DOC/CCRT老化对柴油公交车气态物排放特性的影响

基于重型底盘测功机,研究新鲜及老化氧化型催化器(DOC)、氧化型催化器耦合催化型颗粒捕集器(DOC+CDPF,CCRT)对在用国Ⅲ柴油公交车进行中国典型城市公交车循环CCBC时一氧化碳(CO)、总碳氢化合物(THC)、一氧化氮(NO)、二氧化氮(NO_2)和氮氧化物(NO_x)、二氧化碳(CO_2)等气态物排放特性的影响.结果表明:采用新鲜及老化DOC/CCRT,均可以降低CO、THC、NO排放,增加NO_2排放,NO_x及CO_2排放基本不变;在怠速、加速、减速及匀速这4种工况下,新鲜DOC比老化DOC对CO、THC氧化效率好,新鲜CCRT比老化CCRT对THC氧化效率好,但老化CCRT对CO氧化效率更好,新鲜DOC/CCRT比老化DOC/CCRT对NO减少幅度高,对NO_2增加幅度高,但对NO_x排放总量基本无影响.     

Cu-Al2O3中骨架铜类芬顿催化去除水中有机污染物

为解决传统铁基芬顿催化剂在水体通常酸碱(pH6)条件下活性低的问题,采用简单共沉淀法制备了Cu掺杂的Al_2O_3类芬顿催化剂.通过X射线衍射(XRD)、X射线光电子能谱(XPS)和紫外可见(UV-vis)吸收光谱分析表明,Cu-Al_2O_3中铜掺杂的质量分数低于4.77%时,催化剂中铜主要以Cu~(2+)和Cu~+的形式共存于Al_2O_3的骨架结构中,形成Al—O—Cu键;过量的铜掺杂会导致外骨架铜物种如铜氧化物团簇的存在.以难降解有机污染物2-氯苯酚(2-chlorophenol,2-CP)和染料罗丹明B(Rhodamine B,Rh B)为目标污染物,对Cu-Al_2O_3的类芬顿催化性能进行了详细地研究.结果表明,骨架铜物种在中性温和条件下对2-CP和Rh B显示出很高的催化去除效率和稳定性,反应2 h,Cu-Al_2O_3(Cu质量分数4.77%)对2-CP的去除率达到54%,相应的TOC去除率达到49%,而铜离子溶出浓度仅为0.025 5 mg·L-1,而Cu-Al_2O_3(Cu质量分数7.58%)由于外骨架铜的存在导致催化活性增加缓慢和稳定性下降.ESR测试结果表明,·OH和HO_2~-/O_2~-·是反应中主要的活性物种.     

Toluene removal characteristics by a superimposed wire-plate dielectric barrier discharge plasma reactor

A superimposed wire-plate dielectric barrier discharge reactor was used to remove toluene in this study. The effects of oxygen content, gas flow rate, gas initial concentration and with/without catalyst on toluene decomposition were investigated. It was found that an optimal toluene removal was achieved when the oxygen content was about 5%. Under this condition, the highest toluene removal efficiency of 80.8% was achieved when the gas concentration was 80 mg/m^3. The toluene removal efficiency decreased with the increase of the gas flow rate and the initial concentration of toluene. In addition, the ozone concentration decreased with the increase of the initial concentration of toluene. It suggested that combining DBD （dielectric barrier discharge） with Co3O4/Al2O3/foam nickel catalyst in-situ could improve the toluene removal efficiency and suppress ozone formation. Products analysis showed that the main products were CO and CO2 when oxygen was more than 5%.     

石油化工催化剂生产过程中的职业病防治及应急处理

石化企业使用了大量的催化剂,催化剂开发、生产过程复杂,有许多原料和生产工艺,存在许多潜在的安全隐患和职业病危害因素。为预防催化剂生产过程中的事故,通过分析催化剂生产过程中的职业病危害分析,提出了相应的职业病防范及应急处置措施,加强催化剂生产过程中的职业病防治和应急处置能力,创造良好的经济、生态和社会效益,有效防止催化剂生产过程中发生安全事故和职业病。     

