污泥厌氧消化预处理技术综述

全球环境问题已成为国际社会关注的焦点,围绕全球气候变化,降低温室气体排放,寻求再生能源,节能减排已成为目前国际科技发展的方向。通过"十一五"污水处理厂的建设,每年污泥产量已接近3000万吨(含水率80%脱水污泥计)以上,且以每年10%的速度递增。其处理与处置是制约社会经济发展的重要问题。但是,城市污泥蕴含有大量生物质能,通过借鉴国外先进技术与经验,开发城市污泥生物质能提取和利用技术,对我国节能减排具有重要战略意义。由于细胞壁的存在,使得污泥水解成为限制厌氧消化效率的重要瓶颈,而污泥强化预处理可有效提高污泥细胞壁的破坏,溶出胞内有机物,最大化回收剩余污泥中的有机能源。目前,预处理技术较多,如超声波预处理、热处理、微波预处理、碱解处理、臭氧预处理等,本文从物理、化学等角度分析了不同预处理对厌氧消化技术的影响。     

MBR法/高级氧化技术在中水处理中研究进展

膜生物反应器(MBR)作为一种新型高效的污水处理方法,正受到人们的广泛关注。同时由于高级氧化技术在处理污水过程中无二次污染、易控制,与其他处理过程相结合可提高处理能力,降低处理成本等优点也备受研究者亲睐。本文系统介绍了MBR法的定义、分类、优势及其发展趋势,并对高级氧化技术和中水做了简单说明,阐述了高级氧化技术在膜生物反应器(MBR)中的应用,同时列举了两种工艺相结合在中水处理领域中的作用和地位。     

光催化氧化处理低浓度含醇废水实验

室内实验了TiO2紫外光催化氧化处理废水中的低浓度甲醇。通过对TiO2催化剂活性及添加方式、溶液pH、紫外光强与催化剂加量等参数优化,在TiO2加入浓度为300mg/L和120 W紫外灯照射条件下,对6.8L甲醇浓度为2.77%的低浓度含醇废水持续处理70min后,废水中的甲醇去除率可达98.31%。该实验为进一步处理低浓度含醇废水提供了方法依据。     

污水处理厂AB法工艺改造方案的探讨

针对漳州市东区污水处理厂AB法工艺改造的目标,分析了AB法工艺的局限性,结合该污水处理厂AB法工程的现有设施,从技术上探讨了5种具有脱氮除磷功能的工艺改造方案的可行性,并得到了适合于该污水处理厂AB法工艺改造的方案。     

微生物法处理海上钻井废钻井液

微生物法适用于海上钻井含油废弃物的处理。通过多次对菌株采集、分离、纯化和培养驯化,选育得到了3株对石油烃类有很好降解效果的石油类降解菌;确定了石油类降解菌适宜的生化处理条件:最佳生长及原油降解温度为50℃、最佳生长及原油降解酸碱性环境为pH=6.0、最佳菌株接种量2%、最佳原油初始浓度为500mg/L。处理后的含油废弃钻井液含油量基本稳定在2mg/L以下,降解率达98%以上。     

油田压裂返排液处理技术实验研究

油气井压裂作业过程中产生的压裂返排液已成为当前油田水体的主要污染源之一。文章对吉林油田公司压裂返排液处理工艺进行了实验研究。结果表明:在采用絮凝、微波强氧化、活性炭毡处理、纳滤/反渗透集成处理工艺后,压裂返排液CODCr可以达到GB 8978-1996《污水综合排放标准》一级标准要求。该研究为压裂返排液处理装置的设计和现场实施提供了实验基础。     

炼油污水回用处理RO系统的稳定运行及维护

文章介绍了兰州石化公司炼油污水深度处理反渗透(RO)系统的工艺流程及维护。通过进出水电导率、产水回收率等变化情况,分析了RO系统的运行状况。得知:运用此系统,反渗透系统产水回收率达到65%～70%,系统脱盐率在99%以上,产水可以满足一级除盐水要求,实现了装置稳定运行的目标。     

