到的金属离子.在驯化好的活性污泥系统中,研究了金属离子Cu2+和Zn2+在0～100 mg/L浓度下对活性污泥牛物脱氮系统的影响.试验发现Cu2+＞5 mg/L、Zn2+＞30 ms/L时,对硝化过程具有明显的抑制作用,在同样浓度的试验条件下Cu2+对硝化过程的抑制作用比Zn2+大.Cu2+≤0.5 mg/L时对反硝化过程具有一定的促进作用,有助于提高TN的去除效果;Cu2+＞0.5 mg/L时,对反硝化产牛抑制作用,随着浓度的增加,TN去除率逐渐下降.Zn2+不影响反硝化过程,仅在大于30 mg/L时,对硝化过程产生抑制作用.重金属Cu2+对生物脱氮系统的影响明显强于Zn2+.     

高效菌藻塘系统对农村污水中磷的强化去除效果研究

研究了高效菌藻塘系统处理太湖地区农村生活污水除磷效果及其强化措施。高效菌藻塘和水生生物塘HRT分别为8 d和4 d,进水总磷浓度为1.7～17.1 mg/L,出水总磷浓度全年平均值为3.33 mg/L,高效菌藻塘系统的除磷能力欠佳。通过降低水生生物塘内水深、采用废弃石膏作为填料构建了新型复合水生生物塘,HRT=1.6 d条件下,复合水生生物塘出水总磷可保持在1 mg/L以下,可达到GB18918-2002一级B排放标准。     

花叶芦竹水平潜流人工湿地脱氮性能研究

采用花叶芦竹水平潜流人工湿地处理生活污水,对其脱氮性能进行研究。结果表明：在HRT＝5 d,对TOC,NH⁺₄-N,NO^-₂-N,NO^-₃-N和TN的去除效果分别达到92％、93％、84％、51％和88％,相应空白湿地的去除率分别为91％、85％、-232％、-203％和66％。大部分TOC在湿地的前端被去除。花叶芦竹可以直接吸收氮素,向湿地输送氧气,通过根系分泌物提供碳源。因此,花叶芦竹人工湿地具有很好的硝化反硝化能力,实现了良好的脱氮性能。     

太阳光Fenton法处理垃圾渗滤液中有机污染物

研究利用太阳光Fenton法处理垃圾渗滤液。根据太阳光辐射强度随时间的变化规律,选择重庆7、8月份的晴天,在中午12：00到下午14：00时进行试验,研究太阳光辐射时间、pH值、Fenton试剂用量对垃圾渗滤液COD去除率的影响。研究结果表明：太阳光Fenton法对垃圾渗滤液的COD有较好的去除效果,COD去除率达86.2%。太阳光Fenton法处理垃圾渗滤液的优化条件是：日光辐射时间为120 min,pH值为2.5,Fe²⁺浓度为5 mmol/L,H₂O₂浓度为570 mmol/L。同时,论文还对太阳光Fenton法处理垃圾渗滤液的动力学进行分析。研究结果显示：太阳光Fenton法处理垃圾渗滤液,其表观动力学方程为-dC/dt=2.6×10^-8×P^1.92×F^1.79×E^1.67。     

Fluoride removal by a continuous flow electrocoagulation reactor

Long-term consumption of water containing excessive fluoride can lead to fluorosis of the teeth and bones. Electrocoagulation (EC) is an electrochemical technique, in which a variety of unwanted dissolved particles and suspended matter can be effectively removed from an aqueous solution by electrolysis. Continuous flow experiments with monopolar aluminium electrodes for fluoride removal were undertaken to investigate the effects of the different parameters such as: current density (12.5-50A/m(2)), flow rate (150-400 mL/min), initial pH (4-8), and initial fluoride concentration (5-25mg/L). The highest treatment efficiency was obtained for the largest current and the removal efficiency was found to be dependent on the current density, the flow rate and the initial fluoride concentration when the final pH ranged between 6 and 8. The composition of the sludge produced was analysed using the X-ray diffraction (XRD) spectrum. The strong presence of the aluminium hydroxide [Al(OH)(3)] in the above pH range, which maximizes the formation of aluminium fluoride hydroxide complex [Al(n)F(m)(OH)(3n-m)], is the main reason for defluoridation by electrocoagulation. The results obtained showed that the continuous flow electrocoagulation technology is an effective process for defluoridation of potable water supplies and could also be utilized for the defluoridation of industrial wastewater.     

电袋复合除尘器的滤料试验与应用

清灰周期与阻力是除尘器的主要技术性能指标。本文研究了粉尘浓度及荷电粉尘对清灰周期与阻力的影响,总结了影响电袋复合除尘器性能的主要因素,介绍了电袋复合除尘器的应用实例,并分析了电袋复合除尘器的适用性。     

臭氧同时脱硫脱硝技术研究进展

对利用臭氧同时脱硫脱硝技术进行了综述,分析了臭氧对NOx的脱除机理。臭氧同时脱硫脱硝技术具有明显的一体化脱除特性,但臭氧的发生费用却制约了它的应用。介绍了目前国外在工程上应用的低温氧化技术（LOTOX）,分析了其脱除效果及优缺点。     

Modification of Fe–Mn mixed oxide COS removal sorbent by rare-earth oxides addition

In order to develop highly active sorbent for COS removal, Fe–Mn mixed oxides doped with CeO₂, La₂O₃ or Sm₂O₃ were studied. The effects of these promoters on the structural properties of Fe–Mn oxides were investigated by XRD, BET, TPR and TEM techniques. XRD results revealed that the degree of crystallinity of Fe–Mn oxide phase decreased due to the addition of rare-earth oxides. Doping with CeO₂, La₂O₃ or Sm₂O₃ led to an increase in BET surface area of the sample. TPR studies showed that the reactivity of the reduction of doped samples increased in the temperature range of 300–450 °C. In addition, the desulfurization test was performed at 325 °C with a gas hourly space velocity of 1000 h⁻¹. It was found that the addition of 3% La₂O₃ greatly improved the absorption sulfur capacity of the sorbent, while the sorbent doped 3% CeO₂ achieved a sufficiently high purifying degree before breakthrough.