海洋环境水下电场时频特征分析

目的掌握海洋环境水下电场主要能量来源和衰减规律。方法结合理论研究环境电场幅值随时间的变化规律,重点分析水下环境电场不同频带的频谱分布,最后计算得到海洋环境水下电场不同频点的幅值在整个频带所占比重。结果海洋环境水下电场随海水电导率和海水运动强度的减弱,幅值降低,能量主要集中在0.01~1 Hz的低频以及工频处,在一定的空间范围内海洋环境水下电场的一致性较强。结论实验结果与理论分析结果具有一定的吻合度。     

模拟烹饪油烟的粒径分布与扩散

烹饪油烟颗粒物粒径分布与扩散特性研究有助于解析其对室内空气质量和居民健康的影响,采用电子低压撞击器(ELPI)实时监测了油烟机开启和关闭状态下,模拟烹饪油烟发生处和3 m外位置处,0.03~10μm范围内油烟颗粒数浓度和质量浓度随粒径分布.油烟颗粒主要以655 nm以下的细颗粒为主.油烟机能够显著降低室内油烟浓度,开启油烟机后,油烟发生处颗粒数浓度从2.8×106个·cm-3降低到2.3×105个·cm-3,PM2.5(空气动力学直径≤2.5μm的颗粒)质量浓度从85.9 mg·m-3降低到6.2 mg·m-3.油烟机对PM10的净化效率高于PM2.5.油烟迅速从发生处扩散到3 m外,无通风状态下,总颗粒数浓度衰减达65%,PM2.5质量浓度衰减达75%.计算流体动力学(CFD)模拟了油烟机对油烟PM2.5质量浓度场扩散分布影响.红外摄像仪监测了油烟温度场分布扩散,以扇形向外扩散,伴随着油烟温度梯度降低.     

我国南方四省集中连片水稻田土壤重金属污染评估研究

以2013—2014年南方湖南、江西、浙江、福建四省集中连片水稻田的63个采样数据为基础,利用单因子评价法和内梅罗指数评估南方水稻田土壤重金属的污染情况.结果表明:南方集中连片水稻田土壤Cd点位超标率为0;Hg、As和Ni 3种重金属含量超出《土壤环境质量标准》(GB15618-1995)二级标准的比例最大,分别为6.3%、4.8%和7.9%;研究区水稻田土壤重金属以清洁为主,70%以上符合农业生产和生活要求,但少量样点Hg为中度和轻度污染,As和Ni为轻度污染;从内梅罗综合指数看,研究区土壤重金属仅有3.18%和1.59%的为轻度污染和中度污染,主要分布在湖南和江西.     

热阻力概念的修正及计算方法

以隧道火灾为背景,对一维加热管流中的热阻力进行了研究。通过压力场数值模拟与理论分析,直接证实了热阻力的存在,并表明传统概念上的热阻力明显大于实际的能量损失。根据能量方程提出水平无粘管流的热阻力应等于气流经过加热区的全压力降,而非静压力降;等截面管流的热阻力大小应为传统热阻力值的1/2。这一修正使热阻力概念具有了严格的流体力学意义。在定义新的热阻力系数基础上,建立了2个热阻力系数表达式及低马赫数条件下热阻力的近似表达式。将该近似表达式与热损失方程进行对比,表明两者在低马赫数条件下具有一致性。研究成果进一步发展了热阻力理论体系,对隧道火灾及其它相关工程热物理问题的研究与应用都具有重要价值。     

影响脱硫塔性能的因素分析与研究

湿法烟气脱硫是成熟且具有较好发展前景的工艺,其中关键是对脱硫塔的选择及通过各项参数的控制达到良好的脱硫效率.通过对脱硫塔酸碱度(PH)、气液比(L/G)、流场特性、结垢等各种性能进行分析研究,对脱硫塔的选择和实际运行具有一定的指导意义.     

