Evaluation of adsorption capacities of humic acids extracted from Algerian soil on polyaniline for application to remove pollutants such as Cd(Ⅱ), Zn(Ⅱ) and Ni(Ⅱ) and characterization with cavity microelectrode

The adsorption capacities of new humic acids isolated from Yakouren forest (YHA) and Sahara (Tamenrasset: THA) soils (Algeria) and commercial humic acid (PFHA) on polyaniline emeraldine base (PEB) were studied at pH 6.6. Also the adsorption of heavy metals such as Cd2+, Zn2+ and Ni2+ on humic acid-polyaniline systems (HA-PEB) was investigated at the same conditions. HA-PEB compounds were characterized by scanning electron microscopy (SEM), infrared spectrometry and cavity microelectrode. In addition, batch adsorption and cavity microelectrode were used in the adsorption study of Cd2+, Zn2+ and Ni2+ on HA-PEB. To develop biocaptors of polluting metals using a cavity microelectrode modified by HA-PEB systems, the adsorption kinetic and adsorption capacity were investigated. The SEM analysis showed that the presence of humic acid affected the PEB surface and caused the formation of a granular morphology. The maximum adsorption capacities (qmax) of PFHA, THA and YHA determined by adsorption isotherms were 91.31, 132.1 and 151.0 mg/g, respectively. Batch adsorption results showed that qmax of Cd2+, Zn2+ and Ni2+ on HA-PEB followed the order: THA-PEB > YHA-PEB > PFHA-PEB. The voltammograms obtained with HA-PEB modified cavity microelectrode showed the appearance of new redox couples reflecting the adsorption of HA on PEB. Metal-humic acid-polyaniline voltammograms were characterized by appearance of oxidation-reduction couples or reduction wave corresponding to metal. Finally, the result may be exploited to develop a biocaptor based on the cavity microelectrode amended by THA-PEB and YHA-PEB.     

Modification of Ce02-ZrO2 catalyst by potassium for NOx-assisted soot oxidation

Potassium-modified ceria-zirconia catalyst was synthesized by wetness impregnation method. The ageing treatment was performed in static air at 800℃ for 20 hr to evaluate the thermal stability of the catalyst. The catalysts were characterized by X-ray diffraction,BET surface area, oxygen storage capacity, NOx-temperature programmed desorption and soot-temperature programmed oxidation measurements. By introduction of potassium, the maximum soot oxidation rate temperature (Tm) of the ceria-zirconia based catalyst decreased from 525 to 428℃ in the presence of NO under a loose contact mode. The shift of Tm of the K-modified catalyst after ageing is only 15℃. The enhanced activity of the aged catalyst mainly lies in the promotional effect of potassium on the NOx/oxygen storage cacity as well as the soot-catalyst contact.     

Groundwater contamination and natural attenuation capacity at a petroleum spilled facility in Korea

As a remedial option, the natural attenuation capacity of a petroleum contaminated groundwater at a military facility was examined. Hydrogeological conditions, such as high water level, permeable uppermost layer and frequent heavy rainfall, were favorable to natural attenuation at this site. The changes in the concentrations of electron acceptors and donors, as well as the relevant hydrochemical conditions, indicated the occurrence of aerobic respiration, denitrification, iron reduction, manganese reduction and sulfate reduction. The calculated BTEX expressed biodegradation capacity ranged between 20.52 and 33.67 mg/L, which appeared effective for the reduction of the contaminants levels. The contribution of each electron accepting process to the total biodegradation was in the order: denitrification > iron reduction > sulfate reduction > aerobic respiration > manganese reduction. The BTEX and benzene point attenuation rates were 0.0058-0.0064 and 0.0005-0.0032 day^-1, respectively, and the remediation time was 0.7-1.2 and 2.5-30 years, respectively. The BTEX and benzene bulk attenuation rates were 8.69 × 10^-4 and 1.05 × 10^-3 day^-1, respectively, and the remediation times for BTEX and benzene were 7.2 and 17.5 years, respectively. However, most of the natural attenuation occurring in this site can be attributed to dilution and dispersion. Consequently, the biodegradation and natural attenuation capacities were good enough to lower the contaminants levels, but their rates appeared to be insufficient to reach the remediation goal within a reasonable time frame. Therefore, some active remedial measures would be required.     

改性海泡石除磷剂除磷过程热力学的研究

通过研究改性海泡石对磷的吸附性能,确定了除磷剂用量、温度、含磷废水流量、添加剂等因素对改性海泡石磷吸附热力学平衡的影响.研究结果表明:改性海泡石除磷剂对废水中PO43-离子的吸附容量随除磷剂质量的增加而减小;去除率随除磷剂用量的增加而增大;提高酸改性温度有利于复合除磷剂对磷的吸附;除磷剂的吸附量随海泡石焙烧温度的提高而...     

扬水曝气器曝气室提水性能模型应用研究

文章根据扬水曝气器曝气室的流体特性,在曝气室内气-液两相流体所受推动力和曳力平衡条件下,建立了一维两相流提水性能模型,并应用于同温层曝气器流体运动特性的模拟预测。结果表明:模型对同温层曝气器上升段气含率的估计值与实测值之间的误差限为±10%,对流体表观上升速度的误差限为±20%。这说明提水性能模型对同温层曝气器的流体特性模拟具有很强的适用性。     

路面径流水环境下交通承载力分析

为了对路面径流水容许污染总量控制下的交通承载力问题进行探讨,利用神经网络具有的非线性映射能力和遗传算法具有的全局随机搜索能力,结合公路路面径流水质检测数据,提出了一种基于遗传神经网络进行公路交通环境承载力反计算的分析方法,应用该方法可根据路面径流水质污染数据反演出路段交通量大小,并可据此进行交通量与路而径流水质污染的关...     

