Environmental Persistence of Chemicals

- DOI: http://dx.doi.org/10.1065/espr2006.01.008 Background The hazard criterion of persistence as it applies to chemicals in the environment is reviewed and discussed. This quantity can not be measured directly in the environment, thus it must be estimated using models that synthesise information on chemical half-lives and partitioning properties, the nature of the environment and how the chemical is released into the environment. Main Features It is suggested that the preferred criterion is the average residence time of the chemical in the environment, i.e. conceptually the sum of the life-times of all molecules (attributable only to losses by degrading reactions) divided by the number of molecules. If all chemical fate processes are first order, this persistence is independent of the quantity of chemical introduced and whether introduction is steady- or unsteady-state in nature. It is shown that in a multimedia environment persistence is affected not only by degradation kinetics, but also by mode-of-entry and partitioning. For screening level purposes a Level II equilibrium model may be adequate but a Level III model is generally preferable for estimating the average persistence. If a distribution of persistences is required a dynamic Level IV model must be used. Discussion The implications for regulating chemicals on the basis of persistence are discussed. Conclusion It is concluded that the preferred strategy is to use Level II, III, and IV models and that the use of only degradation kinetics or media-specific half-lives can be misleading and uneconomical.     

Reduction of Cr(VI) by peat and coal humic substances

The reduction of Cr(VI) by humic substances from leonardite and peat was investigated by capillary zone electrophoresis at various pHs. Both humic materials reduced Cr(VI) at pH 5.4, but not at basic pH. The capacity of leonardite humic substances to reduce Cr(VI) was lower than that of peat humic substances. Fe(III) accelerated the reduction of Cr(VI) by peat humic substances, but not by leonardite humic substances. Cr(VI) reduction mechanisms are proposed. The coal humic substances seem more suitable for remediation of Cr(VI)-contaminated sites.     

Effect of sewage amendment on the dissipation of terbuthylazine,its degradation compound desethyl-terbuthylazine,and S-metolachlor in a field study

This study evaluates the effect of sewage amendment (SA) on the dissipation of terbuthylazine, its degradation compound desethyl-terbuthylazine, and S-metolachlor in the soil. The experiment was conducted at Padua Experimental Farm (Italy). Herbicides dissipation was evaluated in soils differently fertilized for three years: with inorganic fertilizer, with sewage sludge, and with a combination of them. Terbuthylazine and S-metolachlor were applied on sorghum as a formulated product at a dose of 2.8?L ha^?1, and their dissipation was followed for 2.5 months. The concentrations of herbicides and one metabolite in soil were analyzed by liquid chromatography-mass spectrometry. The dissipation of terbuthylazine and S-metolachlor followed a pseudo first order kinetics; they dissipated faster in soil amended only with inorganic fertilizer than in soils amended with sewage or sewage?+?inorganic fertilizer. The reduction in mineralization of the herbicides after sewage addition can be attributed to the reduced herbicide availability to microorganisms. The degradation of terbuthylazine led to the formation of desethyl-terbuthylazine. SA slowed down the formation and the degradation of desethyl-terbuthylazine, leading to a higher amount measured at the end of the incubation. These findings have practical implications for the assessment of the environmental fate of terbuthylazine and S-metolachlor in agricultural areas.     

Effect of soil layering on NAPL removal behavior in soil-heated vapor extraction

Soil heating has been proposed as a method to enhance the vapor extraction of NAPLs from contaminated soils. Three-dimensional fluid flow and heat transfer simulations have been performed for soil-heated vapor extraction to determine the transient system performance for a hypothetical configuration. Soil layering has been considered in evaluation of the initial non-aqueous phase liquid (NAPL) distribution and in evaporation and transport to the vapor extraction location. Results from this layered model are compared with results for a homogeneous system with an initially uniform NAPL, indicating the influence of layering, the initial NAPL distribution, the type of NAPL, and the possibility of enhanced vapor diffusion. Not only is the NAPL removal time reduced significantly with the addition of heat, but the uncertainty in the removal time owing to a number of difficult to characterize in situ factors, such as layering and the initial NAPL distribution, is much less than for standard soil vapor extraction without heating, owing to the rise in temperature and increase in NAPL vapor pressure with time.     

Surfactant enhanced recovery of tetrachloroethylene from a porous medium containing low permeability lenses. 1. Experimental studies

A matrix of batch, column and two-dimensional (2-D) box experiments was conducted to investigate the coupled effects of rate-limited solubilization and layering on the entrapment and subsequent recovery of a representative dense NAPL, tetrachloroethylene (PCE), during surfactant flushing. Batch experiments were performed to determine the equilibrium solubilization capacity of the surfactant, polyoxyethylene (20) sorbitan monooleate (Tween 80), and to measure fluid viscosity, density and interfacial tension. Results of one-dimensional column studies indicated that micellar solubilization of residual PCE was rate-limited at Darcy velocities ranging from 0.8 to 8.2 cm/h and during periods of flow interruption. Effluent concentration data were used to develop effective mass transfer coefficient (Ke) expressions that were dependent upon the Darcy velocity and duration of flow interruption. To simulate subsurface heterogeneity, 2-D boxes were packed with layers of F-70 Ottawa sand and Wurtsmith aquifer material within 20-30 mesh Ottawa sand. A 4% Tween 80 solution was then flushed through PCE-contaminated boxes at several flow velocities, with periods of flow interruption. Effluent concentration data and visual observations indicated that both rate-limited solubilization and pooling of PCE above the fine layers reduced PCE recovery to levels below those anticipated from batch and column measurements. These experimental results demonstrate the potential impact of both mass transfer limitations and subsurface layering on the recovery of PCE during surfactant enhanced aquifer remediation.     

