宁波市区近十年酸雨污染趋势分析

采用2001-2010年宁波市区降水监测数据,对宁波市区的酸雨污染现状及2001年以来的变化趋势分析,结果表明:酸雨频率居高不下,且降水酸度并未减弱,宁波市区酸雨的污染类型处于硫酸型向硫酸与硝酸混合型转变的过渡期。并根据宁波市区实际情况提出相应防治对策。     

控制游离氨实现单级自养生物脱氮的研究

通过实时调控SBR反应器内的游离氮浓度的控制策略,实现以亚硝化作用和厌氧氨氧化作用协同的单级自养生物脱氮工艺.实验分成亚硝酸菌富集和厌氧氨氧化菌混合接种2个阶段,SBR内的温度始终保持在(31±2)℃.亚硝酸菌富集阶段,pH值稳定在7.8左右,通过调节进水氩氮浓度(56～446 mg·L-1)实现FA浓度的变化,从而实...     

曝气生物滤池的短程硝化特性

通过控制进水pH值实现曝气生物滤池的短程硝化。工艺运行结果表明,对于进水pH值为8.22~8.57,NH4+-N平均容积负荷为0.5 kg/(m3.d),水温为17.5~20.2℃,曝气生物滤池溶解氧质量浓度平均为4.5 mg/L的条件下能够同步实现95%的NH4+-N去除率和80%的NO2--N积累率。通过分析FA和FNA沿滤池高度的变化特征,发现滤池底部(0~5 cm)区域短程硝化反应主要由FA控制,中部(5~15 cm)区域是由FA和FNA共同掌控;而上部区域(15~50 cm)则是由FNA控制,FNA沿滤池高度的快速增加是确保工艺实现稳定亚硝酸盐积累的重要原因。     

氧化沟处理煤矿低浓度生活污水运行控制技术探讨

本文给出了济三煤矿生活污水水量和水质情况,以及采用卡鲁塞尔氧化沟处理该低浓度生活污水的工艺流程和特点。详细描述了实际运行过程中培养和驯化适应低浓度生活污水优势菌种的几个步骤,以及防止和控制污泥膨胀和老化的方法。运行试验结果表明：采用污泥回流比150%、控制氧化沟未端溶解氧（DO）1.5 mg/L,能取得最佳的CODcr去除率和总氮（TN）去除率,分别为76.7%和79.8%。     

高锰酸盐指数一酸性法空白质量控制研究

常规监测高锰酸盐指数-酸性法,通过对高锰酸盐指数空白测试与检测限、空白质控图、空白加标回收率进行测试研究,可以得到理想的监测结果。     

氧化沟工艺污水处理厂的调试运行

以安徽某县污水处理厂的改良氧化沟工艺调试为例,采用自然培菌和间歇培养相接合的方式进行调试,结果表明方法可行。在进水COD100mg/L时,MLSS在1500mg/L时,出水COD、NH4-N均可取得较好的处理效果。同时对调试过程中的各环节如人员培训、带负荷试车、污泥培养等进行了详细阐述,并确定了各工艺段的控制参数。     

聚硅酸对不同形态铝沉积行为的影响

针对给水管网中残余铝沉积和再溶解现象可能引起的水质问题,研究了聚硅酸对不同水解聚合形态铝沉积、再溶解的影响,并以石英微晶天平为表征手段,初步探讨了聚硅酸对不同形态铝沉积、再溶解过程影响的机理.结果表明,聚硅酸能显著改变不同水解聚合形态铝的沉积、再溶解行为.聚硅酸可与3种水解聚合形态的铝迅速结合而生成可沉积产物,但产物性质不同.以单体形态为主的Al_0与聚硅酸的反应产物性质较稳定,部分以溶解态存在,部分以非溶解态(可沉积态)存在;尽管铝的两种聚合形态Al_(13)和Al_(30)与聚硅酸反应也生成了部分可沉积产物,但随着时间的推移,这些产物又逐渐向溶解态转化.铝硅比对Al_0体系中铝的沉积溶解行为影响较小,而对Al_(13)和Al_(30)影响较大,且在0.2∶20(以Al和SiO_2计的质量比)时,沉积态铝的溶解速率最快.     

Reaction mechanism and metal ion transformation in photocatalytic ozonation of phenol and oxalic acid with Ag+/TiO2

Photocatalytic ozonation of phenol and oxalic acid （OA） was conducted with a Ag^＋/TiO2 catalyst and different pathways were found for the degradation of different compounds. Ag^＋ greatly promoted the photocatalytic degradation of contaminants due to its role as an electron scavenger. It also accelerated the removal rate of OA in ozonation and the simultaneous process for its complex reaction with oxalate. Phenol could be degraded both in direct ozonation and photolysis, but the TOC removal rates were much higher in the simultaneous processes due to the oxidation of hydroxyl radicals resulting from synergetic effects. The sequence of photo-illumination and ozone exposure in the combined process showed quite different effects in phenol degradation and TOC removal. The synergetic effects in different combined processes were found to be highly related to the properties of the target pollutants. The color change of the solution and TEM result confirmed that Ag＋ was easily reduced and deposited on the surface of Tit2 under photo-illumination, and dissolved again into solution in the presence of ozone. This simple cycle of enrichment and distribution of Ag^＋ can greatly benefit the design of advanced oxidation processes, in which the sequences of ozone and photo-illumination can be varied according to the needs for catalyst recycling and the different properties of pollutants.     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

Reduction and characterization of bioaerosols in a wastewater treatment station via ventilation

Bioaerosols from wastewater treatment processes are a significant subgroup of atmospheric aerosols. In the present study,airborne microorganisms generated from a wastewater treatment station(WWTS) that uses an oxidation ditch process were diminished by ventilation.Conventional sampling and detection methods combined with cloning/sequencing techniques were applied to determine the groups,concentrations,size distributions,and species diversity of airborne microorganisms before and after ventilation. There were 3021 ± 537 CFU/m3 of airborne bacteria and 926 ± 132 CFU/m3 of airborne fungi present in the WWTS bioaerosol.Results showed that the ventilation reduced airborne microorganisms significantly compared to the air in the WWTS. Over 60% of airborne bacteria and airborne fungi could be reduced after4 hr of air exchange. The highest removal(92.1% for airborne bacteria and 89.1% for fungi) was achieved for 0.65–1.1 μm sized particles. The bioaerosol particles over 4.7 μm were also reduced effectively. Large particles tended to be lost by gravitational settling and small particles were generally carried away,which led to the relatively easy reduction of bioaerosol particles0.65–1.1 μm and over 4.7 μm in size. An obvious variation occurred in the structure of the bacterial communities when ventilation was applied to control the airborne microorganisms in enclosed spaces.