SBR处理铁路洗涤废水试验研究

铁路洗涤废水中含有的主要污染物直链烷基苯磺酸钠(LAS)是我国环境标准中第2类污染物质.目前,铁路洗涤废水的处理以物理和化学法为主,存在效果不稳定、成本较高和工艺复杂等问题,急需寻求一种适合铁路洗涤废水特点的处理工艺.用SBR小试装置进行铁路洗涤废水处理实验研究,并且投加LAS降解菌于SBR中,进行了工艺参数的确定,处理效果考察和投菌前后对比等方面的初步研究.     

Comparison of criteria for prediction of runaway reactions in the sulphuric acid catalyzed esterification of acetic anhydride and methanol

Loss of temperature control is one of the major reasons that can lead to runaway reaction. This occurrence is commonly named thermal runway. The aim of this paper is the application of thermal runaway criteria in order to predict the onset of runaway phenomena and define the range of stability related to operating conditions in the reactor, with specific reference to the esterification of acetic anhydride and methanol catalysed by sulphuric acid tested in isoperibolic conditions. The isoperibolic calorimeter has also been used to obtain thermodynamic, kinetic and physical chemistry data necessary to develop a model for the reaction. Some runaway criteria applied in this work require a model for the process, so a model for the analyzed system been developed.Because of the modest reaction enthalpy and low activation energy this reacting system provide a severe test to the runaway criteria.In this work, various runaway criteria have been applied to the experimental and simulated data and the results obtained have been compared.     

HUMAN BEHAVIOR AND RESPONSE TOWARDS STORM HAZARD IN WEST VANCOUVER,BRITISH COLUMBIA1

ABSTRACT: Human behavior and response towards storm hazard are examined in this study. One-hundred and twenty flood victims in West Vancouver, British Columbia, were administered a sentence completion test to ascertain how these victims behaved and responded to the flash flood of July 12, 1972. The sentence completion test consisted of 11 sentence stems. Seven of these dealt with the respondent's behavior toward the storm experience, and four with the issue of internal vs. external locus of control. Completions of the seven sentence stems at three time situations showed that West Vancouverites expressed the normal reactions of fear and anxiety before the storm; showed negative emotions during the storm; and displayed a feeling of mutual cooperation after the storm. Completions of the remaining four sentence stems revealed that West Vancouverites emphasized the importance of internal factors, viz., autonomy, drive and hard work, in controlling their lives. They recognized God as a benevolent - protective and almighty - powerful figure. Forty percent of the respondents did not believe in luck, while 8 percent regarded it as important in their lives. One might conclude that West Vancouverites could cope with natural hazardous threats better than those who rely on external factors in directing their lives.     

ALUM CONTROL OF INTERNAL PHOSPHORUS LOADING IN A SHALLOW LAKE1

ABSTRACT: Alum treatment of a shallow lake, with mean depth 2 m and area 137 ha, curtailed internal loading of P for at least one ear. Mean summer total P and chl a decreased from 76 and 27μg l^?1, respectively, in 1978 before treatment. to 29 and 14 μ l^?1, while mean summer Sed transparency increased from 1.6 to 2.2 m and blue green algae were no longer dominant. Macrophyte biomass and distribution retuned during the post-alum year, 1980-1981, to previous levels after a 1979 four-month lake level drawdown had reduced biomass by 84 percent The improved transparency, resulting from the decrease in chl a following treatment, could encourage greater biomass of macrophytes in the deeper area of the lake. Recovery of macrophyte biomass to predrawdown levels may restore internal loading of P through enrichment of deep water sediments during winter dieback and decomposition.     

钠盐量影响下DD6单晶高温合金的高温热腐蚀规律研究

目的 开展镍基单晶高温合金DD6在950 ℃下的热盐腐蚀试验(95%Na2SO4+5%NaCl)，探明涂盐量和涂盐方式(周期涂盐和单次涂盐)对DD6高温热腐蚀的影响规律和机理。方法 结合扫描电子显微镜、X射线能量色散谱、X射线衍射等设备，对不同涂盐量及涂盐方式下DD6的表面及横截面形貌进行观察分析，分析不同涂盐量和涂盐方式下DD6的高温热腐蚀机理。结果 DD6在950 ℃下主要发生碱性熔融热腐蚀，同时伴随氧化、硫化和氯化等过程。高温热腐蚀使得DD6合金表面生成的保护性氧化膜被熔融态的腐蚀介质破坏，导致O、S、Cl等外部元素通过氧化膜的缺陷进入DD6基体中，在合金的亚表面发生内氧化、内硫化以及内氯化反应，横截面上出现明显的腐蚀层，其主要由氧化物以及硫化物组成。随着热腐蚀的进行，DD6表面物质发生了剥蚀，沉积盐量的增加导致剥蚀现象越加严重，合金内部致密的组织结构也被破坏，横截面上出现了大量孔洞、裂纹等缺陷。在相同涂盐量下，周期涂盐法使得DD6的腐蚀程度高于单次涂盐法。结论 DD6高温热腐蚀行为与涂盐量及涂盐方式密切相关，相同涂盐方式下，涂盐量越大，DD6热腐蚀更加严重。涂盐量一定时，周期涂盐法使得DD6的热腐蚀剧烈程度大于单次涂盐法，且DD6在上述热腐蚀条件下均发生剥蚀破坏。     

