5%NaCl盐雾环境对铝合金铆接防护结构性能影响研究

目的研究2024铝合金在5%NaCl盐雾环境下的腐蚀疲劳性能。方法开展2024铝合金5%NaCl盐雾环境下的腐蚀疲劳试验,采用"疲劳加载-腐蚀环境"交替循环的试验模式,通过试验测试铝合金铆接结构在5%NaCl盐雾环境下的腐蚀疲劳寿命值,分析不同疲劳载荷大小对铝合金连接结构的腐蚀疲劳寿命影响。结果 5%NaCl盐雾环境对于铝合金铆接结构疲劳寿命有较大影响,疲劳载荷对防护涂层防护性能和腐蚀疲劳载荷的滞后效应等两方面影响,0.25P破坏载荷相较于0.3P破坏载荷,涂层防护作用影响更小,低载锻炼效应更强,腐蚀疲劳寿命降低量更少。结论 2024铝合金铆接结构耐腐蚀性能与结构载荷和防护涂层特性有重要关系。     

电解铝厂周边土壤和农作物氟污染评价

通过对广西某电解铝厂周边大气、土壤和农作物氟化物污染进行监测评价,结果表明:铝厂周围大气氟污染与采样点到铝厂距离无明显相关,却与采样点的方位成显著相关;土壤中水溶氟的含量与采样点到铝厂距离呈负相关.农作物玉米叶片氟污染物主要来自于铝厂排放的氟化物.玉米果实样品中的氟含量除对照点属于中度污染外,其余样点样品均属重污染.     

我国南方一些酸性土壤铝存在形态的初步研究

以连续提取法研究了我国南方主要酸性土壤铝的形态及其分布特点，探讨了不同铝形态之间的关系及其与母质、成土过程、环境条件的联系。还研究了土壤酸化对铝形态转化的影响．并以连续提取法提取的三种铝形态（交换性铝、活性羟基铝，有机络合态铝）来讨论现今常用的Ａｌ。（Ｔａｍｍ溶液提取）和Ａｌｄ（ＤＣＢ溶液提取）所可能包含的实际土壤铝形态，分析表明，Ａｌ０和Ａｌｄ无明确的形态意义，只是上种由操作定义的多形态组成的混合物。     

Al-Ferron逐时络合比色法研究PACS中铝的水解聚合形态

制备了碱化度(B)及不同Al~(3+)/SO_4~(2-)摩尔比的系列PACS,用Al-Ferron逐时络合比色法研究了铝的形态分布,考察了碱化度(B)、Al~(3+)/SO_4~(2-)摩尔比、稀释作用及pH值对铝的形态分布的影响.实验结果表明,Al~(3+)/SO_4~(2-)摩尔比及溶液的pH值对铝的形态分布有较大的影响,稀释作用对铝的形态分布影响较小.Al~(3+)/SO_4~(2-)摩尔比愈小,pH值愈高,铝的水解聚合大分子及胶体粒子所占的比例就愈大.     

浅论铝盐的水解和吸附电中和过程中被凝聚物浓度的影响

通过对凝聚机理和铝盐在水中水解过程的分析，提出了铝盐水解物吸附起胶本电和中和数学模式，论述了被凝聚物浓度对铝盐水解过程的影响，在实际的凝集过程中，铝盐的水解和向胶体表面的吸附是同时进行的，部分铝盐在完成水解之前就以中间产物的形态吸附于胶体表面，胶体溶液的浓度愈高，这种倾向就愈强，由于较低水解度的物种具有较高的单位电位浓度，它们能显示较强的电中和能力，因此，随着胶体溶液浓度增高，达到最佳凝聚ζ电位所     

