纳米TiO2添加剂对DMDF发动机大负荷燃烧及PM排放影响的试验研究

在一台电控增压中冷四缸柴油机的进气道上加装一套电控喷射装置,使其运行柴油/甲醇双燃料(DMDF)模式.研究了甲醇中Ti O_2添加剂的添加量及同一添加剂添加量在不同甲醇分散系喷射量时对发动机大负荷工况的燃烧和颗粒物(PM)排放的影响.结果表明,在甲醇中添加适量(30和100 mg·kg~(-1))的纳米Ti O_2能够使爆发压力升高,对燃烧有一定的促进作用,但添加过量(100 mg·kg~(-1))会对燃烧产生不利影响.加入纳米Ti O_2后,干炭烟烟度排放和积聚态颗粒数明显降低,在添加剂添加量为1000 mg·kg~(-1)时,最大降幅分别达到26.8%和29.4%,而核态颗粒物排放变化不大.在相同添加剂添加量下,增加甲醇分散系替代率R_m会使放热始点后移,放热更加集中,爆发压力增大,干炭烟烟度和颗粒物排放均大幅度降低.在添加剂添加量为100 mg·kg~(-1)时,与R_m=10%相比,R_m=40%时爆发压力增加0.94 MPa,放热率峰值增加53.5%,烟度、核态颗粒数、积聚态颗粒数和颗粒物总数的降幅分别达66.9%、42.3%、67.0%和58.0%.     

成都市城区大气细颗粒物水溶性离子污染特征

为了解成都市城区大气细颗粒物水溶性离子污染特征,在成都市城区四季采集PM2.5有效样品共计102个,测得颗粒物质量浓度以及水溶性离子质量浓度(NH4+、Ca2+、Na+、Mg2+、K+、F-、NO3-、SO42-、Cl-),并分析其浓度变化特征,重点关注二次无机离子的污染特征及形成影响.结果表明,成都市城区水溶性离子与...     

北京地区PM10与秸秆燃烧排放单颗粒对比分析

采用场发射带能谱扫描电镜(FESEM/EDS)法分析北京怀柔地区PM10与秸秆燃烧排放颗粒的形貌特征和成分差异.结果显示:秸秆燃烧后排放颗粒物多为大粒径颗粒,成分上都含S、Cl和K元素.含有生物质燃烧标志元素K的PM10颗粒物多为含Si、Al和Na元素的燃煤飞灰和矿物颗粒,与秸秆燃烧排放颗粒组成化学元素差异明显.据此推...     

基于地面监测数据的2013~2015年长三角地区PM2.5时空特征

近年来,长三角地区灰霾天气持续增多,空气细颗粒物污染问题日益突出。基于2013年1月至2015年5月长三角地区及周边缓冲区内共214个空气质量监测站点PM_2.5逐时监测数据,运用普通克里金插值方法,从年、季、月尺度上分析了PM_2.5的空间分布格局和时间动态变化。结果表明:(1)2 a来,长三角地区PM_2.5浓度空间分布明显呈现整体北部高南部低,局部地区略有突出的分布特征;长三角地区PM_2.5浓度年均值为57.08μg/m³;其中,江苏省PM_2.5的年均值为三省市最高,为65.84μg/m³;其次为上海市,年均值为53.87μg/m³;浙江省PM_2.5的年均值较小,为51.53μg/m³。(2)从季节尺度分析,长三角地区PM_2.5浓度变化表现出冬春季高,夏秋季低的变化趋势;这与区域内冬季风向来源、降水稀少、气象扩散条件差有着密切的关系; (3)长三角地区月浓度变化大致呈U形分布; 12月份PM_2.5浓度最高; 3月份以后, PM_2.5浓度开始呈逐步下降趋势;在5~9月份,区域PM_2.5处于"U"字的谷底,其中6月份夏收时期秸秆焚烧、气象等因素导致PM_2.5浓度有略微升高;进入10月份后迅速攀升,且11、12月份呈现持续升高态势。     

西安市2013年PM_(2.5)浓度变化分析研究

全面分析2013年西安市13个国控环境空气质量自动监测子站PM2.5监测数据。结果表明:2013年西安市环境空气中PM2.5年均值为105μg/m3,超过《环境空气质量标准》(GB 3095—2012)二级要求(35μg/m3)200.0%,污染较严重;西安市各子站PM2.5月均值总体呈两边高、中间低的"V"型趋势,全市及各子站PM2.5月均值分别为44~206、32~275μg/m3;采暖期(上半年采暖期为1—3月,下半年采暖期为11—12月)、非采暖期(4—10月)PM2.5平均值分别为156、70μg/m3;上、下半年采暖期PM2.5平均值分别为178、124μg/m3;西安市气象风力以微风为主,雨天集中在5—9月,期间PM2.5月均值小于80μg/m3。     

