Phosphorus flows and use efficiencies in production and consumption of wheat, rice, and maize in China

Increasing fertilizer phosphorus (P) application in agriculture has greatly contributed to the increase of crop yields during the last decades in China but it has also increased P flows in food production and consumption. The relationship between P use efficiency and P flow is not well quantified at national level. In present paper we report on P flows and P use efficiencies in rice, wheat, and maize production in China using the NUFER model. Conservation strategies for P utilization and the impact of these strategies on P use efficiency have been evaluated. Total amounts of P input to wheat, rice, and maize fields were 1095, 1240, and 1128 Gg, respectively, in China, approximately 80% of which was in chemical fertilizers. The accumulation of P annually in the fields of wheat, rice, and maize was 29.4, 13.6, and 21.3 kg ha⁻¹, respectively. Phosphorus recovered in the food products of wheat, rice, and maize accounted for only 12.5%, 13.5%, and 3.8% of the total P input, or 3.2%, 2.6%, and 0.9% of the applied fertilizer P, respectively. The present study shows that optimizing phosphorus flows and decreasing phosphorus losses in crop production and utilization through improved nutrient management must be considered as an important issue in the development of agriculture in China.     

How the redox state of tobacco 'Bel-W3' is modified in response to ozone and other environmental factors in a sub-tropical area?

This study intended to determine whether the redox state in plants of Nicotiana tabacum ‘Bel-W3’ fluctuates in response to the environmental factors in a sub-tropical area contaminated by ozone (São Paulo, SE - Brazil) and which environmental factors are related to this fluctuation, discussing their biomonitoring efficiency. We comparatively evaluated the indicators of redox state (ascorbic acid, glutathione, superoxide dismutase, ascorbate peroxidase, and glutathione reductase) and leaf injury in 17 field experiments performed in 2008. The redox state was explained by the combined effects of chronic levels of O₃ and meteorological variables 4-6 days prior to the plant sampling. Moderate leaf injury was observed in most cases. The redox state of tobacco decreases few days after their placement in the sub-tropical environment, causing them to become susceptible to oxidative stress imposed by chronic doses of O₃. Its bioindicator efficiency would not be diminished in such levels of atmospheric contamination.     

环境因素对聚乙烯醇降解菌系降解效果的影响研究

针对在前期研究中已筛选到的一种聚乙烯醇(PVA)降解混合菌系,考察了种龄、菌悬液接种量、培养基装液量、培养温度、初始pH、渗透压及光照等外部环境因素对其PVA降解能力的影响.结果表明,种龄对混合菌系降解PVA的能力影响较小,实际运用中保持种龄为24～48 h较佳;菌悬液接种量过多时,会影响其正常生长,最佳的接种量为4～...     

分点进水A/O工艺处理低碳源生活污水的脱氮性能研究

针对低C/N比污水脱氮的难点问题,在缺氧段不同点设置进水口,采用分点进水A/O工艺处理校园生活污水.考察了在污泥回流比为100%,硝化液回流比为200%,分流比为1∶1,缺氧池水力停留时间(HRT)分别为2、2.4和3 h情况下,分点进水A/O工艺的反硝化性能,并与传统的A/O工艺进行比较.结果表明,当缺氧池的水力停留...     

垃圾渗滤液的加载磁絮凝预处理工艺研究

垃圾渗滤液是一种成分复杂多变的高浓度难处理有机废水。采用加载磁絮凝技术对垃圾渗滤液进行预处理,以提高其可生化性,便于后续生化处理的进行。研究了适宜的磁载体种类、凝聚剂和絮凝剂的加入量,以及不同pH值和药剂投加顺序的影响,并进行了磁絮凝与常规絮凝工艺的对比实验。得到的最优组合工艺为：PAC投加量5.5 g/L,磁载体投加...     

