草制浆造纸中段废水处理及回用技术分析研究

中段废水是制浆造纸工业的主要污染源之一,从工程设计的角度出发,对草制浆造纸中段废水处理及回用提出一套可行适用的工艺方案;对主要工艺环节参数、设备备有说明,以供同行借鉴.     

生物膜填料塔净化低浓度苯乙烯废气的实验研究

研究了进口气体中苯乙烯浓度、气体流量和液体流量等3个因素对生物膜填料塔净化苯乙烯废气的影响.研究结果表明,当进口气体中苯乙烯浓度为1000 mg/m3以下、气体流量为200L/h、循环液流量为10L/h的操作条件下,废气中苯乙烯的去除率可达90%以上.     

Economics and Land-Use Change in Prioritizing Private Land Conservation

Abstract:  Incentive-based strategies such as conservation easements and short-term management agreements are popular tools for conserving biodiversity on private lands. Billions of dollars are spent by government and private conservation organizations to support land conservation. Although much of conservation biology focuses on reserve design, these methods are often ineffective at optimizing the protection of biological benefits for conservation programs. Our review of the recent literature on protected-area planning identifies some of the reasons why. We analyzed the site-selection process according to three important components: biological benefits, land costs, and likelihood of land-use change. We compared our benefit-loss-cost targeting approach with more conventional strategies that omit or inadequately address either land costs or likelihood of land-use change. Our proposed strategy aims to minimize the expected loss in biological benefit due to future land-use conversion while considering the full or partial costs of land acquisition. The implicit positive correlation between the likelihood of land-use conversion and cost of land protection means high-vulnerability sites with suitable land quality are typically more expensive than low-vulnerability sites with poor land quality. Therefore, land-use change and land costs need to be addressed jointly to improve spatial targeting strategies for land conservation. This approach can be extended effectively to land trusts and other institutions implementing conservation programs.     

Evaluating time to maximum rate (TMR) and self-accelerating decomposition temperature (SADT) of self-polymerizing vinyl acetate monomer

Vinyl acetate monomer (VAM) is widely used as a chemical intermediate producing a variety of copolymer products. Besides, VAM has the tendency to readily decompose into free radicals and ions that initiates the self-sustaining polymerization reaction. The non-isothermal experiments of VAM were performed using differential scanning calorimetry (DSC), and the calculations of the kinetic parameters from temperature-programmed DSC curves have been evaluated by the isoconversional method. The thermal analysis of VAM was proceeded using the advanced thermal analysis software (AKTS) to figure out the time to maximum rate (TMR) and self-accelerating decomposition temperature (SADT) for a proactive safety design of VAM. Subsequently, the kinetic model is used to predict the potential thermal runaway in the VAM-PVAc polymerizing process.     

南泉河污染现状及建设人工湿地治理污染的探讨

通过对南泉河污染现状的监测和调查分析,同时基于国家南水北调东线工程治污规划的要求,提出了建设人工湿地治理南泉河污染的方案。对治理方案的可行性、治理方案内容、产生的效益进行了分析。     

石灰-铁盐法处理镍、钼深加工含镍、砷废水工艺设计

采用石灰-铁盐法处理镍、钼深加工含镍、砷废水,工程运行结果表明,出水能达到《污水综合排放标准》(GB8978-1996)中一级排放标准,该工艺具有投资少,占地面积小,便于管理的优点。     

“矿井通风与安全”课程教学实践与探讨

针对“矿井通风与安全”内容多、范围广、理论性和实践性很强等特点,结合笔者教学实践,从注重教学内容的精选、注重案例分析、注重知识的延伸、注重课程设计环节以及注重教学方法等5个方面出发,探讨如何提高学生对该课程的学习主动性和积极性,增强学习效果的问题。     

OPTIMUM DESIGN OF INTERBASIN TUNNEL SYSTEMS1

Interbasin water transfer is often accomplished by tunnel systems discharging the water from subreservoirs into a main reservoir. Such a system involving an arbitrary number of reservoirs is considered and an iterative method is developed for the determination of all tunnel sizes giving minimum total cost of the system when the individual discharges from the subreservoirs and elevations of the water surfaces of all reservoirs are known. It is assumed that all tunnels are flowing full. Influence of average construction cost per unit volume as well as tunnel roughness and cross-sectional shape is taken into consideration. The corresponding computer program for the general case is presented. The method may also be adapted to pipe systems, open channel systems, or combined systems by introduction of the proper cost functions for these conduits.     

多层圆管夹芯结构的装甲车底板防爆设计

为提高轮式装甲车防护地雷的能力,寻找能够实现最佳防护效果的装甲结构形式,利用ANSYS/LS-DYNA软件平台,对不同的装甲结构在爆炸载荷作用下的响应进行仿真计算。首先探究多层圆管排列方式对冲击吸能的影响,得出密排圆管结构的抗冲击能力强于齐排和交叉排列的方式。然后在爆炸载荷下对由双层密排圆管组成的夹芯层防护结构进行数值计算,并对比试验结果,验证了所建立计算模型数值模拟结果的有效性。最后由数值计算结果确定了最佳的防护结构。数值模拟和试验结果表明,防护结构的面密度增大,防护效果明显改善;相同面密度的防护结构中圆管的直径越大,圆管的压缩行程越大,防护效果越好。