长期储存亚硝化颗粒污泥的活化及菌群结构变化

采用无机人工配水,通过逐级提高进水氨氮负荷(0.32~0.64kg/(m³·d))和设定合适的初始游离氨浓度(3.7~7.2mg/L),在SBR反应器中对常温(24~29℃)下储存1a的亚硝化颗粒污泥(NGS)进行了活化,并使用Miseq高通量测序技术分析了污泥中微生物多样性的变化情况.结果表明,NGS的亚硝化性能可在短时间内恢复.运行8d后,反应器的氨氮去除率达到95%以上,亚硝态氮累积率超过了80%,但污泥粒径持续减小,胞外聚合物(EPS)含量明显降低.活化至第20d,NGS的氨氮比去除速率和亚硝态氮比累积速率分别达到24.6mg/(gVSS·h)、23.8mg/(gVSS·h),平均粒径稳定在0.5mm左右.在活化期间,绝大部分厌氧、异养菌属被洗脱,污泥的微生物多样性显著降低.Nitrosomonas等氨氧化菌的相对丰度由活化前的1%上升至约58%,同时,Nitrospira等硝化菌的生长受到了选择性抑制.这意味着即使经历长期的常温储存,NGS仍可作为SBR的接种污泥,实现反应器的快速启动.     

活性污泥数学模型中异养菌产率系数的测定研究

利用活性污泥数学模型预测污水生物处理系统,首先必须确定其参数和水质组分。采用间歇活性污泥法和呼吸计量法对活性污泥数学模型中异养菌产率系数γ_H进行测定研究。结果表明,间歇活性污泥法测定结果重现性较差,试验控制条件比较严格;呼吸计量法测定结果准确性较高,重现性良好,因而,呼吸计量法是比较可行的γ_H测定方法。     

A~2/O-曝气生物滤池工艺处理低C/N比生活污水脱氮除磷

以低C/N比实际生活污水为研究对象,重点考查了A2/O-曝气生物滤池生化系统的脱氮除磷特性.同时,考虑到A2/O工艺的主要功能是除磷及反硝化,而曝气生物滤池则以硝化为目的.因此,通过缩短A2/O的泥龄,可将硝化过程从A2/O中分离出去,让曝气生物滤池完成硝化,实现硝化菌和聚磷菌的分离,并解决了硝化菌和聚磷菌泥龄之间的矛盾.试验结果表明,该生化系统可实现有机物、氮和磷的同步去除.在平均C/N比为4.2,内回流比R为250%的条件下,平均进水COD、TN、TP分别为239.9、57.3和5.1mg·L-1,平均最终出水COD、TN、TP分别为34.1、13.3和0.1mg·L-1,去除率分别为85.8%、76.9%和98.3%.曝气生物滤池对氨氮几乎保持了100%的去除率.序批试验表明,反硝化聚磷菌占聚磷菌的比例为40.5%.     

Thermal stabilization of chromium slag by sewage sludge: Effects of sludge quantity and temperature

To investigate the feasibility of detoxifying chromium slag by sewage sludge,synthetic chromium slag containing 3% of Cr(VI) was mixed with sewage sludge followed by thermal treatment in nitrogen gas for stabilizing chromium.The effects of slag to sludge ratio(0.5,1 and 2) and temperature(200,300,500,700 and 900°C) on treatment efficiency were investigated.During the mixing process before thermal treatment,59.8%-99.7% of Cr(VI) was reduced,but Cr could be easily leached from the reduction product.Increasing heating temperature and decreasing slag to sludge ratio strengthened the reduction and stabilization of Cr(VI).When the slag to sludge ratio was 0.5 and thermal treatment temperature was 300°C,the total leached Cr and Cr(VI) declined to 0.55 mg/L and 0.17 mg/L respectively,and 45.5% of Cr in the thermally treated residue existed as residual fraction.A two-stage mechanism was proposed for the reduction and stabilization of Cr.     

进料负荷调控培养好氧颗粒污泥的试验研究

采用厌好氧交替的SBR反应器,以进料负荷（即进水浓度）作为主要控制参数,研究了好氧颗粒污泥的关键培养技术.结果表明,在30 min的较长污泥沉降时间下,通过进料COD 0～900 mg·L^-1的负荷调控,可以有效控制反应器内污泥生长.初始接种污泥的沉降性能对颗粒污泥产生很重要,SVI值保持在20～50 mg·L^-1才能有助于颗粒污泥形成和培养.应用“空曝”这种强力负荷调控方式可大大改善污泥沉降性能,并促进颗粒污泥的形成.通过进料减负荷运行可很好实现污泥的“完全颗粒化”培养.颗粒化转变出现在进料浓度COD 400～500 mg·L^-1,污泥浓度约8～10 g·L^-1.“完全颗粒化”污泥的性能优异,粒径约1.0 mm,SVI值25～35 mg·L^-1,最大沉降速率60 m·h^-1.污泥颗粒过程的发生可能决定于SBR的独特间歇式运行,即基质浓度的贫富交替,减负荷运行可强化基质贫富交替并增大颗粒化过程的驱动力.     