新农村建设污水处理工程实例

山海关区新民居污水治理工程采用水解酸化+接触氧化+曝气生物滤池为主的工艺进行污水治理,实际运行结果表明:系统运行稳定,处理出水COD≤48 mg.L-1,BOD5≤9 mg.L-1,SS≤10 mg.L-1,NH3-N≤4.5 mg.L-1,TP≤0.47 mg.L-1,处理出水达到《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级A标准,出水用于农村绿化和农灌,经济效益和环境效益明显。     

Treatment of coking wastewater by an advanced Fenton oxidation process using iron powder and hydrogen peroxide

In this study the treatment of coking wastewater was investigated by an advanced Fenton oxidation process using iron powder and hydrogen peroxide. Particular attention was paid to the effect of initial pH, dosage of H₂O₂ and to improvement in biodegradation. The results showed that higher COD and total phenol removal rates were achieved with a decrease in initial pH and an increase in H₂O₂ dosage. At an initial pH of less than 6.5 and H₂O₂ concentration of 0.3 M, COD removal reached 44-50% and approximately 95% of total phenol removal was achieved at a reaction time of 1 h. The oxygen uptake rate of the effluent measured at a reaction time of 1 h increased by approximately 65% compared to that of the raw coking wastewater. This indicated that biodegradation of the coking wastewater was significantly improved. Several organic compounds, including bifuran, quinoline, resorcinol and benzofuranol were removed completely as determined by GC-MS analysis. The advanced Fenton oxidation process is an effective pretreatment method for the removal of organic pollutants from coking wastewater. This process increases biodegradation, and may be combined with a classical biological process to achieve effluent of high quality.     

Identification of relevant micropollutants in Austrian municipal wastewater and their behaviour during wastewater treatment

The European Union has defined environmental quality standards (EQSs) for surface waters for priority substances and several other pollutants. Furthermore national EQSs for several chemicals are valid in Austria. The study investigated the occurrence of these compounds in municipal wastewater treatment plant (WWTP) effluents. In a first screening of 15 WWTPs relevant substances were identified, which subsequently were monitored in 9 WWTPs over 1 year (every 2 months). Out of 77 substances or groups of substances (including more than 90 substances) 13 were identified as potentially relevant in respect to water pollution and subjected to the monitoring, whereas most other compounds were detected in concentrations far below the respective EQS for surface waters and therefore not further considered. The preselected 13 compounds for monitoring were cadmium (Cd), nickel (Ni), copper (Cu), selenium (Se), zinc (Zn), diuron, polybrominated diphenyl ethers (PBDEs), di(ethyl-hydroxyl)phthalate (DEHP), tributyltin compounds (TBT), nonylphenoles (NP), adsorbable organic halogens (AOX) and the complexing agents ethylenediaminetetraacetic acid (EDTA) as well as nitrilotriacetic acid (NTA). In the effluents of WWTPs the concentrations of the priority substances Cd, NP, TBT and diuron frequently exceeded the respective EQS, whereas the concentrations for DEHP and Ni were below the respective EQS. The effluent concentrations for AOX, EDTA, NTA, Cu, Se and Zn frequently are in the range or above the Austrian EQS for surface waters. Besides diuron and EDTA all compounds are removed at least partially during wastewater treatment and for most substances the removal via the excess sludge is the major removal pathway. For the 13 compounds which were monitored in WWTP effluents population equivalent specific discharges were calculated. Since for many compounds no or only few information is available, these population equivalent specific discharges can be used to assess emissions from municipal WWTPs to surface waters as well as to make a first assessment of the impact of a discharge on surface waters chemical status. Comparing discharges and river pollution on a load basis, the influence of diffuse sources becomes obvious and therefore should also be taken into consideration in river management.