MBBR与A/O法对污水中有机物及氮处理效果的研究

实验在不同水力停留时间（HRT）、进水COD浓度和不同COD容积负荷条件下考察了移动床生物膜反应器（MBBR）和活性污泥A/O工艺对污水中有机物及氮的处理效果。结果表明,MBBR工艺去除有机物和脱氮效果均优于A/O工艺。在进水COD和NH₃－N浓度分别为1000和25 mg/L,HRT为8 h时,MBBR的COD和TN去除率分别为92％和94％,而A/O工艺分别为78％和82％。造成这种结果的原因是MBBR的生物活性高,并且在生物膜内发生了同时硝化反硝化。MBBR脱氮能力受COD冲击明显小于A/O,但在较低进水COD浓度下,两者TN去除率均较低。     

新型单级A/O程序无回流复合膜生物反应器处理氨氮废水的试验

采用单级A/O程序复合膜生物反应器(HSMBR)处理高氨氮废水,研究在低DO浓度下系统对有机物、氨氮和总氮的去除效率。研究结果表明:在低DO浓度下,CODCr、氨氮的平均去除率分别为94.4%和92.8%。由于进水CODCr/TN值仅为2.01,则使得总氮平均去除率仅为69.4%,但是当系统亚硝化累积率从60.5%～67.1%提高到83.5%～86.4%时,系统总氮去除率提高了17.7%。另外,维持低DO浓度可以实现亚硝酸型同时硝化反硝化反应。     

以膨润土为辅助添加剂固化/稳定化污泥的试验研究

针对传统以水泥固化污泥,带来的水泥用量大与固化体的浸出液pH过高等问题,提出了以膨润土为添加剂辅助水泥固化/稳定化污泥的思路.通过开展无侧限抗压强度试验、毒性浸出试验,测量掺入膨润土后污泥固化体的强度、重金属浸出率、浸出液COD及pH值,研究该固化/稳定化方法的效果.结果表明,膨润土的掺入极大地提高了固化体的抗压强度,将掺入量为0.4(相对污泥的质量比)的水泥一半用膨润土替代时,固化体的强度提高了6左右.体积安定性也能够满足要求.随膨润土掺入量增加,固化体中锌、铅的浸出率与浸出液的pH值呈现不断减小的趋势,锌与铅的浸出率分别由6.9%下降至0.25%,9.6%下降至5%,pH值由12.3下降至12.1.在强碱条件下及烘干或风干条件下,铜会随着有机物的分解而析出,从而增加铜的浸出率,而膨润土的加入能弥补水泥造成的强碱环境及风干或烘干过程对固化污泥中铜的稳定产生的不利影响.     

改良倒置A2/O工艺设计

在目前广泛采用的AO、A2O、倒置A2O等工艺的基础上,为提高脱氮除磷效率,提出改良倒置A2O工艺。并对其工艺的特点、设计和脱氮除磷效率进行了详细的研究和分析。     

化学解耦联剂对活性污泥产率的控制作用

采用3,3',4',5-四氯水杨酰苯胺(TCS)作为代谢解耦联剂添加到活性污泥工艺中,进行连续曝气分批培养实验.结果表明:在TCS总投加量相同的情况下,采用一次性大剂量投加的污泥减量化效果好于分次小剂量投加.每d投加 12 mg TCS,污泥产量比对照下降了33%,而每2 d一次性投加24 mg TCS,污泥产量比对照下降了55%.污泥的CODCr去除能力有所下降,当一次性投加12 mg时,CODCr去除率比对照下降了12%,但出水氨氮及总氮质量浓度均未受影响.污泥的SVI有所上升,但沉降性能未见有明显变化.      

层状氢氧化镁铝对偶氮染料酸性黑10B的脱色性能研究

分别用层状氢氧化镁铝(LDH)和焙烧层状氢氧化镁铝(CLDH)作为吸附剂吸附脱除水溶液中偶氮染料酸性黑10B.考察了脱色时间、pH值、吸附剂的投加量、温度、染料初始浓度和焙烧温度等因素对脱色率的影响.结果表明,LDH及CLDH对酸性黑10B染料具有良好的脱除效果,室温下,10g/L LDH和1g/L的CLDH对浓度为100mg/L的染料的脱色率分别达95.93%和99.97%.pH值是影响吸附能力的关键因素,吸附剂对溶液pH值有一定缓冲作用.LDH及CLDH对酸性黑10B吸附结果符合Langmuir吸附等温式.饱和吸附后的LDH及CLDH用高温热解法再生,吸附性能良好,随再生次数增多,脱色率下降.     

