污泥脱水性能参数——比阻检测的若干问题研讨

分析了实验压力和含固率对污泥比阻测量的影响,讨论了比阻计算中几个重要参数-单位体积滤液产生的污泥干重!、有效过滤面积A以及粘度的测量",旨在提高比阻测量值的精确度和可比性。     

化学氧化和砂滤对净水工艺中颤蚓污染的协同控制

为实现对净水工艺中蠕虫污染的高效控制,以颤蚓为主要研究对象,研究了化学氧化与砂滤对蠕虫污染的协同控制作用.结果表明,以化学氧化和砂滤拦截为基础的截留灭活技术对颤蚓具有高效控制效果,当ClO2投量超过0.1mg/L后,9~15m/h的滤速范围内均实现了对颤蚓的100%拦截.截留灭活过程中,化学氧化和砂滤拦截实现了对颤蚓污染的协同控制作用:砂滤可延长化学氧化接触时间,化学氧化则通过降低颤蚓的迁移能力提高了砂滤拦截效果. 通过在BAC滤池内增设石英砂垫层对仙女虫进行截留灭活,实现了对仙女虫污染的高效控制,同时避免了对BAC滤池正常吸附和降解功能的影响.     

一体式MBR污泥特性及对其过滤性能的影响

研究了一体式MBR长期不排泥运行的污泥特性变化,考察了水力停留时间、曝气量等因素对污泥增长特性、污泥颗粒粒径分布及膜过滤性能的影响,并探讨了这些因素之间的关系。结果表明:水力停留时间越短,MLSS与MLVSS增加越快,膜污染加速,膜过滤阻力增加越快,但MBR中污泥浓度的增长、变化对出水COD的影响不明显;污泥平均粒径随SRT的延长而减小,实验结束污泥粒径最小值为0.6μm大于实验用膜的孔径0.2μm,表明混合液中的微细颗粒污泥未对膜通量的下降起决定性作用,膜表面污泥的沉积对膜通量影响更大一些,增加曝气强度可以明显改善MBR的过滤性能。     

助剂强化罐底油泥的压滤脱水性能

采用实验室压滤装置对胜利油田某联合站罐底清罐油泥进行压滤脱水研究,采用单独添加助滤剂G、絮凝剂PAM或PAC均可改善过滤效果,提高滤速,降低过滤比阻。但仅使用助滤剂G时滤速的提高尚不够理想,单独使用絮凝剂PAM或PAC时,滤饼含水率偏高,滤饼不易从滤布上剥离;絮凝剂PAM 0.1%与助滤剂G 3.0%复配,滤饼比阻由空白样的18.7×1012 m/kg降低到0.05×1012 m/kg,3 min即可使滤饼含水率降到74.16%,滤液澄清,滤饼成形性好,较仅添加絮凝剂PAM时,更容易从滤布上剥离。     

塑烧板除尘器在精轧机除尘系统中的应用

为满足环境治理的要求以及更好地保证钢板表面质量,日照轧钢有限公司1580带钢厂及新余钢铁有限责任公司1580热轧带钢生产线均采用塑烧板除尘器处理热轧过程中产生的大量的氧化铁粉、油雾、水蒸汽烟气。结合精轧生产线的工艺特点,选用第三代塑烧板作为清灰滤料,比较了两种吸尘罩对除尘系统运行效果的影响。     

Size fractionation and characterization of nanocolloidal particles in soils

A protocol was developed to fractionate soil particles down to the nanocolloid scale by combining sieving, sedimentation, centrifugation, and cross-flow filtration (CFF). The validity of the method and the performance of the CFF system were tested by characterizing fractions using laser granulometry, electron microscopy, and chemical analysis. The 0.1-μm-pore-size membrane CFF system effectively retained nanocolloids (<0.1 μm) as shown by laser granulometry and observed directly by transmission electron microscopy. However, environmental scanning electron microscopy images of freeze-dried colloids were very different from their TEM counterparts, suggesting that sample preparation influenced microscopy imaging. Chemical analysis of Cu, Cd, and organic carbon in each fraction showed that the concentrations of these components increased as particle size decreased, indicating colloids and nanocolloids play an important role in retaining trace metals. Particle-size fractionation combined with chemical analysis and electron microscopy can provide insight into the nature and properties of nanocolloids in soil.     

曝气生物滤池耦合超滤反渗透处理乙烯厂污水工程实例

采用“曝气生物滤池－超滤－反渗透”工艺处理由污水处理厂排水、滤池反洗水、清净下水以及厂区生活污水混合而成的废水,工程运行结果表明,COD ,BOD ,氨氮、浊度、电导率的去除率分别为68．06％,77．93％,72．73％,97．37％,99．17％,出水pH为7．2,本系统出水水质满足循环水补水水质要求。     

Occurance and control of manganese in a large scale water treatment plant

The continuous variations of dissolved oxygen (DO), manganese (Mn), pH, and their effect on manganese removal by different water treatment processes are investigated. The results show that the declined DO concentration and pH value in the bottom of reservoir results in the increasing release of Mn from sediment to source water. Manganese concentration increased from 0.1 to 0.4 mg·L^-1 under the condition that DO concentration decreased from 12.0 to 2.0 mg·L^-1 in raw water. The different water treatment processes exhibited different efficiency on manganese removal. The processes with recycling of the suspended sludge, low elevation velocity in settling tank and slow filter rate, will benefit the manganese removal. During a high release of manganese in raw water, traditional coagulation-sedimentation and filtration could not completely remove Mn, although granular activated carbon filtration (GAC) had been applied. At that case, preoxidation with chlorine or potassium permanganate (KMnO₄) was necessary to address the high manganese concentration.     

次毫米过滤组件分离高浓度污泥试验

采用自主研制的一种次毫米过滤组件,实现高浓度污泥的折衷分离,考察了ρ（污泥）（10～30 g/L）、组件孔径（0.10～1.00 mm）及压差（水头差:30 cm H₂O,90 cm H₂O）对次毫米过滤通量和平均通量的影响;利用多元线性回归模型和因素主次分析方法,探讨了三因素对平均通量的影响程度.结果表明:在不同的ρ（污泥）、组件孔径及压差条件下,过滤通量随时间均呈负指数形式衰减;三因素对平均通量的影响程度为ρ（污泥）>组件孔径>压差,ρ（污泥）与平均通量呈负相关,组件孔径、压差与平均通量呈正相关.同时,通过解析多元线性回归模型得到次毫米平均通量的表达式,为试验设计的优化提供了理论依据.      

高效反渗透工艺处理电厂废水

采用“机械加速澄清—重力式过滤—离子交换—除碳—高效反渗透” 工艺处理某电厂废水,将反渗透产水作为冷却塔补水。运行结果表明：弱酸阳离子交换器出水碱度≤0.10 mmol/L、硬度≤0.02 mmol/L、浊度≤0.2 NTU,满足高效反渗透对进水水质的要求;高效反渗透产水浊度<0.1 NTU,COD_Mn≤0.08 mg/L,硬度≤1.12 mg/L,碱度≤8.40 mg/L,ρ（总铁）<10 μg/L,ρ（总硅）<0.5 mg/L,电导率<45 μS/cm,出水水质满足回用要求。针对该系统存在的自用水率高、过滤器污堵以及水量不平衡等问题提出了相应的建议。