城市间空气污染控制的马氏链模型

根据城市间空气污染物相互扩散和无后效性的特点,应用马尔可夫随机过程理论,先建立各城市污染物浓度状态转移方程,再由城市间污染物浓度状态形成一个吸收链。建立城市间污染物排放控制的马氏链模型。通过模型求解,得出了城市间空气污染物浓度达到国家排放标准的条件,最后应用数值计算软件MAT-LAB,编写了一个城市间空气污染控制的通用程序,它能在保证城市空气质量的前提下,快速准确地计算出控制区内各污染源污染物的最大允许排放量,这对环保部门进行城市空气污染物排放量控制工作具有实际意义。     

上海新农村建设中生活污水污染现状及处理对策

概述了上海农村生活污水排放现状及对附近河道水环境造成的影响,通过分析当前农村生活污水集中处理和分散处理的利弊和条件、常用的农村生活污水就地处理技术以及归纳总结上海已投入使用就地处理技术,进一步阐述上海农村生活污水就地处理应当因地制宜、综合考虑。最后从农村环境管理和环保法律的层面,以及处理技术角度,提出了应根据建设社会主义新农村的要求和上海郊区农村当地的实际情况,进行上海郊区农村生活污水治理的总体思路。     

KTV、慢摇吧等娱乐场所噪声治理方法研究

近年来,随着KTV,慢摇吧等娱乐场所的增加,娱乐场所带来的噪声扰民问题也日益突出。由于业主、施工单位等缺乏隔声降噪的专业知识,使得这一问题没有很好解决。本文通过对这类噪声的特性分析,根据其具有低频为主、穿透力强、不易衰减等特点,结合工程实例,从提高顶棚、侧墙的隔声量,结构上多采用弹性连接及增加阻尼等角度提出几点治理方法。以隔声、隔振为主,控制这类噪声通过空气传声与固体传声等途径向周围居民区传播。     

特异性功能光和细菌克制蓝藻水华——对光合细菌抑制蓝藻生长的探讨

分析了蓝藻水华暴发的条件,详细论述了特异性功能光合细菌在蓝藻水华覆盖面治理、蓝藻水华未暴发前治理、内污染源底泥治理、点面源污水治理方面取得的试验成果,并结合对特异性光合细菌的分解技术路线和使用性能的分析得出结论：EPSB生物制剂完全可靠,不存在二次污染,使用投资省、运行费用低。     

嫩江水污染物排放总量分配方法研究

本文针对嫩江沿岸采用氧化塘处理污水的特点，为充分合理利用水环境容量，以流域总量控制的原则为指导，建立了水污染物总量分配模型，预测不同流量和不同排污情况下的水质，确定不同流量下给定水质目标的临界距离和允许排污量。     

环境审计制度选择影响因素的实证分析

随着环境问题的日益严重,污染治理工具的选择和实施成为社会各界普遍关注的焦点.本文选择150个国家的国别数据,采取logit模型对环境审计制度选择的影响因素进行分析.研究结果表明,经济发展水平、环境保护投资和社会信息化程度与一国是否开展环境审计成显著正相关;审计体制对环境审计的开展也具有显著性影响;而污染排放现状、邻国的决策对环境审计制度选择的影响并不显著.本文的研究表明,与传统命令——控制型规制工具的普适性不同,作为一种信息化的污染治理工具,环境审计是经济社会发展到一定阶段国家最高审计机关的选择.进一步,利用我国2007年-2011年的相关数据进行基于主成分回归的符合性检验,结果显示环境审计的概率值p皆高于50％,且逐年递增,表明我国现阶段实施环境审计的条件和时机已经基本成熟.本文的研究发现为我国最高审计机关“十二五”期间将环境审计作为一种独立的审计类型,在全国推行环境审计工作提供了理论依据.     

