球形磁性活性炭制备及对土壤重金属Pb的吸附研究

以废旧汽车轮胎橡胶与城市污水处理厂污泥为原料,采用ZnCl2与H_2SO_4复配活化法,添加黏结剂和Fe_3O_4粉末,在真空管式气氛炉中炭化制备球形磁性活性炭,并测定其物理化学性能。研究球形磁性活性炭添加量、土壤pH值和含水率对球形磁性活性炭吸附重金属Pb的影响。采用火焰法-原子吸收分光光度计测定球形磁性活性炭对Pb的吸附量。结果表明:球形磁性活性炭的比表面积及亚甲基蓝吸附量相比商品活性炭要小,但其抗压强度高,不容易松散,便于回收,酸性官能团总量高,有助于提高球形磁性活性炭的吸附性能和对重金属的亲和力,因此球形磁性活性炭的综合理化性能优于干污泥活性炭和商品活性炭,适合用于土壤中重金属Pb的吸附;随添加量增加,球形磁性活性炭对土壤中Pb的吸附量也增加,当球形磁性活性炭添加质量分数为6%时,达到最优吸附效果;随土壤pH值增加,球形磁性活性炭对土壤中Pb的吸附量也增加,但当pH值超过5时,其吸附量开始下降;当吸附时间达到35 d后,其吸附量基本处于饱和状态;土壤含水率为20%时,吸附达到平衡。在最优工艺参数下,球形磁性活性炭对土壤中Pb的吸附量达到最大,为3.55 mg/g。球形磁性活性炭对土壤中重金属Pb的吸附过程可以用准二级动力学方程较好地解释,而且球形磁性活性炭经过1次再生后用于吸附土壤中Pb时,其吸附量达到2.56 mg/g,再生效率达72.11%,吸附效果良好。     

导弹橡胶密封件环境失效研究

针对高原荒漠与东南沿海的气候特点,分析了导弹橡胶密封件在温度、湿度、臭氧和盐雾环境下的失效机理,提出了其环境适应性研究的方案;结合部队武器装备使用的现状,提出了在恶劣环境下预防橡胶密封件失效的措施.     

Sequestration of toxic Pb(Ⅱ) ions by chemically treated rubber(Hevea brasiliensis) leaf powder

Rubber leaf powder(an agricultural waste) was treated with potassium permanganate followed by sodium carbonate and its performance in the removal of Pb(Ⅱ) ions from aqueous solution was evaluated.The interactions between Pb(Ⅱ) ions and functional groups on the adsorbent surface were confirmed by Fourier transform infrared(FT-IR) spectroscopy,scanning electron microscopy(SEM) coupled with X-ray energy dispersive spectroscopy(EDX).The effects of several important parameters which can affect adsorption capacity such as pH,adsorbent dosage,initial lead concentration and contact time were studied.The optimum pH range for lead adsorption was 4-5.Even at very low adsorbent dosage of 0.02 g,almost 100% of Pb(Ⅱ) ions(23 mg/L) could be removed.The adsorption capacity was also dependent on lead concentration and contact time,and relatively a short period of time(60-90 min) was required to reach equilibrium.The equilibrium data were analyzed with Langmuir,Freundlich and Dubinin-Radushkevich isotherms.Based on Langmuir model,the maximum adsorption capacity of lead was 95.3 mg/g.Three kinetic models including pseudo first-order,pseudo second-order and Boyd were used to analyze the lead adsorption process,and the results showed that the pseudo second-order fitted well with correlation coefficients greater than 0.99.     

废胶粉与聚氨酯聚苯乙烯互穿聚合物网络

对废胶粉进行了裂解气相色谱、红外光谱、热重分析,并且制备了共轭三组分聚氨酯/聚苯乙烯/废胶粉半互穿聚合物网络(PU/PS/SRP-IPN),并进行了力学性能测试。结果表明:在废胶粉中含有天然橡胶、顺丁橡胶、丁苯橡胶,其中天然橡胶含量较高,顺丁橡胶和丁苯橡胶含量较低,三种胶的含量比为天然橡胶:顺丁橡胶:丁苯橡胶为12:6.2:1;胶粉含胶率为49.61%,炭黑含量为18.89%,无机填料含量为21.01%。当聚苯乙烯含量为40%时,体系的扯断伸长率与拉伸强度都出现最大值,随着聚苯乙烯在体系中所占比例增大,硬度与永久变形逐渐增大。差示扫描量热仪测定的玻璃化转变温度和扫描电镜分析结果表明作为公共组分的聚苯乙烯与废胶粉及聚氨酯发生了互穿缠结,整个材料性能得以提高。     