Mass transport model of ions within biofilms under the effect of external field

A mass transport model was developed to predict the transport rate of ions within biofilms, which was experimentally verified using the fluxes of NH4^＋ and Ca^2＋ through the heterotrophic biofilms with the thickness varying from 230 to 1430μm under the effect of external field in the range of-20 V/m to 60 V/m. It is found that the result predicted by the model is in agreement with the experimentally obtained one, with the error less than 5 percent for the thin biofilms. The error increases with the increase of the biofilm thickness. The transport rate of ions caused by electric migration is affected by the charges, field strength, and biofilm thickness and so on.     

热力耦合作用对桩及桩间土拱效应的影响研究*

为研究负温对桩侧应力及桩间土拱效应的影响,通过FLAC3D软件模拟热力耦合作用下新型排桩冻结法中桩间土拱效应的变化及温度效应下的桩间距,并根据巴霍尔金单排管冻结稳态温度场解析解,建立冻结壁平均温度区域解。研究结果表明:桩土接触面的应力分量τxy近似线性变化,应力分量σx近似均匀分布,温度降低对应力分量τxy的分布影响较小,但对应力分量σx的影响较大;负温使桩间距发生变化,且整体平均应力的分布也更加均匀化;通过与巴霍尔金解析解对比,证明单排管冻结温度场模型的可行性,在此基础上建立的单排管冻结壁平均温度区域解,其与数值模拟结果相差不超过1 ℃,计算误差满足工程要求;随着冻结时间的增加,单排管冻结壁温度场呈抛物线形式降低。     

隧道竖井外流场模拟及风塔外型结构优化研究

为提高长大隧道施工及运营通风过程中竖井通风效率,实现隧道节能通风。依托实际隧道工程,基于Fluent软件,选用RNG k-ε湍流模型,对无竖井风塔、圆柱风塔、矩形风塔和凸台状风塔4种结构、不同环境风速工况下的流场进行数值模拟,并对模拟结果进行交叉比对分析,提出最优化的竖井风塔结构形式。研究结果表明:采用风塔结构竖井出流量要远大于无风塔结构竖井出流量;对于不同竖井风塔外型结构,竖井出流量与环境风速关系呈多项式函数;当倾斜角为45°、圆心角为90°时,凸台结构对应竖井出流量最大,且受环境风影响波动较小,通风稳定性较好。建议竖井出口结构选用矩形或凸台状,实现对环境风的高效利用,提高竖井通风效率。     

油气田含油污泥处理相关标准解析

通过对目前已出台油气田含油污泥处理相关标准的解析,针对标准之间存在着适用范围不一致、检测项目名称及限值不一致、检测方法不统一以及计算基础不统一等,造成油气田环保工作者和管理者认识上的混乱,对含油污泥处理技术的选用和治理市场的管理带来诸多问题。为加快促进油气田含油污泥处理减量化、资源化、无害化技术的发展,建议尽快出台有针对性、普适性强、统一的油气田含油污泥污染控制标准,确保含油污泥处理既科学合理,又经济可行;同时制定针对性强的含油污泥污染物检测方法,检测方法统一、计算公式一致,保证结果真实可靠,具有可比性。     

Numerical study on premixing characteristics and explosion process of starch in a vertical pipe under turbulent flow

Fire and explosion accidents are frequently caused by combustible dust, which has led to increased interest in this area of research. Although scholars have performed some research in this field, they often ignored interesting phenomena in their experiments. In this paper, we established a 2D numerical method to thoroughly investigate the particle motion and distribution before ignition. The optimal time for the corn starch dust cloud to ignite was determined in a semi-closed tube, and the characteristics of the flame propagation and temperature field were investigated after ignition inside and outside the tube. From the simulation, certain unexpected phenomena that occurred in the experiment were explained, and some suggestions were proposed for future experiments. The results from the simulation showed that 60–70 ms was the best time for the dust cloud to ignite. The local high-temperature flame clusters were caused by the agglomeration of high-temperature particles, and there were no flames near the wall of the tube due to particles gathering and attaching to the wall. Vortices formed around the nozzle, where the particle concentration was low and the flame spread slowly. During the explosion venting, particles flew out of the tube before the flame. The venting flame exhibited a “mushroom cloud” shape due to interactions with the vortex, and the flame maintained this shape as it was driven upward by the vortex.