顺丁烯二酸酐生产的环境友好技术

以正丁烷选择性氧化制顺丁烯二酸酐为例，按照氧化还原进行的烃类选择性氧化反应，采用将催化循环的不同步骤在空间或时间上分离的操作方法，可大幅度地提高反应的选择性，实现环境友好生产。重点介绍了循环流化床、人为非定固定床和膜反应器这3种新反应技术在顺丁烯二酸酐生产中的应用。     

丙烯腈反应器的故障树分析

应用系统可靠性分析基本原理，以丙烯腈反应工序的核心装置反应器为分析对象，确定反应器在运行过程中的防爆膜破裂事故为顶事件，应用故障树分析方法建立故障树，并对其进行定性和定量分析，得出顶事件最小割集和发生概率。本工作对石化企业的环境风险评价和安全分析具有重要意义。     

Conversion regular patterns of acetic acid, propionic acid and butyric acid in UASB reactor

On the basis of continuous tests and batch tests, conversion regular patterns of acetate, propionate and butyrate in activated sludge at different heights of the UASB reactor were conducted. Results indicated that the conversion capacity of the microbe is decided by the substrate characteristic when sole VFA is used as the only substrate. But when mixed substrates are used, the conversion regulations would have changed accordingly.Relationships of different substrates vary according to their locations. In the whole reactor, propionate‘s conversion is restrained by acetate and butyrate of high concentration. On the top and at the bottom of the reactor, conversion of acetate, but butyrate, is restrained by propionate. And in the midst, acetate‘s conversion is accelerated by propionate while that of butyrate is restrained. It is proved, based on the analysis of specific conversion rate, that the space distribution of the microbe is the main factor that affects substrates‘ conversion. The ethanol-type fermentation of the acidogenicophase is the optimal acid-type fermentation for the two-phase anaerobic process.     

Characteristics of aerobic granules grown on glucose a sequential batch shaking reactor

Aerobic heterotrophic granular sludge was cultivated in a sequencing batch shaking reactor(SBSR) in which a synthetic wastewater containing glucose as carbon source was fed. The characteristics of the aerobic granules were investigated. Compared with the conventional activated sludge flocs, the aerobic granules exhibit excellent physical characteristics in terms of settleability, size, shape, biomass density, and physical strength.Scanning electron micrographs revealed that in mature granules little filamentous bacteria could be found, rod-shaded and coccoid bacteria were the dominant microorqanisms.     

二氧化碳软化高硬度废水的研究

采用一种新装置——自吸式反应器强化CO_2软化高钙废水过程,探究了温度、起始pH值、CO_2气体流量、CO_2总通入量等因素对钙离子去除率的影响。结果显示,在起始pH值为12.89、温度20℃、通入的CO_2体积分数为100%、CO_2气体流量为1.0 L/min时,钙离子去除率最高达98.47%。与传统的鼓泡搅拌反应器相比,CO_2利用率提高了2倍以上。     

烧结烟气SCR脱硝系统的数值模拟及工程验证

对某钢厂烧结机增设的选择性催化还原（SCR）烟气脱硝系统进行了数值模拟优化及工程验证。将高温焦炉烟气喷入烧结烟气后,喷氨格栅入口平均温度提高了30 K,为催化剂层的SCR反应提供了较适宜的温度。采用分别在烟道弯头处和反应器主体入口处添加导流板的方法解决了烟气回流问题,SCR反应器第一层催化剂入口处速度最大偏转角降为8.2°,氨与NO_x摩尔比的标准偏差系数降至4.11%,SCR反应器脱硝率为82.6%,均达到技术标准要求。     

厌氧附着膜膨胀床工艺活性污泥特性的研究

对厌氧附着膜膨胀床反应器中活性污泥的特性进行了研究。结果表明,载体上生物膜的形成和发展经历吸附、局部挂膜和完全挂膜３个阶段,在此过程中,微生物群演变由以球菌占优势,逐步过渡到丝状菌占优势,厌氧污泥的活性随之提高。酸化状态下的活性污泥表面有许多链球菌和大量的胞外聚物,污泥活性较低。     

SBR生物技术处理竹浆造纸黑液的研究

通过循环序间歇式活性污泥法（ＳＢＲ）处理可使经酸析木质素后所得黑液中的ＢＯＤ５和ＣＯＤ显著减少,当进水中ＣＯＤ浓度为１０９０－１１７０ｍｇ／Ｌ时,ＢＯＤ５去除率为７０％－８３％,ＣＯＤ去除率为５４．５％－６３％,出水中ＢＯＤ５和ＣＯＤ的浓度分别为７６－１０１ｍｇ／Ｌ和４１９－５００ｍｇ／Ｌ,内电解与ＳＢＲ联合对黑液的处理更为有效,当进水ＣＯＤ浓度为１０４６－１１００ｍｇ／Ｌ,ＢＯＤ５和ＣＯＤ去除率     

改进的二相厌氧消化系统的特性研究

研究填充酸化反应器及其与ＵＡＳＢ甲烷化反应器组成的二相厌氧消化系统的运行特性,填充酸化反应器启动方便酸化速率高,抗水力冲击和ｐＨ波动的能力强,ＣＯＤ容积负荷达２００ｋｇ／（ｍ＾３．ｄ）,采用预调碱工艺,二相消化运行正常,可高效地处理酿酒废水,在进为ＣＯＤ浓度１０００－７０００ｍｇ／Ｌ,ＣＯＤ负荷４０ｋｇ／（ｍ＾３．ｄ）时,出料ＣＯＤ浓度小于２００ｍｇ／Ｌ对抗生素生产废水也有较好的处理效果。     

水力负荷对生物陶粒反应器运行的影响

不力负荷较低是影响生物陶粒反应器在实际中运用推广的重要因素之一。本实验研究了不同水力负荷条件下生物陶粒反应器对进水中有机物,氨氮及其它污染物的去除效果。结果表明,不同水力负荷对生物陶粒反应器处理效果没有影响,对ＯＣ,氨氮,ＵＶ２５４,色度和浊度去除率分别为２０％,９０％,３０％,３８％,７６％。