Factors affecting pedestrian behaviors at signalized crosswalks: An empirical study

Introduction: Safety of pedestrians depends, among other factors, on their behavior while crossing the road. This study aims to assess behaviors of pedestrians at signalized crosswalks. Method: Following a literature review and a pilot study, 25 vital pedestrian crossing factors and behaviors were determined. Then data was randomly collected for 708 pedestrians at 10 lighted crossings in Sharjah (UAE), five at road intersections and five mid-block crossings. Results: Results indicated that 17.4% of pedestrians observed crossed partly or fully on red and that crossing speed was 1.22 m/s, on the average, which is slightly faster than most speeds recorded in the literature. Moreover, female pedestrians were more likely to cross while chatting with others, less likely to cross on red, and more likely to walk slower than male pedestrians. Results also showed that pedestrians who crossed at road intersections walked slower than those who crossed at mid-block crossings. It was also found that longer red pedestrian times and narrower roads tended to encourage pedestrians to cross on red and that the majority of pedestrians did not look around before crossing. Practical implications: Use of the Health Belief Model for pedestrian safety are discussed.     

Road safety effects of roundabouts in Flanders

INTRODUCTION: This paper analyzes the effect on road safety of 95 roundabouts that were built in Flanders between 1994 and 1999. RESULTS: The study shows that the effect on the number and severity of road accidents adjusted for the trend and regression to the mean is significant, but varies considerably in accordance with the speed limit regime on the intersection. Roundabouts are most effective on intersections of a main road with a high speed limit (90 km/h) and an adjacent road with a lower speed limit (50 or 70 km/h). The empirical analysis reveals a reduction of 34% (varying between 15% and 59%) for the total number of injury accidents, 30% (7%-45%) for light injury accidents, and 38% (27%-72%) for serious injury accidents. This study also takes a closer look at the impact of different post-implementation periods using accident data of 1-, 3-, or 6-years after the construction of a roundabout on the calculated effectiveness results and warns for a severe underestimation when a one-year period is used. IMPACT ON INDUSTRY: An effective traffic safety policy based on scientific results thus requires some patience from the policy-makers.     

Investigating the influence on safety of retrofitting Italian motorways with barriers meeting a new EU standard

Objective: A new European Union (EU) regulation for safety barriers, which is based on performance, has encouraged road agencies to perform an upgrade of old barriers, with the expectation that there will be safety benefits at the retrofitted sites. The new class of barriers was designed and installed in compliance with the 1998 (European Norm) EN 1317 standards for road restraint systems, which lays down common requirements for the testing and certification of road restraint systems in all countries of the European Committee for Standardization (CEN). Both the older and new barriers are made of steel and are installed in such a way as to avoid vehicle intrusion, but the older ones are thought to be only effective at low speeds and large angles of impact. The new standard seeks to remedy this by providing better protection at higher speeds. This article seeks to quantify the effect on the frequency of fatal and injury crashes of retrofitting motorways with barriers meeting the new standards.

Methods: The estimation of the crash modification was carried out by performing an empirical Bayes before–after analysis based on data from the A18 Messina–Catania motorway in Italy. The methodology has the great advantage to account for the regression to the mean effects. Besides, to account for time trend effects and dispersion of crash data, a modified calibration methodology of safety performance was used.

Results: This study, based on data collected on 76 km of motorway in the period 2000–2012, derived Crash Modification Factor point estimates that indicate reductions of 72% for run-off-road fatal and injury crashes and 38% in total fatal and injury crashes that could be expected by upgrading an old safety barrier by complying with new EU 1317 standards. The estimated benefit-cost ratio of 5.57 for total crashes indicates that the treatment is cost effective.

Conclusions: The magnitude of this benefit indicates that the retrofits are cost-effective even for total crashes and should continue in any European country inasmuch as the estimated Crash Modification Factors are based on treatment sites that are reasonably representative of all European motorways.     

