钢厂热锯机噪声控制方案

某钢厂热锯机的工作噪声问题严重影响附近居民的日常生活，急需解决。根据其发声机理，通过采取对圆盘锯边缘开槽，安装吸隔声罩，对锯片增加阻尼材料，夹紧工件等措施取得了较好的降噪效果。     

炼油厂"三泥"离心脱水处理研究

通过对目前炼油厂“三泥”性状的调查，利用已有污泥处理设施进行了炼油厂“三泥”离心分离的现场试验，并分析了影响“三泥”离心分离处理工艺的主要因素，发现了离心机转速和絮凝剂投加量对“三泥”离心分离的有关规律和最佳操作条件，在此基础上，提出了适合炼油厂“三泥”处理系统的优化方案。     

活性污泥吸附重金属Cr6+的研究

以活性污泥为材料，采用不同时间、温度、pH进行吸附重金属Cr^6 的研究。实验结果表明，当吸附时间为15min，吸附温度为28℃，吸附pH=7时具有较好吸附效果。在此条件下，当重金属Cr^6 浓度为50mg/L，其吸附率可达97．2％。     

固硫剂制备工艺探讨

探讨了循环流化床锅炉脱硫方法中固硫剂的制备工艺，对几种石灰石破碎设备及工艺进行了分析比较，通过柱磨机粉磨石灰石的工业试验，了解其产品粒度分布，从而择优确定固硫剂制备工艺流程。     

含油污泥固化处理后油的迁移研究

利用紫外分光光度计和索氏抽提器,研究了温度、土壤含水率以及水泥与污泥的不同比例等因素在不同时间对含油污泥固化后油迁移的影响。试验结果表明:对于强度为3.84MPa的污泥固化块,油的迁移量从240h迁移6.8mg变为480h迁移178mg,之后变化较小。在20℃～30℃时,随着温度的增加,迁移量从6.8mg增加到20.6mg,超过30℃以后迁移量的增幅变小。水泥与污泥的比例从1∶0.8增加到1∶1.4,油的迁移量从256mg降到27.2mg,之后未检测到。960h后,迁移量达到348mg,此时土壤中油含量为1.16%,在环境的自净作用下,土壤能完全容纳;强度大于9.56MPa时未检测到油。这表明用固化法处理油田含油污泥是安全可靠的。     

改进型石灰混凝法去除城市污水二级出水中有机物的研究

将石灰混凝处理后的沉淀泥渣进行回流，对石灰混凝法进行改进，研究改进后的石灰混凝法对城市污水二级出水中有机物的去除效果。结果表明，活性泥渣回流有利于提高石灰混凝法对城市污水二级出水中有机物的去除。回流位置在石灰投加前、复合絮凝剂投加后，最佳回流量为新泥渣产生量的100％～200％，活性泥渣回流的最佳pH为11．0～11．5；活性泥渣中CaCO3、Mg(OH)2、Fe(OH)3等沉淀物以及有机高分子絮体均有助于提高其对有机物的去除效果，其中Mg(OH)2沉淀物起主导作用；含循环泥渣的活性污泥回流，对有机物的去除效果无明显影响。     

Environmental assessment of supercritical water oxidation of sewage sludge

Environmental aspects of using supercritical water oxidation (SCWO) to treat sewage sludge were studied using a life cycle assessment (LCA) methodology. The system studied is the first commercial scale SCWO plant for sewage sludge in the world, treating sludge from the municipal wastewater treatment facility in Harlingen, TX, USA. The environmental impacts were evaluated using three specific environmental attributes: global warming potential (GWP), photo-oxidant creation potential (POCP) and resource depletion; as well as two single point indicators: EPS2000 and EcoIndicator99. The LCA results show that for the described process, gas-fired preheating of the sludge is the major contributor to environmental impacts, and emissions from generating electricity for pumping and for oxygen production are also important. Overall, SCWO processing of undigested sewage sludge is an environmentally attractive technology, particularly when heat is recovered from the process. Energy-conserving measures and recovery of excess oxygen from the SCWO process should be considered for improving the sustainability potential.     

CO2-free paper?

Black liquor gasification–combined cycle (BLGCC) is a new technology that has the potential to increase electricity production of a chemical pulping mill. Increased electricity generation in combination with the potential to use biomass (e.g. bark, hog fuel) more efficiently can result in increased power output compared to the conventional Tomlinson-boiler. Because the BLGCC enables an integrated pulp and paper mill to produce excess power, it can offset electricity produced by power plants. This may lead to reduction of the net-CO₂ emissions. The impact of BLGCC to offset CO₂ emissions from the pulp and paper industry is studied. We focus on two different plant designs and compare the situation in Sweden and the US. The CO₂ emissions are studied as function of the share of recycled fibre used to make the paper. The study shows that under specific conditions the production of “CO₂-free paper” is possible. First, energy efficiency in pulp and paper mills needs to be improved to allow the export of sufficient power to offset emissions from fossil fuels used in boilers and other equipment. Secondly, the net-CO₂ emission per ton of paper depends strongly on the emission reduction credits for electricity export, and hence on the country or grid to which the paper mill is connected. Thirdly, supplemental use of biomass to replace fossil fuel inputs is important to reduce the overall emissions of the pulp and paper industry.     

气田污泥脱水工艺研究

在对气田废水处理中产生的污泥进行处理时,普遍存在着干化周期长、含水率高等问题,严重影响了废水处理装置的处理能力。脱水剂优化选择实验以及污泥脱水性能实验结果表明:先加入聚合氯化铝并搅拌15 s,再加入阴离子聚丙烯酰胺并搅拌混合30 s,最后加入FO4190SH搅拌,混合凝聚30 s后静止分层,其凝聚效果较好。在污泥脱水性能的各项指标中,真空脱水均好于重力脱水,特别是对于新鲜污泥滤层,真空(45 kPa)脱水速度比重力脱水速度约高8倍。     

含油污泥特点及处理方法

含油污泥主要来源于油田开采、油气集输及污水处理场,污泥中一般含油率在10%～50%,含水率在40%～90%。文章介绍了不同来源含油污泥的特点及脱水方法,并对各种含油污泥处理方法的优、缺点进行了比较。研究结果表明,各种方法都有其特点和适用范围。由于含油污泥成分复杂,没有任何一种处理方法可以处理所有类型的含油污泥。