茜素络合剂-微分吸附计时电位法测定高含铁量土壤中铝形态

研究了茜素络合剂-微分吸附计时电位法(AC-ASV)测定土壤溶液中铝形态的最佳条件,着重探讨了共存离子,特别是土壤溶液中的无机离子和有机阴离子对测定铝的影响,建立了测定土壤溶液中铝形态方法。用该法可测定总反应性铝、总单核铝[Ala]和稳定性单核铝[Ali],由总反应性铝减去总单核铝求得酸溶性铝[Als],由总单核铝[Ala]减去稳定单核铝求得不稳定单核铝[Alo],与标准的Driscoll方法(阳离子树脂交换分离-8-羟基喹啉-原子吸收法)进行了比较。结果表明:茜素络合剂(AC)-微分吸附计时电位法灵敏度较高,铁的干扰较少。该法适合于测定含铁量比较高的土壤溶液中的铝形态。     

Determinants of parental effort: a behavioural study in the Eurasian kestrel,Falco tinnunculus

We recorded behaviour of kestrels (Falco tinnunculus) in western Finland during the courtship (1988–1992), incubation (1989–1991), early nestling (age of young 1–2 weeks, 1989–1992) and late nestling stages (3–4 weeks, 1989–1991) to examine determinants of their parental effort (PE). In males, PE was estimated as the hunting effort (the proportion of budget time spent in flight-hunting) and in females as the food provisioning rate (number of prey items delivered to the nest per hour). The following predictions derived from the parental investment theory were examined. (1) Parents rearing large clutches and broods should invest more in breeding than do parents rearing small clutches and broods. The hunting effort of parents did not increase with clutch or brood size, but males tending large broods had a higher prey delivery rate than males tending small broods (Figs 1–2). (2) PE of parents should increase in the course of the breeding season. In males, this was true only between the incubation and early nestling phases (Fig. 3). (3) The early pairs should invest more in breeding than late ones. This tended to be true during the early (for males) and late nestling phases (for females) (Fig. 4). (4) There should be a negative correlation between PE of mates within pairs, but no evidence for such adjustment was found (Fig. 5). (5) Females mated with bright-coloured attractive males should show higher PE than females mated with dull-coloured males but our results were inconsistent with this prediction. We conclude that PE decisions of kestrels are mainly based on cost-benefit estimates of residual reproductive value, rather than on current investment indicators, like clutch or brood size. This might be beneficial in environments with highly variable survival prospects of offspring caused by pronounced among-year variation in abundance of the main food (microtine rodents). The results also show that hypotheses explaining variation in PE in the short term are not necessarily valid for long-term PE, e.g. tending clutches or broods, which also reflects the demands of female and young.     

钾长石分解副产物制聚硅酸硫酸铝的研究

钾长石分解制钾肥是钾肥制造的一条重要途径。钾长石低温分解制钾肥过程中会产生大量含铝副产物，探讨了该含铝副产物用于研制污水处理的絮凝剂聚硅酸硫酸铝(PSAS)，进行了PSAS的污水处理试验。试验表明，以钾长石分解产物为主要原料制备聚合硅酸铝是可行的，其除浊性能优良，经改性后的PSAS脱色效果良好，为钾长石副产物的利用开辟了一条新的途径。     

聚合氯化铝和改性聚合氯化铝中铝形态分布研究

利用Al-Ferron络合比色法研究实验室合成的聚合氯化铝和改性聚合氯化铝的铝形态分布,并对其合成工艺进行改进.聚合氯化铝合成条件为铝离子初始浓度为1 mol/L,物料比11,反应温度为60℃,熟化温度为60℃～65℃.合成改性聚合氯化铝适宜条件是Al/Si在0.7～1之间,聚硅酸聚合时间为90 min,模数为2的水玻璃.     

铝处理马尾松对高温、低温、干旱和SO_2的抗性研究

马尾松在不同浓度铝溶液(0、30、60、120、240、480ppm)中生长两个月后,转移至高温、低温、干旱或SO_2熏气罩中,结果发现,经过铝培养松苗的膜透性显著高于未经过铝培养松苗的膜透性,且铝浓度越大,膜透性越大,表明铝处理马尾松对高温、低温、干旱和SO_2的抵抗性降低.300ppb的SO_2熏气30h后,未经铝培养的松苗没有明显受害症状出现,而经过铝培养的松苗却表现出针叶发黄、叶缘和叶尖出现明显可见伤害斑点等SO_2受害症状,高温、低温和干旱处理的主要症状表现为针叶发黄、萎蔫。