污泥淤砂分离器再分离底流污泥

研究了污泥淤砂分离器对分离原污泥所得的底流污泥进行再分离时,分离分流污泥的性质。实验结果表明,原污泥MLVSS/MLSS为0.372,1次分离后得到的底流污泥MLVSS/MLSS为0.222,2次分离后得到的底流污泥MLVSS/MLSS为0.126,表明通过底流污泥再分离,能够进一步降低底流污泥中生物有机质的含量,提高底流污泥中无机淤砂的含量。同时,原污泥CST为2.85(s·L)/g SS,1次分离后得到的底流污泥CST为0.98(s·L)/g SS,2次分离后得到的底流污泥CST为0.12(s·L)/g SS,表明底流污泥再分离进一步提高了底流污泥的脱水性能,最终得到的底流污泥脱水性能良好。     

不同运行模式对同步脱氮除磷CAST工艺快速启动及其稳定维持的影响

以实际生活污水为处理对象,考察了传统进水/曝气和改良型分段进水的交替缺氧-好氧(A/O)2种运行模式对CAST工艺的快速启动及脱氮除磷性能稳定维持的影响。结果表明,传统进水/曝气运行模式下,系统达到最佳营养物去除性能所需启动时间30 d,稳定运行阶段TN平均去除80.66%,磷的去除率维持在66.30%左右;采用改良型交替运行模式,反应器达到稳定运行状态仅需18 d,系统稳定运行时TN平均去除81.36%,磷去除率稳定维持在90%以上,出水磷浓度在0.3 mg/L以下,出水水质达到国家污水综合排放标准一级A(GB8978-2002)。研究还发现,传统运行模式下,由低温引起的污泥沉降性能变差导致系统污泥严重流失,反应器几乎丧失污染物去除性能;而低温对交替运行模式下的反应器除磷性能几乎没有影响,总氮去除则因氨氮不完全硝化而大大降低。     

微生物燃料电池的专利技术综述

检索了微生物燃料电池在中国的发明专利文献,综述了微生物燃料电池在废水处理中的应用及与现有技术中其他水处理技术耦合的专利进展,并对其实际应用的前景进行了展望。     

污水处理厂剩余污泥对凤仙花和万寿菊生长的影响

采用盆栽方式,通过对花卉植物生长状况和各项生理指标的考察,研究了不同污泥施用比对凤仙花(Impatiens balsamina)和万寿菊(Tagetes erecta L.)生长的影响。结果表明,污泥施用比不高于5%(质量分数)时对两种花卉植物发芽有促进作用。在前期,对照组凤仙花和万寿菊生长较好,其株高、叶绿素和可溶性糖含量高于污泥施用组,丙二醛(MDA)含量低于污泥施用组。而在后期,污泥的施用对两种花卉生长促进作用明显,污泥施用组的两种花卉植物株高和各项生理指标优于对照组,尤其是开花状况显著好于对照组。凤仙花和万寿菊较优的污泥施用比分别为3%~5%和1%~5%。     

电渗透脱水污泥干燥特性曲线及干燥模型

通过电渗透脱水技术及自然风干技术两种预处理方式降低污泥含水率,当污泥初始含水率相近时,研究经两种方式处理后污泥的干燥特性曲线,并对电渗透脱水污泥干燥特性曲线的优势情况进行探讨。在40—120℃的低温条件下,研究电渗透脱水污泥（泥饼厚度为3．5mm）的干燥特性曲线并分析其干燥特性。通过所得电渗透脱水污泥的干燥特性曲线,引人薄层污泥干燥模型进行数值分析。结果表明,在实验条件下,电渗透脱水污泥的干燥速率要优于自然风干污泥的干燥速率。随着温度的升高,电渗透脱水污泥的干燥速率随之升高,干燥到所需含水率的时间则随之减少。Logarithmic模型比其他模型更适合描述薄层电渗透脱水污泥在低温条件下的干燥特性。     

3种运行模式下CAST工艺脱氮性能

以模拟城市污水为处理对象,采用循环式活性污泥法（CAST）反应器,对3种运行模式（M1：常规模式,M2：缺氧好氧模式、M3：缺氧好氧交替模式）下系统的脱氮性能进行了研究,比较了各模式下CAST反应器的氨氮和总氮的去除效率,并对各模式下典型周期内氮基质浓度变化进行了考察,以确定系统的脱氮模式。结果表明,在氨氮去除不成为限制条件（去除率〉90％）的条件下,3种运行模式下系统总氮的平均去除率分别为67．3％、70．6％和82．4％,以缺氧好氧交替模式下的最高;M1、M2和M3均可实现亚硝酸型硝化,但随着温度的升高,亚硝酸型硝化逐渐消失。静态实验分析表明,3种模式下系统的氨氧化速率大小次序为：vN：M1〉vN：M2〉vN：M3,反硝化速率大小次序为：vDN,M2〉vDN,M3〉vDN,M1。     