2014年APEC期间北京市PM10和PM2.5氧化性损伤能力研究

为评估APEC会议期间联防联控措施对北京市大气可吸入颗粒物毒性的影响,采集2014年APEC会议前后3个月北京市大气PM₁₀和PM_2.5样品,应用质粒DNA损伤评价法来研究其氧化性损伤能力. 结果表明,APEC会议期间PM₁₀对DNA的损伤率高于PM_2.5,颗粒物对 DNA损伤率随剂量的增加而增加. 本研究用TD30值来指示颗粒物氧化性损伤能力,TD30为引起30%的DNA损伤率所需要的颗粒物剂量（单位为 μg·mL^-1）,TD30值越低,颗粒物氧化性损伤能力越强,APEC会议前后样品的TD30值表现为 APEC期间（11月）>APEC前（10月）>APEC后（12月）,说明氧化能力APEC后 >APEC前 >APEC期间. 用PM₁₀质量浓度乘上其在250 μg·mL^-1 剂量下的DNA损伤率得到颗粒物暴露毒性指数TI（toxic index）,与往年具有代表性月份样品的数据对比,TI大小顺序为2004年 >2014年 >2008年,说明大气中颗粒物暴露毒性随着政策控制力度的加大而降低.     

乌鲁木齐大气PM2.5对质粒DNA的损伤研究

2012年1月~2012年12月采集乌鲁木齐大气PM2.5样品,使用质粒DNA评价法研究了不同季节PM2.5的氧化能力,并进行氧化性毒性与相应气象因素和质量浓度之间的相关性研究.结果表明,乌鲁木齐大气PM2.5的质量浓度具有冬季最高,春季和秋季次之,夏季最低的季节性变化特征;PM2.5全样和水溶部分氧化能力的季节差异较大,对质粒DNA的氧化性损伤具有冬季最大,春季和夏季之次,秋季最低.冬、春、夏、秋季大气PM2.5全样的TD30(PM2.5对质粒DNA造成破坏达到30%所需要的颗粒物的剂量)平均值分别为440,491,503,515μg/mL,水溶部分分别为474,721,666,600μg/mL.绝大部分PM2.5样品全样的TD30值均小于水溶部分样,表明全样的毒性大于相应的水溶部分样.全样TD30值与平均温度显著(P<0.05)正相关,表明寒冷的天气/季节可能造成PM2.5的高毒性.水溶样TD30值与风速显著(P<0.01)正相关,与相对湿度显著负相关.这表明,高的风速和低的相对湿度可能跟较低和较高的PM2.5的毒性有关.PM2.5氧化性损伤能力的大小与其质量浓度之间的相关性不明显,表明仅以颗粒物的质量浓度来评价大气颗粒物氧化性损伤能力大小的方法并不能真实地反映其对人体健康的危害程度,起决定作用的还是颗粒物的化学组成及其表面吸附的有害成分.     

曝气膜生物反应器运行过程中污泥活性特征变化及其对膜污染的影响

研究了曝气膜生物反应器运行过程中活性污泥主要活性特征变化及其对膜污染的影响.通过排出剩余污泥的办法维持活性污泥浓度在4000 mg·L-1左右,并连续运行75 d.运行期间,每日检测活性污泥的各项性质指标便于反映污泥特性的变化.结果表明,随着反应器运行时间的延长,污泥脱氢酶活性逐渐增加,其对反应器的运行有着两方面的作用,一方面会强化微生物对污染物的去除,但另一方面则导致了胞外聚合物的增加,并加速膜污染.而污泥表观产率则随着运行时间的延长先增加后有所减少,其粒径逐渐减小,且胞外聚合物呈现增加的趋势,总的出水水质情况逐渐提高,与此同时,反应器内原生动物及后生动物在运行前期较少,而在后期大量出现.膜污染分析结果表明运行后期膜污染速度明显加快,其原因在于:污泥粒径的减小以及胞外聚合物的增加导致细小颗粒及胞外聚合物堵塞或在膜表面沉积数量增加.     

垂直流人工湿地LDHs覆膜改性沸石基质强化除磷效果及其机制

采用碱性水热-共沉淀法,将6种金属化合物(CaCl2、ZnCl2、MgCl2、FeCl3、AlCl3、CoCl3)两两组合生成9种不同类型的层状双金属氢氧化物并覆膜于常用垂直流人工湿地沸石基质表面;利用分别填充原始沸石及9种LDHs覆膜改性沸石基质的模拟垂直流人工湿地小试系统进行除磷净化实验,并结合10种沸石基质的等温吸附实验结果,对LDHs覆膜改性沸石基质的强化除磷机制进行研究.结果表明,相对于原始沸石基质,9种不同组合方式生成的LDHs覆膜改性沸石基质除磷效果均有不同程度的提高;Zn2+参与合成的改性基质除磷效果优良,其中ZnFe-LDHs改性沸石基质对总磷、溶解性总磷及磷酸盐的平均去除率超过90%,其最大理论吸附量达到了原始沸石基质的3倍;LDHs覆膜改性沸石基质通过增加化学吸附容量、提高物理吸附能力达到强化除磷效果的目的.