颗粒状污泥活性炭流化床吸附处理含铜矿山废水

以城市污水处理厂活性污泥为原料,通过高温热解制备了颗粒状污泥活性炭吸附剂。在自制的流化床吸附装置上研究了该吸附剂对含铜矿山废水的吸附处理效果。实验结果表明：在初始废水pH6、吸附剂加入量15g/L、废水循环流量6.0L/min、吸附时间120min的最佳吸附条件下,废水中Cu²⁺去除率达98.2%。     

改性SiO2气凝胶对废水中Fe3+的吸附性能

制备了改性SiO₂气凝胶,考察了经不同类型、不同配比的改性剂改性的SiO₂气凝胶对模拟含Fe³⁺废水的吸附处理效果。实验结果表明：改性SiO₂气凝胶的最佳制备条件为三甲基氯硅烷（TMCS）作改性剂,V（TMCS）#x02236;V（正己烷）=1#x02236;5;当改性SiO₂气凝胶加入量为75g/L、吸附时间为4h、Fe³⁺质量浓度为10mg/L时,模拟含Fe³⁺废水的Fe³⁺去除率为98.32%,剩余Fe³⁺质量浓度为0.168mg/L;采用改性SiO₂气凝胶动态吸附处理流量为420mL/h、Fe³⁺质量浓度为100mg/L的模拟含Fe³⁺废水,吸附后废水中剩余Fe³⁺质量浓度仅为0.196mg/L。     

磷酸微波活化多孔生物质炭对亚甲基蓝的吸附特性

以甘蔗渣为原料,采用微波辅助H3PO4活化法制备富含含氧酸官能团的中孔生物质炭。通过扫描电子显微镜SEM、傅立叶变换红外光谱FT-IR等技术对生物质炭物理化学性质进行表征,并通过静态实验法,探讨炭样对亚甲基蓝的吸附行为及热力学性质。结果表明,H3PO4活化制备蔗渣生物质炭的适宜条件为浸渍比1：1,烘干时间10h,活化功率900W,活化时间22min,在此条件下制得的生物质炭得率为39．2％,碘值为817mg／g,亚甲基蓝值为229mg／g,为国家一级品标准的1．7倍。红外光谱分析表明,炭样表面以羟基、羰基、羧基等酸性官能团为主。静态吸附实验表明,Freundlich方程与Redlich—Peterson方程能较好地描述等温吸附行为,表现为优惠吸附。热力学研究表明,吸附吉布斯自由能（△G0）〈0,说明吸附反应是自发过程,而吸附标准焓变（△H0）〉70KJ／mol,表明亚甲基蓝在制备炭样上的吸附是吸热反应,升温有利于吸附,且化学反应在吸附过程中发挥了重要作用。     

人工湿地基质对NH4＋-N吸附性能

为研究建筑废物红砖和工业废物煤渣用作人工湿地脱氮基质的可行性,分别通过静态吸附实验和动态NHf—N去除效果实验进行考察。结果表明,红砖和煤渣对NH4＋-N最大静态吸附量分别为0．2533mg／g和0．0533mg／g,其吸附等温曲线均符合Freundlich型吸附方程,吸附常数分别为0．0419和0．0091;红砖煤渣组合对污水中NH4＋-N平均动态脱除率达到41．18％,高于红砖的37．63％和煤渣的30．92％。     

As（V）在金红石TiO2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验,研究了温度、共存离子以及溶质的初始浓度对As（V）在金红石TiO2颗粒表面吸附的影响,探讨了As（V）在金红石TiO2颗粒表面吸附特性及机理。结果表明,在As（V）初始浓度为10mg／L,pH为7的条件下,25℃时的吸附量0．41mg／g高于30℃时的吸附量0．31mg／g,As（V）在金红石TiO,上的吸附为放热过程。CaCl2和MgCl2的添加对As（V）在金红石TiO2表面吸附起到明显的促进作用。T=25℃,Ca2＋或Mg2＋浓度为10mmol／L时,As（V）吸附量分别为0．64和0．56mg／g,Ca2＋比Mg2＋对As（V）吸附促进作用强。As（V）在金红石TiO2的吸附等温线符合Frendlich方程,Lagergren二级动力学方程能较好地描述As（V）在金红石TiO2颗粒表面吸附的动力学过程。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。     