湿法脱硫装置效率不高原因分析

分析了石灰石—石膏湿法烟气脱硫系统脱硫效率不高的原因,提出了查找方法和程序。     

机械絮凝池内部流场数值模拟和絮凝效果分析

通过对机械絮凝池内不同进水流量和不同桨板转速的流场分别进行数值模拟,计算得到湍动能k和湍动耗散率ε等水力参数,并结合混凝实验分析水流对絮凝效果的影响。结果表明:湍动能k和湍动耗散率ε可以作为评价絮凝是否充分的标准;机械絮凝池最佳水力停留时间为18 min;平均k值为0.00613～0.00212 m2/s2,平均ε值为0.00869～0.00199 m2/s3时,机械絮凝池装置的絮凝效果比较理想。     

青萍生长特征及其对受污染河水的修复效果

以浮萍优势品种青萍（Lemna minor）为研究对象,开展受污染河水修复。分析了青萍在不同营养盐浓度条件下的生长特征,探讨了青萍对受污染河水的修复效果。在表面积为0.0095 m2的限制空间条件下,青萍在1、2和5 mg总氮（TN）/L营养液中的生长特征都能较好地服从Logistic生长模型,受制约的临界鲜重（FW）分别为1.20、1.36和1.36 g;青萍对受污染河水中氮磷污染物具有较好的去除效果,氨氮（NH＋4-N）的平均去除率、平均去除量和平均去除速率分别为56.87%、1.22 mg/d和0.0466 mg/（g FW·h）,正磷酸盐（PO3-4-P）的平均去除率、平均去除量和平均去除速率分别为66.95%、0.25 mg/d和0.0088 mg/（g FW·h）。根据相关性分析,进水NH＋4-N和PO3-4-P浓度与其对应去除量之间极显著相关;青萍FW与NH＋4-N去除速率之间显著负相关,但与PO3-4-P去除速率之间不存在显著相关性;NH＋4-N进水浓度与去除速率相关性不显著,但PO3-4-P进水浓度与去除速率显著正相关。     

风量对高频气力分选机分选效率及金属分布规律的影响——以废弃印刷电路板粉末为例

以金属高富集粒级0.5～0.125 mm的废弃电路板为分选物料,通过ICP-AES测定分选产品,研究了风量对高频气力分选机分选效率及金属分布规律的影响.结果表明,风量变化对分选效率及金属分布规律影响显著,当风量为200m3/h时分选效率达到最大值78.23％,铜品位为86.745％,相比原料中铜品位13.96％,富集约6.2倍.随着风量的变化,金属的分布呈现规律性变化:密度比铜大或与铜相差不多的金属颗粒(铅、铂和锌等),其变化规律与铜相似,回收率在85％左右变化;密度比铜小很多的金属颗粒(铝、镁等),由于其密度与分选物料中的非金属非常接近,在分选过程中会随非金属带人轻产物中去,从而造成重产物中铝和镁品位最低,甚至低于其在原料中的品位.所以若要分离富集铝和镁,须对分选后的物料进行二次分选.     

曝气条件对串联潜流人工湿地净污效果的影响

选取砾石、炉渣和沸石作为级配基质,构建由三级串联的潜流人工湿地模型,研究了针对三级串联的潜流人工湿地,不同曝气位置和曝气量对人工模拟污水净化效果的影响,并对两个影响因素进行二维方差分析,对曝气条件进行了优选。选取表层曝气、中层曝气、底层曝气3种曝气位置和气水体积比3∶1、6∶1、9∶1的3种曝气量。运行结果表明:曝气后,NH3-N和COD去除率上升,NH3-N去除率由7.80%最高提升到23.79%,COD去除率由5.42%最高提升至23.04%,但PO3-4-P去除率下降,由24.32%最低降至9.76%。优选的曝气位置是底层曝气,优选的气水体积比是6∶1,此时NH3-N、COD、PO3-4-P去除率分别是21.21%、23.04%、13.54%。曝气位置和曝气量的交互作用对NH3-N和COD去除率有显著影响,对PO3-4-P去除率影响不显著。