Single and multiple stressor effect of road deicers and Cu on Atlantic salmon (Salmo salar) alevins from hatching till swim-up

Road salts are frequently used for deicing of roads in the Nordic countries. During snow-melt, the road run-off containing high concentrations of road salt and various metals such as Cu remobilized from sand, silt and dust may negatively influence organisms in downstream receiving water bodies. The present work focuses on the impact of road salt(NaCl) and Cu, separately and in mixtures on Atlantic salmon alevins from hatching till swim-up. The results showed that high road salt concentrations could induce a series of negative effects in alevins such as reduced growth, deformities, delayed swim-up and mortality. For alevins exposed to all tested road salt concentrations(100–1000 mg/L),mortality was significantly higher compared to control. In exposure to Cu solutions(5–20 μg Cu/L), no effects on growth, morphology, swim-up or mortality of alevins compared to control were observed. In mixture solutions(road salt and Cu), ultrafiltration of the exposure water demonstrated that only 20%–40% of Cu was present as positively charged low molecular mass(LMM) Cu species assumed to be bioavailable. When exposed to road salt and Cu mixtures, negative effects in alevins such as reduced growth, deformities,delayed swim-up and mortality were observed. The overall results indicated that the road salt application could seriously affect sensitive life stages of Atlantic salmon, and application of road salt should be avoided during the late winter–early spring period.     

国家运输支撑力下的陆上丝绸之路运输通道风险测算方法

丝绸之路运输通道风险测算可有效分析通道风险因素,为国际运输宏观政策制定及风险管控提供理论支撑。针对25个国家的7条运输通道,结合文献分析法获取国家运输节点风险的影响因素,利用因子分析法量化综合风险;基于运输通道风险构成机制结合多维度的不均衡指数构建国家运输支撑力下的运输通道风险测度模型。结果表明:北线和西1通道风险最小,南线通道风险最大;运输通道风险测度受国家数目、国家参与程度及其影响力及国家风险状态影响;各运输通道内部与通道间均存在风险不均衡现象。     

Gaseous emissions from compressed natural gas buses in urban road and highway tests in China

The natural gas vehicle market is rapidly developing throughout the world, and the majority of such vehicles operate on compressed natural gas(CNG). However, most studies on the emission characteristics of CNG vehicles rely on laboratory chassis dynamometer measurements, which do not accurately represent actual road driving conditions. To further investigate the emission characteristics of CNG vehicles, two CNG city buses and two CNG coaches were tested on public urban roads and highway sections. Our results show that when speeds of 0–10 km/hr were increased to 10–20 km/hr, the CO_2, CO, nitrogen oxide(NO_x), and total hydrocarbon(THC) emission factors decreased by(71.6 ± 4.3)%,(65.6 ± 9.5)%,(64.9 ± 9.2)% and(67.8 ± 0.3)%, respectively. In this study, The Beijing city buses with stricter emission standards(Euro Ⅳ) did not have lower emission factors than the Chongqing coaches with Euro Ⅱ emission standards. Both the higher emission factors at 0–10 km/hr speeds and the higher percentage of driving in the low-speed regime during the entire road cycle may have contributed to the higher CO_2 and CO emission factors of these city buses. Additionally, compared with the emission factors produced in the urban road tests, the CO emission factors of the CNG buses in highway tests decreased the most(by 83.2%), followed by the THC emission factors, which decreased by 67.1%.     

Key airborne concentrations of chemicals for emergency response planning in HAZMAT road transportation- margin of safety or survival