Effect of humic substances on the precipitation of calcium phosphate

For phosphorus （P） recovery from wastewater, the effect of humic substances （HS） on the precipitation of calcium phosphate was studied. Batch experiments of calcium phosphate precipitation were undertaken with synthetic water that contained 20 mg/L phosphate （as P） and 20 mg/L HS （as dissolved organic carbon, DOC） at a constant pH value in the range of 8.0-10.0. The concentration variations of phosphate, calcium （Ca） and HS were measured in the precipitation process; the crystalline state and compositions of the precipitates were analysed by powder X-ray diffraction （XRD） and chemical methods, respectively. It showed that at solution pH 8.0, the precipitation rate and removal efficiency of phosphate were greatly reduced by HS, but at solution pH ≥9.0, the effect of HS was very small. The Ca consumption for the precipitation of phosphate increased when HS was added; HS was also removed from solution with the precipitation of calcium phosphate. At solution pH 8.0 and HS concentrations ≤3.5 mg/L, and at pH ≥ 9.0 and HS concentrations ≤ 10 mg/L, the final precipitates were proved to be hydroxyapatite （HAP） by XRD. The increases of solution pH value and initial Ca/P ratio helped reduce the influence of HS on the precipitation of phosphate.     

高效液相色谱串联质谱法测定某市污水处理厂进出水中的全氟化合物

通过建立直接进样-高效液相色谱串联质谱（HPLC-MS/MS）测定污水处理厂进出水中的10种全氟化合物的方法,了解污水厂进出水中全氟化合物污染情况。10种目标分析物在10~500 ng/L范围内具有良好的线性关系,方法检出限为2.3~8.3 ng/L,精密度为2.1%~7.1%,加标回收率为60.6%~91.7%。应用该方法测定某市典型污水厂进出水中的全氟化合物,进水中全氟化合物质量浓度为90.9~206 ng/L,主要污染物是PFOA、PFHxS和PFBS;出水中全氟化合物的质量浓度为67.4~158 ng/L,环境排放量为6.7~22.9 g/d,主要污染物是PFOA和PFHxS。结果表明,该方法能很好地适用于复杂基质中10种全氟化合物的检测。     

Enhanced triallyl isocyanurate (TAIC) degradation through application of an O3/UV process: Performance optimization and degradation pathways

• UV/O₃ process had higher TAIC mineralization rate than O₃ process. • Four possible degradation pathways were proposed during TAIC degradation. • pH impacted oxidation processes with pH of 9 achieving maximum efficiency. • CO₃^2– negatively impacted TAIC degradation while HCO₃^– not. • Cl^– can be radicals scavenger only at high concentration (over 500 mg/L Cl^–). Triallyl isocyanurate (TAIC, C₁₂H₁₅N₃O₃) has featured in wastewater treatment as a refractory organic compound due to the significant production capability and negative environmental impact. TAIC degradation was enhanced when an ozone(O₃)/ultraviolet(UV) process was applied compared with the application of an independent O₃ process. Although 99% of TAIC could be degraded in 5 min during both processes, the O₃/UV process had a 70%mineralization rate that was much higher than that of the independent O₃ process (9%) in 30 min. Four possible degradation pathways were proposed based on the organic compounds of intermediate products identified during TAIC degradation through the application of independent O₃ and O₃/UV processes. pH impacted both the direct and indirect oxidation processes. Acidic and alkaline conditions preferred direct and indirect reactions respectively, with a pH of 9 achieving maximum Total Organic Carbon (TOC) removal. Both CO₃^2– and HCO₃^– decreased TOC removal, however only CO₃^2– negatively impacted TAIC degradation. Effects of Cl^– as a radical scavenger became more marked only at high concentrations (over 500 mg/L Cl^–). Particulate and suspended matter could hinder the transmission of ultraviolet light and reduce the production of HO· accordingly.