颗粒床过滤中的惯性碰撞效应研究

在实验的基础上,得到了计算单个颗粒惯性碰撞收集效率的经验方程式。结果表明,气溶胶粒子的粒径越大,惯性碰撞越显著;气体流速的增加有利于粒子的惯性沉积;沙介质的粒径越小,气溶胶粒子的惯性碰撞效应越高,穿透率也就越低。     

构建湿地堵塞问题的研究

研究了复合垂直流构建湿地(IVCW)中与填料堵塞相关的填料粒径、渗透性能、有机质含量等因素的变化.经过颗粒分析得知填料粒径在2～5mm间,运用自制的砂样管对填料进行原位采样,渗透试验结果表明IVCW填料层的渗透系数随填料深度的增加而增加.IVCW填料各层中,渗透系数最小值存在于表层以下15～30cm处.IVCW系统运行52个月后,仅填料表面至15cm深处有少量有机质存在,15cm深度以下有机质含量极少,表明IVCW系统运行稳定,未出现堵塞现象.文中通过分析填料堵塞的影响因素提出相应的预防措施和对策.     

大连港专用矿石码头污水处理工程设计

采用沉砂、序批调节沉淀及浅层介质过滤的物化组合方式处理大连港专用矿石码头洗矿污水,介绍了各处理构筑物、运行参数.运行结果表明,用该法处理洗矿污水,其出水水质可达<生活杂用水水质标准>(CJ25.1-89)中绿化用水标准(其中悬浮物不大于10 mg/L).     

Evaluation of fungal potentiality for bioconversion of domestic wastewater sludge

This study was undertaken to screen the filamentous fungi isolated from its relevant habitats (wastewater, sewage sludge and sludge cake) for the bioconversion of domestic wastewater sludge. A total of 35 fungal strains were tested against wastewater sludge (total suspended solids, TSS 1%-5% w/w) to evaluate its potentiality for enhancing the biodegradability and dewaterability using liquid state bioconversion(LSB) process. The strains were divided into five groups i. e. Penicillium, Aspergillus, Trichoderma, Basidiomycete and Miscellaneous, respectively. The strains WWZP1003, SCahmA103, SCahmT105 and PC-9 among their respective groups of Penicillium,Aspergillus, Trichoderma and Basidiomycete played potential roles in terms of separation (formation of pellets/flocs/filaments),biodegradation(removal of COD) and filtration(filterability) of treated domestic wastewater sludge. The Miscellaneous group was not considered due to its unsatisfactory results as compared to the other groups. The pH value was also influenced by the microbial treatment during fermentation process. The filterability of treated sludge was improved by fungal treatment, and lowest filtration time was recorded for the strain WWZP1003 and SCahmA103 of Penicillium and Aspergillus groups respectively compared with other strains.     

两性高分子絮凝剂的制备及其应用研究

以天然植物粉Ｆ６９１为原料,通过羧甲基化、接枝共聚和曼尼期(Ｍａｎｎｉｃｈ)三步反应合成出两性天然高分子改性絮凝剂(ＣＧＡＡＣ),确定了其较佳的制备条件;ＣＧＡＡＣ对造纸抄纸白水和造纸混合污泥的絮凝脱水试验表明:１０ｍｇ·ｌ－１ＣＧＡＡＣ与４０ｍｇ·ｌ－１ＰＡＣ配合使用,ＣＯＤＣｒ去除率可达７２%,效果优于对比样ＰＨＰ;ＣＧＡＡＣ对造纸混合污泥的絮凝脱水性能优于对比样ＰＨＰ和ＰＡＭ－Ｃ．     

生物陶粒柱—PAC—膜过滤装置系统处理饮用水实验研究

生物陶粒柱和粉末活性炭作为淹没式中空纤维膜过滤装置的预处理工艺不仅解决了膜过滤装置氨氮去除不利的弱点,避免了亚硝酸盐氮的积累,而且在浊度、细菌、有机物等方面极大地降低了膜过滤装置的负荷。生物陶粒柱－PAC－膜过滤装置系统高锰酸盐指数平均去除率为76．97％,氨氮和亚硝酸盐氮的平均去除率分别达到顾95．50％和99．15％。     