The release of chemicals due to road transportation accidents could have adverse consequences such as fatality, physical and financial loss and environmental damage. The purpose of this study was to determine the suitable margin of safety/survival of individuals in HAZMAT road transportation accidents for use in Emergency Response Planning (ERP). In this study, at first, the safety margin and survival margin were defined and proposed. Then, as a case study, the chemical tanker trucks in Iran's road transport fleet were investigated and the full bore rupture of the tanker trucks was considered as the selective scenario. Eventually, safety margin and survival margin were determined using ALOHA and PHAST software and the Chemical Exposure Index (CEI). The results showed that using the CEI, among the selected chemicals, ammonia, chlorine and 1,3-butadiene had the highest chemical release potential with the exposure indices of 597, 548 and 284, respectively, and need further investigation. The possible safety margin obtained in this study was distances over 5100 m (using ALOHA software for ammonia) and 10,983 m (using PHAST software for chlorine). On the other hand, the survival margin was distances over 980 m away from the accident area (using ALOHA software for ammonia) and 620 m away from the accident area (using the PHAST software for chlorine). The results of this study indicate that determining the safety and survival margins surrounding the tanker trucks and containers of chemicals is a critical issue for the emergency response planning and determining the standards of road's safety and survival margins. On the other hand, due to the obtainment of different results by various methods and software, in road accidents, the highest hazard distance is suggested to be considered to determine the safety margin (distances longer than 10,983 m) and survival margin (distances longer than 980 m) for ERP, regardless of the type of used material and software.     

New findings regarding the significance of pavement skid resistance for road safety on Swiss freeways

INTRODUCTION: The significance of the influence of poor pavement skid resistance values on accident frequency in wet pavement conditions has been the object of many studies over several years. The various investigations have produced very diverse findings. Only seldom, however, has detailed consideration been given to the central question of whether pavement skid resistance is a decisive parameter in the occurrence of local accident "black spots." Until now, the focus has been more on describing a relationship between pavement skid resistance and accident frequency. METHOD AND RESULTS: In the course of the network-wide survey of the states of pavements and of accident occurrence on Switzerland's freeways from 1999 to 2003, it emerged that a relationship with inadequate pavement skid resistance was provable for only a small proportion of accident black spots. These findings were used to frame a guideline for authorities and highway operators about how to treat skid resistance when assessing pavements and accident occurrence on freeways.     

When may road fatalities start to decrease?

Introduction

The comparative analysis of macroscopic trends in road safety has been a popular research topic. The objective of this research is to propose a simple and, at the same time, reliable multiple regime model framework for international road safety comparisons, allowing for the identification of slope changes of personal risk curves and respective breakpoints.

Method

The trends of road traffic fatalities in several EU countries have been examined through the temporal evolution of elementary socioeconomic indicators, namely motorized vehicle fleet and population, at the country level.

Results

Piece-wise linear regression models have been fitted, using a methodology that allows the simultaneous estimation of all slopes and breakpoints. The number and location of breakpoints, as well as the slope of the connecting trends, vary among countries, thus indicating different road safety evolution patterns.

Impact on industry

Macroscopic analysis of road accident trends may be proved beneficial for the identification of best examples and the implementation of appropriate programmes and measures, which will lead to important benefits for the society and the economy through the reduction of road fatalities and injuries. Best performing countries and the related programmes and measures adopted may concern several safety improvements at the processes of the road, the vehicle and the insurance industries.

Conclusions

Lessons from the analysis of the past road safety patterns of developed countries provide some insight into the underlying process that relates motorization levels with personal risk and can prove to be beneficial for predicting the road safety evolution of developing countries that may have not yet reached the same breakpoints. Furthermore, the presented framework may serve as a basis to build more elaborate models, including more reliable exposure indicators (such as vehicle-km driven).     

Case studies: Application of SEA in provincial level expressway infrastructure network planning in China — Current existing problems

Since the Law of the People's Republic of China on Environmental Impact Assessment was enacted in 2003 and Huanfa 2004 No. 98 was released in 2004, Strategic Environmental Assessment (SEA) has been officially being implemented in the expressway infrastructure planning field in China. Through scrutinizing two SEA application cases of China's provincial level expressway infrastructure (PLEI) network plans, it is found that current SEA practice in expressway infrastructure planning field has a number of problems including: SEA practitioners do not fully understand the objective of SEA; its potential contributions to strategic planning and decision-making is extremely limited; the employed application procedure and prediction and assessment techniques are too simple to bring objective, unbiased and scientific results; and no alternative options are considered. All these problems directly lead to poor quality SEA and consequently weaken SEA's effectiveness.