A method to estimate the impact of clear-cutting on nutrient concentrations in boreal headwater streams

Large-scale forestry operations, like clear-cutting, may impair surface water quality if not done with environmental considerations in mind. Catchment and country level estimates of nutrient loads from forestry are generally based on specific export values, i.e., changes in annual exports due to the implemented forestry operations expressed in kg ha⁻¹. We introduce here a specific concentration approach as a method to estimate the impact of clear-cutting on nutrient concentrations and export in headwater streams. This new method is potentially a more dynamic and flexible tool to estimate nutrient loads caused by forestry, because variation in annual runoff can be taken into account in load assessments. We combined water quality data from eight boreal headwater catchment pairs located in Finland and Sweden, where the effect of clear-cutting on stream water quality has been studied experimentally. Statistically significant specific concentration values could be produced for total nitrogen, nitrate, ammonium, and phosphate. The significant increases in the concentrations of these nutrients occurred between 2 and 6 years after clear-cutting. Significant specific concentration values could not be produced for total phosphorus and total organic carbon with the whole dataset, although in some single studies significant increases in their concentrations after clear-cutting were observed. The presented method enables taking into account variation in runoff, temporal dynamics of effects, and the proportional size of the treated area in load calculations. The number of existing studies considering large site-specific variation in responses to clear-cutting is small, and therefore further empirical studies are needed to improve predictive capabilities of the specific concentration values.     

Screening risk areas for sediment and phosphorus losses to improve placement of mitigation measures

Identification of vulnerable arable areas to phosphorus (P) losses is needed to effectively implement mitigation measures. Indicators for source (soil test P, STP), potential mobilization by erosion (soil dispersion), and transport (unit-stream power length-slope, LS) risks were used to screen the vulnerability to suspended solids (SS) and P losses in two contrasting catchments regarding topography, soil textural distribution, and STP. Soils in the first catchment ranged from loamy sand to clay loam, while clay soils were dominant in the second catchment. Long-term SS and total P losses were higher in the second catchment in spite of significantly lower topsoil STP. A higher proportion of areas in the second catchment were identified with higher risk due to the significantly higher risk of overland flow generation (LS) and a significantly higher mobilization risk in the soil dispersion laboratory tests. A simple screening method was presented to improve the placement of mitigation measures.     

丝藻对含钼废水中MoO_4~(2-)的吸附特性及机制研究

研究了丝藻对含钼废水中MoO2-4的吸附作用。分别考察了初始pH、吸附时间、温度、投加量以及竞争离子等5个因素对吸附过程的影响,并应用吸附热力学和动力学方法对吸附机制进行了探讨。结果表明,丝藻在初始pH 1、吸附时间40min、投加量为1.0g以及30℃条件下,对含钼废水中MoO2-4的去除率达82%,平衡吸附量为0.657 0mg/g。PO3-4对MoO2-4的吸附具有较强的拮抗作用,平衡吸附量下降至0.380 0mg/g,SiO4-4对MoO2-4的拮抗作用相对较弱,而SO2-4对MoO2-4的吸附却有一定的协同作用。丝藻对MoO2-4的吸附等温数据更符合Langmuir吸附等温模型,准二级动力学方程拟合的吸附动力学过程相关性较高,20、25℃下的R2都在0.99以上。说明丝藻吸附MoO2-4属于化学吸附,受化学反应速率控制,且丝藻可以应用于含钼废水治理领域。     

建筑垃圾对雨水径流中Cu的吸附特性

以砖混建筑垃圾为研究对象,采用人工模拟雨水,通过静态和动态吸附实验研究了不同粒径粒级建筑垃圾对雨水径流中Cu的吸附效果。结果表明,准二级动力学模型比准一级动力学模型能更好地描述建筑垃圾对Cu的吸附过程;Freundlich等温模型能较好地拟合其等温吸附过程;不同粒径粒级建筑垃圾均对雨水径流中的Cu具有较好的净化效果,去除率均超过90%,粒径粒级越小,对Cu的净化效果越好,但其渗透性能越差;建筑垃圾的粒径粒级对Cu的吸附平衡时间、吸附速率和吸附量具有重要影响,粒径粒级2.36~4.75 mm的建筑垃圾对Cu的平衡吸附速率和平衡吸附量最大,分别为4.1μg/min和12.4μg/g。