湿法脱硫系统对烟气中可吸入颗粒物特性影响的实验研究

采用荷电低压颗粒冲击器对4套湿法烟气脱硫(WFGD)系统进出口颗粒物进行在线检测和采样分析,获得烟气中PM10、PM2.5质量浓度以及粒径分布特征,并通过场发射扫描电镜(FESEM)和元素能谱对飞灰颗粒的形貌特征和主要元素含量进行分析。实验结果表明,由于脱硫塔喷淋浆液的洗涤作用,WFGD系统对飞灰颗粒有一定的脱除效果,但喷淋浆液产生的小液滴以及石灰石/石膏颗粒被携带进入烟气,导致WFGD系统对烟气中颗粒物质量浓度及粒径分布影响较大。WFGD系统对飞灰颗粒组成成分也有一定影响,以WFGD系统B为例,出口飞灰颗粒中Ca和S的质量分数从进口的1.60%、2.81%上升到出口的6.12%、10.92%。FESEM观察结果表明,脱硫后小颗粒在脱硫浆液的促进作用下团聚凝并,形成大颗粒,呈现致密的不规则块状、层状或絮状结构。     

复合式静电除尘器脱除电厂排放PM2.5研究

控制燃煤电厂的小颗粒PM2.5排放是控制大气可吸人颗粒物污染的重要途径之一.传统静电除尘器对亚微米级颗粒脱除效率较低,为提高脱除效率,建立了一种脉冲预荷电直流收尘的复合式除尘系统,采用较低能耗的高压窄脉冲放电对颗粒物预荷电,大大提高了亚微米级颗粒的荷电量.结合传统的直流静电除尘器可以大幅提高对亚微米级颗粒的脱除效率,对小于1μm的颗粒脱除效率可以达到90%以上.并分析了脉冲荷电的电源形式和电压等因素对脱除效率的影响,为改造传统静电除尘器提供了理论支持.     

开放源对环境空气质量影响的评估技术与实例

开放源排放的颗粒物已经成为城市环境大气颗粒物的主要来源之一,介绍了其对环境空气质量影响的评估技术,采用开放源的动力学经验公式测算S市粉煤灰场、原煤堆场、土堆、沙石料堆4类开放源不同粒径颗粒物的起动风速及扩散距离,并利用箱模型(A值)和源解析(化学质量平衡法,CMB)模型测算开放源的区域年均起尘量及其对环境空气中颗粒物的贡献值.结果表明:开放源排放的颗粒物易升腾而且影响面积很大;S市区开放源类排放的小于100 μm的颗粒物约22.2×104 t/a,小于10 μm的颗粒物约15.8×104 t/a;开放源对环境空气中TSP的贡献值约370 μg/m3,质量浓度分担率达60%,对PM₁₀的贡献值约263 μg/m3,分担率达64%.      

A new approach to Assess Atmospheric Nitrogen Deposition by Way of Standardized Exposition of mosses

A standardized method of moss exposition for assessing variations in nitrogen deposition was tested in the western part of Germany. Six pleurocarpous moss species were transplanted to two sites differing in their deposition rates but being comparable as to their climatic conditions. The mosses were exposed in standardized containers over a period of 12 months; the focus of interest was the effect of N deposition on nitrogen content and on ¹⁵N natural abundance (δ¹⁵N-values). Within the first nine months only trends could be observed. However, after one year all species tested showed significantly higher N concentrations at the highly polluted site. Besides, more negative δ¹⁵N-values possibly reflecting the higher ammonium input were detected at this site. Surprisingly, most of the plants though being kept in plastic containers without a favourable substratum did not show any conspicuous deficiency symptoms. The potential advantages of a standardized moss exposition for N monitoring purposes are discussed. It is concluded that the method presented here can yield significant results in particular if the number of testing sites is increased.     

The Metallic Composition of Aerosols at Three Monitoring Sites in Korea During Winter 2002

In the present study, the distribution patterns of various metals were analyzed and compared using PM samples collected concurrently from three monitoring sites located in Korea (Seoul, Busan, and Jeju island) in December 2002. As these sites can represent metal pollution with different degrees of anthropogenic activities, their concentration levels were distinguished in a systematic manner in the order of Jeju, Busan, and Seoul. By comparing the present data sets with those measured previously from other locations in Korea and around the world, we attempted to diagnose the general status of elemental pollution on the Korean peninsula. Through an application of different statistical approaches, the major processes controlling elemental levels were assessed for each of the three study sites. The results indicated the importance of both crustal and anthropogenic sources in all sites with their relative roles varying significantly from each other. The results of the metal analysis data, when examined in relation to back trajectory analysis, confirmed that their concentration changes are affected quite sensitively with air mass movement patterns. The overall results of this study consistently indicated the contribution of a strong anthropogenic source area (e.g., China) to the observed metal concentration levels in the study area, but the strengths of such signals vary considerably across the Korean peninsula.