颗粒状污泥活性炭流化床吸附处理含铜矿山废水

以城市污水处理厂活性污泥为原料,通过高温热解制备了颗粒状污泥活性炭吸附剂。在自制的流化床吸附装置上研究了该吸附剂对含铜矿山废水的吸附处理效果。实验结果表明：在初始废水pH6、吸附剂加入量15g/L、废水循环流量6.0L/min、吸附时间120min的最佳吸附条件下,废水中Cu²⁺去除率达98.2%。     

UASB-SBR-絮凝工艺处理地沟油制生物柴油废水

采用UASB-SBR-絮凝工艺处理地沟油制生物柴油废水,考察了各个阶段的废水处理效果。实验结果表明：UASB稳定运行阶段进水COD约为15000mg/L时,COD去除率约为87%,出水COD在2500mg/L以下,出水挥发性脂肪酸（VFA）浓度为4~6mmol/L,最佳容积负荷为15.0kg/（m3·d）;采用SBR处理UASB出水,当容积负荷为1.5kg/（m3·d）时,出水COD在200mg/L以下,COD去除率在83%以上,ρ（NH₃-N）在5mg/L以下,TP约为25mg/L。向SBR出水中加入质量分数为5%的聚合氯化铝进行化学除磷,加入量为5mL/L,处理后废水TP为4~6mg/L。处理后废水的COD,ρ（NH₃-N）,TP均达到CJ343-2010《污水排入城市下水道水质标准》的A类要求。     

Feasibility of vermicomposting dairy biosolids using a modified system to avoid earthworm mortality

Abstract

A laboratory study was conducted to examine the feasibility of vermicomposting dairy biosolids (dairy sludge), either alone or with either of the bulking agents ‐ cereal straw or wood shavings, using the epigeic earthworm ‐ Eisinea andrei. Earthworms added directly to these three substrates died within 48 hours. A system was developed to overcome the toxic effect of unprocessed dairy biosolids. The substrates were placed over a layer of vermicomposted sheep manure into which the earthworms were inoculated. Within two weeks, all earthworms were within the upper layer of substrate. Compared to sheep manure which is a favourable substrate for vermicomposting, the three substrates containing dairy biosolids were more effective in supporting earthworm growth and reproduction. The final products obtained after 63 days of vermicomposting had 39–53% less organic carbon than the initial substrates. Organic fractionation indicated that vermicomposting increased the stability of the materials to biological decomposition. The vermicomposts obtained from the three substrates with dairy biosolids had low heavy metal contents and electrical conductivities, and did not inhibit plant growth when compared with a commercial vermicompost in a bioassay.     

Co-composting of Paper Mill Sludge and Hardwood Sawdust Under Two Types of In-Vessel Processes

Abstract

Recycling of organic residues by composting is becoming an acceptable practice in our society. Co-composting dewatered paper mill sludge (PMS) and hardwood sawdust, two readily available materials in Canada, was investigated using uncontrolled and controlled in-vessel processes. The composted materials were characterized for total C and N, water-soluble, acid-hydrolyzable, and non-hydrolyzable N, extractable lipids, and by Fourier Transform Infrared (FT-IR) spectrophotometry. In the controlled scale process, the loss of organic matter was approximately 65% higher than in the uncontrolled process. After undergoing initial fluctuations in N fractions during the first two days of composting, by the end of the process, concentrations of water-soluble N decreased while those of acid-hydrolyzable and nonhydrolyzable N increased in the controlled process, whereas in the uncontrolled process, water-soluble N increased, but N in the other two fractions decreased continuously, indicating that the biochemical transformations of organic matter were not completed. Data on extractable lipids and FT-IR spectra suggest that the compost produced from the controlled process was bio-stable after 14 days, while the uncontrolled process was not stabilized after 18 days. In addition, FT-IR data suggest the biological activity during composting centered mainly on the degradation of aliphatic structures while aromatic structures were preserved. The co-composting of the PMS and hardwood sawdust can be successfully achieved if aeration, moisture, and bio-available C/N ratios are optimized to reduce losses of N.