Effect of lubricant sulfur on the morphology and elemental composition of diesel exhaust particles

This work investigates the effects of lubricant sulfur contents on the morphology, nanostructure, size distribution and elemental composition of diesel exhaust particle on a light-duty diesel engine. Three kinds of lubricant (LS-oil, MS-oil and HS-oil, all of which have different sulfur contents: 0.182%, 0.583% and 1.06%, respectively) were used in this study. The morphologies and nanostructures of exhaust particles were analyzed using high-resolution transmission electron microscopy (TEM). Size distributions of primary particles were determined through advanced image-processing software. Elemental compositions of exhaust particles were obtained through X-ray energy dispersive spectroscopy (EDS). Results show that as lubricant sulfur contents increase, the macroscopic structure of diesel exhaust particles turn from chain-like to a more complex agglomerate. The inner cores of the core-shell structure belonging to these primary particles change little; the shell thickness decreases, and the spacing of carbon layer gradually descends, and amorphous materials that attached onto outer carbon layer of primary particles increase. Size distributions of primary particles present a unimodal and normal distribution, and higher sulfur contents lead to larger size primary particles. The sulfur content in lubricants directly affects the chemical composition in the particles. The content of C (carbon) decreases as sulfur increases in the lubricants, while the contents of O (oxygen), S (sulfur) and trace elements (including S, Si (silicon), Fe (ferrum), P (phosphorus), Ca (calcium), Zn (zinc), Mg (magnesium), Cl (chlorine) and Ni (nickel)) all increase in particles.     

成都市污染边界层高度的演变特征分析

基于2014年1月21日至2月5日成都市人民南路四段逐时PM_(2.5)质量浓度、大气能见度资料以及同期Mie散射激光雷达探测数据,遵循消光系数与细颗粒物质量浓度之间的关系,探讨污染边界层高度的演变特征。结果表明:污染时段内的污染边界层高度偏低,平均为221m;污染边界层高度与地面PM_(2.5)浓度的变化具有明显相关性,但污染边界层高度改变在前,地面PM_(2.5)浓度响应在后;污染边界层高度的日变化表现为单峰单谷型,峰值和谷值分别出现在08:00时和14:00时前后。     

废旧印刷线路板电解过程中铜的分布特性

以废旧印刷线路板粉末为原材料,采用压片电解方法回收单质铜,研究了CuSO_4·5H2O浓度、H_2SO_4浓度、电流密度、电解时间和NaCl浓度对电解过程中Cu分布特性的影响。结果表明:废旧印刷线路板中的Cu以Cu2+的形式进入溶液,最终以粉末形式沉积在阴极;过高的H_2SO_4浓度、电流密度和NaCl浓度会导致析氢反应等,从而降低Cu在阴极和溶液中的分布;当CuSO_4·5H_2O浓度、H_2SO_4浓度、电流密度、电解时间、NaCl浓度分别为50 g/L、6 mol/L、80 m A/cm~2、5 h、40 g/L时,Cu在阴极、溶液、阳极泥中的分布比率分别为63.16%、34.14%和2.70%。     

台州市大气PM_(2.5)中PAHs的污染特征与毒性评价

使用中流量颗粒物采样器采集台州市2015—2016年大气PM_(2.5)样品,利用气相色谱-质谱仪对样品中16种多环芳烃(PAHs)进行分析,研究PAHs的污染特征及可能来源。结果显示:PAHs总浓度为(20.69±4.84)ng/m3,浓度季节变化大小顺序依次为冬季>春季>秋季>夏季,空间变化为商住区>工业区>背景点。PM_(2.5)中PAHs以高环为主(≥4环),占86%。不同季节商住区和工业区PAHs(4环)含量均略高于背景点,PAHs(5~6环)的含量商住区略高于工业区和背景点。PAHs环数分布和比值法结果表明台州市大气PM_(2.5)中PAHs的主要来源是机动车尾气和燃煤。成年人和儿童的终生超额致癌风险(ILCR)分别为8.02×10-7和5.61×10-7,表明台州市PM_(2.5)中PAHs对人体健康影响在可接受范围内。     

β射线法与重量法监测环境空气PM_(2.5)的应用比较

重量法是测量PM_(2.5)的传统手工经典方法,而β射线法加动态加热系统联用光散射法作为自动在线监测技术的常用方法被广泛使用。将5030-SHARP型β射线法加动态加热系统联用光散射法PM_(2.5)自动监测设备监测结果与手工法测量结果进行比对、分析,结果表明:β射线法与重量法监测结果具有一致性,测量结果不存在显著性差异;β射线法与重量法相对偏差值与温度、相对湿度、风速等气象因子的相关性不明显;β射线法与重量法监测结果的差异性与PM_(2.5)质量浓度、季节等条件有关;随着PM_(2.5)质量浓度逐渐升高,β射线法与重量法相对偏差的绝对值|RD|也随之增大,不同季节的|RD|平均值差异较大,春季、冬季的|RD|平均值大于夏季、秋季。     

