印染污泥混燃特性及其燃烧动力学模型

采集了广东某印染污泥(YR)、造纸污泥(ZZ)及两种市政污水污泥(LJ、KFQ),利用热重法对不同来源污泥的单一及混合样在不同焚烧条件下进行了热重实验研究,并通过TG-DTG曲线计算了各试样的综合燃烧特性指数,获得了其燃烧动力学参数.结果表明,各单一试样的燃烧主要分为水分析出、挥发分析出、固定碳燃烧和残留物的燃烧和分解4个燃烧阶段,其中挥发分的析出制约着YR、KFQ、LJ污泥的整个燃烧过程,而ZZ污泥还受到固定碳燃烧阶段的显著影响.当向印染污泥中加入50%的KFQ市政污泥后,YR污泥的综合燃烧特性指数和可燃性指数分别提高了将近2倍和1.6倍.富氧(CO2/O2)燃烧可以提高印染污泥的后期燃烧强度,降低印染污泥燃烧阶段活化能,促进印染污泥的综合燃烧性能.采用积分法(Coats-Redfern方程)计算得到各燃烧阶段反应的机理方程及相应的活化能参数,发现第一挥发分峰前取反应级数n=0.5、峰后n=2,可描述各自阶段的燃烧反应机理,而第二挥发分峰没有显著规律.     

湖北省主要固定燃烧源大气颗粒物及VOCs排放特征研究

于2014年1月至12月对湖北省9个城市21家典型企业的固定燃烧源进行了典型大气颗粒物及挥发性有机物(VOCs)的监测工作,研究了固定燃烧源大气颗粒物及VOCs的排放特征及其物质组成。结果表明:大气颗粒物年排放总量与装机容量呈正相关关系,颗粒物粒径越细占总颗粒物的质量百分比越低;不同燃料的锅炉废气中的PM10和PM2.5质量浓度表现为:石油焦煤生活垃圾,燃气锅炉废气中只检出PM1.0;焦化厂和炼铁厂锅炉废气中的VOCs以烯(炔)烃为主,各占79.21%和81.09%,乙烯占总VOCs的百分比最高,分别为69.13%和68.88%;燃油锅炉废气中的VOCs以烯(炔)烃(91.74%)为主,燃气锅炉废气中的VOCs以烯(炔)烃(37.96%)和醛脂(38.79%)为主;锅炉废气中VOCs的组分和浓度受锅炉使用类型和燃料类型差异的影响,排放废气中的VOCs浓度水平表现为:焦化厂锅炉炼铁厂锅炉,燃油锅炉燃气锅炉,且组分更复杂。     

火电厂燃煤锅炉系统湿量平衡分析与计算

针对煤的有效热能降低、烟气管道和烟囱腐蚀严重,以及向环境中排放湿量过多等问题,对燃煤锅炉系统湿量来源进行分析,建立了锅炉燃烧系统湿量计算的基本模型。根据热力学基本原理和物料守恒原理,给出了燃煤锅炉系统湿量的计算方法。采用该方法对燃烧不同煤种锅炉的实际运行数据进行湿量计算分析比较。结果表明:通过理论分析计算得到的燃煤锅炉系统湿量与锅炉的实际运行时烟气湿量较吻合,所给出的燃煤锅炉系统湿量的计算方法可以用于锅炉燃烧系统的运行优化。     

飞灰颗粒物介导活性氧氧化损伤与金属离子浸取浓度的关系研究

本文利用脱氧核糖氧化法考察了飞灰颗粒物氧化能力与络合剂及盐酸浸取颗粒物上金属浓度的关系。结果表明,代表氧化损伤程度指标的脱氧核糖氧化物,通过硫代巴比妥酸似丙二醛加合物显色反应,其吸光度值与飞灰颗粒物被浸取剂盐酸及氨三乙酸作用后的金属离子铁、锌、镉、铅和锰的浓度显著相关。基于铁在自然环境中的高含量及在活性氧催化反应中的特殊性,本文认为二乙三氨五乙酸、乙二胺四乙酸及柠檬酸浸取液中的金属浓度不能很好地表     

催化燃烧法处理聚酯工艺废气的实践

探索研究使用催化燃烧方法处理聚酯生产工艺废气的可行性，并在生产装置上进行了中试。试验结果证明，使用催化燃烧法处理效果好，不产生二次污染，处理后的废气可达标排放。     

Effects of Zr substitution on soot combustion over cubic fluorite-structured nanoceria: Soot-ceria contact and interfacial oxygen evolution