热重点斜法快速评估氟硅橡胶贮存寿命

阐述了热重点斜法（TPS）的基本原理。利用热重分析法求算出氟硅橡胶的功能性活化能E,同时开展373.15 K下热空气老化试验,然后参照JB/T 1544-1999计算氟硅橡胶贮存寿命,并对热重点斜法提出了分析和讨论。     

直升机用橡胶密封产品环境试验技术研究进展

以我国直升机在恶劣环境条件下服役导致密封产品频繁发生失效故障为背景,对航空橡胶密封材料及产品的环境试验与评价技术进行了梳理总结。分析了橡胶密封材料及产品大气暴露试验、户外自然加速暴露试验等自然环境试验技术的发展现状,介绍了热空气老化、紫外老化、臭氧老化、湿热、低温、盐雾、霉菌及综合环境试验等橡胶密封材料及产品实验室模拟加速试验技术的作用机理及试验方法。在此基础上,提出了今后应在橡胶密封产品实验室多因素模拟加速试验技术、密封结构件环境效应数据积累和应用等方面加强研究。     

带压作业闸板防喷器胶芯失效机理研究

针对带压作业过程中闸板防喷器胶芯易失效的问题,以现场使用的带压作业闸板防喷器胶芯为研究对象,通过实验确定了橡胶基体的本构关系,利用ABAQUS软件对比研究了4种不同井筒压力对胶芯的疲劳失效与密封失效的影响。结果表明:分析结果与现场应用胶芯的失效位置相符,验证了分析的正确性;胶芯的疲劳失效位置集中在橡胶基体与闸板上下部的4个尖角接触区域,上部区域失效严重;井筒压力的大小影响橡胶基体密封面上的接触应力分布,但对耐磨块密封面上接触应力分布影响不显著。建议在橡胶基体与闸板上下部的4个尖角区域补强以增加胶芯寿命。     

废轮胎的热解及其产物分析

研究了废轮胎热解产生的三相 (气、液、固 )产率与裂解温度的关系 ,气相组成与温度的关系 ,以及氢氧化钠作为催化剂加入热解体系对三相产率和气体组成的影响 .实验表明 ,轮胎橡胶的热稳定性分为 :～ 200℃,200℃～300℃及300℃以上3个区域 .在200℃以上时 ,随着温度升高 ,固体产率减少 ,气体产率增加 ,液体产物的产率在 500℃左右出现一个峰值 .加入 4%NaOH作催化剂以后 ,在相同的温度下固态碳黑和液态油的产率均有所提高 ,而相应混合气的产率降低 .实验确定了所用混合胶粉主要为合成橡胶 .不同温度下热解所产生的液体产物的红外谱图及裂解色谱图表明 ,300℃时主要是助剂分解,400℃左右主要是聚异戊二烯(天然胶)开始裂解,600℃以上残留物开始裂解.     

Effect of cement content and recycled rubber particle size on the performance of rubber-modified concrete

According to the Rubber Manufacturer’s Association, the United States generated 3664 thousand metric tons of scrap tires in 2015. While most waste tires are repurposed, approximately 409.5 thousand metric tons were disposed in landfills. This study investigates an alternative use of the waste tires as a replacement of natural aggregates in concrete mixtures. This study investigated fresh concrete properties and compressive strength. Different coarse and fine aggregate rubber particle sizes were evaluated: 19-mm tire chips (TCs) and 30-mesh crumb rubber (CR). TCs were used to replace coarse aggregates, while CR was used to replace fine aggregate in the concrete mixtures in increments of 10% by volume. Concrete strength loss was reduced with a fine aggregate replacement with CR as opposed to greater losses of strength exhibited by a coarse aggregate replacement with TCs. Adequate strengths were achieved at replacement levels as high as 40% by volume with CR, whereas satisfactory strengths were achieved with only a 10% replacement of coarse aggregates with TCs. Acceptable strengths were obtained from mixtures utilizing a combination of the two rubber sizes. Cement content was observed to have greater influence on rubberized concrete compressive strength at lower rubber contents than higher levels.     

十年来我国废旧橡胶(轮胎)利用专利及启示

党和政府近几年来,高度重视知识产权建设和保护工作.废旧橡胶利用(含轮胎翻新)是再生资源利用重点行业之一.从数据库中选取2009-2019年废旧橡胶行业专利申请情况,并根据行业现状进行分类整理和分析研究,有针对性地提出行业知识产权建设和保护工作的若干建议.在引起废旧橡胶利用(含轮胎翻新)行业重视基础上,进一步推动再生资源...