铜合金坯饼光饰废液治理研究

根据铜合金坯饼生产线产生废液的性质 ,用盐析法使有机物浊化析出 ,用中和法使重金属离子沉淀析出。工程运行表明处理后的废水可以达到国家排放标准     

高压湿式空气氧化技术在炼厂碱渣处理中的应用

钟对碱渣酸化处理工艺带来的一系列问题，通过引进美国高压湿式空气氧化处理技术对旧的碱渣处理装置进行全面改造，取得了良好的效果。     

钝顶螺旋藻处理氨氮废水的研究

螺旋藻是一种营养丰富的新型保健食品，利用含氮废水为培养基，研究螺旋藻以NH4－N的处理效率，着重探讨利用生活污水培养螺旋藻的可行性，及其对生活污水的处理效果。研究证明，在NH4－N浓度小于40.0mg/L时，其对NH4－N的去除率最大，可达93％左右。在体积百分比生活污水为80％时，添加NaHCO38mg/L，对NH4－N的去除率达91.8%。同时对螺旋藻化学组分及含铁、锌、锰、铜、硒进行分析，生活污水培养螺旋藻，其所含有机物和氮源，可供螺旋藻生长繁殖，使废水资源化，并减少环境污染；藻粉可作为饲料添加剂，是使废水变为蛋白源的有效途径。     

In situ measurement of isoprene in the marine air and surface seawater from the western North Pacific

Isoprene (2-methyl-1,3-butadiene) was measured on board of R/V Mirai for eight air samples and 14 seawater samples collected in the western North Pacific during ACE-Asia campaign (from 18 to 26 May 2001). The measurements were conducted in situ using a cryo-focus/gas chromatography/mass spectrometry (Cryo/GC/MS). Concentrations of isoprene ranged from 7.2 to 110 parts-per-trillion (pptv) in the marine air, and ranged from below 12 to 94 pmol l⁻¹ in the seawater. Based on these results, sea-to-air fluxes of isoprene were calculated to be 184 and 300 nmol m⁻² day⁻¹ for two samples, and the upper limits of the fluxes were also calculated to be from 32 to 300 nmol m⁻² day⁻¹. Atmospheric isoprene concentrations cannot be explained only by the flux from the seawater. Thus, the concentrations of isoprene in the marine air in western North Pacific should be significantly affected by terrestrial vegetational emission and subsequent long-range atmospheric transport of isoprene.     

The Thermodynamic Performance of a Double-Acting Traveling-Wave Thermoacoustic Engine with Liquid-Water Piston

A double-acting traveling-wave thermoacoustic engine with liquid-water piston (DTTELP) was proposed by the authors. This article conducted numerical simulation on its performance for the cases of with and without acoustical loads. The effects of mean working pressure and water-piston mass on its non-load performance were firstly discussed. Then, the output performance of this novel thermoacoustic engine under fixed heating temperature was analyzed. Also, influences of different heating temperatures on the performance of this engine were discussed. According to the simulation, the novel double-acting thermoacoustic heat engine (TTHE) is very efficient and a maximum thermal efficiency can reach about 51% when the heating temperature is 1500 K.     

Qualitative and quantitative determination of heavy metals in waste cellular phones

Twenty four waste cellular phones, manufactured between 2002 and 2011, were selected in order to determine the total heavy metal content in each of their parts (printed circuit boards (PCBs), plastic housing (PH) and liquid crystal display monitors (LCDs)) and compare the results with the permissible limits set by the 2003 Directive on Restriction of Hazardous Substances (RoHS). All the selected samples were pulverized and digested with strong acids. Inductively coupled plasma-mass spectrometry was used to measure the heavy metal content in each sample. The results revealed that concentration levels of the examined heavy metals were higher in PCBs, followed by PH and LCD in that particular order (PCB > PH > LCD). With the exception of Pb and Cr present in PCBs of mobile phones released before the year 2006, all the other metal concentrations were according to the Directive. Concentration levels of Cd, Hg were lower than the permissible limits set by the EU, either before or after the validity of the 2003 RoHS Directive. Considering their significant heavy metal content, coupled with their large quantities produced worldwide in an annual rate, waste cellular phones need to be treated under an environmentally sound management scheme, prioritizing recycling and at the same time eliminating the possibility of any harm.     