内排压脚与边坡稳定性的关系

为了研究边坡角及边坡形状与边坡稳定性的关系,采用有限元软件ANSYS模拟了不同边坡角对应的稳定系数,以及不同平盘宽度和压脚高度所形成的等储备强度边坡的稳定系数。模拟中假设材料符合相关联的理想弹塑性本构关系,强度准则符合Drucker-Prager准则,用计算收敛性作为边坡稳定性的准则,用强度折减法得出边坡的稳定系数。为了形成等储备强度边坡,由下到上分步骤进行压脚。先在平面边坡最下台阶压脚,这样提高了边坡稳定系数,在边坡进入临界状态时,最下两台阶的塑性状态相同,则压脚停止;再在最下两台阶同时压脚,在边坡进入临界状态时,最下3个台阶的塑性状态相同,则压脚停止;以此类推,在最下边n个台阶同时压脚,在边坡进入临界状态时,压到与第n+1个台阶的塑性状态相同为止。结果表明,边坡总是从坡脚开始形成塑性区,在重力加载过程中,塑性区以弧形条带向坡顶扩展,形成滑带。最有效的内排压脚是从最下台阶开始形成等储备强度边坡的压脚。     

Ion exchange membrane-assisted electro-activation of aqueous solutions: Effect of the operating parameters on solutions properties and system electric resistance

The properties of electro-activated (EA) aqueous solutions as well as the dynamics of their changes were considered in the current study using aqueous solutions of NaCl and NaHCO₃. The concentrations of the salt solutions were 0.5, 0.25, 0.125 and 0.05 M. The tests were performed at the DC current densities of 25, 37.5, and 50 Å/m². The electro-activation reactor consisted of three individual cells assembled together and separated by anion-exchange (AEM) and cation-exchange (CEM) membranes. During the experiments, four configurations of the membrane placements and solutions concentrations were studied. The obtained results showed the dynamics of the electro-activation process that allows obtaining electro-activated solutions with targeted properties such as pH and oxydo-reduction potential (ORP). It was possible to obtain electro-activated solutions at the anodic side (acid anolyte) with pH of 3.0, 3.5, and 4.0 and ORP of +1100 ± 15 mV when NaCl solution was used as electrolyte. Furthermore, several types of electro-activated solutions with high redox potential (ORP = +921 ± 12 mV) and neutral pH (6.48 ± 0.05) were obtained on the anode side when sodium carbonate was used. At the same time, two types of solutions, one with acid pH (2.14 ± 0.14) and the other one with alkaline pH (10.46 ± 0.03) with ORP = +689 ± 10 and 110 ± 21 mV, respectively, were obtained in the central compartment which considered as electro-activated solutions obtained by means of noncontact electro-activation.     

喷嘴直径对降尘效果影响的试验研究

为提高喷雾降尘效率,以改善作业环境,有必要研究喷嘴直径与降尘效果间的关系。基于自行设计的喷雾降尘试验系统,采用马尔文实时高速喷雾粒度分析仪、高速摄像仪及粉尘浓度测定仪对不同直径喷嘴的雾化特性参数和降尘效率进行测定。结果表明,在相同喷雾压力下,随着喷嘴直径的增大,全尘降尘效率持续增加,而呼吸性粉尘降尘效率先增加后减小,并在喷嘴直径为1.5 mm时达到最大值;在耗水量相同的情况下,随着喷嘴直径的增大,全尘和呼吸性粉尘降尘效率均下降。在井下喷雾降尘中,当耗水量不受限制时,为同时确保全尘和呼吸性粉尘降尘效率,宜选择直径为1.5 mm的喷嘴;当耗水量受限制时,宜选择直径为1.2 mm的喷嘴。     

压缩空气泡沫在长距离管路输送中压降的数值模拟

基于Fluent对压缩空气泡沫在长距离管道中的流动特性进行了数值模拟研究,将压缩空气泡沫近似为弥散流,采用Saplart-Allmaras模型模拟了不同管径下压缩空气泡沫以及不同泡沫原液浓度的AFFF泡沫在长距离管道内的流动及压降变化。模拟结果表明,随着距离变化,各管径管道内压降均呈现线性变化,且随着压缩空气泡沫的流动,压降线性增大。管道管径对管内压降变化具有显著影响,管道直径越小,管道内压降越大;泡沫原液浓度对压降的影响较小,且压缩空气泡沫在长距离输送中的压力随距离线性衰减。将模拟结果与长距离输送的试验结果进行了对比,误差在10%以内。