A theoretical model of air and steam co-injection to prevent the downward migration of DNAPLs during steam-enhanced extraction

When steam is injected into soil containing a dense volatile non-aqueous phase liquid contaminant the DNAPL vaporized within the heated soil region condenses and accumulates ahead of the steam condensation front. If enough DNAPL accumulates, gravitational forces can overcome trapping forces allowing the liquid contaminant to flow downward. By injecting air with steam, a portion of the DNAPL vapor remains suspended in equilibrium with the air, decreasing liquid contaminant accumulation ahead of the steam condensation front, and thus reducing the possibility of downward migration. In this work, a one-dimensional theoretical model is developed to predict the injection ratio of air to steam that will prevent the accumulation of volatile DNAPLs. The contaminated region is modeled as a one-dimensional homogeneous porous medium with an initially uniform distribution of a single component contaminant. Mass and energy balances are combined to determine the injection ratio of air to steam that eliminates accumulation of the contaminant ahead of the steam condensation front, and hence reduces the possibility of downward migration. The minimum injection ratio that eliminates accumulation is defined as the optimum injection ratio. Example calculations are presented for three DNAPLs, carbon tetrachloride (CCl4), trichloroethylene (TCE), and perchloroethylene (PCE). The optimum injection ratio of air to steam is shown to depend on the initial saturation and the volatility of the liquid contaminant. Numerical simulation results are presented to validate the model, and to illustrate downward migration for ratios less than optimum. Optimum injection ratios determined from numerical simulations are shown to be in good agreement with the theoretical model.     

柱淋洗法修复铬污染土壤的效果研究

以铬渣污染土壤为供试土壤,采用土柱淋洗法研究柠檬酸、草酸和盐酸单一淋洗以及复合淋洗对铬去除动态和修复效果的影响,并对淋洗前后土壤中铬形态进行分析,探讨修复机理。结果表明,各淋洗方案中,以10体积0.5 mol/L草酸溶液为淋洗剂时的修复效果最好,总Cr累计淋出量为2 304 mg/kg,上层、中层和下层土壤总Cr去除率分别为79.6%、78.1%和69.6%,Cr(VI)去除率为87.8%、86.2%和75%,且土壤Cr(VI)和总Cr随着土壤深度的增加而升高,有在底部积累的可能;淋洗后土壤明显酸化,p H值从10.5降至3左右;以酸作为淋洗剂能有效降低土壤可氧化态铬含量,将其转化为移动性较强的酸可提取态,这有助于达到预期修复效果。     

氚在黏土矿物等多孔介质中的滞留机制

通过电感耦合等离子体光谱(ICP)、热重(TG)等分析方法对黏土矿物的结构成分、加热特性等进行了检测;通过蒸馏冷凝等实验,实现了对吸附后黏土矿物的吸附水、层间水、结构水的分离,检测了氚在黏土矿物结构内外各类型水中的分布;通过红外吸收光谱(IR)等分析方法对氚在黏土矿物结构中的吸附位置及形态进行了检测研究;通过同位素效应...     

A new concept: the use of neutrally-buoyant microemulsions for DNAPL remediation

Even in the absence of mobilization of dense nonaqueous phase liquid (DNAPL), the microemulsion that forms when the surfactant solubilizes a dense contaminant such as trichloroethylene will be more dense than water and tends to migrate downward. This paper addresses the issue of migration with a new concept: surfactant enhanced aquifer remediation at neutral buoyancy. Laboratory results of surfactant remediation in two-dimensional model aquifers show that downward migration of microemulsion containing solubilized dense contaminants can be reduced to an acceptable level, even in the absence of capillary barriers in the aquifer. One model experiment was designed to exhibit a small degree of vertical migration and full capture of the microemulsion at the extraction well. The second experiment was designed to demonstrate the effect of large buoyancy forces that lead to excessive downward migration of the microemulsion. Density measurements of aqueous solutions containing sodium dihexyl sulfosuccinate surfactant, isopropanol, trichloroethylene, and sodium chloride are presented. A companion paper presents the results of the flow and transport calculations needed for this approach to surfactant flooding.     

巢湖营养化状况评价及水质恢复探讨

巢湖水质的污染特征为营养盐浓度居高不下,局部水域藻类疯长,已属重富营养化。根据近10 a监测数据,总氮的点源污染负荷占51%,非点源占49%;总磷的点源污染负荷占60%,非点源占40%。笔者也探讨了COD、总氮、总磷的湖内空间分布及水质恢复对策。综合分析巢湖的环境特征、水质现状及流域环境经济状况,短期内巢湖的水质将很难明显改观。如各项规划中的措施到位,预计到2010年,巢湖的水质可望从富营养－极度富营养化向中富营养－富营养化转变,达到国家Ⅲ类水体标准。