Building urban gas process safety management (UG-PSM) system: Based on root cause analysis with 160 urban gas accidents in China

Urban safety is significantly impacted by the complexity of urban gas accidents. Although China has put forward the goal of “zero fatalities in accidents” for urban gas, unfortunately, the root causes of the unsound safety culture and imperfect safety management system of urban gas enterprises remain unresolved. Therefore, statistical analysis and 24Model analysis of 160 urban gas accidents in mainland China were performed to investigate the proximate causes of the accidents and the current situation of urban gas safety. The CCPS's risk-based process safety elements were used to identify potential deficiencies in the current urban gas process safety management (UG-PSM). During the analysis, it was observed that insufficient implementation of concealed danger investigation and rectification accounted for 76%, which is the primary proximate cause of urban gas accidents. Stakeholder outreach is the most under-represented competency in urban gas safety management. Based on the results, a novel framework for the UG-PSM system was constructed, and the theory of urban gas safety management was further improved. Furthermore, we evaluated the matching degree between UG-PSM elements and the existing measures of the government, urban gas associations, third-party organizations, and urban gas enterprises. Finally, we analyzed the feasibility, challenges, and development directions of the UG-PSM system. This study establishes a foundation for researchers and practitioners in the future research and practice of urban gas process safety and provides theoretical guidance for preventing high-incidence accidents of urban gas in China.     

Root causes of hydrocarbon leaks on offshore petroleum installations

Hydrocarbon leaks on offshore installations may result in severe consequences to personnel, to the environment and to assets. In order to prevent such leaks, it is crucial to understand their root causes. The objective of this paper is to study the circumstances of hydrocarbon leaks on the Norwegian continental shelf (NCS). In the study, all reported hydrocarbon leaks from process inventories on all offshore installations on the NCS, with an initial leak rate higher than 0.1 kg/s in the period 2008–2014, have been considered. This includes 78 hydrocarbon leaks, of which about 60% have occurred during manual intervention on normally pressurized systems. The dominating activity when leaks occur is preventive maintenance. A significant fraction of the leaks occur during the preparation for maintenance; such a preparation is typically carried out during the night shift. About half of the leaks are associated with wellhead area and manifolds, separation and compression systems. A substantial fraction of the leaks can be associated with verification faults, dominated by the failure to comply with procedural requirements that are needed to carry out independent verification.     

Pre-oxidation enhanced cyanobacteria removal in drinking water treatment: A review

Cyanobacterial bloom has many adverse effects on source water quality and drinking water production. The traditional water treatment process can hardly achieve satisfactory removal of algae cells. This review examines the impact of pre-oxidation on the removal of cyanobacteria by solid-liquid separation processes. It was reported that the introduction of chemical oxidants such as chlorine, potassium permanganate, and ozone in algae-laden water pretreatment could improve algae removal by the subsequent solid-liquid separation processes. However, over dosed oxidants can result in more serious water quality risks due to significant algae cell lysis and undesirable intracellular organic matter release. It was suggested that moderate pre-oxidation may enhance the removal of cyanobacteria without damaging algae cells. In this article, effects of moderate pretreatment on the solid-liquid separation processes (sedimentation, dissolved air flotation, and membrane filtration) are reviewed.     

Filtration Properties of Nonwovens

Abstract

This paper presents the results and conclusions from experimental investigations concerning filtration properties of nonwovens. The needled nonwovens were made from polyester fibres (PTE) with average fibre diameter 12 µm and polypropylene fibres (PP) with average fibre diameter 32 μm. Nonwovens were produced out of each of those fibres or out of a mixture of polyester and polypropylene fibres. This paper also presents investigations of nonwoven fabric made of polypropylene fibres (PP) with average fibre diameter 2.6 μm, which was formed according to melt-blown technology. Oil mist, as challenge aerosol, was used to evaluate the performance of filter media at various aerosol velocities. The average oil mist test aerosol particle diameter was 0.3 μm. Filter penetration was measured at oil mist concentration 0.24 g/m³.