诱导结晶磷回收技术处理低浓度含磷废水研究

诱导结晶技术是近年发展的新型废水处理技术。采用自设计的诱导结晶反应器,反应器形式与Phosnix相似,但结构相对简单,无Phosnix反应器的内外同心筒结构,并增加了过渡区。研究了HRT、[PO43-]、[Ca2+]/[PO43-]对诱导结晶处理低浓度含磷废水的影响规律,并以实验室双泥系统厌氧上清液为原水,考察了结晶反应器长期运行效果。研究表明,在一定范围增加HRT、[PO43-]或[Ca2+]/[PO43-]均可提高磷酸盐去除率,但超过一定数值后,再继续增加对提高磷酸盐去除效果的贡献很小,[PO43-]或[Ca2+]/[PO43-]过高还会导致均相结晶出现,使磷酸盐去除率下降;研究给出了一定条件下的最佳HRT、[PO43-]或[Ca2+]/[PO43-];运行效果试验表明,诱导结晶反应器在进水平均磷酸盐浓度仅为23.6 mg/L的情况下,磷酸盐的平均去除率仍可达到55.2%,该技术在处理低浓度含磷水方面较具应用前景。     

2-萘酚生产废水综合治理与资源化利用工程实例

针对2-萘酚生产废水p H值低、色泽深,亚硫酸盐和萘磺酸盐高、COD浓度高的特点,采用酸化脱硫-两级络合萃取-氧化絮凝工艺处理,介绍了专利工艺的流程设计,给出了主要工艺设计参数及投资运行成本。工程运行结果表明,该工艺设计合理、技术成熟、处理效果稳定,2-萘酚生产废水经处理后达到GB 8978—1996《污水综合排放标准》一级排放标准要求;回收的萘磺酸钠固体可返回2-萘酚生产系统套用;反萃取黑液经蒸发浓缩,合成的减水剂产品各项指标达到或超过GB 8076—2008《混凝土外加剂》高效减水剂指标要求。     

磷回收对厌氧/好氧交替式生物滤池蓄磷/除磷的影响

为能提高生物除磷系统的除磷/回收磷效率,研究采用厌氧/好氧交替式生物滤池(AABF)处理低碳磷比废水,观察利用周期性扩增进水碳源进行磷回收时,生物滤池除磷效率及生物膜内微生物特性的变化.通过分析生物滤池除磷效率变化,生物膜多聚物染色、扫描电镜(SEM)观察以及荧光原位杂交(FISH)技术分析生物滤池系统实施周期性磷回收对生物膜内微生物菌群形态与组成的影响.结果发现,生物滤池在先后经历3次生物蓄磷-磷回收(PB-PR)的运行操作过程中,生物滤池除磷效率分别由磷回收前的60.3%、82.9%、86.6%提高到磷回收后的87.2%、91.2%、93.5%;生物滤池生物膜内优势菌群形态逐渐由大球菌演变为小球菌、杆菌与丝状菌;经过连续3个周期的PB-PR操作,生物滤池底部生物膜中聚磷菌所占比例由43%提高至70%;聚磷菌群在生物膜内混合菌群中的比例随着上流式生物滤池高度的增加而不断提高.结果表明,采用周期性的碳源扩增与回收磷的操作,可以提高生物滤池除磷效率;引起生物滤池生物膜内微生物菌群形态与组成发生变化,促进聚磷菌成为优势菌群.     

中国矿山地质环境恢复治理激励机制探索研究

目前,中国矿山地质环境恢复治理形势依然严峻,国家高度重视矿山地质环境恢复与治理工作,财政部、国土资源部不断加大矿山地质环境治理资金,但目前资金缺口仍然很大。文章通过梳理中国矿山地质环境恢复治理激励机制建设创新做法,总结各省开展矿山地质环境恢复治理"五结合"激励模式实践探索,并针对我们矿山地质环境治理目前存在的主要困难和问题提出了引入市场机制出台土地使用权,及尽快出台国家层面的鼓励政策等多方面的优惠政策等建议。     

王坡井田煤层气井采出水处理方法研究

针对王坡井田煤层气井采出水中污染物含量低,仅CODcr超出国家一级排放标准(GB 8978-1996)的特点,采用活性炭吸附处理,然后通过絮凝沉降迅速回收采出水中悬浮活性炭。结果表明:活性炭投加量为3g/L、吸附时间为40 min,PAM投加量为2 mg/L,沉降时间为5 min,活性炭回收率为98.35%,处理后采出水CODcr为45.45 mg/L、SS为7 mg/L,达到国家一级排放标准(GB 8978-1996)。     