石油化工企业含苯胺消防污水处理技术研究

针对石油化工企业含苯胺的消防污水,利用基于过氧化氢和氯化铁为氧化剂的深度氧化技术,通过氧化、絮凝、过滤和吸附对消防污水进行处理。实验确定氧化剂的投加量为理论投加量,氧化时间1.0h,消防污水pH值为6.86时,絮凝剂最佳使用浓度约为2%,消防污水中苯胺和COD去除率达到99.5%以上,达到了消防污水处理效果。     

基于TiO2载体的锰铈系低温SCR脱硝催化剂研究进展

开发低温、高活性、高抗硫抗水性能的选择性催化还原(SCR)脱硝催化剂已成为国内外的研究热点。综述了基于TiO2载体的锰铈系低温脱硝催化剂的脱硝性能,探讨了助剂掺杂改性、制备方法、反应条件等对催化剂脱硝性能的影响,总结了现有低温脱硝催化剂的技术难点,指出SCR催化剂的研究需要着重考虑以下几方面:深入研究催化剂的反应机理和中毒机理;研究催化剂的循环再生;探究拓宽催化剂温度窗口,使其适应不同的温度条件。     

催化超临界水氧化处理1,5-萘二磺酸

采用Mn2O3/γ-AL2O3和V2O5/γ-Al2O/为催化剂,在一连续流固定床反应器中进行了超临界水氧化1,5-萘二磺酸实验.实验结果表明,在380～440℃,24 MPa条件下,Mn2O3/γ-Al2O3和V2O5/y-Al2O3催化剂对1,5-萘二磺酸的氧化降解具有显著的促进作用,TOC去除率达到90%以上;催化剂的催化效果随反应温度的升高而增强,随pH值的降低而增强,随停留时间的延长先增强后趋于平缓.     

全白土催化剂生产废水的处理

用4种无机絮凝剂和3种有机絮凝剂进行了脱除全白土催化剂生产废水（简称废水）中固体悬浮物（SS）的实验研究。实验结果表明：在废水pH6．8条件下,无机絮凝剂和有机絮凝剂脱除废水中SS的效果均较差,用无机絮凝剂时的SS去除率低于26％,用有机絮凝剂时的SS去除率低于18％;废水pH对SS去除率的影响较大,当调节废水pH为8．0时,无机絮凝剂中硫酸铝脱除废水中的SS效果最好,在硫酸铝加入量为0．02mg／L、沉降时间为2h的最佳操作条件下,SS的去除率可达93％。     

Ozone facilitated degradation of caffeine using Ce-TiO2 catalyst

The ozone initiated oxidation of 1,3,7-trimethylxanthine (caffeine), commonly found in wastewaters as model compound is reported using cerium (Ce)/titanium dioxide (TiO₂) as catalyst. The effect of pH and loading of ceria on titania were investigated. Effect of reaction conditions on degradation of caffeine based on their pseudo first-order rate constants were compared. The combination of catalyst Ce-TiO₂ and ozone aeration significantly enhanced the degradation of caffeine compared to uncatalysed ozonation. The oxidation of caffeine ensued via the free radical mechanism, through enhanced ozone decomposition into OH radicals. Ce/TiO₂(0.5?wt%) showed good activity in degradation of caffeine at pH 6, in both natural stream and river water samples showing about 60% total organic carbon removal in 2?h ozonation period. Using liquid chromatography-mass spectroscopy, degradation products were analysed. A reaction intermediate and one final product were positively identified. Nano-catalysts with different loadings of Ce on TiO₂ synthesized by sol-gel route were characterized by scanning electron microscope, transmission electron microscopy, BET and powder X-ray diffraction spectrum techniques. The results showed that the material retained a highly ordered mesoporous structure and possessed large surface area.     

CeO2/TiO2纳米管催化剂脱硝性能研究

利用废气中本身含有的CO催化还原烟气中的NO_x,可以实现以废治废。采用TiO₂纳米管负载CeO₂,制备CeO₂/TiO₂纳米管催化剂,并对其进行了SEM表征及影响因素实验。实验结果表明：在n（Ce）∶n（Ti）=3∶7、焙烧温度500 ℃、焙烧时间3 h时制备的CeO₂/TiO₂纳米管催化剂形貌较好,表面颗粒分布相对均匀;反应温度400~600 ℃时NO脱除率达98%;该催化剂具有一定的抗氧性能;当n（SO₂）∶n（NO）=（1∶2）~（2∶1）时,NO脱除率仍然在95%以上。