Ceria is widely used as a catalyst for soot combustion, but effects of Zr substitution on the reaction mechanism is ambiguous. The present work elucidates effects of Zr substitution on soot combustion over cubic fluorite-structured nanoceria. The nanostructured CeO₂, Ce_0.92Zr_0.08O₂, and Ce_0.84Zr_0.16O₂ composed of 5–6 nm crystallites display T_m-CO2 (the temperature at maximum CO₂ yield) at 383, 355, and 375°C under 10 vol.% O₂/N₂, respectively. The size of agglomerate decreases from 165.5 to 51.9–57.3 nm, which is beneficial for the soot-ceria contact. Moreover, Zr increases the amount of surface oxygen vacancies, generating more active oxygen (O₂^? and O^?) for soot oxidation. Thus, the activities of Ce_0.92Zr_0.08O₂ and Ce_0.84Zr_0.16O₂ in soot combustion are better than that of CeO₂. Although oxygen vacancies promote the migration of lattice O^2?, the enriched surface Zr also inhibits the mobility of lattice O^2?. Therefore, the T_m-CO2 of Ce_0.84Zr_0.16O₂ is higher than that of Ce_0.92Zr_0.08O₂. Based on reaction kinetic study, soot in direct contact with ceria preferentially decomposes with low activation energy, while the oxidation of isolated soot occurs through diffusion with high activation energy. The obtained findings provide new understanding on the soot combustion over nanoceria.     

Emission control for precursors causing acid rain (V): Improvement of acid soil with the bio-briquette combustion ash

The bio-briquette technique which mixes coal, biomass and sulfur fixation agent and bio-briquettes under 3-5 t/cm^2 line pressure has aroused people‘s attention in view of controlling the air pollution and the acid rain. In this paper, the physicochemical properties of bio-briquette and its ash were investigated. And the acid soil was improved by the bio-briquette combustion ash, which contained nutritive substances such as P, N, K and had the acid-neutralizing capacity(ANC). The pH, EC, effective nutrient elements(Ca, Mg, K, P and N), heavy metal elements(AI, Cu, Cd, Cr, Zn and Mn) and acid-neutralizing capacity change of ash-added soils within the range of 0-10%, were also studied. Specially, when 5% bio-briquette combustion ash was added to the tested soil, the content of the effective elements such as Ca, Mg and K rose by 100 times, ? times and twice, respectively. The total nitrogen also increased by about twice. The results showed the oxyanions such as that of AI, Cu, Cd, Cr, Zn and Mn were not potentially dangerous, because they were about the same as the averages of them in Chinese soil. It is shown that the ANC became stronger, though the ANC hardly increases in the ash-added soil. On the basis of the evaluation indices, it is concluded that the best mixture ratio is to add 2.5%--8% of the bio-briquette combustion ash to the tested soil.     

煤矿巷道瓦斯爆炸传播规律及破坏效应分析

井下瓦斯爆炸的影响因素众多,随机性强,分析和研究瓦斯爆炸的传播规律只有通过巷道模拟实验的方法。通过对爆炸过程中爆炸压力、温度、速度等相关参数随时间、空间的变化规律的分析,进一步研究瓦斯爆炸的机理和破坏效应,在煤矿生产过程中采取合适的阻隔防爆技术措施,减少瓦斯爆炸带来的损失。     

基于统计回归模型的硫化矿石自燃倾向性鉴定指标研究

合理的提出硫化矿石自燃倾向性的鉴定指标,准确鉴别其自燃倾向性,对于矿山防火工作有着重要的意义。本文采用应用非常广泛的一类随机模型—统计回归模型,首先通过分析硫化矿石自燃氧化机理,找到影响硫化矿石自燃倾向性的3个主要影响因素,实验获得相关数据;其次基于3个因素的数据,通过统计分析,建立回归模型,对硫化矿石自燃倾向性进行预测。     

煤炭自燃指标性气体确定的实验研究

矿井火灾是矿井五大灾害之一,煤炭自燃则是矿井火灾最主要的起因。为了了解煤炭氧化、自燃规律,本文采用TG-DSC技术研究了不同煤种在水分蒸发、吸氧增重、受热分解及燃烧等不同氧化阶段的氧化特征值;并采用TG-DSC-GC联用技术研究了不同煤种在整个氧化阶段的气体产物生成规律及其特征。在煤的低温氧化阶段,找出了CO等可作为判别煤自燃的指标性气体及C2H4等辅助指标性气体;并得出了各煤种氧化阶段的耗氧规律。