纳米复合GeO2/TiO2的制备及光催化性能研究

采用改进的Sol-gel方法,制备了一种新型的单分散椭球形微孔结构的纳米GeO2/TiO2复合光催化剂,并用TG-DTA、XRD、XPS、UV-vis、FT-IR、TEM、BET等手段进行了表征.以难生化降解的染料罗丹明B为目标降解物,采用HPLC测定不同光照时间下催化剂对染料降解的情况,考察了催化剂的光催化活性结果表明,改进的Sol-gel法制得的复合光催化剂具有明显的孔结构,而且比表面积大、粒径小、粒径分布窄、分散性好;与适量GeO2复合后能够有效提高TiO2纳米粒子的光催化活性;复合光催化剂的最佳制备条件为GeO2摩尔含量为0.1%,煅烧温度为400℃,所制得的GeO2/TiO2光催化活性比纯TiO2有显著提高.     

产品生命周期环境成本核算实例研究

针对项目层次环境成本核算技术存在的2大缺陷，构建了产品生命周期环境成本核算模型。以红矾钠产品生命周期为例，通过企业的实地调查，以直接计算法、费用当量法进行拟合，得到了红矾钠产品（产量2.28万t/a)生命周期环境成本为，直接计算法：5084.48万元；费用当量法：4941.43万元。分析了环境成本核算对可持续发展决策和管理的作用和意义。     

TiO2光催化技术在有害气体净化中的应用

主要介绍了TiO2光催化技术在有害气体净化中的应用、提高TiO2光化效率的方法以及影响TiO2光催化效率的因素。     

温室效应及其生态影响综述

温室效应是目前全球性的环境问题 ,本文介绍了温室效应的机理和温室气体的来源 ,分析了温室效应的主要生态影响 ,并探讨了减缓温室效应的措施。     

扩散法测定环境空气中的二氧化硫

介绍了利用自制分子扩散式个体采样器 ,监测环境空气中的二氧化硫的方法 ,该方法改 PRA光度法为离子色谱法 ,提高了方法的灵敏度。经实验室性能评价能够满足实验室测试的要求。并经有动力的溶液吸收管法现场对比测试 ,两种测试方法结果一致     

Ag/Al2O3催化剂用于碳氢化合物选择性还原NO

比较了富氧条件下CH4、C3H8、C3H6和C2H5OH分别用作还原剂时,NO在Ag/Al2O3催化剂上的还原活性.结果表明, CH4和C3H8还原NO的活性很低,而C3H6和C2H5OH能有效地还原NO.在此基础上,研究了H2O和SO2对C3H6和C2H5OH在Ag/Al2O3催化剂上还原NO活性的影响.结果表明,H2O的存在会降低低温区的NO还原活性,而且这种影响是可逆的.将H2O 和SO2同时加入反应混合气,引起NO还原活性较大幅度降低,结合程序升温脱附实验结果,认为可能是由于存在SO2时,Ag/Al2O3催化剂吸附NO的能力降低.     

SO2污染对小鼠骨髓细胞微核的诱发作用

在SO2吸入慢性染毒条件下,小鼠骨髓嗜多染红细胞（PCE）的微核细胞率与微核率均显著增加,且雌雄差异显著。结果也表明,SO2对阳性致突变剂乌拉坦航发微核的作用有显著抑制效应。本研究模拟SO2空气污染,从整体水平直接证实了SO2是哺乳类细胞染色体断裂剂、SO2与阳性致突变剂的联合作用是复杂的结论。     

不同DSA类阳极催化降解苯胺的试验研究

很多工业都产生苯胺废水。本文用新兴的电化学催化系统 ,采用特殊工艺自制的两种 DSA类电极作为阳极 ,对自配的苯胺溶液进行了降解处理 ,并得出了本试验范围内的最佳条件。     

Experimental and theoretical studies on NO selective catalytic oxidation over α-MnO2

Based on the experimental and theoretical methods, the NO selective catalytic oxidation process was proposed. The experimental results indicated that lattice oxygen was the active site for NO oxide over the $\mathrm{\alpha }$-MnO₂(110) surface. In the theoretical study, DFT (density functional theory) and periodic slab modeling were performed on an $\mathrm{\alpha }$-MnO₂(110) surface, and two possible NO oxidation mechanisms over the surface were proposed. The non-defect $\mathrm{\alpha }$-MnO₂(110) surface showed the highest stability, and the surface O_s (the second layer oxygen atoms) position was the most active and stable site. O₂ molecule enhanced the joint adsorption process of two NO molecules. The reaction process, including O₂ dissociation and O=N-O-O-N=O formation, was calculated to carry out the NO catalytic oxidation mechanism over $\mathrm{\alpha }$-MnO₂(110). The results showed that NO oxidation over the $\mathrm{\alpha }$-MnO₂(110) surface exhibited the greatest possibility following the route of O=N-O-O-N=O formation. Meanwhile, the formation of O=N-O-O-N=O was the rate-determining step.     

2-Chlorophenol oxidation kinetic by photo-assisted Fenton process

Experimental data are presented to test and validate a kinetic model for the oxidation of 2-chlorophenol wastewater by photo-assisted Fenton process. The data showed that this process had produced good effects under acidic conductions. Up to 90% 2-chlorophenol was removed after 90-minute reaction time with H2O2 of 25% CODCr. in, while in UV/H2O2 system ordy 16.8% 2-chlorophenol was removed after one hour treatment. The optimal pH in this reaction occurred between pH 3.0 and pH 4.0. The reaction kinetics for photo-assisted Fenton process experimented in this research was investigated. Kinetic models were proposed for the treatment of 2-chlorophenol wastewater. The reaction was found to follow the 2nd order. The equations of reaction kinetics are as follows:-d[RH]/dt=KRH[RH][H2O2]0exp(-KH2o2t);-d[CODCr]/dt=KCODCr[CODCr][H2O2]0exp(-K′t).The prediction of the models was found to be in a good agreement with experimental results, thus confimfing the proposed reaction mechanism.