风蚀扬尘抑尘剂效率测试方法与应用

风蚀扬尘抑尘剂是一种控制风蚀扬尘的有效措施,探讨使用便携式风洞(PI-SWERL)测试风蚀扬尘抑尘剂效率的方法,并对比国内外2种抑尘剂对风蚀扬尘PM2. 5的抑制效率,以研究喷洒方式、稀释倍数和风速对抑尘效率的影响.结果表明:①按照推荐的稀释倍数分别配置G和Enviroseal(ES)抑尘剂水溶液并测试,液滴喷洒方式对应的抑尘效率优于雾化喷洒方式,在17. 2 m·s~(-1)(相当于8级风)风速时G抑尘剂效率(99. 5%)优于ES抑尘剂(94. 0%)和水(77. 5%);②对稀释倍数为50、100、150、200和400倍的G抑尘剂进行测试,在17. 2 m·s~(-1)风速时,抑尘效率分别为99. 7%、99. 5%、99. 7%、98. 1%和95. 9%,可根据抑尘效率变化拐点确定抑尘剂最佳成本效益稀释倍数;在13. 1～17. 2 m·s~(-1)风速范围内,抑尘效率随风速增加而增加.③使用便携式风洞测试风蚀扬尘抑尘剂效率的方法,可以量化抑尘剂对风蚀扬尘PM2. 5的抑制效率,建议对风蚀扬尘抑尘剂开展抑尘有效期和环境友好性测试.     

Minimizing external indirect health costs due to aerosol population exposure: a case study from Northern Italy

Environmental Agencies require Decision Support Systems, in order to plan Air Quality Policies considering the cost of emission reduction measures and the human health effects (with related social costs). The use of Decision Support Systems is also useful to spread information to general public, explaining the effectiveness of proposed air quality plans. In this paper, a multi-objective approach to control PM10 concentration at a regional level is presented. The problem considers both the internal costs (due to the implementation of emission reduction measures) and the external costs (due to population exposure to high PM10 concentrations). To model PM10 concentrations, a single surrogate model is used for the entire domain, allowing the implementation of a very efficient optimization procedure. The surrogate model is derived through a set of 10 simulations, performed using a Chemistry Transport Model fed with different emission reduction scenarios. The methodology is applied to Northern Italy, a region affected by very high PM10 concentrations that exceed the limit values specified by the EU legislation.     

General vs. domain specific recycling behaviour—Applying a multilevel comprehensive action determination model to recycling in Norwegian student homes

This paper reports the results of a multilevel structure equation model predicting general and fraction specific self-reported recycling behaviour. The model was tested on a sample of 697 undergraduate students from four Norwegian universities who each reported their degree of participation in the local recycling schemes for paper/cardboard, glass, metal, and plastic. It was demonstrated that variance in recycling behaviour can be divided into a smaller general part that is relatively stable across waste fractions and a specific part that depends on the respective fraction. General recycling behaviour is well predicted by intentions to recycle and recycling habits, whereas perceived behavioural control is to a large extend fraction specific and influences the fraction specific recycling. Perceived behavioural control mediates the influence of the recycling scheme type, distance to recycling containers, and transport mode used to reach the recycling containers.     

Formulation of criteria for pollution control on cement products produced from solid wastes in China

The process of producing cement products from solid waste can increase the level of pollutants in the cement products. Therefore, it is very important to establish a pollution control standard for cement products to protect the environment and human health. This paper presents acceptance limits for the availability of heavy metals in cement products which have been produced from solid wastes and explains how the limits have been calculated. The approach and method used to formulate these criteria were based on EN 12920. The typical exposure scenarios used in this paper involve concrete being used for drinking water supply pipelines and concrete pavements and are based on an analysis of typical applications of cement in China, and the potential for contact with water. The parameters of a tank test which was based on NEN 7375 were set in accordance with the environmental conditions of typical scenarios in China. Mechanisms controlling the release of heavy metals in concrete and a model for that release were obtained using the leaching test. Finally, based on acceptance criteria for drinking water and groundwater quality in China, limit values for the availability of heavy metals in concrete were calculated.