不同粒径羟基磷灰石对污染土壤铜镉磷有效性和酶活性的影响

为研究不同粒径羟基磷灰石对重金属污染土壤的修复效果,采用向污染土壤添加常规磷灰石（150 μm）、微米（3 μm）和纳米（40 nm）羟基磷灰石的田间原位试验方法,考察其钝化修复5 a后对土壤铜镉磷有效性和酶活性的影响.结果表明:3种粒径羟基磷灰石均提高了土壤pH,降低了土壤交换性酸和交换性铝的含量,且微米羟基磷灰石处理效果最好.常规磷灰石、微米和纳米羟基磷灰石处理分别使w（离子交换态铜）降低了62.6%、74.3%和70.4%,w（离子交换态镉）降低了15.7%、25.3%和26.7%.3种材料均增加了土壤w（TP）,其中4.61%~17.4%和73.4%~89.8%分别转化为树脂磷和稳定态磷.微米羟基磷灰石处理分别使土壤脲酶活性和微生物量碳含量提高了4.66和0.66倍.研究显示,微米羟基磷灰石更有利于铜和镉由活性态向非活性态转化,增加土壤磷的有效性,提高土壤微生物活性,在我国南方重金属污染红壤区具有较好的应用潜力.      

Tissue distribution of perfluoroalkyl acids and health status in wild Mozambique tilapia (Oreochromis mossambicus) from Loskop Dam, Mpumalanga, South Africa

This study examined concentrations of 15 perfluoroalkyl acids (PFAAs) in tissues from male Mozambique tilapia (Oreochromis mossambicus) collected at Loskop Dam, Mpumalanga, South Africa in 2014 and 2016. Nine of the 15 PFAAs were detected frequently and were included in statistical analysis and included two of the most commonly known PFAAs, perfluorooctanesulfonic acid (PFOS) (median, 41.6 ng/g) and perfluorooctanoic acid (PFOA) (median, 0.0825 ng/g). Of the tissues measured, plasma (2016 and 2014 median, 22.2 ng/g) contained the highest PFAA burden followed by (in descending order): liver (median, 11.6 ng/g), kidney (median, 9.04 ng/g), spleen (median, 5.92 ng/g), adipose (median, 2.54 ng/g), and muscle (median, 1.11 ng/g). Loskop Dam tilapia have been affected by an inflammatory disease of the adipose tissue known as pansteatitis, so this study also aimed to investigate relationships between PFAA tissue concentrations and incidence of pansteatitis or fish health status. Results revealed that healthy tilapia exhibited an overall higher (p-value < 0.05) PFAA burden than pansteatitis-affected tilapia across all tissues. Further analysis showed that organs previously noted in the literature to contain the highest PFAA concentrations, such as kidney, liver, and plasma, were the organs driving the difference in PFAA burden between the two tilapia groups. Care must be taken in the interpretations we draw from not only the results of our study, but also other PFAA measurements made on populations (human and wildlife alike) under differing health status.     

铁炭内电解垂直流人工湿地对污水厂尾水深度脱氮效果

针对污水厂尾水总氮(TN)含量偏高、微生物可利用碳源低的问题,构建铁炭内电解垂直流人工湿地(ICIE-VFCW)装置,研究了ICIE-VFCW对尾水的处理效果,并采用紫外-可见光光谱(UV-VIS)、凝胶过滤色谱(GFC),进一步探讨了ICIEVFCW强化脱氮机制.结果表明,ICIE-VFCW可提高系统对尾水中COD的去除,出水COD可稳定在30 mg·L~(-1)以下,全年、暖季、寒季COD平均去除率较普通垂直流人工湿地分别可提高10.16%、9.81%、11.22%.系统出水TN可维持在10 mg·L~(-1)以下,全年、暖季、寒季TN平均去除率较普通垂直流人工湿地分别提高13.72%、12.90%、16.17%.经过人工湿地处理后,污水中有机物的腐殖度、芳香度及相对分子质量(Mr)均有所下降,且ICIE-VFCW中Mr下降更为明显.湿地基质掺杂铁炭可促进尾水中大分子有机物转化为小分子,为微生物提供更多可利用碳源,从而提高脱氮效率.     

雷达海杂波统计特性建模研究

介绍了海杂波统计特性建模的幅度特性、多普勒谱及空间相关这三个方面的研究状况,对各种建模的思路和模型效果进行了对比总结。对于幅度均值已有多个较为成熟的模型,但适用范围不同,结果差异也很大。幅度分布建模重点解决拖尾问题,复合建模是趋势。除平均谱外,开始研究短时多普勒谱。空间相关性建模主要建立空间相关长度与雷达及海洋参数间的联系,但是研究还不够全面。总的来看,已由单纯经验建模发展为力图在机理研究指导下有一定物理意义的建模。尽管海杂波建模效果愈来愈接近实际,但建模依然存在诸多问题。     

基于GIS和LUR模型的西安市PM2.5浓度空间分布模拟研究

基于地理信息系统GIS和土地利用回归LUR模型,模拟西安市PM2.5浓度空间动态分布,结果表明:与PM2.5浓度相关性最高的分别为缓冲区为2 km的水域面积、人口密度和距离水域距离,R 2分别为0.501,0.393和0.280;与PM2.5浓度相关性最低的分别为缓冲区为4 km的水域面积、未利用地面积和耕地面积,R 2分别为0.039、0.021和0.017.未考虑风速建立的LUR模型多元回归的相关系数为0.856,R 2为0.733,考虑风速的相关系数为0.892,R 2为0.796,表明风速对于污染物的分布影响较大,LUR模型模拟效果较好.模拟的PM2.5年均浓度高风险区分布于中部,中风险区分布于中西部,低风险区分布于东南部和西部.