Liquid balance monitoring inside conventional,Retrofit, and bio-reactor landfill cells

The Outer Loop landfill bioreactor (OLLB) in Louisville, KY, USA has been the site of a study to evaluate long-term bioreactor performance at a full-scale operational landfill. Three types of landfill units were studied including a conventional landfill (Control cell), a new landfill area that had an air addition and recirculation piping network installed as waste was being placed (As-Built cell), and a conventional landfill that was modified to allow for liquids recirculation (Retrofit cell). During the monitoring period, the Retrofit, Control, and As-Built cells received 48, 14, and 213 L Mg^?1 (liters of liquids per metric ton of waste), respectively. The leachate collection system yielded 60, 57 and 198 L Mg^?1 from the Retrofit, Control, and As-Built cells, respectively. The head on liner in all cells was below regulatory limits. In the Control and As-Built cells, leachate head on liner decreased once waste placement stopped. The measured moisture content of the waste samples was consistent with that calculated from the estimate of accumulated liquid by the liquid balance. Additionally, measurements on excavated solid waste samples revealed large spatial variability in waste moisture content. The degree of saturation in the Control cells decreased from 85% to 75%. The degree of saturation increased from 82% to 83% due to liquids addition in the Retrofit cells and decreased back to 80% once liquid addition stopped. In the As-Built cells, the degree of saturation increased from 87% to 97% during filling activities and then started to decrease soon after filling activities stopped to reach 92% at the end of the monitoring period. The measured leachate generation rates were used to estimate an in-place saturated hydraulic conductivity of the MSW in the range of 10^?8 to 10^?7 m s^?1 which is lower than previous reports. In the Control and Retrofit cells, the net loss in liquids, 43 and 12 L Mg^?1, respectively, was similar to the measured settlement of 15% and 5–8% strain, respectively (Abichou et al., 2013). The increase in net liquid volume in the As-Built cells indicates that the 37% (average) measured settlement strain in these cells cannot be due to consolidation as the waste mass did not lose any moisture but rather suggests that settlement was attributable to lubrication of waste particle contacts, softening of flexible porous materials, and additional biological degradation.     

Claiming a corner at work: Measuring employee territoriality in their workspaces

Territoriality is an emerging concept of importance in organizations. Unfortunately, there does not exist currently a valid measure of territoriality with which to conduct research on territoriality in organizations. I developed a theoretically driven four-factor measure of territoriality. Six hundred and sixty-three people working in office settings completed an online survey about their territorial behaviors. Using confirmatory factor analysis I found that the four-factor structure had acceptable fit. I also found preliminary evidence of construct validity. Collectively, the results support the validity of the measure, thus providing an instrument for studying territoriality in organizations. I then discuss specific implications of this measure for both research and practise.     

Development of solid phase adsorption toxin tracking (SPATT) for monitoring anatoxin-a and homoanatoxin-a in river water

Sampling and monitoring for cyanotoxins can be problematic as concentrations change with environmental and hydrological conditions. Current sampling practices (e.g. grab samples) provide data on cyanotoxins present only at one point in time and may miss areas or times of highest risk. Recent research has identified the widespread distribution of anatoxin-producing benthic cyanobacteria in rivers highlighting the need for development of effective sampling techniques. In this study we evaluated the potential of an in situ method known as solid phase adsorption toxin tracking (SPATT) for collecting and concentrating anatoxin-a (ATX) and homoanatoxin-a (HTX) in river water. Fifteen different adsorption substrates were screened for efficiency of ATX uptake, nine of which retained high proportions (>70%) of ATX. Four substrates were then selected for a 24-h trial in a SPATT bag format in the laboratory. The greatest decrease in ATX in the water was observed with powdered activated carbon (PAC) and Strata-X (a polymeric resin) SPATT bags. A 3-d field study in a river containing toxic benthic cyanobacterial mats was undertaken using PAC and Strata-X SPATT bags. ATX and HTX were detected in all SPATT bags. Surface grab samples were taken throughout the field study and ATX and HTX were only detected in one of the water samples, highlighting the limitations of this currently used method. Both Strata-X and PAC were found to be effective absorbent substrates. PAC has the advantage that it is cheap and readily available and appears to continue to sorb toxins over longer periods than Strata-X. SPATT has the potential to be integrated into current cyanobacterial monitoring programmes and would be a very useful and economical tool for early warning of ATX and HTX contamination in water.     

An improved method for Kr analysis by liquid scintillation counting and its application to atmospheric Kr determination

Atmospheric ⁸⁵Kr concentration at Fukuoka, Japan was determined by an improved ⁸⁵Kr analytical method using liquid scintillation counting (LSC). An average value of 1.54 ± 0.05 Bq m⁻³ was observed in 2008, which is about two times that measured in 1981 at Fukuoka, indicating a 29 mBq y⁻¹ rate of increase as an average for these 27 years. The analytical method developed involves collecting Kr from air using activated charcoal at liquid N₂ temperature and purifying it using He at dry ice temperature, followed by Kr separation by gas chromatography. An overall Kr recovery of 76.4 ± 8.1% was achieved when Kr was analyzed in 500-1000 l of air. The Kr isolated by gas chromatography was collected on silica gel in a quartz glass vial cooled to liquid N₂ temperature and the activity of ⁸⁵Kr was measured with a low-background LS counter. The detection limit of ⁸⁵Kr activity by the present analytical method is 0.0015 Bq at a 95% confidence level, including all propagation errors, which is equivalent with ⁸⁵Kr in 1.3 l of the present air under the analytical conditions of 72.1% counting efficiency, 0.1597 cps background count rate, and 76.4% Kr recovery.