超临界CO2回收线路板工艺研究

采用正交试验设计进行了超临界CO₂回收废弃印刷线路板的实验。以温度、压强、时间和夹带剂为实验因素,通过对实验前后样本在重量、厚度、弯曲强度和断裂强度四方面变化的分析考察了各实验因素对实验效果的影响。实验结果表明,影响超临界CO₂法回收印刷线路板的最主要因素为温度、时间和夹带剂,超临界CO₂法回收废弃印刷线路板的最佳工艺条件：温度270℃,压强大于7.38 MPa,时间3 h,夹带剂(水)160 mL。实验进一步验证了压强对实验结果的非显著性影响。     

液晶显示器液晶处理与铟回收技术

在实验室条件下,对液晶显示器回收的各个重要环节作了初步的探索,提出了一整套回收工艺.其中包括利用丙酮常温浸取去除偏光片、分离玻璃基板、溶解液晶,还包括利用硫酸溶液和二氧化锰联合浸取玻璃基板,铟的浸取率达89%.得到的铟的酸液经过萃取、置换和电解,可以得到铟的产品,为液晶显示器的资源化和无害化提供实验数据和技术支持.     

The impact of the 2004 tsunami on coastal Thai communities: assessing adaptive capacity

The suddenness and scale of the 26 December 2004 tsunami and the challenges posed to affected communities highlighted the benefits of their members having a capacity to confront and adapt to the consequences of such a disaster. Research into adaptive capacity or resilience has been conducted almost exclusively with Western populations. This paper describes an exploratory study of the potential of a measure of collective efficacy developed for Western populations to predict the capacity of members of a collective society, Thai citizens affected by the 2004 tsunami, to confront effectively the recovery demands associated with this disaster. Following a demonstration that this measure could predict adaptive capacity, the role of religious affiliation, ethnicity and place of residence in sustaining collective efficacy is discussed. The implications of the findings for future research on, and intervention to develop, adaptive capacity among Thai citizens in particular and collectivist societies in general are discussed.     

Modeling Acidification Recovery on Threatened Ecosystems: Application to the Evaluation of the Gothenburg Protocol in France

To evaluate the acid deposition reduction negotiated for 2010 within the UNECE LRTAP Gothenburg Protocol, sulphur and nitrogen deposition time-series (1880–2100) were compared to critical loads of acidity on five French ecosystems: Massif Central basalt (site 1) and granite (2); Paris Bassin tertiary sands (3); Vosges mountains sandstone (4) and Landes eolian sands (5). The SAFE model was used to estimate the response of soil solution pH and ratio to the deposition scenario. Among the five sites, critical loads were exceeded in the past at sites 3, 4 and 5. Sites 3 and 4 were still expected to exceed in 2010, the Protocol year. Further reduction of atmospheric deposition, mainly nitrogen, would be needed to achieve recovery on these ecosystems. At sites 3, 4 and 5, the delay between the critical load exceedance and the violation of the critical chemical criterion was estimated to be 10 to 30 years in the top soil and 50 to 90 years in the deeper soil. At site 5, a recovery was expected in the top soil in 2010 with a time lag of 10 years. Unexpectedly, soil pH continued to decrease after 1980 in the deeper soil at sites 2 and 5. This time lag indicated that acidification moved down the soil profile as a consequence of slow base cation depletion by ion exchange. This delayed response of the soil solution was the result of the combination of weathering rates and vegetation uptake but also of the relative ratio between base cation deposition and acid compounds.     

Optical and Chemical Methods of Metal Ash Analysis and Tin Recovery

‘Metal ash’ presents a waste disposal problem in most of the developing countries as the industries employ obsolete technologies. In this paper we describe analysis of tin ash, zinc ash and aluminium ash by means of optical methods, such as X-ray diffraction (XRD), inductively coupled plasma mass spectrometry (ICP-MS), electron probe micro analysis (EPMA), scanning electron microscopy (SEM) and chemical methods. The results of tin ash obtained by XRD method matched well with the cassiterite, a naturally occurring mineral of tin. ICP-MS studies reveal the presence of a large number of tracer metals, which may cause pollution by tertiary dispersion and this aspect is discussed. Conversely, the data generated by chemical methods are limited. However, the methods are simple and cost-effective. Then, they can easily be adopted by low-budget industries. Simple and cost-effective process to recover tin from tin ash is described. It is based on heating tin ash with sodium cyanide to about 900°C to separate tin component from the metal ash. The process recovers good quality tin and offers a very high yield. The process can be scaled up to small pilot plant.