细河污泥填埋渗滤液现状及处理方法研究

细河污泥含重金属和复杂有机污染物,填埋处理后产生的渗滤液会含一定量污染物质,对渗滤液的污染水平和污染特征进行了研究,对处理方法进行了比较和筛选,从而为渗滤液的最终无害化处理提供了参考依据。     

AUSB中置曝气对CANON颗粒污泥工艺的影响

常温(25±1)℃下,向中置(R1)、底部曝气(R2)的AUSB反应器中接种絮状厌氧氨氧化(ANAMMOX)污泥,研究AUSB不同曝气位置对连续流CANON颗粒污泥工艺启动及运行的影响.结果表明,R1、R2分别于第43 d、56 d成功启动CANON颗粒污泥,平均粒径分别为214.79μm、205.27μm,特征值(ΔNO-3-N/ΔTN)为0.128、0.129.低氨氮(90 mg·L-1)下,逐步增大氮负荷(NLR),AUSB中置曝气更利于CANON颗粒粒径的持续增长及脱氮负荷(NRR)的提高,R1于第88 d颗粒平均粒径即增至507.46μm,NRR达0.277 kg·(m3·d)-1;R2污泥颗粒历时108 d,粒径增长至467.72μm,NRR仅为R1的87.73%.底部曝气AUSB全程好氧模式下长期运行,亚硝酸盐氧化菌(NOB)显著增殖,第125 d后特征值增至0.136±0.004,NRR仅(0.231±0.015)kg·(m3·d)-1;而中置曝气AUSB特定的缺氧/好氧模式有效抑制了NOB活性,特征值维持在0.127±0.003,NRR为(0.262±0.019)kg·(m3·d)-1.AUSB中置曝气可促进絮状ANAMMOX污泥演变至CANON颗粒污泥,且系统脱氮性能及运行稳定性均优于底部曝气AUSB.     

可见光驱动微生物光电化学池处理剩余污泥同步产氢

氢气是一种理想的清洁能源.太阳能驱动的微生物光电化学池(Microbial photoelectrochemical cell, MPEC)因可同时实现废物处理与自发产氢而受到人们的关注.本文以剩余污泥为底物,构建了一种由无定型硫化钼改性硅纳米线(MoS_3/SiNWs)光阴极和生物阳极组成的MPEC系统,研究了3组MPEC在不同的酸性阴极液pH和外加电压条件下的产氢及污泥减量效果.研究结果表明,MPEC在阴极液pH为1和3的条件下均能在无外加电压下自发产氢;pH=1的MPEC-1实验中平均产氢速率为(0.66±0.02) mL·h~(-1),约是pH=3的MPEC-2实验平均产氢速率的1.5倍,但阴极过酸的条件限制了其实际应用; pH为3、外加0.2 V电压的MPEC-3与MPEC-2相比,产氢周期由15 h增加到40 h,平均产氢速率由(0.44±0.05) mL·h~(-1)提高到(0.52±0.04) mL·h~(-1),污泥TCOD、SCOD、TSS、VSS的降解率分别可达53.96%、70.18%、38.21%和61.76%.可见本文构建的MPEC系统是一种有前景的利用太阳能进行废物处理和资源化的新技术.     

Decolorization of molasses melanoidins and palm oil mill e uent phenolic compounds by fermentative lactic acid bacteria

Lactobacillus plantarum SF5.6 is one of the lactic acid bacteria (LAB) that has the highest ability of molasses melanoidin (MM) decolorization among the 2114 strains of LAB. The strains were isolated from spoilage, pickle fruit and vegetable, soil and sludge from the wastewater treatment system by using technical step of enrichment, primary screening and secondary screening. This LAB strain SF5.6 was identified by 16S rDNA analysis and carbohydrate fermentation (API 50 CH). The top five LAB strains having high MM decolorization (> 55%), namely TBSF5.8-1, TBSF2.1-1, TBSF2.1, FF4A and SF5.6 were selected to determine the optimal condition. It was found that the temperature at 30°C under facultative conditions in GPY-MM medium (0.5% glucose, 0.1% peptone, 0.1% yeast extract, 0.1% sodium acetate, 0.05% MgSO4 and 0.005% MnCl2 in MM solution at pH 6) giving a high microbial growth and MM decolorization for all five strains. It was noticed that the decolorization of MM by LAB strains might be cell growth associated. L. plantarum SF5.6 grew rapidly within one day while the other strains took 2–3 days. This L. plantarum SF5.6 could rapidly decolorize MM to 60.91% without any lag phase, and it also had the ability to remove 34.00% phenolic compounds and 15.88% color from treated palm oil mill e uent.     

Effect of organic matter on phosphorus recovery from sewage sludge subjected to microwave hybrid pretreatment

Microwave (MW) hybrid processes are able to disrupt the flocculent structure of complex waste activated sludge, and help promote the recovery of phosphorus as struvite. In this study, to optimize struvite yield, (1) the characteristics of matter released in MW-hybrid treatments were compared, including MW, MW-acid, MW-alkali, MW-H₂O₂, and MW-H₂O₂-alkali. The results showed that selective release of carbon, nitrogen, phosphorus, Ca^2 +, and Mg^2 + achieved by sludge pretreatment using MW-hybrid processes. MW-H₂O₂ is the recommended sludge pretreatment process for phosphorus recovery in the form of struvite. The ratio of Mg^2 +:NH₄⁺-N:PO₄^3 −-P was 1.2:2.9:1 in the supernatant. (2) To clarify the effects of organic matter on struvite recovery, the composition and molecular weight distribution of organic matters were analyzed. Low molecular weight COD was found to facilitate the removal rate of NH₄⁺-N and PO₄³-P via crystallization, and the amorphous struvite crystals (< 1 kDa) from the filtered solutions had high purity. Therefore, the present study reveals the necessity of taking into consideration the interference effect of high molecular weight organic matters during struvite crystallization from sewage sludge.